key battery MERCEDES-BENZ CL55AMG 2003 C215 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2003, Model line: CL55AMG, Model: MERCEDES-BENZ CL55AMG 2003 C215Pages: 384, PDF Size: 6.42 MB
Page 31 of 384
31 Getting started
Unlocking
Starter switch positionsStarter switch0For removing key
1Power supply for some electrical con-
sumers, such as seat adjustment
2Ignition (power supply for all electrical
consumers) and driving position
3Starting position
Warning!
G
When leaving the vehicle, always remove the
key from the starter switch, take the
KEYLESS-GO* card with you and lock the ve-
hicle. Do not leave children unattended in
the vehicle, or with access to an unlocked
vehicle. Unsupervised use of vehicle equip-
ment may cause an accident and/or serious
personal injury.iThe SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
!If the key is left in starter switch posi-
tion 0 for an extended period of time, it
can no longer be turned in the starter
switch.
Remove the key from the starter
switch and reinsert.
If the key can still not be turned, the
battery may not be sufficiently
charged.
Check the battery and charge it
if necessary (
page 313).
Get a jump start (
page 316).
To prevent accelerated battery dis-
charge or a completely discharged bat-
tery, always remove the key from the
starter switch.
Page 44 of 384
44 Getting startedDrivingStarting difficulties
If the engine does not start as described
above, carry out the following steps:
If you are starting the engine with the
SmartKey, turn key in starter switch to
position0 and repeat starting proce-
dure.
If you are starting the engine with
KEYLESS-GO: Close all doors to allow
for better detection of the KEYLESS-GO
card.
Or:
Start the engine with the key as radio
signals from another source may be in-
terfering with the KEYLESS-GO card.
Repeat the starting procedure
(page 42). Remember that extended
starting attempts can drain the battery.
Get a jump start (
page 316).
If the engine does not start after several
starting attempts, there could be a mal-
function in the engine electronics or in the
fuel supply system.
Notify an authorized Mercedes-Benz
Center.
Parking brake
1Parking brake pedal
2Parking brake release handle
Release the parking brake by pulling on
handle2.
The indicator lamp
;
(USA only) or
3
(Canada only) in the instrument
cluster goes out.
Warning!
G
When leaving the vehicle, always remove the
key from the starter switch, take the KEY-
LESS-GO* card with you and lock the vehi-
cle. Do not leave children unattended in the
vehicle, or with access to an unlocked vehi-
cle. Children could release the parking
brake, which could result in an accident
and/or serious injury.
Page 76 of 384
76 Safety and SecurityAnti-theft systems
Anti-theft systemsImmobilizer
The immobilizer prevents unauthorized
persons from starting your vehicle.
Activating
With the SmartKey: Removing the key
from the starter switch activates the
immobilizer.
With KEYLESS-GO*: Turning off the en-
gine by means of the KEYLESS-GO
start/stop button on the gear selector
lever activates the immobilizer.Deactivating
With the SmartKey: Inserting the key in
the starter switch deactivates the im-
mobilizer.
With KEYLESS-GO*: Starting the en-
gine by means of the KEYLESS-GO
start/stop button on the gear selector
lever deactivates the immobilizer.
iIn case the engine cannot be started
(yet the vehicle’s battery is charged),
the system is not operational. Contact
an authorized Mercedes-Benz Center
or call 1-800-FOR-MERCedes (in the
USA), or 1-800-387-0100 (in Canada).
Page 80 of 384
80 Controls in detailLocking and unlockingIn the “Controls in detail” section you will
find detailed information on how to oper-
ate the equipment installed on your vehi-
cle. If you are already familiar with the
basic functions of your vehicle, this section
will be of particular interest to you.
To quickly familiarize yourself with the ba-
sic functions of the vehicle, refer to the
“Getting started” section of this manual.
The corresponding page numbers are giv-
en at the beginning of each segment.
Locking and unlockingInformation on locking and unlocking can
be found in the “Getting started” section
on (
page 30) and (
page 49).
SmartKey
Your vehicle comes supplied with two
SmartKeys with remote controls and a re-
movable mechanical key. The locking tabs
for the mechanical key portion of the two
SmartKeys are a different color to help dis-
tinguish each SmartKey unit.
The SmartKey provides an extended oper-
ating range. To prevent theft, however, it is
advisable to only unlock the vehicle when
you are in close proximity to it.
