audio MERCEDES-BENZ E-Class 2005 W211 Comand Manual

35 Audio
Audio main menu
Radio operation
Single CD operation
MP3 operation
CD changer* operation
Audio AUX operation

36 AudioAudio main menu
Press
.
The Audio main menu appears.
If one of the Audio submenus appears: 
Press the
Back
soft key as often as
necessary until the Audio main
menu appears,
or

Press
again.
Various audio sources can be selected in
the Audio main menu.

Radio
soft key
Station settings for WB, FM, and AM
wavebands appear (
page 37)

CD soft key or
MP3
soft key
The Single CD main menu (
page 46)
or the MP3 main menu (
page 53) ap-
pears

CDC
soft key
The CD changer main menu appears
(page 66)

AUX
soft key
Facilitates operation of an external au-
dio source (
page 72)Switching the mute function ON:

Press .
The system is switched to mute.
Switching the mute function OFF:

Press again,
or

Turn the rotary control
located on
the COMAND control unit,
or

Pressæ or ç on the multifunc-
tion steering wheel.
The audio source heard is the one se-
lected before the mute function was
activated.
Opening the Audio main menu
Selectable soft keysiThe Satellite Radio menu is accessed
by pressing (
page 75).
Mute functioniThe mute function is still activated if
the system is switched off and then on
again.

37 Audio
Radio operation

Radio operation

Open the Audio main menu
(page 36).

Press the
Radio
soft key.
The Radio main menu appears. The sta-
tion last tuned to will begin to play. In this example:

Weather Band


Channel 1
= current station

Press the
FM/AM
soft key in the Radio
main menu.
Alternatingly the Radio main menu for
the FM or AM wavebands appears. The
station last tuned to will begin to play.The waveband is indicated in the center
of the status bar.
In this example:

FM = FM waveband

1 = selected station is stored on
preset 1
Safety InstructionsWarning
G
In order to avoid distraction which could
lead to an accident, the driver should enter
system settings with the vehicle at a stand-
still and operate the audio system only when
road, weather and traffic conditions permit.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.Switching to radio mode
Switching wavebands

38 AudioRadio operation
The following options are available:
Tuning via station search (
page 38).

Tuning via station presets (
page 39).

Tuning via Autostore presets
(page 39).

Tuning via scan search (
page 40).

Manual tuning (
page 40).

Tuning via direct frequency input
(page 41).
Tuning via station search
On COMAND control unit

Switch to the desired FM or AM wave-
band (
page 37).

Press or :
The next receivable ascending frequen-
cy is tuned in and begins to play,
or

Press or :
The next receivable descending fre-
quency is tuned in and begins to play.
On multifunction steering wheel

Switch the multifunction display in the
instrument cluster to the Radio display
(page 25).

Pressj:
The next receivable ascending frequen-
cy is tuned in and begins to play,
or
iThe wavebands cover different fre-
quency ranges.
FM broadcast band:
FM (VHF = very high frequency)
87.7 - 107.9 MHz

Tuning increments 0.2 MHz
AM broadcast band:

MW (medium wave)
530 - 1710 kHz

Tuning increments 10 kHz
WB waveband:

WB (Weather Band)
162.400 - 162.550 MHz

Tuning increments = 1 channel
Tuning to a FM/AM station

39 Audio
Radio operation

Pressk:
The next receivable descending fre-
quency is tuned in and begins to play.
Tuning via station presets
Ten presets each are available for FM and
AM. The presets are accessed using the
number keypad, or via the Presets menu.
Accessing via number keypad:

Switch to the desired waveband
(page 37).

Press one of the number keys

- :
The system tunes to the station stored
under this number.
Accessing via Presets menu:

Switch to the desired waveband
(page 37).

Press the
Presets
soft key.
The Presets menu appears.

Use , ,  or  to choose a
preset and press,
or

Press one of the number keys

- .
The system tunes to the station stored
under this number.
Tuning via Autostore presets
The Autostore function allows placing of
stations into the presets sorted by recep-
tion quality (
page 43). The system will store the station with the
strongest signal in preset 1.
Ten presets each are available for FM and
AM.

Switch to the desired waveband
(page 37).

Press the
Autost.
soft key.
The Autostore preset list appears. It
can take several seconds until all fre-
quencies are displayed.


40 AudioRadio operation
Use , ,  or  to choose a
preset and press.
or

Press one of the number keys

- .
The system tunes to the station stored
under this number.
Tuning via scan search
Scan search is characterized as follows:

Scan search performs two runs.
During the first run, stations with ex-
tremely good reception are played.
During the second run, stations with
weaker reception are played.

