navigation MAZDA MODEL CX-7 2008 Quick Tips (in English)

GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Steering-
wheel
audio
controls
To increase/
decrease
volume:
Press (4).
Press ( 5) to either mute standard
Audio system or activate
Navigation Voice Command*.
Press ( 6) to select AM, FM 1,
FM 2 and CD mode.
Radio: Press ( 7) less than
one second to select next/previous
preset station, press ( 7)
more than one second until beep
sound is heard to seek next/
previous station.
CD: Press ( 7) to select next
track, press ( 7) to repeat
current track.

/
/
Getting
Started
Getting
Started
Tilt
steering-
wheel
release lever
Pull lever ( 8) down
to unlock column
and pull up to
lock column.
WARNING: Do not adjust
steering-wheel while driving
because you may lose control
of the vehicle.
AUTO* = With ignition switch
in ON position; headlights and
exterior lights automatically
turn ON/OFF depending on
surrounding darkness/lightness;
rotate knob ( 1) to third notch
= Fog lights* on: Rotate ( 2);
functions only with low
beams on
Turn signals right/left: move
lever up/down.
Cruise
control
Operates
above
19 mph.
Press ON/OFF
switch ( 1) to
enable/disable.
To set speed: Press switch ( 2)
down and release.
To increase set speed: Push
switch ( 2) up and release
at desired speed.
To decrease set speed: Press
switch ( 2) down and release
at desired speed.
To cancel: Tap brake or press
CANCEL switch ( 3).
Turn signal/lighting
control lever
OFF = Lights off
= Tail, parking and
dashboard lights on: Rotate
knob ( 1) to first notch
= Tail, parking,
dashboard and headlights on:
Rotate knob ( 1) to second notch
High beams on/off: Push
forward/pull back to detent.
To flash high beams: Pull back
slightly and release.
Rear window wiper/washer To activate rear interval wiper:
Rotate knob ( 4) up to INT.
To activate rear normal speed
wiper: Rotate knob ( 4) up to ON.
To activate rear washer: Rotate
knob ( 4) to and release.Wiper/washer control leverSingle wipe: Push lever up.
Washer: Pull back, also operates wipers.
Intermittent wiper: One click down.
To change interval speed: Rotate
inner ring ( 3).
Normal wiper speed: Two clicks down.
High-speed wiper: Three clicks down.
*Denotes optional equipment
21
AUTO
R EA R
43
M IS TPU LL
8
31
ON OFF CANCEL
RES/ +
SET/–
256
VOL+ – MODE
47

INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
WARNING LIGHTS
• Cruise control onAmber light: Cruise control
system activated
Green light: Cruising speed set;
see Getting Started
• Tire Pressure Monitoring System (TPMS),
see Getting Started
• High beams on • Engine oil-pressure warning lightStop car when safe and turn
off engine; check oil level
• Brake system Parking brake on/low brake fluid
• Always fasten seat belts • Security indicator light*
• OLow fuel
• Door ajar

GAUGES
1. Tachometer
2. Speedometer
3. Instrument cluster dimmer select button*
Pressing this button will toggle
between Navigation screen
DAY or NIGHT modes; rotating
knob will adjust brightness.
Tip: Instrument cluster
brightness can be adjusted
with headlight switch in
any position (black-out
meter mode).
4. Engine coolant temperature gauge
Stop car if above normal
range, turn off engine, let
vehicle cool; check coolant
level when safe.
• Charging system warning light
Charging system malfunction;
dealer inspection required
• Air bag/front seat belt pretensioner system
If light flashes or stays on, the air
bags/front seat belt pretensioners
may not operate in an accident;
dealer inspection r equired
• Check engine Dealer inspection required if light
remains on, see Owner’s Manual
• AT Automatic transaxle
warning light*
Automatic transaxle malfunction;
dealer inspection required
• Anti-lock Brake System (ABS)
ABS malfunction, normal brakes
only; dealer inspection required
5. Fuel gauge 18.2-gallon/69-liter tank
6. Odometer/Trip meter selector
Press to view odometer; press
again to reset trip odometer
A/B settings.
InstrumentCluster
Instrument Cluster

TRIPA773.7
67498
H140
8
7
6
5
4
3 2 10220
40
60
80
100
120
140
160
180
200
20
120
100
80
60
40 20 0
C
F
x1000km/min km/hE
P
R
N
D
M
785
12364
• Turn signals/hazard warning on
• KEY*,see Getting Started
• TCS OFF Traction Control System is
deactivated
• Lights ON indicator light*
• Traction Control System (TCS)/Dynamic
Stability Control (DSC)
Light flashes when in use; dealer
inspection required if light
remains on
•
4WDAWD warning light*
Flashing lamp indicates high
temperature differential oil,
illuminated lamp indicates an
abnormality with AWD system;
dealer inspection required
7. Odometer/Trip meter
8. Gear indicator Displays current gear
position or manual mode.
CRUISE
*Denotes optional equipment

