lights MAZDA MODEL PROTÉGÉ 2001 (in English) User Guide

Driving Your Mazda
I Heedlight Hish-Beam E^I I O/DOFF Indicetor Lighr 0/D I Cruise Ser Indicator Lishr* [Jlndicator Light =) ( Auromatic Transa\ler off l-'---This light comes on lvhen a cruisingThis ligbt indicates one oftwo thingsr This light comes on when the overdrive speed is ser.
has been tumed off.. Tbe higb-beam headlights are on.
. The tum signal lever is in the
flash to pass position.Ac.quuoN
If the overdrive-off indicator lighi
flashes, the trarsaxiehas an eleclrical
problem. Continuing ro drive your
Mazda in this condition could cause
damage to tour rransaxle. Consultan
Autho.ized Mazda Dealer as soon as
possibl€.
5-32 'so-" ^oo.r'.

Driving Your Mazda
Lighting
Signals
Control and Turn
V Lights-on r€minder
If the lights :re on and rhe key js
removed fiom the ignition switch. abeep
will sound when any dooris opened.
NOTE
To prevent discharging the battery,
don'tleave the lights on while the
engine is off.
I Headlights
To 1um on the lights, turn the knob on rhe
end of the control leve.
The firs! stop turns on rhe taiiligbts-
dashboard lights. parklng lights, licenseIights, and side-maJker lights.
The second stop turns on the headlights,
taillights, daslboard lighrs, parking
lighls, license lighls, and side-marker
tigh!s.
V Headlight highnow beam
Push ihe lever iorward for high beams.Pull it back for low.
The high-beam indicator light on the
dashboard is blue.
5-33

Driving Yotrr Mazda
V Lane-change signals
Move $e lever slightly towaJd the
direction of th€ change-unlit th€
indicator flashes andhold it drere.lt
will r€tum io the offposition when
NOTE
Ifan indicatorlighl stays on without
flashing or jf il flashes abnormally.
$e tum signal bulb tnay be burnedV Flashing the headlights
To flash the headlights, pull the lever
fully toward you. The headlight switch
need notb€ on, and the leverwill relurn
to the normal position when released.
The high-beam indicaior light on $e
dashboard is blue.
I Tirrn and Lsne-Change Signals
V T|lrn signal
Move ihe signal lever down (for a left
tum) or up (for a right lurn) to fte stop
position. The signal will self-cancel after
the turn is completed.
Green indicalors on $e dashboard show
which signal is workiry.
lfthe indicator light continues !o flash
after a tum, manually retum the lever to
its original position.
5-34

Driving Your Mazda
Windshield WiDers and
Washer
I Fog Lights+
Use this switch lo 1um on the fog lights.
They help you to see as well as to be
To turn on the fog lights, first turn on the
headlight switch. Then press the fog ligh!
switch. To turn ihe fog lights off, pr€ss
the fog light switch again or turn ihe
headljght switch off.
I Windsbi€ld Wipers
The ignition switch nusi be in the ON
Turn the wipen on by pulling the lever
INT lntermittent
I Normal
2 Fast
V One-touch wipers
For a single wiping cycle, push the lever
up to MIST.
"sonenoders. 5-35

In Case of an Em€rg€ncy
NOTE
The tum signals don't work when
the hazard waming lights are on.
Check local regulations about tbe
use of hazard waming lights while
ihe vehicle is being towed. They
may forbid it.
Hazard Warning Flasher
6.2
Overheating
If the temperature gauge indicates
overheating, you experience power loss,
or you hear a loud knocking or pinging
noise, the engine is probably too hot.
If this happens:
l Drive safely ro the side of the road and
park off the right-of-way.
2. Put a vehicle with an automatic
rransaxle in park G), a rnanual
transaxle in neutral.
Apply the parking brake.
3. Tum offthe air conditioner
The hazard warning lights wam other
drivers ihat your vebicle is a traffic
hazard and that they musl take extreme
caution when near il.
The hazard warnins ligbts should always
be used when you stop on or near a
Depress the hazard warning swirch and
all four tum signals willflash at once.

