rear view mirror MERCEDES-BENZ CLK CABRIOLET 2000 A208 User Guide
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2000, Model line: CLK CABRIOLET, Model: MERCEDES-BENZ CLK CABRIOLET 2000 A208Pages: 323, PDF Size: 9.32 MB
Page 155 of 323

Garage door opener
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index For operation in the USA only: This device complies 
with Part 15, Subpart C, Section 209 of the FCC Rules. 
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, 
including interference that may cause undesired 
operation.
WARNING: Changes or modification not expressly 
approved by party responsible for compliance could void 
the user’s authority to operate the equipment.
Programming or reprogramming the integrated 
remote control:
1. Turn electronic key in steering lock to position 1 
or 2.
2. Hold the end of the hand-held transmitter of the 
device you wish to train approximately 2 to 5 inches 
(5 cm to 12 cm) away from the surface of the 
integrated remote control located on the inside rear 
view mirror, keeping the indicator lamp in view.3. Using both hands, simultaneously push the hand-
held transmitter button and the desired integrated 
remote control button. Do not release the buttons 
until completing step 4.
4. The indicator lamp on the integrated remote control 
will flash, first slowly and then rapidly. When the 
indicator lamp flashes rapidly, both buttons may be 
released (the rapid flashing lamp indicates 
successful programming of the new frequency 
signal). To program the remaining two buttons, 
follow steps 1 though 4.
Note: 
If after repeated attempts, you do not successfully 
program the integrated remote control device to learn 
the signal of the hand-held transmitter, the garage door 
opener could be equipped with the “rolling code 
feature”.
155 
Page 174 of 323

Tele Aid
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Te l e  A i d  
The electronic key in the steering lock must be in position 
1 or 2 for the Tele Aid to be operational.Important!
The initial activation of the Tele Aid system may only be 
performed by completing the subscriber agreement and 
placing an acquaintance call using the “SOS” button. 
Failure to complete either of these steps will result in a 
system that is not activated. 
If you have any questions regarding activation, please 
call the Response Center at 1-800-756-9018 (in the USA) 
or 1-888-923-8367 (in Canada).
(Te l ematic Alarm Identification on Demand)
The Tele Aid system consists of three types of response; 
automatic and manual emergency, roadside assistance 
and information.Emergency calls
An emergency call is initiated automatically
following an accident in which the Emergency 
Tensioning Retractors (ETR’s) or airbags deploy,
  An emergency call can also be initiated manually by 
opening the cover next to the inside rear view mirror 
labeled “SOS”, then pressing the button (for longer than 
2 seconds) located under the cover. Once the emergency
 call is in progress, the indicator 
lamp in the “SOS”
 button will begin to f lash.   All information relevant to the 
emergency, such as the location of the vehicle 
(determined by the GPS satellite location system), 
vehicle model, identification number and color are 
generated.
A voice connection between the Response Center and 
the occupants of the vehicle will be established 
automatically soon after the emergency call has been 
initiated. The Response Center will attempt 
to determine more precisely the nature of the accident 
provided they can speak to an occupant of the vehicle.
174