door lock MAZDA MODEL MX-5 MIATA 2006 Service Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2006, Model line: MODEL MX-5 MIATA, Model: MAZDA MODEL MX-5 MIATA 2006Pages: 378, PDF Size: 4.01 MB
Page 103 of 378

Black plate (103,1)
Detachable Hardtop (Canada)í
Top latch assemblySide latch assembly
Rear deck latch
Rear deck stud
Rear window defroster coupler
Knowing Your Mazda
Doors and Locks
3-45íSome models.
MX-5_8U35-EA-05F_Edition4 Page103
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 104 of 378

Black plate (104,1)
qDetachable Hardtop Precautions
WARNING
Standing in a Moving Vehicle:
Standing in the vehicle, or sitting on
the convertible top storage area or
center console when the vehicle is
moving is a dangerous way to ride.
During a sudden maneuver or
collision you could be seriously
injured or even killed.
Sit in the seat with the seat belt on
when the vehicle is moving.
Hardtop and Rollover Accidents:
Rollover accidents on a hardtop
vehicle are dangerous. The hardtop is
not as strong as a regular steel roof.
Rollover accidents could dislodge or
crush the hardtop and cause serious
injuries or even death, just as with no
top or the convertible top.
Always drive safely and observe the
speed limit.
Fastening Mechanisms:
It is dangerous to place your hands or
fingers near the fastening
mechanisms. Your hands or fingers
could be caught and injured by the
mechanism. Always keep your hands
and fingers away from the fastening
mechanisms when moving the
hardtop.
lWhen removing or installing the
hardtop, make sure the operation is
performed by 2 persons.
lBefore removing or installing the
hardtop, be sure you are parked out of
traffic in a flat area near the location
your hardtop is to be stored.
lWhen removing the hardtop, make sure
objects inside the vehicle aren't blown
away by the wind.
lSecure all loose objects inside before
driving with the hardtop removed.
lDon't drive through an automatic car
wash; it may damage the hardtop.
lDon't remove or install the hardtop
when the wind is strong; the wind
could damage the hardtop.
lBefore removing the hardtop, lower the
antenna.
lRemoving the hardtop while it's wet
can cause water to drip into the
passenger compartment.
qRemoving the Detachable Hardtop
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Remove the antenna if it is installed. Refer to Antenna on page 6-10.
3-46
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page104
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 105 of 378

Black plate (105,1)
4. Push the unlock button and fullyrelease the top latch.
Unlock button
Top latch
5. Remove the seat belts from the belt guides.
Belt guide
6. Slide the seats forward.Refer to Seat Slide on page 2-2.
7. Fold the seatbacks forward. Refer to Seat Recline on page 2-3. 8. Pull the levers and fully release the side
latches.
Side latch
Lever
9. After the side latches are fully released,
release the lever.
10. Lift the side latches while pulling the lever. Make sure the hooks are fully
released.
Side
latch
Lever Hook
Knowing Your Mazda
Doors and Locks
3-47
MX-5_8U35-EA-05F_Edition4 Page105
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 106 of 378

Black plate (106,1)
11. Disconnect the cord.
12. Slide the hardtop rearward whilepressing down on the rear deck
latches to unlock the latches.
Hardtop
Rear deck latch
13. Lift the hardtop straight off the bodyto prevent damage to the rear deck
latches and studs.
Hardtop
Rear deck stud
14. Set the belt guides and the seats backto their original positions.
15. Disconnect the hardtop rear window defroster coupler (A) from the coupler
(B), and remove the convertible top
rear window defroster coupler (C)
from its holder (D).
(A)
(B)
(C)
(D)
16. Connect the convertible top's rear
window defroster coupler (C) to the
coupler (B).
(C)
(B)
3-48
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page106
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 107 of 378

Black plate (107,1)
WARNING
Windshield's Edges:
Not being careful of the windshield's
edges when getting into or out of the
vehicle is dangerous. The windshield's
edges could scratch and cause
injuries.
Be careful of the windshield's edges
when getting into or out of the vehicle.
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lUse extreme care when carrying the
hardtop to prevent scratching or
other damage to it.
NOTE
Points to remember when storing the
detachable hardtop.
lDo not place the hardtop on a hard
surface, such as concrete or asphalt.
Place it on a cushioning material,
such as an old blanket.
lBe sure the top and side latches are
locked.
lDo not lean the hardtop against a
wall or stand it in an unstable way.
lStore the hardtop in a dry clean area,
and cover it with a soft material,
such as an old blanket.
qInstalling the Detachable Hardtop
CAUTION
Do not attempt to install the hardtop
with the convertible top also up.
Lower the convertible top before
installing the hardtop, otherwise
damage will occur to the convertible
top.
NOTE
lBe sure to place the convertible top
latches in the locked position.
lMake sure the convertible top is
completely lowered before installing
the hardtop. Also confirm that the
rear window defroster coupler is
disconnected.
1. Park the vehicle on a level surface and firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Remove the antenna if it is installed. Refer to Antenna on page 6-10.
4. Remove the seat belts from the belt guides.
Belt guide
Knowing Your Mazda
Doors and Locks
3-49
MX-5_8U35-EA-05F_Edition4 Page107
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 108 of 378

