key MAZDA MODEL MILLENIA 2002 (in English) User Guide

3-14
Knowing Your Mazda
Doors and Locks
Form No. 8Q47-EA-01F

Operating the Driver’s Side
Power Window
To open the window, push the lower part
of the switch.
To close the window, push the upper part
of the switch.
Auto-opening
To fully open the window automatically,
push the lower part of the switch
completely.
To stop the window partway, push the
upper part of the switch and then release
it.
Engine-off power window operation
The power window can be operated about
40 seconds after the ignition switch is
turned from the ON position to the ACC,
LOCK position or key out of ignition with
all doors closed. If any front door is
opened, the power window will be
inoperable.

Operating the Passenger Power
Windows
The power windows may be operated
when the power window lock switch is in
the unlock position.
The passenger windows may be opened or
closed by the power window master
control switches on the driver’s door.
To open the window, push the lower part
of the switch.
To close the window, push the upper part
of the switch.
Left front window
OpenClose
Left rear
window
Right front
window
Right rear
window
Close
Open
J76Y.book Page 14 Wednesday, March 27, 2002 5:04 PM

3-15
Knowing Your Mazda
Doors and Locks
Form No. 8Q47-EA-01F
Engine-off power window operation
The power window can be operated about
40 seconds after the ignition switch is
turned from the ON position to the ACC,
LOCK position or key out of ignition with
all doors closed. If any front door is
opened, the power window will be
inoperable.

Power Window Lock Switch
With the lock switch in the unlocked
position, all power windows on each door
can be operated.
With the lock switch in the locked
position, only the driver’s side power
window can be operated.
Unintentional Window Operation:
Unintentional window operation is
dangerous. A person’s hands, head,
or neck could be caught by the
window and result in serious injury.
Unless a passenger needs to operate a
window, keep the power window lock
switch in the locked position.
Unlock position
Lock position
WARNING
Fuel-Filler Lid and Cap
Fuel Spray:
Fuel spray is dangerous. Fuel can
burn skin and eyes and cause illness
when ingested. Fuel spray is released
when there is pressure in the fuel
tank and the fuel cap is removed too
quickly. When removing the fuel cap,
loosen the cap slightly and wait for
any hissing to stop. Then remove it.
Fuel Vapor:
Fuel vapor is dangerous. It could be
ignited by sparks or flames causing
serious burns and injuries. Before
refueling, stop the engine, and always
keep sparks and flames away from the
filler neck.
Always use only a genuine Mazda fuel
cap or an approved equivalent,
available at Authorized Mazda
Dealers. The wrong cap can result in a
serious malfunction of the fuel and
emission control systems. It may also
cause the check engine light in the
instrument cluster to illuminate.
WARNING
CAUTION
J76Y.book Page 15 Wednesday, March 27, 2002 5:04 PM

3-20
Knowing Your Mazda
Form No. 8Q47-EA-01F
Security System
The theft-deterrent system is designed to
prevent your vehicle or its contents from
being stolen when all the doors, hood, and
trunk lid are locked.
If forcible entry is attempted, the system
sounds the horn and flashes the hazard
warning lights and headlights. It also
makes the starter inoperable.
The system won’t function unless it’s
properly armed. So when you leave the
vehicle, lock all the doors, close all the
windows, take your key, your transmitter,
and make sure the security indicator light
is flashing.

Operation
What turns it on:
•Forcing open a door, the hood or the
trunk lid.
•Unlocking the driver’s door with the
inside door-lock button or door-lock
switch.
•Opening a front or rear passenger’s
door , the hood or the trunk lid by
operating an inside door-lock button ,
the hood release handle or the trunk lid
release button.What it does:
•The horn sounds intermittently and the
hazard warning lights and headlights
flash.
•The starter is bypassed so that the
engine can’t be started.
•The alarm continues for about 3
minutes, then stops.
If the system is triggered again, the lights
and horn will activate and the starter will
not work until a door or the trunk lid is
unlocked with the key or with the
transmitter.

