belt MAZDA MODEL MPV 2003 (in English) User Guide

2-16
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G
7. The seat is heavier than it looks,
carefully pull up and detach the seat.
Get assistance to lift it out of the
vehicle.
To install the seat
1. First identify which seat fits which
position by verifying that the seat belt
buckles point to the center (inboard) of
the vehicle.
2. Align the clamps on the front underside
of the seat with the forward loop
anchors on the floor and support the
seat so that it doesn’t fall (the rear
portion of the seat cannot be mounted
first). The clamps on the front of the
seat automatically lock into the floor
loop anchors after lowering the seat.3. Supporting the seat with your hands,
slowly lower the seat rearwards to lock
it in place.
4. Raise the reclining lever and lift the
seatback upright. Attempt to move the
seatback forward and backward to
make sure it is locked.
5. Buckle the seat belts once just to
confirm the seat belt buckles are
inboard which means each seat is on
the correct side of the vehicle.
Loops Clamp
Loops
Clamp
Unsecured Seat:
Driving with the seat unsecured is
dangerous. The seat may become
detached while the vehicle is moving
causing serious injury. After
installing the seat, push it forward
and backward to make sure it is
securely locked.
Do not move the side seat-slide lever
with the seat removed. The lever could
be damaged resulting in loss of
functionality.
WARNING
CAUTION
J16L_8R21-EA-02G.book Page 16 Saturday, June 8, 2002 11:16 AM

2-17
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G

Seat Recline
To change seatback angle, lean forward
slightly while pulling the flat-folding
strap. Then lean back to the desired
position and release the strap. Make sure
the seat is securely latched.
Third-Row Seat
Stacking Cargo:
Stacking luggage or other cargo
higher than the seatback is
dangerous. During a sudden stop or
collision, objects can become
projectiles that could hit and injure
passengers. Don’t stack things higher
than the seatback.
Securing Seats:
Adjustable seats and seatbacks that
are not securely latched are
dangerous. In a sudden stop or
collision, the seat or seatback could
move, causing injury. Make sure the
adjustable components of the seat are
locked in place by attempting to rock
the seatback.
Unlocked Seatback:
A seatback plays an important role in
your protection in a vehicle. Leaving
the seatback unlocked is dangerous as
it can allow passengers to be ejected
or thrown around and baggage to
strike occupants in a sudden stop or
collision, resulting in severe injury.
After adjusting the seatback at any
time, even when there are no other
passengers, rock the seatback to make
sure it is locked in place.
WARNING
NOTE
When returning a third-row seat to its
original position, also replace the seat
belt to its normal position. Verify that
the seat belt pulls and retracts.
Reclining:
Sitting in a reclined position while the
vehicle is moving is dangerous
because you don’t get the full
protection from seat belts. During
sudden braking or a collision, you
can slide under the lap belt and suffer
serious internal injuries. For
maximum protection, sit well back
and upright.
WARNING
Flat-folding strap
J16L_8R21-EA-02G.book Page 17 Saturday, June 8, 2002 11:16 AM

2-18
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G

Head Restraint
Height adjustment
To raise a head restraint, pull it up to the
desired position.
To lower the head restraint, press the stop-
catch release, then push the head restraint
down.
Adjust the head restraint so that the top is
parallel with the top of the passenger’s
ears, never the passenger’s neck.Removal
To remove the head restraint, press the
stop-catch release, then pull up on the
head restraint.

Folding the Third-Row Seat
1. Remove the head restraints from the
third-row seat (page 2-18).
Head Restraints Adjustment:
Driving with the head restraints
adjusted too low or removed is
dangerous. With no support behind
your head, your neck could be
seriously injured in a collision.
Always drive with the head restraints
inserted when seats are being used
and make sure they are properly
adjusted.
WARNING
Stop-catch release
Riding on Folded Flat Third-Row
Seat:
Riding on the third-row seat when it’s
folded is dangerous. During sudden
braking or a collision, passenger’s
could be thrown around inside the
vehicle and seriously injured. Always
ride with the third-row seat in the
forward-facing, upright position and
seat belt securely fastened.
Stop-catch release
WARNING
J16L_8R21-EA-02G.book Page 18 Saturday, June 8, 2002 11:16 AM

2-19
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G
2. Pull the third-row seat’s flat-folding
strap and push the seatback down until
it locks.

