lock MERCEDES-BENZ CLS 2014 Owners Manual

the systemmay still display thetire
pressure of theremovedwheel forafew
minutes. The value displayed for the
mountedemergencysparewheel is notthe
same as the current tire pressure of the
emergency spare wheel.
"Minispare" emergency sparewheel/
collapsible sparewheel
Removing the "Minispare" emergency
sparewheel
The emergency spare wheel can be found in
the stowage well under the trunk floor.
XLift the trunk floor upwards (Ypage 283).
XTurn stowage traycounter-clockwise
and remove together with vehicle tool kit
tray.
XRemove "Minispare" emergency spare
wheel$.
Removing the collapsible sparewheel
(AMG vehicles)
The emergency spare wheel can be found in
the stowage wellunderthe trunk floor.
XLift the trunk floor upwards (Ypage 283).
XReach into cutoutin the tool holder and
lift it up.
XRemove collapsiblespare wheel.
Always observe the instructions and safety
notes in the "Mountingawheel" section
(Ypage 358).
Stowingaused collapsible spare
wheel
!Only place the collapsible spare wheel in
the vehicle when it is dry. Otherwise,
moisture may get into the vehicle.
Take the following steps to stowaused
collapsible spare wheel. It will not otherwise
install into the spare wheel well. Mercedes-
Benz recommends that you have this work
performed ataqualified specialist workshop,
e.g. at an authorized Mercedes-Benz Center.
XUnscrew the valve cap from the valve.
XUse the back of the valve cap to unscrew
the valve insert from the valve and release
the air.
iFully deflating the tires can takeafew
minutes.
XScrew the valve insert back into the valve.
XScrew the valve cap back on.
XRemove the protective sheet from the
vehicle tool kit and pull it over the
collapsible spare wheel.
XStow the collapsible spare wheel in the
emergency spare wheel well under the
trunk.
Inflating the collapsible sparewheel
!Inflate the collapsible spare wheel using
the tire inflation compressor before
lowering the vehicle. The wheel rim could
otherwise be damaged.
368Emergency sparewheel
Wheels and tires

!Do not operate the tire inflation
compressor for longer than eight minutes
atatime withoutabreak. It may otherwise
overheat.
The tire inflation compressor can be
operated againonce it hascooleddown.
XMount the collapsiblespare wheelas
described (Ypage 357).
The collapsible spare wheel must be
mounted before it is inflated.
XPull connector!and the air hose out of
the housing.
XRemove the cap from the valve on the
collapsible spare wheel.
XScrew union nuton the air hose ontothe
valve.
XMake sure on/off switchof the tire
inflation compressor is set to0.
XInsert connector!intothe cigarette
lighter socket or intoa12Vsocket in your
vehicle.
Observe the notes on the cigarettelighter
(Ypage 288). Observe the notes on
sockets(Ypage 289).
XTurn the SmartKey to position1in the
ignition lock (Ypage 147).
XPress on/offswitchon thetireinflation
compressor toI.
The tireinflationcompressor is switched
on. The tire is inflated. The tire pressure is
shown on pressure gauge$.
XInflate the tire to the specified tire
pressure.
The specified tire pressure is printed on the
yellow label of the emergencyspare wheel.
XWhen the specified tire pressure has been
reached, press on/offswitchon the
electric air pump to0.
The tireinflationcompressor is switched
off.
XTurn the SmartKey to position0in the
ignition lock.
XIf the tire pressure is higher than the
specified pressure, press pressure release
buttonuntil the correcttire pressure has
been reached.
XUnscrew union nuton the air hose from
the valve.
XScrew the valve cap ontothe collapsible
spare wheel valve again.
XStow plug!and the air hose in the lower
section of the blower housing.
XStow the tire inflation compressor in the
vehicle.
Emergency sparewheel369
Wheels and tires
Z

Windshield washersystemand
headlamp cleaning system
Important safety notes
GWARNING
Windshieldwasher concentrate is highly
flammable. If it comes into contact with hot
engine components or the exhaust systemit
could ignite. There isariskoffire and injury.
Make sure that no windshield washer
concentrate is spilled nexttothe filler neck.
!Only use washer fluid that is suitable for
plastic lamp lenses, e.g. MB SummerFit or
MB WinterFit. Unsuitable washer fluid
could damage the plastic lenses of the
headlamps.
!Do not add distilled or de-ionized water to
the washer fluid container. Otherwise, the
level sensor may be damaged.
!Only MB SummerFit and MB WinterFit
washer fluid should be mixed together. The
spray nozzles may otherwise become
blocked.
Comply with the importantsafetynotesfor
serviceproductswhen handlingwasher fluid
(Ypage 373).
At temperatures abovefreezing:
XFill thewasherfluid reservoir withamixture
of water and windshield washer fluid, e.g.
MB SummerFit.
Add1part MB SummerFit to 100 partswater.
At temperatures below freezing:
XFill thewasherfluid reservoir withamixture
of water and washer fluid, e.g. MB
WinterFit.
Adapt the mixing ratio to the outside
temperature.
RDown to 14‡("10 †): mix1part MB
WinterFit to2partswater.
RDown to"4‡("20 †): mix1part MB
WinterFit to1part water.
RDown to"20.2‡("29 †): mix2partsMB
WinterFit to1part water.
iAdd windshield washer fluid, e.g. MB
SummerFit or MB WinterFit, to the washer
fluid all year round.
Climate control system refrigerant
Important safety notes
Typeofrefrigerant
The climate control system of your vehicle is
The instruction label regarding the refrigerant
type used can be foundonthe radiator cross
member.
Refrigerant R-134a
!Only the refrigerantR-134a and the PAG
oil approved by Mercedes-Benzmay be
used. The approved PAGoil may notbe
mixed with any other PAG oil that is not
approved for R-134a refrigerant.
Otherwise, the climate control system may
be damaged.
Service work, such as topping-uprefrigerant
or replacing components, may only be carried
out byaqualified specialist workshop.All
applicable regulations must be adhered to,
SAEstandard J639 included.
Always have work on the climate control
system carried out ataqualified specialist
workshop.
378Service products and filling capacities
Technica ld ata
filled with refrigerantsR-134a.