ln Cas€ ofan Emergency
ffiffi
AcluuoN
Always replace a fuse with one of the
same rating. Otherwise you may
damage the electric system.
.{. lnspect it and replace ifit blown.
5. Push in anew fuse of the same rating,
and make sure it fits tightly. If it
doesn't, have an Authorized Mazda
Dealer insiall it.
If you have no spare fuses, borrow one of
the same rating from a circuit not
essential to vehicle operation. such as the
RADIO c;cuit.
If the headlights or other electrical
componenls don work and lhe iuses in
the cabin are OK. inspect rhe fuse block
under the hood.Ifafuse is blown, il must
be replaced. Follow th€se steps:
1. Tum off the ignition switch and all
2. To remove the fuse btock cover,
unhook it a:rd lift up on tbe side with
dle tab.
6-7

In Case of an Emergency
I Fuse Panel DescriDtion
tr88
E80
HBE
HEE
HEE
F'H
EE
E
V Fuse block (Engin€ compartment)
DESCRIPTIONFUSDRA1.INGPROTECIED COMPONDNT
HEATER
2(ABS)For pmrection of vanons ci(uirs*
lIC KEYlor pole.lio of veious cimiB
5(CLOw)
6
COOLINC30A
BTNInlerior lights, Power dooi lock+
9Addrtronrl rool,ng lan for r'r rondirion.r'
INJORFIP
(r'JC)
(sTsrc)
HORN
TAIL
(HEADC U)Foi piote.rion of vfjos c;cuits
(FOC)For protecion of vdious cncuns
'sune nodek. 6-9

Maintenance
(cont'd)I:
L:
Inspccr: Inspect @d cled. epair, adjust, or replee ir necessary .LubricaF T: Tighten
"6i This h a full function check ofelcctrical sts|eds such as lights, qiper and washer sysGns (including riper bladet, md poser*indows.
MAINTENANCDINTERVAL
MAINTENANCI]ITEM
Nnmbe. of months or km lnlles). whichever con6 fNt
6t2l8u30425460667a8il9096
1020305070801001101201J0140150160
o2)(13)(a)(30)(36)(12)(48)(s4)(60)(66)o2J(78)(84)(901(96)
II
Exhaust sy$en hcar shieldsII
TTTTTTTT
Bults eJ nuL on chsesrd bftltTTTTTT1T
IIII
IIIII
Body condition (for rust, corcsion bd Frioniion)
(including spae dE, *idl inflation pEsue adjusmenoIIIIT
LLLLLLLL
IIIIIIITI
8-ll

Maini€nance
AclurroN
A wrong sized wheel may adYersely
affect
. Tire fit
. wleel and bearing life
. Ground clearance
. Snow chainclearance
. Speedometer calibration
. Headlight aim
V Replacing a wheel
When replacing a wheel, male sure the
new one is the same as the original
Iactory wheel in diameter, rim width, and
oflsel.
Proper tire balancing provides the best
riding comfort and helps reduce tread
wear. Oul of'balance tires can cause
vibration and uneven wear, such as
cupping and flat spots.
Do nol louch tne glass surface
I Replacing a Headlight Bulb
Your Mazda's headlights have
replaceabl€ halogen bulbs.A wamrnrc
asinr a wrcns-Sized Wheel:
Asing a turong-si&d wheel is
dangem s. Brakw and hantrline
couu be aflected,leani g to loss of
contrcl and an accuent. Alwars ute
wheels of the coftect ske on rour

Maintenance
I Replacing a Bulb (Front)
Fmnt-turn signal lights/
--'9:
To replace the fog light bulbs, contact an Authorized Mazda Dealer
The number in ( ) shows the bulb number
8-40