garage door opener MERCEDES-BENZ CLS500 2008 W219 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2008, Model line: CLS500, Model: MERCEDES-BENZ CLS500 2008 W219Pages: 481
Page 7 of 481
Contents
Useful features .................................. 243
Storage compartments................. 243
Cup holders .................................. 246
Ashtrays ....................................... 248
Cigarette lighter ........................... 249
Power outlets ............................... 250
Heated steering wheel
(Canada only) ............................... 251
Floormats ..................................... 252
Telephone*................................... 253
Tele Aid ........................................ 256
Garage door opener ..................... 262
Operation......................................... 269
The first 1 000 miles (1 500 km)......... 270
Driving instructions............................ 271
Drive sensibly – save fuel ............. 271
Drinking and driving ..................... 271
Pedals .......................................... 271
Power assistance ......................... 272
Brakes .......................................... 272
Driving off .................................... 274
Parking ......................................... 275
Tires ............................................. 275
Hydroplaning ................................ 276
Tire traction.................................. 276
Tire speed rating .......................... 277
Winter driving instructions ........... 278
Standing water ............................. 279
Passenger compartment .............. 280
Driving abroad.............................. 280
Control and operation of
radio transmitter .......................... 280
Catalytic converter ....................... 281
Emission control .......................... 281
Coolant temperature .................... 282At the gas station .............................. 283
Refueling ...................................... 283
Check regularly and before a
long trip ....................................... 285
Engine compartment ......................... 286
Hood ............................................ 286
Engine oil ..................................... 287
Transmission fluid level................ 289
Coolant level ................................ 290
Battery ......................................... 291
Washer system and headlamp
cleaning system* ......................... 292
Tires and wheels................................ 293
Important guidelines .................... 293
Tire care and maintenance........... 294
Direction of rotation..................... 295
Loading the vehicle ...................... 296
Recommended tire inflation
pressure ....................................... 301
Checking tire inflation pressure ... 303
MOExtended system* .................. 313
Tire labeling ................................. 314
Load identification ....................... 318
DOT, Tire Identification Number
(TIN) ............................................. 318
Maximum tire load ....................... 320
Page 32 of 481
31 At a glance
Overhead control panel
Overhead control panel
ItemPage
1Rear interior lighting on/off133
2Automatic interior lighting133
3Front interior lighting on/off133
4Right front reading lamp
on/off133
5Power tilt/sliding sunroof
switch210
6Tele Aid (emergency call
system) button256
7Rear view mirror183
8Front reading lamps133
ItemPage
9Garage door opener262
aHands-free microphones for
Tele Aid (emergency call
system), telephone*, and
Voice Control System* (see
separate operating instruc-
tions)
bAmbient lighting161
cInterior lighting133
dLeft front reading lamp
on/off133
Page 263 of 481
262 Controls in detail
Useful features
Stolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered
incident report.
Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is
located, the Response Center will
contact the local law enforcement and
you. The vehicle’s location will only be
provided to law enforcement.
Garage door opener
The integrated remote control is capable of
operating up to three separately controlled
devices. It provides a convenient way to re-
place up to three hand-held remote con-
trols used to operate devices such as
garage door openers, gate openers, or oth-
er devices compatible with HomeLink
® or
some other systems.
Before the integrated remote control can
be used, it must be programmed to the ga-
rage door opener, gate operator or other
device you wish to operate. See the follow-
ing instructions for programming informa-
tion.
iThe remote door unlock feature is available
if the relevant cellular phone network is avail-
able.
The SOS button will flash and the message
Connecting Call
will appear in the multifunc-
tion display to indicate receipt of the door unlock
command.
Once the vehicle is unlocked, a Response Center
specialist may attempt to establish voice contact
with the vehicle occupants.
If the tailgate recessed handle was pulled for
m o r e t h a n 2 0 s e c o n d s b e f o r e d o o r u n l o c k a u t h o -
rization was received by the Response Center,
you must wait 15 minutes before pulling the tail-
gate recessed handle again.
iWhen the anti-theft alarm or the tow-away
alarm stays on for more than 30 seconds, a call
is initiated automatically to the Response Cen-
ter. See anti-theft alarm system (
page 97).
Page 264 of 481
263 Controls in detail
Useful features
Interior rear view mirror with integrated re-
mote control
1Indicator lamp
2 3 4Signal transmitter button
Needed for programming (not part of vehi-
cle equipment):
5Hand-held remote control of ga-
rage door opener, gate operator
or other device
6Hand-held remote control but-
tonProgramming integrated remote
control
Step 1:Switch on the ignition (page 38).
