reset MAZDA MODEL CX-9 2016 (in English) Service Manual

6–20
Maintenance and Care
Scheduled Maintenance
Tab Item Explanation
Oil Change Reset
In À exible setting
Resets the remaining distance until oil replacement is due to the
initial value.
In ¿ xed setting
Resets the remaining distance until oil replacement is due to the
initial value. In addition, a vehicle engine control unit reset is
required as follows:
Press and hold the dashboard illumination knob with the ignition
switched OFF, then switch it ON. Keep pressing the dashboard
illumination knob for more than 7 seconds.
Dashboard illumination knob
In OFF setting
Press and hold the dashboard illumination knob with the ignition
switched OFF, then switch it ON. Keep pressing the dashboard
illumination knob for more than 7 seconds.
Dashboard illumination knob

$9@'%&"#@&EJUJPOJOEC


$9@'%&"#@&EJUJPOJOEC










6–28
Maintenance and Care
Owner Maintenance
Vehicle Engine Control Unit Reset Procedure
After replacing the engine oil, it is recommended to have a repair shop such as an
Authorized Mazda Dealer perform the initialization (engine oil data resetting) of the
recorded value. If the value recorded by the computer is not initialized, the wrench indicator
light may not turn off or it may turn on earlier than normal.
N O T E
There are two methods for resetting the engine control unit.
1. The procedure described in the following.
2. The procedure described in the maintenance monitor item when the À exible
maintenance setting is selected. Refer to Maintenance Monitor on page 6-19 .

If either one of the methods is performed, resetting of the engine control unit is completed.

N O T E
The initialization (engine oil data resetting) of the recorded value can be performed using
the following procedure:

1. Switch the ignition OFF.
2. Switch the ignition ON with the dashboard illumination knob pressed, and press and
hold the dashboard illumination knob for about 7 seconds.
 

Dashboard illumination knob



$9@'%&"#@&EJUJPOJOEC


$9@'%&"#@&EJUJPOJOEC










9–15
Speci¿ cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings
Change
Method


Three-À ash turn
signal (page
4-56 ) Operational/non-operational
On On/Off A —


Ambient
Lighting (page
5-83 ) Ambient lights brightness
*7 Medium Bright/
Medium/
Dark/
O f f
*8 A —


Rear window
defogger (page
4-61 ) The operation time for the rear window defogger
can be changed. 15
minutes 15 minutes/
Continuous
*9 — —
System
Language Language indicated in display
English Depends on
market
*10 A —

Temperature Temperature unit indicated in display
°F or °C °F/°C A —


Distance Distance unit indicated in display
mi or km mi/km A —


Fuel Economy Monitor (page 4-78 )
Ending display On/off
Off On/Off B —


Fuel economy
resetting
procedureLinkage/non-linkage with fuel economy reset
and trip meter resetOff On/Off B —
Active driving display (page 4-29 )
Turn by turn
(TBT) Display of turn by turn (TBT) can be turned off. On On/Off C —
Street name Display timing of street name can be changed. On-
Demand Off/Always/
On-Demand C —
Tachometer Setting can be changed to display the tachometer. Off On/Off C —
*1 Though these systems can be turned Off, doing so will defeat the purpose of the system and Mazda recommends
that these systems remain On.
*2 Only the volume of the warning beep during Blind Spot Monitoring (BSM) operation can be changed. The
volume of the warning beep during Rear Cross Traf¿ c Alert (RCTA) operation cannot be changed.
*3 If the auto-wiper control is set to Off, the wiper lever
position is set to intermittent operation.
*4 If the setting is changed to Off, the following operation is performed according to the headlight switch position:
y A t position: Headlights turn off immediately after the ignition is switched off.
y At any position other than : Headlights on/off conditions vary according to the headlight switch
position. Refer to Headlights on page 4-49 .
*5 When set to Off, the lights-on reminder is operable.
*6 The lights-on reminder settings can be changed at anytime, however, the lights-on reminder only operates when
the auto headlight function is set to Off. Refer to Lights-On Reminder on page 7-45 .
*7 Change the ambient light illumination level with the parking lights or headlights turned on.
*8 When set to OFF, the ambient lights remain turned off regardless of whether of not the parking lights or
headlights are on or off. However, they will turn on or off in conjunction with the illuminated entry system.
*9 The operation may stop in 15 minutes due to the effect of the outside temperature even if the operation time of
the rear window defogger has been changed to Continuous.
*10 Available only in display from the center display.

$9@'%&"#@&EJUJPOJOEC


$9@'%&"#@&EJUJPOJOEC