warning MERCEDES-BENZ E-Class 2008 W211 Comand Manual

85 Telephone*
Telephone operation


Telephone operation
Switching ON The telephone is switched ON automatical
-
ly when COMAND is activated. The cellular
phone must be readily inserted into the
cradle.If COMAND is switched ON, the switched
OFF telephone can also be switched ON
manually:
Press and hold

for a few seconds
until the telephone is switched ON.
The Telephone main menu appears ( page
89)
.
One of the following messages could also
appear:
Please
insert
phone

Insert the cellular phone into the
cradle.

Phone
not
installed

Your vehicle is not configured for cellu
-
lar telephone operation.

Please
insert
SIM
card
This message appears only when using
a GSM cellular phone. 
Insert a SIM card (
 Telephone Op
-
eration Guide).
Switching OFF 
In the Telephone main menu ( page
89)
, press and hold

for
longer than 2 seconds.
or
Switch COMAND OFF
( page
29)
.
The telephone switches OFF after a
one-minute delay. If a call is in progress
during this time, the telephone switch
-
es OFF approx. one
minute after the
call is ended.
The following conditions must be met for a
“911” emergency call:
cellular phone readily inserted

telephone switched ON

available cellular phone network
Switching the phone ON/OFF
iIf a call is in progress (handsfree) you
cannot switch the COMAND OFF,
.
is
disabled.
911 emergency callsWarning
G
The “911” emergency call system is a
public service. Using it without due
cause is a criminal offense.

89 Telephone*
Telephone operation
1 Observe all legal requirements

Press

.
The Telephone main menu appears.
Telephone status information is displayed
on the right end of the status bar.The following displays are possible:
READY
= telephone is logged into your
cellular phone home network and
ready for use,

ROAMING
= telephone is logged into a
cellular phone network outside your
home network,

NO SERV.
= no network available,

= telephone signal strength,

= call active
( page
95)
.
Other messages could also appear:
If the message

Please
insert
phone
,
Phone
not
installed
or Please insert
SIM card
appears, see chapter “Switch
-
ing the phone ON / OFF”
( page
85)

If the message

Please
Enter
PIN:
appears, see “En
-
tering the PIN”
( page
87)

If the message

Enter
unlock
code:
appears, see “En
-
tering unlock code”
( page
88)
Telephone main menuWarning
G
Some jurisdictions prohibit the driver from
using a cellular telephone while driving.
Whether or not prohibited by law, for safety
reasons, the driver should not use the cellu
-
lar telephone while the vehicle is in motion.
Stop the vehicle in a safe location before
placing or answering a call.If you nonetheless choose to use the cellular
phone while driving, please use the hands-
free device and be sure to pay attention to
the traffic situation at all times. Use the cel
-
lular phone
1 only when road, weather and
traffic conditions permit.
iThe information is also displayed in
Navigation* mode (only in map dis
-
plays).

104 Navigation*Important notesSafety InstructionsWarning
G
For safety reasons, you should only enter a
destination when the vehicle is stationary.
When the vehicle is in motion, a passenger
should enter the destination. Study manual
and select route before driving.Do not watch display screen or operate but
-
tons while the vehicle is in motion - let navi
-
gation announcements guide you. Stop at a
safe location before using buttons or mak
-
ing corrections.Traffic regulations always have priority over
any route recommendations given. Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate
-
ly 14 m) every second.
The route calculated by COMAND is a rec
-
ommendation on how to best reach your se
-
lected destination.During route guidance, you will not receive
any information on
Traffic lights

Stop and yield signs

Parking or stopping zones

One-way streets

Narrow bridges

Similar traffic regulation data
You should therefore always strictly observe
traffic regulations while driving. Drive care
-
fully and always obey traffic laws and road
signs even if they contradict COMAND in
-
structions.
Warning
G
The Navigation DVD module contains a

Class 1 laser product. There is a danger of
invisible laser radiation if the cover is
opened or damaged.Do not remove the cover. The Navigation
DVD module does not contain any parts
which can be serviced by the user. For safe
-
ty reasons, have any service work which
may be necessary performed only by quali
-
fied personnel.

