MERCEDES-BENZ C240 2003 W203 Owner's Manual

311 Practical hints
Towing the vehicle
Installing towing eye bolt
1Cover on right side of front bumper.2Cover on right side of rear bumper.Removing cover

Press mark on cover in direction of ar-
row.

Lift cover off to reveal threaded hole for
towing eye bolt.
The towing eye bolt is supplied with the
tool kit (located behind the left hand trim
panel in cargo area).

Screw towing eye bolt in to its stop and
tighten with lug wrench.
Reinstalling cover

Fit cover and snap into place.

312 Practical hintsFuses
FusesFuse box in passenger compartment
1CoverOpening

Pull cover1 open with a screw driver or
similar tool.

Remove cover1 rearward.
Closing

Attach the cover1 in the front.

Fold the cover1 in until it engages.
Fuse chart
The fuse chart is found in the fuse box in
the passenger compartment. The amper-
ages of the fuses are also given there.
Fuse box in engine compartment
The fuse box is located in the engine com-
partment on the left hand side.
1Screw
2Cover
3Retainer
Removing/installing cover
Twist screws1 90° counterclockwise.

Pull up cover2.

Slide out retainer3 and remove cover
by pulling towards front.

Install cover2 in reverse order.
iOnly install fuses that have been tested
and approved by Mercedes-Benz and
that have the specified amperage rat-
ing.
Never attempt to repair or bridge a
blown fuse. Have the cause determined
and remedied by an authorized
Mercedes-Benz Center.

313 Practical hintsFuses
Opening fuse box
4Fuse box cover
5Clamps
Release clamps5.

Remove cover4.
Closing fuse box

Ensure that the sealing rubber is prop-
erly positioned.

Press the cover4 down and secure
with clamps5.
Auxiliary fuse box in trunk
The auxiliary fuse box is located in the
trunk.
1Trim panel
2Cover of auxiliary fuse box
3Special fuse extractor
Opening
Pull away trim panel1.

Remove cover2.Spare fuses
Spare fuses are found in the vehicle tool kit
in the spare wheel well.

314

315 Technical data
Spare parts service
Warranty coverage
Identification labels
Layout of poly-V-belt drive
Engine
Rims and Tires
Electrical system
Main dimensions
Weights
Fuels, coolants, lubricants etc.
Consumer information

316 Technical dataSpare parts serviceThe “Technical data” section provides the
necessary technical data for your vehicle.
Spare parts serviceAll authorized Mercedes-Benz Centers
maintain a stock of original spare parts re-
quired for maintenance and repair work. In
addition, strategically located parts distri-
bution centers provide quick and reliable
parts service.
More than 300 000 different spare parts
for Mercedes-Benz models are available.
Mercedes-Benz original spare parts are
subject to stringent quality inspections.
Each part has been specifically developed,
manufactured or selected for and adapted
to Mercedes-Benz vehicles.
Therefore, Mercedes-Benz original spare
parts should be installed.
!The use of non-genuine parts and
accessories not authorized by
Mercedes-Benz could damage the
vehicle, which is not covered by the
Mercedes-Benz Limited Warranty, or
could compromise the vehicle’s dura-
bility or safety.

317 Technical data
Warranty coverage
Warranty coverage
Your vehicle is covered under the terms of
the “warranties” printed in the Service and
Warranty Information booklet. Your
authorized Mercedes-Benz Center will ex-
change or repair any defective parts origi-
nally installed in the vehicle in accordance
with the terms of the following warranties:

New Vehicle Limited Warranty


Emission System Warranty


Emission Performance Warranty


California, Maine, Massachusetts, and
Vermont Emission Control Systems
WarrantyReplacement parts and accessories are
covered by the Mercedes-Benz Spare Parts
and Accessories warranties, copies of
which are available at any Mercedes-Benz
Center.Loss of Service and Warranty
Information Booklet
Should you lose your Service and Warranty
Information booklet, have your authorized
Mercedes-Benz Center arrange for a re-
placement. It will be mailed to you.

318 Technical dataIdentification labels
Identification labels1Certification label2Vehicle Identification Number (VIN)3Information label, California version
Vacuum line routing for emission con-
trol system
4Engine number (engraved on engine)
5VIN, visible (lower edge of windshield)
6Emission control label
When ordering spare parts, please specify
vehicle identification and engine numbers.

319 Technical data
Layout of poly-V-belt drive
Layout of poly-V-belt drive
C 230 Kompressor Sport
1Power steering pump
2Idler pulley
3Mechanical loader
4Automatic belt tensioner
5Air conditioning compressor
6Crankshaft
7Coolant pump
8Generator (alternator)
C240 / C320 (all models)
1Idler pulley
2Automatic belt tensioner
3Power steering pump
4Air conditioning compressor
5Crankshaft
6Coolant pump, fan
7Generator (alternator)
C32AMG
1Idler pulley
2Idler pulley
3Supercharger
4Automatic belt tensioner
5Power steering pump
6Air conditioning compressor
7Crankshaft
8Coolant pump, fan
9Generator (alternator)

320 Technical dataEngine
EngineModel
C 230 Kompressor Sport (203.040)
1
1The quoted data apply only to the standard vehicle. See an authorized Mercedes-Benz Center for the corresponding data of all special bodies and
special equipment.
C 240 (203.061)
1
C 240 4MATIC (203.081)
1
Engine
271
112
Mode of operation
4-stroke engine, gasoline injection
4-stroke engine, gasoline injection
No. of cylinders
4
6
Bore
3.23 in (82.00 mm)
3.54 in (89.90 mm)
Stroke
3.35 in (85.00 mm)
2.68 in (68.20 mm)
Total piston displacement
109.6 cu.in. (1 796 cm
3)
158.5cu.in. (2597cm
3)
Compression ratio
8.5:1
10.5:1
Output acc. to SAE J 1349
189 hp / 5 800 rpm
(141 kW / 5 800 rpm)
167 hp / 6 000 rpm
(125 kW / 6 000 rpm)
Maximum torque
acc. to SAE J 1349
192ft.lb/3500rpm
(260 Nm / 3 500 rpm)
177 ft.lb / 4 500 rpm
(240 Nm / 4 500 rpm)
Maximum engine speed
6000 rpm
6 200 rpm
Firing order
1-3-4-2
1-4-3-6-2-5
Poly-V-belt
7ft 11in (2420mm)
7 ft 10 in (2 390 mm)