Scan search plays each receivable sta-
tion for approx. 8 seconds.

Scan search can be ended manually.

Scan search automatically stops at the
station listened to before the scan
search was started.
Starting scan search

Switch to the desired waveband
(page 37).

Press the
Scan
soft key.
Scanning begins.
Ending Scan search manually

Press the
Scan
soft key again.Manual tuning

Switch to the desired waveband
(page 37).

Press and hold or  for at
least 2 seconds to tune up or down.
Manual tuning is activated.

Keep the button pressed or release it
and keep tapping or  in
quick succession.
The frequency will change by the tuning
increments for the respective wave-
band each time one of the buttons is
pressed or for as long as a button is
pressed and held.
Manual tuning is deactivated if no but-
ton is pressed for approx. 3 seconds.

41 Audio
Radio operation
Tuning via direct frequency input
Entry example:
98.5 MHz in FM waveband
Switch to the FM waveband
(page 37).

Press.The frequency input display appears.
The frequency range of the FM wave-
band is shown.

Press the number buttons in
succession:, , and .
Each number entered appears in the
display.
The system tunes to the frequency en-
tered (in this example: 98.5 Mhz) and
switches back to the FM menu.Tuning via station search
Seven channels are available on the
Weather Band.
On COMAND control unit

Switch to the WB waveband by press-
ing the
WB soft key in the Radio main
menu (page 37).
iManual tuning is also possible in all
wavebands by pressing or .
The frequency will change by the tuning
increments for the respective wave-
band each time one of the buttons is
pressed.
Frequency increments for manual
tuning:
FM 0.2 MHz

AM 10 kHz
iEntries outside the frequency range are
not possible.
Within the AM waveband, the input is
restricted to frequencies within the re-
spective frequency increment, which
is10 kHz.
The system will select the nearest valid
frequency if a frequency outside the
frequency increment is entered.Tuning to a station on Weather Band


42 AudioRadio operation
The system will tune to the strongest
receivable station.

Press  or.
Search begins in ascending or
descending frequency.
The search stops at the next receivable
station.
On multifunction steering wheel

Switch the multifunction display in the
instrument cluster to Radio display
(page 25).

Pressj ork.
The search stops at the next receivable
station. Tuning via station presets
The seven strongest channels are sorted in
prest 1 to 7 each time you press the
WB soft
key. They are accessed using the number
keypad.

Press one of the number keys

- .
The system tunes to the station stored
under this number.
Ten presets each are available for the
FM and AM waveband.
The following options are available:

Storing manually using number keys

Storing manually using the Presets
menu

Storing using Autostore Storing manually using the number
keys
- 

Tune to the station to be stored
(page 38).

Press a number key between
and
 and hold it for more than 2 sec-
onds.
The station is now stored in the respec-
tive memory location.
Storing manually using the Presets
menu

Tune to the station to be stored
(page 38).

Press the
Presets
soft key.
The Presets menu appears.
Storing FM/AM stations

43 Audio
Radio operation

Use, ,  or  to select a
preset.

Press for more than 2 seconds.
The station will be stored in the respec-
tive memory location.
Storing using Autostore
The Autostore function places stations into
the Autostore memory sorted by reception
quality.
The system stores the station with the
strongest signal in preset 1.

Switch to the desired waveband
(page 37).

Press the
Autost.
soft key.
The Autostore preset list appears.

Use to select the Reprogram Autostore
header entry.

Press.
The Autostore search starts. After a de-
lay the new preset assignment ap-
pears. The system tunes to the station
stored on preset 1.
To tune-in another station from the
Autostore preset list (
page 39).
iThe Autostore feature stores presets in
a separate memory, not in the regular
presets seen under the
Presets
soft key.
As such, the Autostore memory is only
temporary.

44 AudioSingle CD operation

Only touch the CD on the edges.

Clean the CD with a dry, lint-free cloth.
Wipe the CD a straight line from the
center. Never wipe the CD in a circular
motion.

Do not use rubbing alcohol or solvents
to clean CDs.

Do not expose the CDs to heat or direct
sunlight.

Do not write or put labels on CDs
Safety InstructionsWarning
G
In order to avoid distraction which could
lead to an accident, the driver should insert
CDs with the vehicle at a standstill and
operate the audio system only when road,
weather and traffic conditions permit.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.
Warning
G
The CD drive is a Class 1 laser product.
There is a danger of invisible laser radiation
when you open or damage the cover.
Do not remove the cover. The CD drive does
not contain any parts serviceable by the us-
er. For safety reasons, have any necessary
service work performed by qualified person-
nel.
Tips on caring for your CDs