Black plate (108,1)
5. Slide the seats forward.Refer to Seat Slide on page 2-2.
6. Fold the seatbacks forward. Refer to Seat Recline on page 2-3.
7. Connect the rear window defroster coupler.
NOTE
Connect the convertible top's rear
window defroster coupler into the
holder so that it does not rattle.
8. Make sure the top latch and the sidelatches on the hardtop are unlocked.
Top latch
assembly
Side latch
assembly
9. Align the rear deck latches with therear deck studs and set the hardtop
squarely onto the body.
Hardtop
Rear deck stud
3-50
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page108
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 109 of 378

Black plate (109,1)
10. Slide the hardtop forward whilepressing down on the rear deck
latches to lock the latches, and then
verify that they are secure by
attempting to lift the rear of the
hardtop.
Hardtop
Rear deck latch
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lThe rear defogger grid and the
defogger cord could be damaged
when removing or installing the
hardtop. Make sure the rear defogger
grid isn't folded and the defogger
cord isn't caught between the
vehicle's body and the hardtop. 11. Make sure the striker for the top latch
is securely engaged with the anchor
before pushing up the top latch lever.
Push the lever of the top latch up with
the palm of your hand until the top
latch is locked.
Striker
Anchor
12. Pull the levers and fully release theside latches.
Side latch
Lever
Knowing Your Mazda
Doors and Locks
3-51
MX-5_8U35-EA-05F_Edition4 Page109
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 110 of 378

Black plate (110,1)
13. Make sure the hooks are engaged.Lift the side latches with the palm of
your hand until the latches are locked.
Side
latch
Hook
CAUTION
After installation, verify that all latches
are secure. Operating the vehicle with
unlocked latches may cause hardtop
damage or loss.
14. Set the belt guides and the seats back to their original positions.
15. Connect the cord.
NOTE
If the hardtop rattles even when all
latches are secure, drive slowly and
contact an Authorized Mazda Dealer for
inspection.
q Detachable Hardtop Appearance
Care
Refer to Detachable Hardtop Maintenance
(page 8-53) for information on detachable
hardtop appearance care.
3-52
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page110
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 117 of 378

Black plate (117,1)
Theft-Deterrent Systemí
The theft-deterrent system is designed to
prevent your vehicle or its contents from
being stolen when both doors, hood, and
trunk lid are locked.
If forcible entry is attempted, the system
sounds the horn and flashes the hazard
warning lights.
NOTE
lThe theft-deterrent system operates
with the key or the keyless entry
system transmitter.
l(With advanced key)
The theft-deterrent system can also
be operated using a request switch or
the start knob.
The system operates only when the
driver is in the vehicle or within
operational range while the advanced
key is being carried.
lThe system will not function unless
it is properly armed. To properly
secure the vehicle, always make sure
both windows are completely closed
and both doors and the trunk lid are
locked before leaving the vehicle.
Remember to take your key and
transmitter.
qOperation
System triggering conditions
The horn sounds intermittently and the
hazard warning lights flash for about 25
seconds when the system is triggered by
any one of the following:
lForcing open a door, the hood or the
trunk lid.
lOpening a door by operating an inside
door-lock knob.
lOpening the hood by operating the
hood release handle.
lOpening the trunk lid by operating the
trunk lid release button.
If the system is triggered again, the lights
and horn will activate until a door is
unlocked or the trunk lid is opened with
the key or with the transmitter.
(With advanced key)
The lights and horn can also be
deactivated by pressing a request switch.
q How to Arm the System
1. Remove the key from the ignition
switch.
(With advanced key)
Turn the start knob to the LOCK
position.
2. Make sure the hood and the trunk lid are closed. Close and lock both doors
from the outside using the key. If you
have the keyless entry system, press
the lock button on the transmitter.
(With advanced key)
Press a request switch on the doors or
the lock button on the transmitter.
The hazard warning lights will flash
once to indicate that the system is
armed.
(Without advanced key)
The following method will also arm the
theft-deterrent system:
Close the hood and the trunk lid . Press
the area on the door-lock switch
marked “LOCK ”once. Close both
doors.
Knowing Your Mazda
Security System
3-59íSome models.
MX-5_8U35-EA-05F_Edition4 Page117
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F
Page 118 of 378

Black plate (118,1)
NOTE
Locking the doors with the inside door-
lock knob will not arm the system.
qTo Turn off an Armed System
An armed system can be turned off by any
one of the following methods:
lUnlock a door with the key.
lPress the unlock button on the keyless
entry system transmitter.
lInsert the key into the ignition switch
and turn it to the ON position.
l(With advanced key)
lPress a request switch on the doors
or the unlock button on the
transmitter.
lTurn the start knob to the ON
position.
The hazard warning lights will flash twice
to indicate that the system is turned off.
NOTE
The trunk lid can be opened with the
key or the transmitter even when the
system is armed. The alarm will not
come on and the system will remain
armed.
q To Stop an Alarm
A triggered alarm can be turned off by
any one of the following methods:
lUnlock a door with the key.
lOpen the trunk lid with the key.
lPress the unlock button or press and
hold the trunk button on the keyless
entry system transmitter.
l(With advanced key)
lPress a request switch on the doors.lPress the unlock button or press and
hold the trunk button on the
transmitter.
NOTE
If you have any problem with the theft-
deterrent system, consult an Authorized
Mazda Dealer.
qTheft-Deterrent Labels
A label indicating that your vehicle is
equipped with a Theft-Deterrent System is
in the glove box.
Mazda recommends that you affix it to the
lower rear corner of a front door window.
3-60
Knowing Your Mazda
Security System
MX-5_8U35-EA-05F_Edition4 Page118
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F