oil temperature MAZDA MODEL MPV 2006 Owners Manual (in English)

Black plate (272,1)
The quality designation SL, or ILSAC
must be on the label.
5W-20
120 100 80
60 40
20
0 –20
50 40 30
20 10
0 –10
–20 –30
qInspecting Engine Oil Level
1. Be sure the vehicle is on a level
surface.
2. Warm up the engine to normal
operating temperature.
3. Turn it off and wait at least 5 minutes
for the oil to return to the oil pan.
4. Pull out the dipstick, wipe it clean, and
reinsert it fully.
Full
LowOK
5. Pull it out again and examine the level.
It's OK between MIN and MAX.
But if it's near or below MIN, add
enough oil to bring the level to MAX.
CAUTION
Don't add engine oil over MAX. This
may cause engine damage.
6. Make sure the O-ring on the dipstick is
positioned properly before reinserting
the dipstick.
qChanging Engine Oil and Filter
Change engine oil and filter according to
Scheduled Maintenance (page 8-3).
Please act responsibly―protect the
environment and take used oil to a
recycling facility. Ask your dealer or a
service station for information.
WARNING
Handling Used Engine Oil:
Continuous contact with used engine
oil is dangerous. It could cause skin
cancer. Always wash with soap and
water immediately after changing oil
and filter.
CAUTION
Remove any oil splatter from the
exhaust manifold, the exhaust pipe and
the shield. Oil left on these areas will
smoke when the engine is running.
8-12
Maintenance and Care
Owner Maintenance
Mazda MPV_8U61-EA-05G_Edition1 Page272
Tuesday, June 21 2005 9:38 AM
Form No.8U61-EA-05G

Black plate (278,1)
Power Steering Fluid
qInspecting Power Steering Fluid
Level
CAUTION
To avoid damage to the power steering
pump, don't operate the vehicle for long
periods when the power steering fluid
level is low.
NOTE
Use specified power steering fluid
(page 10-4).
Inspect the fluid level in the reservoir at
each engine oil change with the engine off
and cold. Add fluid if necessary; it does
not require periodic changing.
The level must be kept between MIN and
MAX.
Visually examine the lines and hoses for
leaks and damage.
If new fluid is required frequently, consult
an Authorized Mazda Dealer.
Automatic Transaxle Fluid
(ATF)
qInspecting Automatic Transaxle
Fluid Level
The automatic transaxle fluid level should
be inspected regularly. Measure it as
described below.
The volume of fluid changes with the
temperature. Fluid must be checked at idle
without driving at normal operating
temperature.
CAUTION
lLow fluid level causes transaxle
slippage. Overfilling can cause
foaming, loss of fluid, and transaxle
malfunction.
lUse specified fluid (page 10-4). A
nonspecified fluid could result in
transaxle malfunction and failure.
1. Park on a level surface and set the
parking brake firmly.
2. Start the engine and depress the brake
pedal.
3. Move the shift lever through all ranges
and set it at P.
8-18
Maintenance and Care
Owner Maintenance
Mazda MPV_8U61-EA-05G_Edition1 Page278
Tuesday, June 21 2005 9:38 AM
Form No.8U61-EA-05G

Black plate (361,1)
D
Daytime Running Lights ................... 5-34
Defroster
Rear window .............................. 5-37
Dimensions ....................................... 10-5
Door Locks ......................................... 3-8
Driving In Flooded Area ................... 4-11
Driving Tips ........................................ 4-7
Automatic transaxle ................... 5-12
Break-in period ............................ 4-7
Driving in flooded area .............. 4-11
Hazardous driving ........................ 4-8
Money-saving suggestions ........... 4-7
Rocking the vehicle ...................... 4-9
Winter driving .............................. 4-9
E
Easy Closure ..................................... 3-12
Emergency Starting ........................... 7-18
Flooded engine ........................... 7-18
Jump-starting .............................. 7-19
Push-starting .............................. 7-22
Emergency Towing ........................... 7-23
Emission Control System .................... 4-3
Engine
Coolant ....................................... 8-14
Exhaust gas .................................. 4-5
Hood release .............................. 3-24
Oil .............................................. 8-11
Overheating ................................ 7-16
Starting ......................................... 5-3
Engine Compartment Overview ........ 8-10
Engine Coolant
Overheating ................................ 7-16
Engine Coolant Temperature
Gauge ................................................ 5-22
Exhaust Gas ........................................ 4-5
Exterior Care ..................................... 8-46
E
Eyeglass Holder ................................ 6-54
F
Flasher
Hazard warning .......................... 5-38
Headlights .................................. 5-33
Flat Tire ............................................... 7-3
Changing ...................................... 7-9
Spare tire and tool storage ............ 7-3
Fluids
Classification .............................. 10-4
Owner maintenance ..................... 8-8
Fog Lights ......................................... 5-35
Foot Brake .......................................... 5-4
Front Console ................................... 6-54
Front Seats
(Electrically Operated Seats) ............... 2-8
Front Seats
(Manually Operated Seats) ................. 2-3
Fuel
Filler lid and cap ........................ 3-23
Gauge ......................................... 5-23
Requirements ............................... 4-2
Tank capacity ............................. 10-4
Fuses ................................................. 8-39
Panel description ........................ 8-41
Replacement ............................... 8-39
G
Glove Box ......................................... 6-54
H
Hazard Warning Flasher .................... 5-38
Hazardous Driving .............................. 4-8
Index
11-3
Mazda MPV_8U61-EA-05G_Edition1 Page361
Tuesday, June 21 2005 9:38 AM
Form No.8U61-EA-05G