brake light MERCEDES-BENZ CLK430 2001 C208 User Guide

231 Malfunction and indicator lamps
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car care Index Electronic stability program (ESP) — warning lamp
The yellow ESP warning lamp in the
speedometer dial comes on with the
electronic key in steering lock position 2.
It should go out with engine running.
See page 219 if the warning lamp lights up or f lashes
when the vehicle is moving.
BAS / ESP malfunction indicator lamp
The malfunction indicator lamp for the ESP
is combined with that of the BAS.
The yellow BAS/ESP malfunction indicator
lamp in the instrument cluster comes on with the
electronic key in steering lock position 2. It should go
out with the engine running.
If the BAS/ESP malfunction indicator lamp remains
illuminated with the engine running, see page 215 for
notes on the brake assist (BAS) and page 219 for notes
on the electronic stability program (ESP).ABS malfunction indicator lamp
The ABS malfunction indicator lamp in the
instrument cluster comes on with the
e l e c tr o n ic key i n ste e ri n g l oc k p os i ti o n 2 a n d
should go out with the engine running.
When the ABS malfunction indicator lamp symbol and
warning in the instrument cluster remains illuminated
while the engine is running, it indicates that the ABS
has detected a malfunction and has switched off. In this
case, the brake system functions in the usual manner,
but without antilock assistance.
With the ABS malfunctioning, the BAS and ESP are also
switched off. Both malfunction indicator lamps come on
with the engine running.
If the charging voltage falls below 10 volts, the
malfunction indicator lamp comes on and the ABS is
switched of f. Wh en t he voltage is a bove th is value a gain,
the malfunction indicator lamp should go out and the
ABS is operational.
Have the system checked at your authorized
Mercedes-Benz Center as soon as possible.
See page 217 for notes on the antilock brake system
(ABS).
BAS
ESP
ABS

241 Malfunction and warning messages
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car care Index LIGHTING SYSTEMWhen the message appears after starting the engine, or
if it comes on while driving, this indicates a failure in
the parking lamp, taillamp, stop lamp, or low beam
headlamp. See page 275 for instructions on replacing
bulbs.
If an exterior lamp fails, the message will appear only
when that lamp is switched on.
If a brake lamp fails, the message will appear when
applying the brake and stays on until the engine is
turned off.
Note:
If additional lighting is installed (e.g. auxiliary
headlamps etc.) be certain to connect into the fuse
before the failure indicator monitoring unit order to
avoid damaging the system.
Line 1 Line 2
LAMP DEFECTIVE CHECK LAMPS!
DISPLAY DEFECTIVE VISIT WORKSHOP!

271 Jump starting
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index Proceed as follows:
1. Position the vehicle with the charged battery so that
the jumper cables will reach, but never let the
vehicles touch. Make sure the jumper cables do not
have loose or missing insulation.
2. On both vehicles:
•Turn off engine and all lights and accessories,
except hazard warning f lashers or work lights.
•Apply parking brake and shift selector lever to
position “P”.
Important!
3. Clamp one end of the first jumper cable to the
positive (+) under hood terminal of the discharged
battery and the other end to the positive (+) terminal
of the charged battery. Make sure the cable clamps
do not touch any other metal parts.
4. Clamp one end of the second jumper cable to the
grounded negative (–) terminal of the charged
battery and the final connection to the negative (–)
terminal (2) of the discharged battery.Important!
5. Start engine of the vehicle with the charged battery
and run at high idle. Make sure the cables are not
on or near pulleys, fans, or other parts that move
when the engine is started. Allow the discharged
battery to charge for a few minutes. Start engine of
the disabled vehicle in the usual manner.
6. After the engine has started, remove jumper cables
by exactly reversing the above installation
sequence, starting with the last connection made
first. When removing each clamp, make sure that it
does not touch any other metal while the other end
is still attached.
Notes:
If engine does not run after several unsuccessful
starting attempts, have it checked at the nearest
authorized Mercedes-Benz Center.
Excessive unburned fuel may damage the catalytic
converter.

319 Index
Te ch n ica l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car careIndex Lighter ............................................................................. 159
LIGHTING SYSTEM - malfunction
and warning messages ............................................ 241
Limp home mode (Automatic transmission) ............. 201
Loading instructions ..................................................... 162
Locking and unlocking ................................................... 30
Low engine coolant level warning ..............................239
MMaintenance ................................................................... 177
Malfunction and indicator lamps
in the instrument cluster .........................................228
Malfunction and warning messages ...........................233
ABS-SYSTEM .............................................................236
BATTERY/ALTERNATOR ..........................................235
BRAKE ASSIST ..........................................................236
BRAKE FLUID ............................................................237
BRAKE LINING WEAR .............................................237
COOLANT (coolant level) .........................................239
COOLANT TEMP. (coolant temperature) ...............240
DISPLAY DEFECTIVE
(engine control unit) ...........................................234
DISPLAY DEFECTIVE
(several systems) ..................................................234
ELEC. STABIL. PROGR. ............................................244ENGINE FAN ............................................................. 238
ENGINE OIL LEVEL ................................................. 243
LIGHT SENSOR ......................................................... 242
LIGHTING SYSTEM ...................................................241
PARKING BRAKE ..................................................... 238
REMOVE KEY ........................................................... 244
STEER. WHEEL ADJUST. ......................................... 242
TELE AID ................................................................... 246
WASHER FLUID ........................................................ 245
Malfunction message memory ....................................106
Manual operation of sliding/pop-up roof .................. 286
Mechanical keys ............................................................... 33
Memory .............................................................................48
Recalling ....................................................................... 49
Storing .................................................................... 48, 81
Mirror, exterior, adjusting ..............................................80
Mirror, exterior, rear view ..............................................80
Mirror, inside, rear view ................................................. 79
Multicontour seat ............................................................. 55
Multifunction display ...................................................... 90
Engine oil level indicator ...........................................94
FSS (Flexible service system) ................................... 94
Setting the audio volume ......................................... 110
Trip and main odometer ............................................ 94
Vehicle speed ............................................................... 94
Multifunction steering wheel .........................................90