How to Arm the System
1. Remove the key from the ignition
switch.
2. Close the hood and the trunk lid. Then
close all doors and lock them from the
outside using the key in the door. If you
have the keyless entry system, press the
LOCK button on the transmitter.
3. The indicator light comes on for about
10 seconds. Then it flashes once every
3 seconds to indicate that the system is
fully armed. It continues to flash until
the theft-deterrent system is turned off.
Theft-Deterrent System
NOTE
The theft-deterrent system operates
without the keyless entry system
transmitter, as well.
J76Y.book Page 20 Wednesday, March 27, 2002 5:04 PM

3-21
Knowing Your Mazda
Security System
Form No. 8Q47-EA-01F

To Tu r n o f f a n A r m e d S y s t e m
An armed system can be turned off by any
one of the following methods:
•Unlock a door with the key.
•Press the UNLOCK button on the
keyless entry system transmitter.
•Insert the key into the ignition switch
and turn it to the ON position.

To Stop an Alarm
A triggered alarm can be turned off by any
one of the following methods:
•Unlock a door with the key.
•Open the trunk lid with the key.
•Press the UNLOCK button or
button on the keyless entry system
transmitter.

Theft-Deterrent Labels
Labels indicating that your vehicle is
equipped with a Theft-Deterrent System
are in the glove box.
Mazda recommends that you affix them to
the lower rear corner of the front door
windows.
NOTE
The trunk lid can be opened with the
key or the transmitter even when the
system is armed. The alarm will not
come on and the system will remain
armed.
NOTE
If you have any problem with the theft-
deterrent system, consult an
Authorized Mazda Dealer.
J76Y.book Page 21 Wednesday, March 27, 2002 5:04 PM

3-22
Knowing Your Mazda
Form No. 8Q47-EA-01F
Steering Wheel and Mirrors

Auto-Tilt Steering Wheel
To change the angle of the steering wheel,
stop the vehicle, put the ignition switch in
the ON position and push the switch to
adjust the steering column up or down.Push in the AUTO button to activate the
auto-tilt function.
When you remove the key from the
ignition, the steering wheel will move up,
away from the driver.
The steering wheel will move back to its
position before the key was removed,
when the key is returned to the ignition.
Steering Wheel
Adjusting the Steering Wheel:
Adjusting the steering wheel while the
vehicle is moving is dangerous.
Moving it can very easily cause the
driver to abruptly turn to the left or
right. This can lead to loss of control
or an accident. Never adjust the
steering wheel while the vehicle is
moving.
WARNING
Up
Down
J76Y.book Page 22 Wednesday, March 27, 2002 5:04 PM

5-2
Driving Your Mazda
Form No. 8Q47-EA-01F
Starting and Driving

Ignition Switch Positions
LOCK
The steering wheel locks to protect
against theft. Only in this position can the
key be removed.ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
ON
This is the normal running position after
the engine is started. The warning lights
(except brakes) should be inspected
before the engine is started (page 5-22).
START
The engine is started in this position. It
will crank until you release the key; then
it returns to the ON position. The brake
warning light can be checked after the
engine is started (page 5-22).

Ignition Key Reminder
If the ignition switch is in the LOCK or
ACC position, a beep will sound when the
driver’s door is opened.
Ignition Switch
Removing the Key:
It’s dangerous to remove the key from
the ignition switch while the vehicle is
moving. Removing the key allows the
steering wheel to lock. You will lose
steering control and a serious
accident could occur.
Remove the key only when the vehicle
is parked.
Not Setting the Parking Brake:
Leaving the driver’s seat without
setting the parking brake is
dangerous. Unexpected vehicle
movement could occur if the parking
brake is not set. This could cause an
accident. Before leaving the driver’s
seat, always set the parking brake and
make sure the shift lever is in P.
WARNING
NOTE
If turning the key is difficult, jiggle the
steering wheel from side to side.
J76Y.book Page 2 Wednesday, March 27, 2002 5:04 PM

5-9
Driving Your Mazda
Starting and Driving
Form No. 8Q47-EA-01F
D (Drive)
D is the normal driving position. From a
stop, the transaxle will automatically shift
through a 4-gear sequence.
S (Second)
The S position is helpful when driving in
slow-moving traffic and when climbing a
hill.
L (Low)
Use the L position when pulling heavy
loads and climbing steep grades.
Shift patterns without hold mode:

Shift-Lock System
The shift-lock system prevents shifting
out of P unless the brake pedal is
depressed.

