fold seats MERCEDES-BENZ C CLASS COUPE 2005 Owners Manual

39
Getting started
Adjusting
Head restraint tilt
Manually adjust the angle of the head re-
straint. 
Push or pull on the lower edge of the
head restraint cushion.
For more information, see “Seats”
(
page 100). Folding front seat backrest forward
1 Release lever
2 Seat belt presenter
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the center of
the head restraint supports the back of the
head at eye level. This will reduce the poten-
tial for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
iIn addition to the front seat backrests,
the front seat cushions can also be
shifted forward to permit easy access
to the rear whenever the seat is located
in the rear half of its adjustment range.
Swivel backrest forward by pulling the
release lever until the seat moves in a
combined forward and upward move-
ment.

40 Getting startedAdjustingFolding backrest forward
Pivot seat belt presenter2 down.

Pull release lever 1 forward and fold
the seat backrest forward.
Vehicles with manual seat adjustment:

If necessary, press the head restraint
downward while tilting the backrest
forward. Folding backrest back

Fold and press the backrest rearward
until it engages in driving position.
Vehicles with manual seat adjustment:

If necessary, pull the head restraint out
while tilting the seat back.
For more information, see “Seats”
(
page 100).
Steering wheel
iVehicles with power seat*: The head
restraints will automatically move
down.
iVehicles with power seat*: The head
restraint returns to its previous posi-
tions.
Warning!
G
Do not adjust the steering wheel while
driving. Adjusting the steering wheel while
driving, or driving without the steering wheel
adjustment locked could cause the driver to
lose control of the vehicle.
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle.
Even with the SmartKey removed from the
starter switch, the electrical steering wheel
adjustment feature* can be operated when
the driver’s door is open. Therefore, do not
leave children unattended in the vehicle, or
with access to an unlocked vehicle. Unsu-
pervised use of vehicle equipment may
cause an accident and/or serious personal
injury.

77
Safety and Security
Occupant safety
Self-test Occupant Classification
System
After turning the SmartKey in the starter
switch to position
1 or 2, the
56 indicator lamp 1 located in
the center console illuminates. If an adult
occupant is properly sitting on the front
passenger seat and the system senses the
occupant as being an adult, the
56 indicator lamp will illuminate
and go out after approximately six sec-
onds.
If the seat is not occupied and the system
senses the front passenger seat as being
empty, the 56indicator lamp will
illuminate and not go out. For more information, see “Lamp in center
console” (
page 345).Installation of infant and child restraint
systems
This vehicle is equipped with tether an-
chorages for a top tether strap at each of
the rear seating positions.
1 Anchorage rings

Release rear seat backrest
(page 251).

Fold rear seat backrest slightly for-
ward.

Guide tether strap between head
restraint and top of the seat back.
Warning!
G
If the 56 indicator lamp should not
illuminate, the system is not functioning.
You must see an authorized Mercedes-Benz
Center before seating any child on the front
passenger seat.Warning!
G
Never place anything between seat cushion
and child seat (e.g. pillow), since it reduces
the effectiveness of the Occupant Classifi-
cation System. The bottom of the child seat
must make full contact with the passenger
seat cushion. An incorrectly mounted child
seat could cause injuries to the child in case
of an accident, instead of increasing protec-
tion for the child.
Follow the manufacturer’s instructions for
installation of child seats.


78 Safety and SecurityOccupant safety
Head restraint must be positioned such
that the top tether strap can pass freely
between the head restraint and the top
of the seat back.
Make sure the tether strap is not twist-
ed.
2 Hook
3 Anchorage ring

Securely fasten the hook 2 to the
anchorage ring 3.

Swing rear seat backrest to the rear
until it engages.

Check the rear seat backrest to be
locked in its upright position
(page 251).
Once the top tether anchorage hook is
attached, the child restraint itself can be
secured. Tighten the top tether strap
according to the child restraint manufac-
turer's instructions. Child seat anchors - LATCH type
To fold anchors out
This vehicle is equipped with two LATCH
(L
ower A
nchors and T
ethers for CH
ildren)
type anchors (at each of the rear seats) for
the installation of a “LATCH” child seat
with the matching mounting fittings.
The foldable LATCH type anchors are
located between the seat cushion and the
backrest.
1 Anchors
2 Release button
iFor safety, make sure the hook 2 has
attached to the ring 1 beyond the
safety catch, as illustrated.
Warning!
G
Always lock backrest in nearly upright posi-
tion when rear seat bench is occupied by
passengers, or the extended cargo area is
not in use. Check for secure locking by
pushing and pulling on the backrest.


79
Safety and Security
Occupant safety

Grip inner side of anchor
1 and fold
forward until they lock in place.

Install child seat according to the
manufacturer’s instructions. To fold anchors back

Press down button
2 on each anchor
and return the anchors 1 to its catch.
iThe child seat must be firmly attached
in the right and left side anchors 1.
iNon-LATCH type child seats may also
be used and can be installed using the
vehicle’s seat belt system. Install child
seat according to the manufacturer’s
instructions.Warning!
G
Children too big for a toddler restraint must
ride in seats using regular seat belts. Posi-
tion shoulder belt across chest and shoul-
der, not face or neck. A booster seat may be
necessary to achieve proper belt positioning
for children from 41 lbs until they reach a
height where a lap/shoulder belt fits proper-
ly without a booster.
Before installing the child seat, make sure
anchors
1
are folded out and locked in
place.
Install child seat according to manufactur-
er’s instructions.
T h e c h i l d s e a t m u s t b e f i r m l y a t t a c h e d i n t h e
right and left side anchors
1
.
An incorrectly mounted child seat may come
loose during an accident which could result
in serious injury or death to the child.
Damaged or impact damaged child seats or
child seat anchor fittings must be replaced.
Do not leave children unattended in the
vehicle, even if the children are secured in a
child restraint system.

