MAZDA MODEL MX-5 MIATA 2012 Owners Manual

Black plate (121,1)
NOTElThe gear units on both sides have to be
unlocked to release the deck before it is
raised manually. Because the deck is heavy,
two adults are required to raise it.
lThe following describes the procedure for
the gear unit on one side. Perform the
procedure on both sides.
2. Insert the Allen wrench into the Allensocket in the bolt head that is pointed
forward of the gear unit located under
the deck lid as shown in the figure.
Deck
Bolt
Gear unit
Allen wrench
NOTE
The gear units are located underneath the
deck.
Bolt
3. Use the eyebolt to get enough torque on the short leg of the Allen wrench
and turn the Allen wrench 4 times
counterclockwise.
Allen wrench
Eyebolt
4. Disconnect the eyebolt from the Allen wrench leaving the Allen wrench in
place, and insert the threaded end of
the eyebolt in the hole directly above
the Allen socket and tighten it
clockwise two full turns.
Eyebolt
Bolt
Thread hole
NOTE
Tighten the eyebolt with the Allen wrench
inserted. The Allen wrench can serve as a
reference for inserting the eyebolt more easily.
5. Remove the bolt, which is loosened
using the Allen wrench, by turning it
counterclockwise.
Knowing Your Mazda
Doors and Locks
3-57
MX-5_8CC1-EA-11F_Edition2 Page121
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (122,1)
NOTElAfter the bolt is clear of the hole, keep the
Allen wrench level while pulling it out with
the bolt attached so as to prevent the bolt
from hitting the vehicle and dropping.
lBring the removed bolt to an Authorized
Mazda Dealer. If you drop the bolt in the
vehicle by mistake, contact an Authorized
Mazda Dealer.
6. Tighten the eyebolt by turning itclockwise 5 more times.
Eyebolt
7. Unscrew the eyebolt now by turning itcounterclockwise.
8. Insert the threaded end of the eyebolt through the guide.
Guide
Eyebolt
9. Press the eyebolt against the sector
gear.
Sector gear
Eyebolt
Guide
10. Press and rotate the sector gear rearward to release the lock.
Sector gear
Eyebolt
Guide
CAUTION
When releasing the sector gear lock
using the eyebolt, make sure the
eyebolt remains centered as you push
it against the sector gear lock. If the
eyebolt slips it could cause your hand
to veer and hit the vehicle resulting in
minor scrapes or bruises.
11. Pull out the eyebolt from the guide when the lock is released.
12. Do the same procedure on the other side.
3-58
Knowing Your Mazda
Doors and Locks
MX-5_8CC1-EA-11F_Edition2 Page122
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (123,1)
13. Lift up the deck using two adults, oneon each side of the vehicle, and open
the deck completely.
CAUTION
ØLift the deck using two adults.
Doing it alone could result in
injury or the deck lid mechanism
being twisted which could damage
it.
Ø Do not let go of the deck lid on
both sides until it is fully open. The
deck lid could fall if it is released
too soon and cause injury.
Ø Do not attempt to forcefully lift the
deck. If the lock has not detached
and the deck is forcefully lifted, it
could damage the deck. Closing the hardtop
CAUTION
Ø
The procedure should be done by
at least two adults. Do not do it
alone so as not to cause injury or
vehicle damage.
Ø Some steps in the procedure
require holding your body in a
strained position for extended
periods and if over exerted it could
result in injury.
Ø Be very careful when closing the
hardtop to prevent pinching and
possible injury.
1. Grasp the hardtop along the side and front surfaces and lift it up enough to
create a clearance at the rear of
hardtop.
Knowing Your Mazda
Doors and Locks
3-59
MX-5_8CC1-EA-11F_Edition2 Page123
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (124,1)
2. Grasp the hardtop along the side andrear surfaces and lift it up enough to
create a clearance behind the rear glass.
3. Grasp the hardtop along its side surfaceand the rear area of the rear glass, pull
the hardtop towards the front of the
vehicle, and completely close it.
4. Lock the top latch.Refer to Closing the Power Retractable
Hardtop on page 3-53. Closing the deck
1. Loop the center of the rope through the
pin on the link twice so that it does not
loosen.
Pin
Rope
Link
NOTE
Before closing the deck, two small ropes need
to be installed and tied into the trunk so that
the deck does not pop up while driving, and so
that the deck can be raised for servicing by an
Authorized Mazda Dealer.
2. Route one end of the rope to the insideof the vehicle passing it through the
gap in the trim. Route the other end to
the outside of the vehicle passing it
through the links.
To the inside of the vehicle
Trim
Rope
3-60
Knowing Your Mazda
Doors and Locks
MX-5_8CC1-EA-11F_Edition2 Page124
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (125,1)
To the outside of the vehicle
Rope
Links
NOTE
Always route the one end of the rope to the
inside of the vehicle. If it is not inside the
vehicle, it will be difficult to service the
hardtop at an Authorized Mazda Dealer.
3. Do the same procedure on the other
side.
4. Close the deck uniformly on both sides using two adults, one on each side of
the vehicle.
CAUTION
Close the deck using two adults.
