jack MERCEDES-BENZ C230 2006 W203 Owner's Manual

383 Practical hints
Where will I find ...?
Where will I find ...?
First aid kit
The first aid kit is located in the trunk on
the left side secured by a hook and loop
fastener.
1First aid kit
2Hook and loop fastener
Unfasten hook and loop fastener2.

Remove first aid kit1.
Vehicle tool kit
The vehicle tool kit is located in the storage
compartment underneath the trunk floor.
The following is included:

Towing eye bolt


Wheel wrench


Alignment bolt


Vehicle jack


Spare fuses


Collapsible wheel chock


A pair of gloves Removing the vehicle tool kit

Lift up trunk floor cover and engage
trunk floor handle in upper edge of
trunk.
1Retaining screw
2Storage well casing

Loosen retaining screw1 by turning it
counterclockwise.

Remove storage well casing2.
iCheck expiration dates and contents
for completeness at least once a year
and replace missing/expired items.


385 Practical hints
Where will I find ...?
Vehicle jackThe vehicle jack is located in the storage
compartment underneath the trunk floor.
Storage position
Turn crank handle in direction of arrow
as far as it will go.

Push crank handle up.
Operational position
Turn crank handle clockwise.
Before storing the vehicle jack in its
compartment:


It should be fully collapsed.


The handle must be folded in (storage
position).
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Make sure the jack arm is
fully seated in the jack take-up bracket.
Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.

406 Practical hintsFlat tire
Preparing the vehicle
Park the vehicle in a safe distance from
moving traffic on a hard, flat surface
when possible.

Turn on the hazard warning flasher
(page 124).

Turn the steering wheel so that the
front wheels are in a straight ahead
position.

Set the parking brake (
page 58).

Move the gear selector lever toP
(manual transmission: to first or
reverse gear).

Turn off the engine (
page 59).

Remove the SmartKey from the starter
switch.

Have any passenger exit the vehicle at
a safe distance from the roadway.
Mounting the Minispare wheel
Preparing the vehicle
Prepare the vehicle as described
(page 406).

Take the wheel wrench, the wheel
bolts, and the jack out of the trunk
(page 383).

Take the Minispare wheel out of the
trunk (
page 386).
Warning!
G
The dimensions of the Minispare wheel are
different from those of the road wheels. As
a result, the vehicle handling characteristics
change when driving with a Minispare wheel
mounted. Adapt your driving style accord-
ingly.
The Minispare wheel is for temporary use
only. When driving with Minispare wheel
mounted, ensure proper tire inflation
pressure and do not exceed a vehicle speed
of 50 mph (80 km/h).
Drive to the nearest Mercedes-Benz Center
as soon as possible to have the Minispare
wheel replaced with a regular road wheel.
Never operate the vehicle with more than
one Minispare wheel mounted.
Do not switch off the ESP
® when a
Minispare wheel is mounted.
iOpen doors only when conditions are
safe to do so.

407 Practical hints
Flat tire
Lifting the vehicle
Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
or other sizable objects.
One wheel chock is included with the
vehicle tool kit (
page 383).
When changing wheel on a level surface:

Place the wheel chock in front of and
another sizable object behind the
wheel that is diagonally opposite to the
wheel being changed.
Always try lifting the vehicle using the jack
on a level surface. However, should cir-
cumstances require you to do so on a hill,
place the wheel chock and the other size-
able object as follows:

Place wheel chocks and another siz-
able object on the downhill side block-
ing both wheels of the axle not being
worked on.

On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with
wrench).
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Make sure the jack arm is
fully seated in the jack take-up bracket. Al-
ways lower the vehicle onto sufficient ca-
pacity jackstands before working under the
vehicle.

408 Practical hintsFlat tireThe jack take-up brackets are located
directly behind the front wheel housings
and in front of the rear wheel housings.
1Take-up bracket
2Jack
Place jack2 on firm ground.

Position jack2 under take-up
bracket1 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.

Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.Removing the wheel
1Alignment bolt

Unscrew upper-most wheel bolt and
remove.

Replace this wheel bolt with alignment
bolt1 supplied in the tool kit.

Remove the remaining bolts.

Remove the wheel.
Warning!
G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.

Never start the engine when the vehicle
is raised.


Never lie down under the raised vehicle.
!Do not place wheel bolts in sand or dirt.
This could result in damage to the bolts
and wheel hub threads.

410 Practical hintsFlat tire
Unscrew the alignment bolt, install last
wheel bolt and tighten slightly.Lowering the vehicle

Lower vehicle by turning crank
counterclockwise until vehicle is
resting fully on its own weight.

Remove the jack.
1 - 5Wheel bolts

Tighten the five wheel bolts evenly,
following the diagonal sequence
illustrated (1to5), until all bolts are
tight. Observe a tightening torque
of 80 lb-ft (110 Nm).Before storing the jack, it should be fully
collapsed, with handle folded in (storage
position) (
page 385).

Store the jack and the other vehicle
tools in the trunk.
Warning!
G
Only use genuine equipment
Mercedes-Benz wheel bolts. Other wheel
bolts may come loose.
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle
could fall off the jack.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque
of 80 lb-ft (110 Nm).