103
Controls in detailSeats
Front seat head restraints, power seat*
The head restraint height switch is located
in each door.
1 Head restraint switch
Switch on the ignition (
page 33). Removing front seat head restraints

Press switch
1 upwards and hold until
the head restraint is fully extended.

Pull out head restraint.
Installing front seat head restraints

Press switch 1 upwards and hold for
about five seconds.

Push the head restraint down until it
engages.

Adjust head restraint to desired posi-
tion.
Rear seat head restraints
Head restraint height
1 Release buttonWarning!
G
For safety reasons, always drive with the
rear head restraints in the upright position
when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.

104 Controls in detailSeatsRaising
Manually adjust the height of the head
restraint by pulling it upward.
If the head restraint is fully retracted,
press release button 1 and pull the
head restraint out.
Lowering

To lower the head restraint, press
release button 1 and press down on
the head restraint. Folding head restraints back
The rear seat head restraints can be folded
backward for increased visibility.
1 Release button

Press release button 1.
The head restraints will fold backward.
iAdjust the head restraint in such a way
that it is as close to the head as possi-
ble.
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the center of
the head restraint supports the back of the
head at eye level. This will reduce the poten-
tial for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.

105
Controls in detailSeats
Placing head restraints upright
Pull the head restraint forward until it
locks into position.
Head restraint tilt
Two different head restraint angle posi-
tions are available.

Press the release button and tilt the
head restraint to the desired position. Removing and installing rear seat head
restraints
1Release button
Removing rear seat head restraints

Fold back head restraint (
page 104).

Pull head restraint to its highest posi-
tion.

Press release button 1 and pull out
head restraint.
Installing rear seat head restraints

Insert head restraint and push it down
until it engages.

Press release button 1 and adjust
head restraint to desired position.
Warning!
G
Make sure the head restraints engage when
placing them upright. Otherwise their pro-
tective function cannot be assured.
iAdjust the head restraint in such a way
that it is as close to the head as possi-
ble.Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the center of
the head restraint supports the back of the
head at eye level. This will reduce the poten-
tial for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
Do not interchange head restraints from
front and rear seat.

443
Index
A
ABS 25, 81, 437
Malfunction indicator lamp 340
Messages in display 353
Warning lamp 340
Accelerator position, automatic transmission* 165
Accessory weight 323
Accident In case of 55
Activating Air conditioning (cooling) 193Climate control 179
Air recirculation mode 189 Climate control 177
Anti-theft alarm system 86
Automatic climate control* 183
Central locking (control system) 148
Charcoal filter 191
Climate control 173
Climate control system 175
Defrosting 188 Climate control 177
Easy-entry/exit feature* 148
Electric air pump 399
ESP 85 Exterior headlamps 51
Exterior lamps 111
Exterior rear view mirror parking
position* 169
Hazard warning flasher 116
Headlamps 51
High beams 114
Ignition 33
Immobilizer 86
Rear fog lamp 113
Rear window defroster 170
Residual heat 193
Seat heating* 106
Tow-away alarm 88
Windshield wipers 53
Adding Coolant 296, 297
Engine oil 294
Headlamp cleaning fluid 299
Windshield washer fluid 299
Additional turn signals 385
Adjustable air vents, rear passenger compartment 194Climate control 180 Adjusting 35
Air distribution 186 Climate control 176
Air volume 187 Climate control 176
Backrest tilt 36, 38
Exterior rear view mirrors 42
Head restraint height 37, 38
Head restraint height, rear seats 103
Head restraint tilt 37, 39
Head restraint tilt, rear seats 105
Head restraints, rear seats Folding back 104
Placing upright 105
Instrument cluster illumination 119
Interior rear view mirror 42
Manual seat 36
Mirrors 42
Rear seat head restraints 103
Seat cushion tilt 36, 38
Seat fore and aft adjustment 36, 38
Seat height 36, 38
Seats 35
Steering column height 42
Steering column length 42
Steering wheel 40

451
Index
Engine oil 292, 428
Adding 294
Additives 428
Checking level 292
Consumption 292
Display messages 363–364
Filler neck 295
Messages in display 293, 363–364
Viscosity 438
Engine oil level see Oil level
ESP 25, 83, 438 Messages in display 355–356
Switching off 84
Switching on 85
Warning lamp 343
ETD 438 Safety guidelines 64
ETD (Emergency tensioning device) 69
Ethanol fuel At the gas station 288
Switching fuels 431
Exterior lamp switch 110
Exterior lamps Delayed shut-off 146
Exterior rear view mirror
Parking position* for 150 Exterior rear view mirrors
Adjusting 42
F
Fahrenheit Setting temperature units 137
Fastening the seat belts 44
Fine adjustment Cruise control 249
First aid kit 373
Flat tire 394 Inflating the spare tire 398
Lowering the vehicle 400
Mounting the spare wheel 394
Preparing the vehicle 394
Spare wheel 375
Tighten wheel bolts 400
Flexible fuel vehicles 431 At the gas station 288
Switching fuels 431
Flexible Service System (Canada vehicles) 330, 438
Fog lamp, rear Message in display 368
Switching on 113 Fog lamps, front
Messages in display 366
Replacing bulbs 385, 386
Switching on 113
Front air bags 65
Front lamps Bi-Xenon* type 388
Halogen-type 386
Messages in display 366–370
Replacing bulbs 385, 386
Switching on 110
Front passenger front air bag off indicator lamp 27, 76, 345
Front seat backrest Folding backrest back 40
Folding backrest forward 39
Front seat head restraints Installing 102 Power seat* 103
Manual seat 102
Power seat* 103
Removing 102 Power seat* 103
Front seats Heating* 106