oil additives MERCEDES-BENZ CLK CABRIOLET 2000 A208 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2000, Model line: CLK CABRIOLET, Model: MERCEDES-BENZ CLK CABRIOLET 2000 A208Pages: 323, PDF Size: 9.32 MB
Page 6 of 323
Headlamps, taillamps, turn signal
lenses 294Technical data
Wiper blade 294 Spare parts service 300 Coolants 311
Seat belts 294 Warranty coverage 300 Consumer information 313
Headliner 294 Identification labels301 Uniform tire quality grading 313
Instrument cluster 294 Layout of poly-V-belt drive 302 Index 315
Steering wheel and gear selector lever 295 Technical data 303
Hard plastic trim items 295 Fuels, coolants, lubricants etc. –
capacities 307
Upholstery 295 Engine oils 309
Ornamental moldings 295 Engine oil additives 309
Paintwork, painted body components 296 Air conditioner refrigerant 309
Light alloy wheels 296 Brake fluid 309
Soft top 297 Premium unleaded gasoline 310
Wind screen 298 Fuel requirements 310
Rubber weatherstrip 298 Gasoline additives 311
6
Page 299 of 323
Technical dataSpare parts service 300
Warranty coverage 300
Identification labels 301
Layout of poly-V-belt drive 302
Technical data 303
Fuels, coolants, lubricants etc. – capacities 307
Engine oils 309
Engine oil additives 309
Air conditioner refrigerant 309
Brake fluid 309
Premium unleaded gasoline 310
Fuel requirements 310
Gasoline additives 311
Coolants 311
Consumer information 313
Uniform tire quality grading 313
Index 315
299
Page 309 of 323
Fuels, coolants, lubricants etc.
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car care Index Engine oils
Engine oils are specifically tested for their suitability in
our engines. Therefore, use only engine oils
recommended by Mercedes-Benz. Information on
recommended brands is available at your authorized
Mercedes-Benz Center.
Please follow Service Booklet recommendations for
scheduled oil changes. Failure to do so could result in
engine damage not covered by the Mercedes-Benz
Limited Warranty.
Engine oil additives
Do not blend oil additives with engine oil. They may be
harmful to the engine operation.
Damage or malfunctions resulting from blending oil
additives are not covered by the Mercedes-Benz Limited
War ra nt y.Air conditioner refrigerant
R-134a (HFC) refrigerant and special PAG lubricating oil
is used in the air conditioner system.
Never use R-12 (CFC) or mineral-based lubricating oil,
otherwise damage to the system will occur.
Brake fluid
During vehicle operation, the boiling point of the brake
fluid is continuously reduced through the absorption of
moisture from the atmosphere. Under extremely hard
operating conditions, this moisture content can lead to
the formation of bubbles in the system thus reducing
the system’s efficiency.
The brake fluid must therefore be replaced every two
years, preferably in the spring.
It is recommended to use only brake fluid approved by
Mercedes-Benz. Your authorized Mercedes-Benz Center
will provide you with additional information.
309
Page 311 of 323
Fuels, coolants, lubricants etc.
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car care Index Gasoline additives
A major concern among engine manufacturers is carbon
build up caused by gasoline. Mercedes-Benz
recommends the use of only quality gasoline containing
additives that prevent the build up of carbon deposits.
After an extended period of using fuels without such
additives, carbon deposits can build up especially on the
intake valves and in the combustion area, leading to
engine performance problems such as:
•warm-up hesitation,
•unstable idle,
•knocking/pinging,
•misfire,
•power loss.
Do not blend other specific fuel additives with fuel.
They only result in unnecessary cost, and may be
harmful to the engine operation.
Damage or malfunctions resulting from poor fuel
quality or from blending specific fuel additives are not
covered by the Mercedes-Benz Limited Warranty.Coolants
The engine coolant is a mixture of water and
anticorrosion/antifreeze, which provides:
•corrosion protection,
•freeze protection,
•boiling protection (by increasing the boiling point).
The cooling system was filled at the factory with a
coolant providing freeze protection to approximately
-22°F (-30°C) and corrosion protection.
If the antifreeze mixture is effective to -22°F (-30°C), the
boiling point of the coolant in the pressurized cooling
system is reached at approximately 266°F (130°C).
The coolant solution must be used year round to provide
the necessary corrosion protection and increase in the
boil-over protection. You should have it replaced every
3years.
To provide the important corrosion protection, the
solution must be at least 45% anticorrosion/antifreeze
(equals a freeze protection to approx. - 22°F [-30°C]). If
you use a solution that is more than 55% anticorrosion/
antifreeze (freeze protection to approx. - 49°F [-45°C]),
311
311
Page 318 of 323
ELEC. STABIL PROGR. - malfunction and
war ning mes sag es ............................................. 234
Electronic main key ................................................25
Changing batteries.............................................277 Syn ch ron izin g r emote c on tr ol ............................ 279
Electronic stability program (ESP)
M a l fu n ct i on i n d i ca t or l a m p . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 219 W a r n i n g l a m p . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 219
Emergency tensioning retractor (ETR) .....................64 Emergency unlocking in case of accident .................38 E m i ss i on c on t r ol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 173 Engine compartment .............................................. 244 ENGINE FAN - malfunction and
war ning mes sag es .............................................. 227
En gin e oil additives ................................................ 309 Engine oil consumption 111 Engine oil level
Checking..................................................... 110, 246
ENGINE OIL LEVEL - malfun ction and
war ning mes sag es .............................................. 232
Engine oil level indicator
110
ENGINE OIL LEVEL NOT WHEN ENGINE ON
(measuring) - multifunction indicator
111
ENGINE OIL TEMP
- malfunction and warning messages..................232
Engine oils .............................................................309 ESP (Electr onic stability pr ogram) ...........................208
Control switch ....................................................209 Synchronizing ....................................................209
Exterior lamp switch 112 Exterior lamps
Adjusting headlamp aim .....................................274 Low and high beam ...........................................271 Parking lamps ....................................................271 Replacing bulbs ................................................. 269 Side mar ker lamp, fr on t ..................................... 273 S t an di n g l am p s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 271 Taillamp assemblies ........................................... 272 Turn signal lamp ...............................................271
318