high beam MERCEDES-BENZ C230 2006 W203 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: C230, Model: MERCEDES-BENZ C230 2006 W203Pages: 474
Page 24 of 474
23 At a glance
Cockpit
Item
Page
1
Cruise control lever
247
2
Multifunction steering
wheel
26,
131
3
Horn
4
Instrument cluster
24,
127
5
Lever for voice control
system*, see separate
operating instructions
6
Overhead control panel
29
7
Glove box lid release
257
8
Glove box lock
257
Item
Page
9
Center console
27
a
Starter switch
33
b
Hood lock release
297
c
Steering wheel adjustment
handle (manual)
40
d
Steering wheel adjustment
lever (electrical)*
41
e
Parking brake pedal
50, 58
f
Remote trunk opening
switch
104
g
Door control panel
30
h
Parking brake release
50
Item
Page
j
Combination switch
Turn signals
53
Windshield wipers
53
High beam
52
k
Exterior lamp switch
52,
118
l
Exterior rear view mirror
adjustment
43,
117
m
Headlamp washer button*
170
Page 26 of 474
25 At a glance
Instrument cluster
Item
Page
1
Speedometer with:vElectronic Stability
Program (ESP
®)
warning lamp
89,
354
;Brake warning lamp,
USA only
50, 58,
351
3Brake warning lamp,
Canada only
50, 58,
351
BLow beam headlamp
indicator lamp
52,
118
2
LLeft turn signal
indicator lamp
53
3
Multifunction display
with:
130
Trip odometer
128
Main odometer
130
Gear selector lever
position*
49,
130,
164
Item
Page
Program mode*
167
Status indicator (outside
temperature/digital speed-
ometer
129,
144
Digital clock
130
4
KRight turn signal
indicator lamp
53
5
Tachometer with:
129
-Antilock Brake
System (ABS)
indicator lamp
87,
350
úEngine malfunction
indicator lamp,
USA only
352,
353
±Engine malfunction
indicator lamp,
Canada only
352,
353
1Supplemental
Restraint System
(SRS) indicator lamp
62,
355
Item
Page
355
AHigh beam head-
lamp indicator lamp
52,
122
6
Fuel gauge with:Fuel reserve warning lamp
354
4The arrow indicates
that the fuel filler cap
is on the rear
right-hand side.
7
Coolant temperature gauge
128
8
Reset button for:
127
Resetting trip odometer
128
Resetting all settings
140
Instrument cluster
illumination
127
Page 34 of 474
33 Getting started
Unlocking
Starter switch positions SmartKey
Starter switch0For removing SmartKey
The steering is locked when the
SmartKey is removed from the starter
switch.
1Power supply for some electrical
consumers, such as seat adjustment2Ignition (power supply for all electrical
consumers) and driving position.
All lamps (except low beam headlamp
indicator lamp, high beam headlamp in-
dicator lamp, and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, see “Lamps in
instrument cluster” (
page 350).
3Starting position
Warning!
G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.
Page 35 of 474
34 Getting startedUnlocking
iWhen you switch on ignition, the
indicator and warning lamps (except
low beam headlamp indicator lamp,
high beam headlamp indicator lamp,
and turn signal indicator lamps unless
activated) in the instrument cluster
come on. The indicator and warning
lamps (except low beam headlamp in-
dicator lamp, high beam headlamp indi-
cator lamp, and turn signal indicator
lamps if activated) will go out when the
engine is running. This indicates that
the respective systems are operational.iVehicles with automatic transmission*:
The SmartKey can only be removed
from the starter switch with the gear
selector lever in positionP.
!If the SmartKey cannot be turned in the
starter switch, the battery may not be
sufficiently charged.
Check the battery and charge it if
necessary (
page 412).
Get a jump start (
page 415).
To prevent accelerated vehicle battery
discharge or a completely discharged
battery, always remove the SmartKey
from the starter switch when the en-
gine is not in operation.
Page 53 of 474
52 Getting startedDriving
Switching on headlamps
Low beam headlamps
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.Exterior lamp switch1Off
2Low beam headlamps on
Turn exterior lamp switch to
positionB.
The low beam headlamp indicator
lampB in the instrument cluster
comes on (
page 24).High beam
The combination switch is located on the
left of the steering column.
Combination switch1High beam
2High beam flasher
Push combination switch in direction of
arrow1.
The high beam headlamp indicator
lampA in the instrument cluster
comes on (
page 24).
For more information on headlamps, see
“Lighting” (
page 118).
Warning!
G
It is dangerous to shift the gear selector le-
ver out ofP orN if the engine speed is high-
er than idle speed. If your foot is not firmly
on the brake pedal, the vehicle could accel-
erate quickly forward or in reverse. You
could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and when
your right foot is firmly on the brake pedal.
