brake pads MERCEDES-BENZ C230 KOMPRESSOR 2003 W203 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2003, Model line: C230 KOMPRESSOR, Model: MERCEDES-BENZ C230 KOMPRESSOR 2003 W203Pages: 376, PDF Size: 5.97 MB
Page 224 of 376
224 OperationDriving instructionsPower assistanceBrakesTo help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
If your brake system is normally only
subject to moderate loads, you should
occasionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads. If the parking brake is released and the
brake warning lamp in the instrument clus-
ter stays on, the brake fluid level in the res-
ervoir is too low.
Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected at an au-
thorized Mercedes-Benz Center immedi-
ately.
All checks and service work on the brake
system should be carried out by an autho-
rized Mercedes-Benz Center.
Only install brake pads and brake fluid
recommended by Mercedes-Benz.Warning!
G
When the engine is not running, the brake
and steering systems are without power as-
sistance. Under these circumstances, a
much greater effort is necessary to stop or
steer the vehicleWarning!
G
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking ef-
fect. Maintain a safe distance from vehicles
in front.
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating,
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an acci-
dent.
!Be very careful not to endanger other
road users when you apply the brakes.
Refer to the description of the Brake
Assist System (BAS) (
page 74).
Page 225 of 376
225 Operation
Driving instructions
After hard braking, it is advisable to drive
on for some time, rather than immediately
parking, so that the air stream will cool
down the brakes faster.
Driving off
Apply the brakes to test them briefly after
driving off. Perform this procedure only
when the road is clear of other traffic.
Warm up the engine smoothly. Do not
place full load on the engine until the oper-
ating temperature has been reached.
When starting off on a slippery surface, do
not allow one drive wheel to spin for an ex-
tended period with the ESP switched off.
Doing so may cause serious damage to the
drive train which is not covered by the
Mercedes-Benz Limited Warranty.
Parking
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
can result in an accident.!When driving down long and steep
grades, relieve the load on the brakes
by shifting into a lower gear to use the
engine’s braking power. This helps pre-
vent overheating of the brakes and re-
duces brake pad wear.
!Simultaneously depressing the
accelerator pedal and applying the
brake reduces engine performance and
causes premature brake and drivetrain
wear.
!Set the parking brake whenever park-
ing or leaving the vehicle. In addition,
move selector lever to positionP (man-
ual transmission: first or reverse gear).
In addition, when parking on hills,
always turn front wheels towards road
curb.
Page 265 of 376
265 Practical hints
What to do if …
Display
Possible cause
Suggested solution
3
(Canada
only)
;
(USA only)
BRAKE PAD WEAR
VISIT WORKSHOP!
The brake pads have reached their wear
limit.
Have the brake pads replaced as soon
as possible.
BRAKE FLUID
VISIT WORKSHOP!
There is insufficient brake fluid in the
reservoir.
Risk of accident! Stop the vehicle and
notify an authorized Mercedes-Benz
Center. Do not add brake fluid! This
will not solve the problem.
Warning!
G
Driving with this message displayed can re-
sult in an accident. Have your brake system
checked immediately. Don’t add brake fluid
before checking the brake system. Overfill-
ing the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and
the brake fluid catching fire. You can be se-
riously burned.
!If you find that the brake fluid in the
brake fluid reservoir has fallen to the
minimum mark or below, have the
brake system checked for brake pad
thickness and leaks.
!Brake pad thickness must be visually
checked by a qualified technican at the
intervals specified in the Service
booklet.
Page 349 of 376
349 Index
Automatic transmission 138
Accelerator position 143
Emergency operation
(Limp Home Mode) 143
Fluid level 238
Gear ranges 140
Gear selector lever position 141
Gear shifting malfunctions 143
Kickdown 143
Manual shifting 139
One-touch gearshifting 139
Program mode selector switch 142
Selector lever position 138
Starting with 44
Transmission fluid 238
Winter program mode 142
Auxiliary fuse box 313
B
BabySmart
TM
Airbag deactivation system 67, 341
Compatible child seats 67, 341
Self-test 67
Backrest
Folding forward 200
Folding rearward 200
Backrest tilt 33Backup lamps 291, 295
Bulbs 291
BAS 74, 341
Messages in display 263
Batteries, SmartKey
Changing 286, 287
Check lamp 85
Checking 86
Battery discharged
Jump starting 306
Battery, vehicle 240, 303
Charging 304
Disconnecting 304
Messages in display 278
Reconnecting 305
Reinstalling 304
Removing 304
Bi-Xenon headlamps* 341
Bi-Xenon type*
Front lamp bulbs 293
Block heater 246
Blocking
Rear door window operation 71
Bolts
For Minispare wheel 284
For spare wheel 282Brake assist system (BAS) 341
Brake fluid 332
Checking 234
Brake lamp bulbs 291
Brake lamp, high mounted 291
Brake pads
Message in display 265
Brakes 224
Warning lamp 258
Break-in period 222
Bulbs, replacing 290
Additional turn signals 290
Backup lamps 291
Brake lamps 291
Fog lamps 290
Front lamps 290
High beam 290
High mounted brake lamp 291
License plate lamps 291, 295
Low beam 290
Parking lamps 290, 291, 293, 294
Rear fog lamp 291, 295
Side marker lamps 290, 294
Standing lamps 290, 291, 293, 294
Tail lamp assemblies 291, 295
Turn signal lamps 290, 291
Page 359 of 376
359 Index
Mechanical key 285
Memory function* 98, 343
Recalling positions from memory 99
Storing exterior rear view mirror
parking positions 100
Storing key dependent settings 99
Menus 112
AUDIO 116
Control system 343
In control system 114, 115
Malfunction memory 118
NAVI* 118
Settings menu 119
Standard display 116
Submenus 113
TEL* 134
Trip computer 132
Microphone
Hands-free microphone 27
Miles/kilometers in speedometer
Setting 123
Minispare wheel 300
Bolts 284
Removing 283Mirrors
Activating exterior rear view mirror
parking position* 145
Adjusting 39
Automatic antiglare* for inside
mirror 144
Automatic antiglare* for rear view
mirror 144
Exterior rear view mirror 39
Exterior rear view mirror parking
positions 131
Inside rear view mirror 39
Storing exterior rear view mirror
parking position* 100
MON (Motor Octane Number) 234, 343
Mph or km/h in speedometer 123
Multicontour seat* 96
Multifunction display 111, 343
Selecting language 124
Standard display 115
Multifunction display messages
ABS 262
BAS 263
Battery 278
Brake fluid 265
Brake pads 265Check engine 259
Coolant 267
Coolant level 266
Display 278
Doors 272
Engine 259
Engine oil level 270
ESP 269
Fuel reserve tank 272
Hood 272
Key 272
Lamps 272–275
Parking brake 264
Steering column not properly
locked 276
Steering gear oil level 276
Tele Aid* 277
Telephone* 277
Trunk lid 272
Washer fluid 278
Multifunction steering
wheel 24, 112, 343
Buttons 112