The SmartKey centrally locks and unlocks:
the doors
the trunk
the fuel filler flap
SmartKey with remote controls1‹
Lock button
2
Š
Unlock button for trunk lid
3 Mechanical key locking tab
4
Œ
Unlock button
5Battery check lamp
6
Â
Panic button (
page 70)
iYou can also open and close the power
windows (
page 171) and sliding /
pop-up roof using the SmartKey
(
page 174).
Page 81 of 384
81 Controls in detail
Locking and unlocking
Factory setting
Global unlocking
Press button
Œ
.
All turn signal lamps blink once. The
locking knobs in the doors move up.
The anti-theft alarm system is switched
off. If it is dark, the locator lighting
switches on.
The vehicle will lock again automatically
within approximately 40 seconds of un-
locking if:
neither door nor trunk is opened
the SmartKey is not inserted in the
starter switch
the central locking switch is not acti-
vatedGlobal locking
Press button
‹
.
All turn signal lamps blink three times.
The locking knobs in the doors move
down.
The anti-theft alarm system is activat-
ed.
Selective setting
If you frequently travel alone, you may wish
to reprogram the key so that
pressing
Œ
only unlocks the driver’s
door and the fuel filler flap.
Press and hold buttons
Œ
and
‹
simultaneously for about five seconds
until battery check lamp5 blinks twice.
The key will then function as follows:
Unlocking driver’s door and fuel filler
flap
Press button
Œ
once.
Global unlocking
Press button
Œ
twice.Global locking
Press button
‹
.
Restoring to factory setting
Press and hold buttons
Œ
and
‹
simultaneously for about six seconds
until battery check lamp5 blinks twice.
!To prevent possible malfunction, avoid
exposing the key to high levels of elec-
tromagnetic radiation.
Warning!
G
When leaving the vehicle, always remove the
key from the starter switch, take the
KEYLESS-GO* card with you and lock the ve-
hicle. Do not leave children unattended in
the vehicle, or with access to an unlocked
vehicle. It is possible for children to open a
locked door from the inside, which could re-
sult in an accident and/or serious injury.
Page 82 of 384
82 Controls in detailLocking and unlockingChecking the batteries
Press button
‹
or
Œ
.
Battery check lamp5 lights up briefly
to indicate that the key batteries are in
order.Unlocking the trunk lid
You can unlock the trunk separately.
A minimum height clearance of 6.1 ft
(1.90 m) is required to open the trunk lid.
Press and hold button
Š
until trunk
unlocks.Loss of SmartKey or mechanical key
If you lose a SmartKey or mechanical key,
you should do the following:
Have the SmartKey deactivated by an
authorized Mercedes-Benz Center.
Report the loss of the SmartKey or the
mechanical key immediately to your
car insurance company.
If necessary, have the mechanical lock
replaced.
Your authorized Mercedes-Benz Center
will be glad to supply you with a replace-
ment.
!If you can no longer lock or unlock the
vehicle with the key, then either the
batteries in the SmartKey are dis-
charged or the key is malfunctioning.
Check the batteries in the key and
replace them if necessary
(page 299).
or
Use the mechanical key to unlock
the doors (
page 297) and trunk
(
page 298) as required. Lock the
vehicle using the mechanical key
(page 298).
If the key is malfunctioning, contact an
authorized Mercedes-Benz Center.
!If battery check lamp5 does not light
up briefly during check, then the key
batteries are discharged.
Replace the batteries (
page 299).
You can obtain the required batteries
at any authorized Mercedes-Benz Cen-
ter.
!The trunk lid swings open automatical-
ly. Always make sure that there is suffi-
cient overhead clearance.
iIf the vehicle was previously centrally
locked with the SmartKey, the trunk lid
will lock automatically after closing it.
The turn signals will flash three times to
confirm locking.
If the trunk was previously separately
locked (
page 90), the trunk lid will re-
main locked.
Page 85 of 384
85 Controls in detail
Locking and unlocking
Press and hold the programming
button1 until the “Driver’s door”
symbol2 lights up.
The KEYLESS-GO card will then func-
tion as follows:
Unlocking the driver’s door
Grasp the driver’s door handle.
Global unlocking
Grasp the door handle on the pas-
senger side.
Global locking
Press lock button at door handle or
trunk.
Restoring to factory setting
Press and hold the programming
button1 until the “Global unlock”
symbol3 lights up.Checking the batteries
Briefly press the programming
button1.
The KEYLESS-GO card batteries are in
order if the indicator lamp for either the
“Driver’s door”2 or “Global unlock”3
comes on red or green.