Page 119 of 474
118 Controls in detailLightingFor information on how to switch on the
headlamps and use the turn signals, see
“Switching on headlamps” (
page 52)
and “Turn signals” (
page 53).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.Exterior lamp switch
MOff
Daytime running lamp mode
(
page 120)
UAutomatic headlamp mode
Daytime running lamp mode
(page 120)
CParking lamps (also tail lamps,
license plate lamps, side marker
lamps, instrument panel lamps)
BLow beam headlamps (or high
beam headlamps when the
combination switch is pushed
forward) and parking lamps
ˆStanding lamps, right (turn left one
stop)
‚Standing lamps, left (turn left two
stops)
‡Indicator lamp for front fog lamps
†Indicator lamp for rear fog lamp
iIf you drive in countries where vehicles
drive on the other side of the road than
the country where the vehicle is regis-
tered, you must have the headlamps
modified for symmetrical low beams.
Relevant information can be obtained
at your authorized Mercedes-Benz
Center.
Page 121 of 474
120 Controls in detailLightingDaytime running lamp mode
Turn the exterior lamp switch to
positionM orU.
When the engine is running, the low beam
headlamps are switched on.
In low ambient light conditions, the
following lamps will switch on additionally:
Tail and parking lamps
License plate lamps
Side marker lamps
For nighttime driving you should turn the
exterior lamp switch to positionB to
permit activation of the high beam head-
lamps.Canada only:
The daytime running lamp mode is manda-
tory and therefore in a constant mode.
Vehicles with automatic transmission*:
When the engine is running, and you shift
from a driving position to positionN orP,
the low beam headlamps will switch off
with a three-minute delay.
When the engine is running, and you
turn the exterior lamp switch to
positionC, the parking lamps
switch on additionally.
turn the exterior lamp switch to
positionB, the manual headlamp
mode has priority over the daytime
running lamp mode.
The corresponding exterior lamps
switch on (
page 118).USA only:
By default, the daytime running lamp mode
is deactivated. Activate the daytime
running lamp mode using the control
system, see “Set daytime running lamp
mode (USA only)” (
page 149).
When the engine is running, and you turn
the exterior lamp switch to positionC
orB, the manual headlamp mode has
priority over the daytime running lamp
mode.
The corresponding exterior lamps switch
on (
page 118).
iWith the daytime running lamp mode
activated and the exterior lamp switch
in positionM, the high beam head-
lamps cannot be switched on.
The high beam flasher is available at all
times.
Page 123 of 474
122 Controls in detailLightingRear fog lamp (driver’s side only)
Switch on the front fog lamps
(page 121).
Pull out the exterior lamp switch to
second stop.
The rear fog lamp is switched on.
The yellow indicator lamp† in the
exterior lamp switch comes on
(page 118).
Push in the exterior lamp switch to first
stop.
The rear fog lamp switches off.
The yellow indicator lamp† in the
exterior lamp switch goes out.
The front fog lamps remain lit.
Combination switch
The combination switch is located on the
left of the steering column.Combination switch1High beam
2High beam flasherHigh beam
Turn the exterior lamp switch to
positionB orU (
page 118).
Push the combination switch in
direction of arrow1 to switch on the
high beam.
The high beam headlamp indicator
lampA in the instrument cluster
comes on (
page 24).
Pull the combination switch in direction
of arrow2 to its original position to
switch off the high beam.
The high beam headlamp indicator
lampA in the instrument cluster
goes out.
High beam flasher
Pull the combination switch briefly in
direction of arrow2.
Page 360 of 474
359 Practical hints
What to do if …
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may
appear in the multifunction display.
For your convenience the messages are
divided into two sections:
Text messages (
page 360)
Symbol messages (
page 369)
iSwitching on the ignition causes all
instrument cluster lamps (except low
beam headlamp indicator lamp, high
beam headlamp indicator lamp, and
turn signal indicator lamps unless
activated) as well as the multifunction
display to come on. Make sure the
lamps and multifunction display are in
working order before starting your
journey.
Page 379 of 474
378 Practical hintsWhat to do if …Display symbol
Display message
Possible cause/consequence
Possible solution
.
High beam left
The left high beam lamp is
malfunctioning.
Replace the bulb as soon as possible.
High beam right
The right high beam lamp is
malfunctioning.
Replace the bulb as soon as possible.
License plate lamp,
left
The left license plate lamp is
malfunctioning.
Replace the bulb as soon as possible.
License plate lamp,
right
The right license plate lamp is
malfunctioning.
Replace the bulb as soon as possible.
Light sensor
Drive to workshop
The lamp sensor is malfunctioning.
The headlamps switch on automatically.
In the control system, set lamp
operation to manual (
page 149).
Switch on the headlamps using the
exterior lamp switch (
page 118).
Visit an authorized Mercedes-Benz
Center as soon as possible.
Low beam left
The left low beam lamp is malfunctioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:
Visit an authorized Mercedes-Benz
Center as soon as possible.