Stowing the Third-Row Seat
More storage space can be created by
folding away the third-row seat into the
rear seat well. With the second-row seats
removed and the third-row seat stowed,
even more space is available.
Flat-folding strap
Riding in the Seat Well:
Riding in the seat well for the third-
row seat is dangerous. Sudden
braking or a collision could cause
serious injury. Do not sit on lie in the
seat well while the vehicle is moving.
Never ride in a vehicle where you
can’t sit in the seat and wear the seat
belt.
Pinching Fingers or Hands:
Placing your hands around the seat
stowage well when stowing the third-
row seat is dangerous. You could
pinch your hands or fingers between
the seat and the well. Hold the handle
when lowering the seat into place.
Never place your hands between the
seat and the seat well.
Unlocked Seatback:
An unlocked seatback is dangerous.
While stowing the seat, the seatback
could suddenly move causing serious
injury. Push the seatback forward and
backward to make sure it is locked in
place.
NOTE
Remove any items from the seat well
for the third-row seat before stowing
the seat. Anything in the baggage area
when the seat is set into the well can
damage the seatback material and
prevent a flat cargo area.
WARNING
J16L_8R21-EA-02G.book Page 19 Saturday, June 8, 2002 11:16 AM

2-20
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G
Stowing the third-row seat
1. Insert the seat belts in the retainers.
2. Remove the head restraint and set them
aside temporarily (page 2-18).
3. Pull strap A and ease the seatback
toward the front of the vehicle with
your other hand and be sure it locks
with a click.4. Pull strap B and lift the combined
seatback and seat bottom up to vertical
with your other hand. Gently set the
seat the remainder of the way down
into the seat well.
5. Insert the head restraints between the
floor and seat at the positions indicated
on the labels.
Retainer
Strap A
Strap B
Labels
J16L_8R21-EA-02G.book Page 20 Saturday, June 8, 2002 11:16 AM

2-21
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G
Raising the third-row seat upright for
road use
1. Clear the entire cargo floor.
2. Remove the head restraints.
3. Carefully reverse the procedures used
to lower the seat into the seat well. Use
the handle and ease the combined
seatback and seat bottom up to vertical.
4. Carefully lower the seat forward and
make sure it’s latched to the floor.5. Pull strap A and raise the seatback
upright. Attempt to move the seatback
forward and backward to make sure it
is locked.
6. Insert the head restraints.
7. Place the seat belt buckles face up.
Handle
Strap A
J16L_8R21-EA-02G.book Page 21 Saturday, June 8, 2002 11:16 AM

2-24
Essential Safety Equipment
Seats
Form No. 8R21-EA-02G
4. Place the seat belt buckles face up.
The second-row and front seats can be
folded down for use as beds when the
vehicle is safely parked.

To Fold the Seats Flat
1. Pull the seat slide levers and slide the
second-row seats all the way back
(page 2-10).
2. Raise the recline levers and fold down
the second-row seatbacks rearward
until they lock (page 2-11).
3. Remove the head restraints from the
front seats (page 2-7).
4. Pull the seat slide levers and slide the
front seats all the way forward
(page 2-3).
Flat Folding
Folded-Flat Seats:
Sitting or lying on seats folded flat is
a dangerous way to ride. During
sudden braking or a collision you
could be thrown around inside the
vehicle and seriously injured. Don’t
ride on seatbacks folded flat.
WARNING
J16L_8R21-EA-02G.book Page 24 Saturday, June 8, 2002 11:16 AM

