belt MAZDA MODEL MPV 2006 Quick Tips (in English)

INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
WARNING LIGHTS
9. Charging system
warning light
Dealer inspection required
10. Low engine oil
pressure warning light
Stop vehicle and turn off
engine; check oil level
11. Cruise main
indicator
System ON/OFF
See Getting Started
12. Cruise control,see Getting Started
13. TCS Traction Control
System*
Light flashes when in use;
dealer inspection required
if light remains on
CRUISE
MAIN
14. Traction Control
System* off
System turned off manually
or malfunctioning; dealer
inspection required
15. Air bag readiness
Front or side air bag malfunction,
warning light constantly
flashes, stays on or never
illuminates with ignition on,
dealer inspection required
16. Turn signals/hazard
warning on
17. High beams on
18. Door ajar19. Check enginePossible faulty emission control,
dealer inspection required, or
fuel filler cap not tight
20. Brake system
Parking brake on/low
fluid level
21. Anti-lock Brake System
(ABS)
ABS malfunction, normal brakes
only, dealer inspection required
22. Overdrive off indicator,
see Transaxle
Lights when the overdrive
button is in the off position
23. Always fasten
safety belts
Instrument
Cluster
Instrument
Cluster
x1000r/min
5-SPEED AT
0 1234
5
6
7
8
H
CF
E
1092312117228
16164121718
15
1413
0 10 2030405060
70
80
90
100
110
120
200
0 20 406080100
120
140
160
180mph
km/h
3
TRIP
ODOA88888.8BPRND32
65
19
20
21
*Denotes optional equipment
GAUGES
1. Engine coolant
temperature gauge
If above normal range, stop
vehicle and turn off engine;
check coolant level when safe2. Fuel gauge
19.8-gallon/75-liter tank
3. Speedometer
4. Tachometer
5. Gear indicator
6. Odometer/trip meter7. Odometer/trip meter
select button
Press to select amongtrip A,
trip B and odometer
Press and hold to reset
selected trip odometer
8. Low fuel level

82
3
1
5
4
SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Seats
Manual seat controls1. Fore-aft adjustment
Lift lever, slide seat
2. Head restraint
To raise/lower: Pull up/push
stop-catch (8) and push down
3. Seatback angle
To adjust: Lift and hold lever, lean
forward or backward, release lever
4. Seat tilt (Driver’s only)
Rotate front/rear dial to change
angle of seat front/rear
5. Lumbar adjustment
(Driver’s only)
Power driver’s seat controls6. Fore/aft adjustment
Slide switch horizontally
Raise/lower seat cushion
Pull/push center vertically
Raise/lower front of seat
Pull/push front vertically
Raise/lower rear of seat
Pull/push rear vertically
7. Seatback angle
Press front/rear of switch
WARNINGS: Do not adjust
seats while driving
Safety belts must always be
worn when vehicle is in motion
All air bags are supplemental and
do not replace safety belt usage
Always wear your safety belt
and properly secure children
12 and under in a rear seat
Use age appropriate child
restraints and safety seats, see
Owner’s Manual and state or
province laws
Never place rear-facing infant-
safety seat in front of any air
bag, an infant is in serious
danger of being injured or killed
If you must install a
forward-facing child-safety
seat in the front seating
position, move vehicle seat
as far back as possible
Front passenger seat
side table
Pull up to locked position; push
down to verify table is secure
Expand table rearward
by pulling out the rear
Lowering side
table: Pull lever
(2) under table
frontal section
and fold down
completely
WARNING: Do not use front
passenger seat side table
while vehicle is in motion
Shoulder belt
height
adjustment
To raise/lower
belt: Push button
(1) and move belt
to desired position
WARNINGS: Make sure adjuster
locks in one of its positions
Removing and reinstalling
front seats is dangerous and
may compromise the air
bag system, an authorized
Mazda Dealer should perform
this task
1
2
82
5
67

SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Child-safety
Seats
Child-safety seat
To install in 2nd row outboard
seats: Use dual locking mode
retractor seat belts; see Owner’s
Manual for proper installation
and child seat tether and LATCH
system instructionsWARNING: Read all
informationand warnings
in Owner’sManual and
attached to seat before
using child-safety seat
Safety belt emergency
locking mode
Belts lockonly on hard acceleration,
braking, cornering or impacts of
about 5 mph or moreAutomatic locking mode
(front passenger and all
rear safety belts only)
Must be used when installing
child-safety seat
To activate: Pull belt fully out of
retractor, allow belt to retract until
click is heard; belt will only tighten
To disengage: Unbuckle belt and
allow belt to retract fullyWARNING: Make sure all seats
are properly latched, because
during a sudden stop or
collision the seat or seatback
could move, causing injury
Third-row seatInsert seat belts in retainers;
remove head restraints; pull strap
(1), push seatback toward front of
vehicle until it locks with a click
Pull strap (2); release the lock of
front seat legs
Pull strap (3); lift seatback and
seat bottom up to vertical; gently
lower the seat into seat well123

DRIVING TIPS
Always check the Owner’s Manual for more operating information and safety features
Driving
Tips
Break-in period
First 600 miles: Avoid heavy
braking and acceleration; drive at
varying road and engine speeds
Anti-lock Brake System (ABS)
When brake pedal is pressed, ABS
automatically reduces hydraulic
pressure to any wheel on the
verge of locking up
You may feel a slight pulsing of the
brake pedal and hear a clicking noise;
this tells you the ABS is functioning
properly; increase pressure on pedal
for maximum braking
Tips: Maintain constant
pressure on the brake pedal
Do not pump the brakes
Unique driving conditions†
Every 5,000 miles change oil/
filter, inspect coolant level,
lights, brake/clutch fluid, tire
pressure/wear, power steering
fluid, locks/hinges, washer fluid
and rotate tires
Maintenance notes:
Rotate tires every 7,500 miles
or sooner if needed
Replace cabin air filter once
every 2 years or 25,000 miles
†
Replace spark plugs every
100,000 miles (or 60,000 miles
if following the Unique driving
conditions
†)
Replace (FL22)* engine coolant
every 120,000 miles or 10 yearsTraction Control System*
Automatically controls engine
torque to prevent excessive
wheel spin at all speeds,
especially when accelerating
on slippery surfaces
Tire economy and tips
Check pressure at least monthly
when tires are cold
Maintain correct front-end
alignment and tire balance; rotate
tires at 7,500-mile intervals; see
Owner’s Manual for rotation chart
Tire pressure
Decal on the edge of the
driver’s door provides tire
pressure information
A.Change: Engine oil/
replace filter
Lubricate: All locks and hinges
B.Inspect: Disc brakes
C.Inspect: Drive belts, fuel lines
and hoses, cooling system,
brake lines, hoses and
connections, steering
operation and linkages,
front suspension ball joints,
driveshaft dust boots
D.Replace: Air filter
E.Inspect: Exhaust system and
heat shields
F.Inspect: PCV valve
Change: Engine coolant
(Other than FL22) Tire chains
†Tire chains can damage aluminum
wheels; use on steel wheels only
Tips: Use only SAE class “S”
chains, install only on front
tires; install as tightly as
possible and retighten
after driving 1/4 -1/2 mile;
chains may affect handling
Never exceed 30 mph with
tire chains
*Denotes optional equipment†See Owner’s Manual
NORMAL SERVICE INTERVALS
7,500 miles
15,000 miles
22,500 miles
30,000 miles
37,500 miles
45,000 miles
52,500 miles
60,000 miles
67,500 miles
75,000 miles
82,500 miles
90,000 miles
A BC E A A B
D A A
B C F A
A B
E A D
A
BC A

A B
A