To shift from P:
1. Depress and hold the brake pedal.
2. Start the engine.
3. Push and hold the lock-release button.
4. Move the shift lever.
Shifting from N or P:
It’s dangerous to shift from N or P
into a driving gear when the engine is
running faster than idle. If this is
done, the vehicle could move
suddenly, causing an accident or
serious injury. If the engine is
running faster than idle, don’t shift
from N or P into a driving gear.
Shifting into N while Driving:
Shifting into N while driving is
dangerous. Engine braking cannot be
applied when decelerating which
could lead to an accident or serious
injury. Do not shift into N when
driving the vehicle.
D 1st, 2nd, 3rd, 4th
S 1st, 2nd, 3rd
L 1st, 2nd
WARNING
Sudden Engine-Braking:
Shifting down while driving on wet,
snowy, or frozen roads, or driving at
high speeds causes sudden engine
braking, which is dangerous. The
sudden change in tire speed could
cause the tires to skid. This could lead
to loss of vehicle control and an
accident. Do not cause sudden engine
braking on slippery road surfaces or
at high speeds.
NOTE
•When the ignition switch is in the
ACC or LOCK position, the
transaxle cannot be shifted from P.
•If the brake is pumped with the shift
lever in P, a chattering near the shift
lever may be heard. Don’t worry,
this is a normal sound.
•To be sure the vehicle is in park, the
ignition key cannot be removed
unless the shift lever is in P.
WARNING
J76Y.book Page 9 Wednesday, March 27, 2002 5:04 PM

5-30
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q47-EA-01F

Seat Belt Warning Beep
If the driver’s seat belt is not fastened
when the ignition switch is turned to the
ON position, a beep will sound for about
6 seconds.

Ignition Key Reminder
If the ignition switch is in the LOCK or
ACC position, a beep will sound when the
driver’s door is opened.

Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when the driver’s door is opened.
Beeps
J76Y.book Page 30 Wednesday, March 27, 2002 5:04 PM

5-31
Driving Your Mazda
Form No. 8Q47-EA-01F
Switches and Controls

Headlights
To turn on the lights, turn the knob on the
end of the control lever.

Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when the driver’s door is opened.

Headlight High-Low Beam
Push the lever forward for high beams.
Pull it back for low.

Flashing the Headlights
To flash the headlights, pull the lever fully
toward you. The headlight switch need
not be on, and the lever will return to the
normal position when released.
Lighting Control
Lever
PositionOFF
Headlights Off Off On
Taillights
Parking lights
License lights
Side-marker lightsOff On On
NOTE
•If the light switch is left on, the
lights will automatically switch off
30 seconds after turning the ignition
switch to the LOCK position or
removing the key.
The lights will automatically switch
back on when the ignition switch is
turned to the ACC or ON position.
•To prevent discharging the battery,
don’t leave the lights on while the
engine is off.
High beams
Low beams
J76Y.book Page 31 Wednesday, March 27, 2002 5:04 PM

6-34
Interior Comfort
Form No. 8Q47-EA-01F
Interior Equipment
When you need a sunvisor, lower it for use
in front or swing it to the side.

Va n i t y M i r r o r s
To use the vanity mirror, lower the
sunvisor.

Illuminated Entry System
When the switch is in the DOOR position,
the overhead light comes on for:
•about 30 seconds after the driver’s door
is unlocked and the ignition key is
removed.
•about 15 seconds after all doors are
closed.
•about 15 seconds after the key is
removed from the ignition.
The light also goes out when:
•the ignition switch is turned to the ON
position and all doors are closed.
•the driver’s door is locked.
SunvisorsInterior Lights
NOTE
If any door is left opened, the light
goes out after about 5 minutes.
The light turns on again when the
ignition switch is turned to the ON
position, or when any door is opened
after all doors have been closed.
J76Y.book Page 34 Wednesday, March 27, 2002 5:04 PM