REAR SEATS
Always check the Owner’s Manual for more operating information and safety features
Automatic
Transaxle
Gearshift
must be in
Park or
Neutral to
start engine;
it must
be in Park
to remove
ignition key.
P = Park
To move gearshift from Park:
Press firmly on brake pedal then
move the shift lever out of P.
R = Reverse
N = Neutral
No gear engaged.
D Drive (Overdrive)
For normal driving: Shifts through
all forward gears automatically.
Rear Seats
Transaxle
Rear center position seat belt†
Connecting seat belt: Pull seat
belt from ceiling recess ( 1) and
connect tongue ( 2) to anchor ( 3).
Wearing seat belt: Slowly pull out
lap/shoulder belt ( 4) and insert
tongue ( 5) into buckle ( 6) until
click is heard.
Unfastening seat belt: Depress
buckle button ( 6) to release.
Tip: Leave center-rear lap portion
of seat belt fastened at all times
except when folding rear seat.
Stowing seat belt: Insert key or small
object in anchor buckle slot ( 7) to
release entire belt, let it fully retract,
then put tongues ( 2) and ( 5) together,
insert securely into recess ( 1). Folding second-row seats
Unfasten lap portion of center-rear
seat belt; push knob (
8) down and
carefully lower seatback downward.
See Cargo Area tab for location of
rear cargo area remote handle levers.
Returning seatbacks to
original positions
Raise seatback to upward position.
Make sure seatback is locked
into position.
M (Sport A/T
manual shift mode)
Move shifter from
D to M to engage
manual shift mode,
M will be illuminated
for manual mode on
shift position indicator located
in the instrument panel.
Manual shifting of transmission
is achieved by moving shifter
back to upshift and forward to
downshift, move shifter from
M to D to engage automatic
shift mode.
Gear
indicator
Illuminated
numeral of
gear indicator
located in the
instrument panel
displays current gear in
Automatic and Manual
shift modes.
Tips: Back-up camera*
automatically operates when
gearshift lever is placed into
reverse and is viewable via
navigation display screen.
When using back-up camera,
objects may be closer than
they appear, please check
your surroundings.

P
R
N
D
M
8
140220
200P
R
N
D
M
*Back-up camera feature is only available with optional Technology Package
†See Owner’s Manual
8
8
2
1
365
4
7

AM/FM STEREO/CD/CD CHANGER
Always check the Owner’s Manual for more operating information and safety features
6. SEEK/TRACKRadio: Press to
automatically seek higher/
lower frequency.
CD: Press to select next
track/beginning of current track.
7. LOAD* To load multiple discs:
Press and hold LOAD ( 7) until
beep sound is heard; insert
CD when “IN” is indicated on
information display ( 20).
To eject disc: Press Eject ( 15).
To eject specific disc: Press
and hold Eject ( 15) until beep
sound is heard; within five
seconds press the desired tray
number 1-6 ( 16).

/

/

1. Power/Volume
Press to turn on/off; rotate
to increase/decrease volume.
2. Random Press to play CD selections
in random order, press again
to cancel.
3. Program
†4. Auto-Memory Press and hold until a beep sound
is heard; system automatically
scans and temporarily stores six
strong stations in each band;
press again to switch to another
preset station.
DISP
CD: Press repeatedly to scroll
through displays.
Text* : Rotate right/left to display
titles longer than 12 characters.
5. Tune Radio: Rotate counterclockwise/
clockwise for lower/higher
frequency.
10. FM/AMPress to turn radio on and
select between FM1/FM2/AM
station preset buttons ( 16).
11. CD slot
12. SA T*, Satellite ready capability.
13. CD, Press to play CD.
14. Media
†
15. CD eject button
16. Memory preset buttons To set: Tune to station, press and
hold until beep sound is heard.
17. Disc / * Press to skip to next/previous CD.
18. Audio control Audio: Press to select ALC/BASS/
TREB/FADE/BAL/BEEP/Surround*
OFF/1/2/3, rotate right/left to
adjust selected feature.
Tip: Automatic Level Control
(ALC) automatically adjusts
audio volume depending
on vehicle speed.

8. ScanRadio: Press to sample
strong stations, press again
to stop at current station.
CD: Press to play first few seconds
of each selection, press again
to stop at current selection.
9. RPT Press to replay current
CD selection.
Clock**To set: With ignition in ACC
or ON position, press ( A) and
hold until beep sounds; 12hr/24hr
will appear on display ( 20); press
( B ) to select; press ( A) again while
selection is flashing: Hr ADJUST
displays; press ( B) to select hour;
press ( A) when done, do the
same to set minutes.
Navigation/Audio System*AudioPilot* (BOSE system)
Automatically adjusts audio volume
in accordance with level of noise
entering vehicle; press on-screen
button to turn ON/OFF.
Centerpoint* (BOSE system)
Delivers multi-channel surround
sound while listening to CDs.
See Owner's Manual for
complete details.
19.
Reverse / Fast forward
Press to reverse/fast forward
through a track.
20. Display,
see Information Display

Audio
Systems
Audio
Systems

LOAD
CLOCK S
ET
SCANTRACK
S EE K APCRPT
PROG RDM FM/AM SAT CD M
EDIA VOL
PUSH POWERDISC
DISC123 6
45
910111213BA14
1845231
78
6
16
17
15
19
88:88 FM1 88.9 88.8CHDISC IN MD W ST RPT RDM AUTO-M8AMB FOAUTOA/C ECO20
TEXT
PUSH AUDIO CONT TUNE PUSH AUTO-M.DISP.ESN
*Denotes optional equipment
**See Navigation Owner’s Manual for clock setting procedure if
equipped with Navigation System
†Not functional in U.S. market