Doing it alone could result in injury
or the deck lid mechanism being
twisted which could damage it. 5. Lightly pushing the deck downward,
pull the ropes to the rear along both
sides of the trunk to hold the deck
down.
NOTE
Pull the ropes horizontally to the vehicle rear.
Rope
6. Lightly move the deck and verify that it is secured completely.
7. Open the trunk using the key, and tie the rope to the bracket and knot it twice
so that it does not loosen.
Rope
Bracket
CAUTION
Tie the ropes securely so that the
deck does not open while the vehicle
is being driven.
Knowing Your Mazda
Doors and Locks
3-61
MX-5_8CC1-EA-11F_Edition2 Page125
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (126,1)
NOTE
Open the trunk using the key. The remote
release button, advanced keyless entry
function, and the keyless entry system do not
operate when this emergency procedure is
done.
8. Tie off the other side rope the sameway.
9. Close the trunk lid.
After finishing the procedure
After finishing the procedure, have the
hardtop checked at an Authorized Mazda
Dealer as soon as possible.
WARNING
Drive the vehicle at a speed of 40 km/h
(25 mph) or lower before having the
hardtop checked at an Authorized
Mazda Dealer: The hardtop may open while the
vehicle is being driven and cause an
accident.
NOTE
The trunk cannot be opened with the remote
release button, advanced keyless entry
function, and the keyless entry system as they
are disabled when this emergency procedure is
done.
q Power Retractable Hardtop
Appearance Care
Refer to Hardtop Maintenance (page
8-56) for information on retractable
hardtop appearance care.
3-62
Knowing Your Mazda
Doors and Locks
MX-5_8CC1-EA-11F_Edition2 Page126
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (127,1)
qWhen Warning Indicator/Beep is Activated
If an improper operation is performed or a system malfunction has occurred, the indicator light or a warning beep
is activated to notify the user of improper operation or a system malfunction.
Warning What to check
A warning beep sound is heard when the open or close
switch is pressed. Make sure that all the conditions for operating the
retractable hardtop have been met. If the chime sounds
despite having met all the operation conditions, consult
an Authorized Mazda Dealer to have the system
inspected.
A warning beep sound is heard when the open or close
switch is released. The hardtop is not fully opened or closed. Press the
switch until the open or close operation is completed.
A warning beep sound is heard continuously and the
indicator light is illuminated while the vehicle is driven. The hardtop has not completely opened or closed.
Continue to press the button until the operation is
completed. After the hardtop is completely closed, latch
the top latch.
If the open or close button has not been operated and
the operation indicator light is flashing: The system may have a malfunction. Have the vehicle
checked at an Authorized Mazda Dealer.
Knowing Your Mazda
Doors and Locks
3-63
MX-5_8CC1-EA-11F_Edition2 Page127
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (128,1)
Immobilizer System (with
Advanced Key)
The immobilizer system allows the engine
to start only with an advanced key the
system recognizes.
If someone attempts to start the engine
with an unrecognized advanced key, the
engine will not start, thereby helping to
prevent the theft of your vehicle.
If you have a problem with the
immobilizer system or the advanced key
(including auxiliary key), consult an
Authorized Mazda Dealer.
CAUTION
ØRadio equipment like this is
governed by laws in the United
States.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to
operate the equipment.
Ø To avoid damage to the key, do
not:
ØDrop the key.
ØGet the key wet.
ØExpose the key to any kind of
magnetic field.
ØExpose the key to high
temperatures on places such as
the dashboard or hood, under
direct sunlight.
CAUTION
Do not allow the following when
starting the engine with the auxiliary
key due to an advanced key dead
battery or other malfunction.
Otherwise the signal from the
auxiliary key will not be received
correctly and the engine may not
start.
ØA key ring rests on the auxiliary
key grip.
ØMetal parts of other keys or metal
objects touch the auxiliary key
grip.
ØSpare auxiliary keys or keys for
other vehicles equipped with an
immobilizer system touch or come
near the auxiliary key.
3-64
Knowing Your Mazda
Security System
MX-5_8CC1-EA-11F_Edition2 Page128
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (129,1)
ØDevices for electronic purchases, or
security passage which touch or
come near the auxiliary key.
NOTE
lThe advanced keys (including auxiliary key)
carry a unique electronic code. For this
reason, and to assure your safety, obtaining
a replacement advanced key (including
auxiliary key) requires some waiting time.
They are only available through an
Authorized Mazda Dealer.
lAlways keep a spare advanced key in case
one is lost. If an advanced key is lost,
consult an Authorized Mazda Dealer as
soon as possible.
lIf you lose an advanced key (including
auxiliary key), an Authorized Mazda Dealer
will reset the electronic codes of your
remaining advanced keys (including
auxiliary keys) and immobilizer system.
Bring all the remaining advanced keys
(including auxiliary keys) to an Authorized
Mazda Dealer to reset.
Starting the vehicle with a key that has not
been reset is not possible.
Knowing Your Mazda
Security System
3-65
MX-5_8CC1-EA-11F_Edition2 Page129
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F

Black plate (130,1)
Declaration of Conformity
3-66
Knowing Your Mazda
Security System
MX-5_8CC1-EA-11F_Edition2 Page130
Monday, July 18 2011 10:8 AM
Form No.8CC1-EA-11F