Warning!G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
– signaling the door to stop and reverse –
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park the vehicle outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health.
All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.
Page 265 of 481
264 Controls in detail
Useful features
Step 2:
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when indicator lamp1 be-
gins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.Step 3:Hold the end of hand-held remote
control5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or4) to be pro-
grammed, while keeping indicator
lamp1 in view.
Step 4:
Using both hands, simultaneously
press hand-held remote control
button6 and the desired signal trans-
mitter button (2, 3 or4). Do not
release the buttons until step 5 is com-
pleted.
Indicator lamp1 will flash, first slowly
and then rapidly.Step 5:
After indicator lamp1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
Step 6:
Press and hold the just-trained signal
transmitter button (2, 3 or4) and
observe indicator lamp1.
If indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or4) is pressed and re-
leased.
Step 7:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
iIndicator lamp1 flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.
iIf indicator lamp1 flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.
Page 266 of 481
265 Controls in detail
Useful features
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
Locate “training” button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the
“training” button may also be referred
to as “learn”or “smart” button. If there
is difficulty locating the transmitting
button, refer to the garage door opener
operator’s manual.
Step 9:
Press the “training” button on the ga-
rage door opener motor head unit.
The “training light” is activated.You have 30 seconds to initiate the follow-
ing two steps.
Step 10:
Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed signal transmitter button
(2, 3 or4).
Step 11:
Press, hold for 2 seconds and release
same signal transmitter button a sec-
ond time to complete the training pro-
cess.
Step 12:
Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or4).Step 13:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
iSome garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.
Page 268 of 481
267 Controls in detail
Useful features
Programming tips
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
Check the frequency of hand-held re-
mote control5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 280-390 MHz.
Put a new battery in hand-held remote
control5. This will increase the likeli-
hood of the hand-held remote control
sending a faster and more accurate sig-
nal to the integrated remote control.
While performing step 3, hold
hand-held remote control5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 in (5 to
12 cm) away or the same angle at vary-
ing distances.
If another hand-held remote control is
available for the same device, try the
programming steps again using that
other hand-held remote control. Make
sure new batteries are in the hand-held
remote control before beginning the
procedure.
Straighten the antenna wire from the
garage door opener assembly. This
may help improve transmitting and/or
receiving signals.
iCertain types of garage door openers are in-
compatible with the integrated remote control. If
you should experience further difficulties with
programming the integrated remote control,
contact an authorized Mercedes-Benz Center, or
call Mercedes-Benz Customer Assistance Cen-
ter (in the USA only) at 1-800-FOR-MERCedes, or
Customer Service (in Canada) at
1-800-387-0100.
iUSA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interfer-
ence, and
(2) this device must accept any interference re-
ceived, including interference that may
cause undesired operation.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
iCanada only:
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference re-
ceived, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
Page 464 of 481
463 Index
Fog lamp, rear 129
Fog lamps 129
Messages in display 382–384, 386
Fog lamps, front
Corner-illuminating* 130
Switching on 129
Front air bags 69
Front lamps see Headlamps
Front passenger front air bag
Messages in display 356
Front passenger front air bag off indicator
lamp 70, 75
Front seat head restraints see Head re-
straints
Fuel
Additives 452
Capacities, Fuel tank 449
Filler flap and cap 283
Filling the tank 283
Fuel reserve warning lamp 351
Premium unleaded gasoline 284
Requirements
Gasoline additives 452
Premium unleaded gasoline 451Fuel consumption statistics
Since last reset 165
Since start 165
Fuel filler flap 283
Locking/unlocking 283
Opening 283
Fuel tank
Capacity 283
Filler flap 283
Fuels, coolants, lubricants etc. 448
Fuse box in trunk 429
Fuses 428
Fuse box in passenger
compartment 429
Fuse box in trunk 429
G
Garage door opener 262
Gasoline see Fuel
GAWR 324
Gear range
Automatic transmission 174
Limiting 174
Shifting into optimal 177, 179Gear selector lever 169
Cleaning 340
Gearshift pattern 169
Lock 51
Position 170, 171
Shifting procedure 170
Unlocking in an emergency 400
Gear selector lever one-touch gearshifting
Automatic transmission 176
Global locking 102
Global locking/unlocking see Key, Smart-
Key or Key, SmartKey with KEY-
LESS-GO*
Glove box 243
Good visibility 183
Gross Axle Weight Rating see GAWR
Gross Vehicle Weight Rating see GVWR
Gross Vehicle Weight see GVW
GVW 324
GVWR 324
H
Halogen headlamps see Headlamps
Hands-free microphone 31
Hard plastic trim items, cleaning 340
Hazard warning flasher 132