2-26
Essential Safety Equipment
Form No. 8R21-EA-02G
Seat Belt Systems
Seat belts help to decrease the possibility of severe injury during accidents and sudden
stops. Mazda recommends that the driver and all passengers always wear seat belts.
All of the outboard seat belt retractors are designed to keep the lap/shoulder belts out of the
way when not in use.
The driver’s seat belt has no provisions for child-restraint systems and has only an
emergency locking mode. The driver may wear it comfortably, and it will lock during a
collision.
However, the front passenger’s seat and rear outboard lap/shoulder belt retractors operate in
two modes: emergency locking mode, and for child-restraint systems, automatic locking mode.
The third-row center seat positions have a lap belt with manual adjustment.
Seat Belt Precautions
Not Wearing Seat Belts:
Not wearing a seat belt is extremely dangerous. During a collision, occupants not
wearing seat belts could hit someone or things inside the vehicle or even be thrown
out of the vehicle. They could be seriously injured or even killed. In the same
collision, occupants wearing seat belts would be much safer. Always wear your seat
belt and make sure all occupants are properly restrained.
Seat Belt Damaged During an Accident:
Using a damaged seat belt is dangerous. An accident could damage the belt webbing
of the seat belt in use. A damaged seat belt cannot provide adequate protection in a
collision. Have an Authorized Mazda Dealer inspect all seat belt systems in use during
an accident before they are used again.
Twisted Seat Belts:
Twisted seat belts are dangerous. In a collision, the full width of the belt isn’t available
to absorb the impact. This puts more force on the bones beneath the belt, which could
break them or cause other serious injury or death. Don’t wear twisted seat belts.
One Belt, One Passenger:
Using one seat belt for more than one person at a time is dangerous. A seat belt used
in this way can’t spread the impact forces properly and the two passengers could be
crushed together and seriously injured or even killed. Never use one belt for more
than one person at a time.
WARNING
J16L_8R21-EA-02G.book Page 26 Saturday, June 8, 2002 11:16 AM

2-27
Essential Safety Equipment
Seat Belt Systems
Form No. 8R21-EA-02G

Pregnant Women and Persons with Serious Medical Conditions
Pregnant women should wear seat belts. Ask your doctor for specific recommendations.
The lap belt should be worn SNUGLY AND AS LOW AS POSSIBLE OVER THE HIPS.
The shoulder belt should be worn across your shoulder properly, but never across the
stomach area.
Persons with serious medical conditions also should wear seat belts. Check with your
doctor for any special instructions regarding specific medical conditions.

Emergency Locking Mode
If the belt has fully retracted, it will always be in the emergency locking mode until you
move it into automatic locking mode by pulling the belt all the way out to its full length. In
the emergency locking mode, the belt remains comfortable on the occupant and the
retractor will lock in position during a collision.
If the belt feels tight and hinders comfortable movement while the vehicle is stopped or in
motion, you may be in the automatic locking mode because you have pulled the belt too far
out. To return to the more comfortable emergency locking mode, wait until you can stop
the vehicle in a safe area, retract the belt fully to convert it back to emergency locking
mode and then again extend it around you.Belt retraction may become difficult if the belts and rings are soiled, so try to keep them
clean.
CAUTION
Ring
J16L_8R21-EA-02G.book Page 27 Saturday, June 8, 2002 11:16 AM

2-28
Essential Safety Equipment
Seat Belt Systems
Form No. 8R21-EA-02G

Automatic Locking Mode
Always use the automatic locking mode to keep the child-restraint system from shifting to
an unsafe position in the event of an accident. To get the seat belt into the automatic
locking mode, pull it all the way out and connect it as instructed on the child-restraint
system. It will retract down to the child-restraint system and stay locked on it. See the
section on child restraint (page 2-37).
J16L_8R21-EA-02G.book Page 28 Saturday, June 8, 2002 11:16 AM