460 Index
Number 428
Starting 49
Tachometer 25
Technical data 430
Turning 59
Engine coolant see coolant
Engine number 450
Engine oil 298, 442
Adding 300
Additives 442
Changing 440
Checking level (Dipstick) 299
Consumption 298
Filler neck 300
Recommended engine and
oil filter 375
Viscosity 450
ESP®
89, 450
Four wheel electronic traction system
with ESP
®
92
Messages in display 361–362
Warning lamp 25, 354ETD 72, 450
Safety guidelines 66
Exterior lamp switch 52, 118
Exterior rear view mirrors 43
Parking position* 172
F
Fahrenheit see Temperature display
mode 142
Filler neck, Engine oil 300
First aid kit 383
Flat tire 406
Jacking up the vehicle 407
Lowering the vehicle 410
Minispare wheel 386
Mounting the spare wheel 406
Preparing the vehicle 406
Flexible Service System see FSS
Fluids
Automatic transmission fluid 300,
440
Brake fluid 295, 442
Capacities 440Engine coolant 295, 444
Engine oil 298, 442
Power steering fluid 441
Windshield washer and headlamp
cleaning system* 303, 448
Fog lamps 121, 122
Message in display 377, 379
Replacing bulbs 398, 399
Four wheel electronic traction system
(4MATIC) with ESP
®
92
4MATIC 92
Front air bags 67
Front lamps see Headlamps
Front passenger front air bag 67
Messages in display 364–367
Front passenger front air bag off indicator
lamp 27, 80, 356, 357
Front seat head restraints see Head
restraints 109
FSS (Flexible Service System)
(Canada vehicles) 338, 450

463 Index
J
Jack 383
Jacking up the vehicle 407
Jump starting 415
K
Key, mechanical 389
Key, SmartKey
Batteries 101
Battery check lamp 101
Changing batteries 396
Factory setting 100
Locking/unlocking 32, 100
Locking/unlocking, Global
setting 100
Locking/unlocking, Selective
setting 100
Loss of 102
Messages in display 376
Opening and closing the power
windows 243
Opening and closing the tilt/sliding
sunroof* 243
Positions in starter switch 33Remote control 98
Starting the engine 48, 49
Turning off the engine 59
Unlocking, Trunk lid 102
Valet locking 106
Kickdown 165, 451
Kilopascal 332
L
Labels 428
Certification 428
Emission control information 428
Emission control vacuum line
routing 428
Lamp sensor
Message in display 378
Lamps, exterior 398, 399
Light sensor 378
Messages in display 377, 378, 379,
380
Lamps, indicator and warning
ABS 25, 350
Battery (SmartKey) 100
Brakes 25, 351Engine diagnostics 352, 355
Engine malfunction 25, 352–353
ESP
®
25, 354
Fog lamps 118
Front passenger front air bag off 27,
68
Fuel reserve 25, 354
High beam headlamps 25
Instrument cluster 350, 355
Low beam headlamps 25
Maintenance service indicator 338
Rear fog lamp 118
Seat belt telltale 25
SRS 25, 63, 355
Turn signals 25
Language, Setting 143
LATCH-type child seat anchors see
Children in the vehicle
Leather upholstery, Cleaning and
care of 348
License plate lamps
Messages in display 378
Replacing bulbs 399

471 Index
Tools 383
Top tether, see Children in the vehicle
Tow-away alarm* 95
Towing eye bolt 420
Towing the vehicle 417
Traction 168, 334
Transmission gear selector lever see Gear
selector lever
Transmission see Automatic* or Manual
transmission
Traveling abroad 290
Tread 334
Tread depth 306, 336
Treadwear indicators 334
Trip computer 155
Trip odometer 128
Trunk
Closing the lid 104
Fuse box 423
Lamp 126
Message in display 382
Opening 102, 103, 104
Tie-down rings 256
Trunk emergency release 105
Unlocking in an emergency 105Turn signal lamps
Messages in display 380
Replacing bulbs 398, 399
Turn signals 53
Additional in mirrors 398
Bulbs 398, 399
Cleaning lenses 344
Indicator lamps 25
Turning off engine 59
U
Uniform Tire Quality Grading
Standards 334
Units, Setting
Speedometer 143
Upholstery, Cleaning 348
Useful features 257
V
Vacuum line routing diagram label 428
Valet locking 106
Vehicle
Battery 412
Breaking-in the vehicle 282
Care 341
Dimensions 438Individual settings 140, 142
Locking/unlocking 108
Locking/unlocking in an
emergency 389, 390
Lowering 410
Modifications and alterations,
Operating safety 16
Towing 417
Washing 342, 343
Weights 439
Vehicle capacity weight 334
Vehicle Identification Number see VIN
Vehicle jack 385
Vehicle lighting 296
Vehicle loading
Cargo tie-down rings* 256
Instructions 255, 307
Load limit 439
Roof rack* 250
Split rear bench seat* 253
Terminology 331
Vehicle maximum load on the tire 334
Vehicle recovery services, Stolen
(Tele Aid*) 265
Vehicle status message memory 138