!If you cannot lock or unlock the vehicle
with the KEYLESS-GO card, then either
the batteries of the KEYLESS-GO card
are discharged or the KEYLESS-GO
card is malfunctioning or the vehicle
battery is drained.
Check the batteries of the
KEYLESS-GO card (
page 85) and
replace them if necessary
(
page 299).
or
Use the mechanical key to unlock
the doors (
page 297) and trunk
(
page 298) as required. Lock the
vehicle using the mechanical key
(page 298).
If your KEYLESS-GO card is malfunc-
tioning, contact your authorized
Mercedes-Benz Center.
!If the symbols2 or3 do not light up
during the check, then the batteries of
the KEYLESS-GO card are discharged.
Change the batteries (
page 299).
You can obtain the batteries at any au-
thorized Mercedes-Benz Center.
Page 167 of 384
167 Controls in detail
Automatic climate control
Residual heat and ventilation
With the engine switched off, it is possible
to continue to heat or ventilate the interior
for up to 30 minutes. This feature makes
use of the residual heat produced by the
engine.
Activating
Turn the key in the starter switch to
position1 o r r e m o v e i t f r o m t h e s t a r t e r
switch.
Press button
T
(page 159).
The indicator lamp on button
T
comes on.Deactivating
Press button
T
(page 159).
The indicator lamp on button
T
goes off.
The residual heat is automatically turned
off:
when the ignition is switched on
after about 30 minutes
if the battery voltage dropsVentilated storage compartment under
armrest
The storage compartment under the arm-
rest (
page 200) can be ventilated when
the automatic air conditioning is switched
on. The switch is located inside the storage
compartment in the front. The air tempera-
ture is about the same as that of the center
air vents.
The air volume is dependent on the setting
of:
Air distribution control
Air volume control
Air vents in the dashboard
The air temperature is about the same as
that of the dashboard air vents. It cannot
be regulated separately.
iHow long the system will provide heat-
ing depends on the coolant tempera-
ture and the temperature set by the
operator. The blower will run at speed
setting1 regardless of the air distribu-
tion control setting.
Page 172 of 384
172 Controls in detailPower windowsClosing the side windows and sliding /
pop-up roof with KEYLESS-GO*
Press and hold lock button at door
(page 52) until the side windows and
the sliding / pop-up roof are closed.
Synchronizing power windows
The power windows must be resynchro-
nized each time after the battery has been
disconnected:
Push the power window switches until
the side windows are closed and hold
the switches for approximately one
second.
Warning!
G
When closing the windows and the sliding /
pop-up roof, make sure that there is no dan-
ger of anyone being harmed by the closing
procedure.
The windows will not automatically re-open
if blocked during convenience closing.
If potential danger exists, proceed as fol-
lows:
SmartKey
Release the
‹
button.
Press and hold the
Œ
button until
the windows and the sliding / pop-up
roof open again.
KEYLESS-GO*
Release the lock button.
Pull on the door handle and hold firmly.
The side windows and the
sliding / pop-up roof will open for as long
as the door handle is held but the door
not opened.
Page 175 of 384
175 Controls in detail
Sliding / pop-up roof
Opening (Summer opening feature)
Press and hold button
Œ
after un-
locking the vehicle.
The windows and sliding / pop-up roof
begin to open after approximately one
second.
Release the
‹
button to stop proce-
dure.
Closing (Convenience feature)
Press and hold button
‹
after lock-
ing the vehicle.
The windows and sliding / pop-up roof
begin to close after approximately one
second.
Release the
‹
button to stop proce-
dure.
Make sure that all side windows and the
sliding / pop-up roof are properly closed
before leaving the vehicle.Closing the side windows and sliding /
pop-up roof with KEYLESS-GO*
(Convenience feature)
Press and hold lock button at door
(page 52) until the side windows and
the sliding / pop-up roof are closed.
Synchronizing the sliding / pop-up roof
The power sliding / pop-up roof must be re-
synchronized each time after:
the battery has been disconnected
the sliding / pop-up roof has been
closed manually
the sliding / pop-up roof does not open
smoothly
a malfunction
Press the switch in direction1
(page 173).
Wait until the sliding / pop-up roof is
raised and hold the switch down for
approx. one second.
Warning!
G
When closing the windows and the sliding /
pop-up roof, make sure that there is no dan-
ger of anyone being harmed by the closing
procedure.
If potential danger exists, proceed as fol-
lows:
Release the lock button.
Pull on the door handle and hold firmly.
The side windows and the
sliding / pop-up roof will open for as long
as the door handle is held but the door
not opened.