129 Navigation*
Route guidance
After route calculation, the system assists
route guidance using pictorial displays and
navigation announcements.Current navigation announcementsIf a navigation announcement is not readily
understood, it can be repeated at any time. 
Press
6
.
The current navigation announcement
is repeated.
Switching navigation announcements
ON/OFF Switching OFF
During a navigation announcement,
press
1
.
For a short period of time, the message Voice
announcements
muted
is dis
-
played. Now further route guidance takes
place using only the symbols in the dis
-
play. If a new route guidance cycle is
started, the announcements are auto
-
matically switched ON again.
Switching ON manually
Press
6
.
The navigation displays are visible only
with activated route guidance.
To switch to the navigation display
from another display, e.g. from CD
mode, press

or
%
.
Two display examples are shown below.Display example 1The road currently travelled on is indicated
in the status bar at the bottom, in this ex
-
ample
I-80 E
(Interstate 80 East).

The information 1.2 mi indicates the dis
-
tance to the next driving maneuver.
Navigation announcementsWarning
G
Navigation announcements are intended to
direct you while driving without diverting
your attention from the road and driving. Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your at
-
tention from driving and increase your risk
of an accident.
Navigation displays
iThe display unit can be changed to km
or miles using the control system (see
your vehicle Operator's Manual).


132 Navigation*Route guidanceRoute guidance ends when the selected
destination is reached.
In navigation mode, press

.
A prompt as to whether or not route
guidance is to be cancelled appears.

Use

to select the menu item
Yes
.

Press

.
Route guidance is cancelled. After a
short time, the Navigation main menu
appears.
If the destination is within a partially
digitized areaCOMAND guides you through fully digitized
areas for as long as possible. Route guid
-
ance is conducted in the usual manner, i.e.
with navigation announcements and route
guidance displays.
Destination reachedCancelling route guidance
iRoute guidance can be continued again
in the Navigation main menu ( page
108)
.
Partially digitized areasiThe digital map may contain areas that
are only partially digitized although
they are within a digitized region.Warning
G
Due to incomplete digitization, the route
shown on the map may differ from the actual
road/traffic situation.
Warning
G
If you follow the route shown on the map, for
example, it is possible that you could drive
the wrong way down a one-way street or
that a street cannot be driven on.When using route guidance in a partially dig
-
itized area, you must therefore be sure to
observe all relevant traffic regulations and
the course of the road.All relevant traffic regulations and the
course of the road always take priority over
the route shown on the map.

134 Navigation*Route guidanceRoute guidance to an off-road destina
-
tion
COMAND can guide you to destinations
within the area covered by the digital map,
even if a destination is not located at a
road known to the system.These destinations are shown as off-road
destinations, which you can enter using
the map, for example.In these cases, COMAND guides you for as
long as possible with navigation announce
-
ments and displays on roads known to the
system.Shortly before you reach the last known
point in the digitized road network, you will
hear the announcement “The destination is
nearby. Follow the arrow on the display”.You will then see an arrow that indicates
the direction to the off-road destination.
When the off-road destination is close to
the road,
Area of dest. reached
appears
in addition below the arrow.
When you leave the last known point in the
digitized road network, direction arrows
showing the compass heading to the desti
-
nation guide you. You will also see the
Di-
rection to destination
display.
Route guidance from an off-road loca
-
tion to a destinationIf there is no road available on map at cur
-
rent position of the car, vehicle is off road.COMAND is also able to guide you to a des
-
tination from such a location.At the start of the route guidance, you will
see the
Off Road
message and a direction
arrow. The direction arrow shows the com
-
pass heading to the actual destination.The route is highlighted blue from the near
-
est road known to the system. As soon as the vehicle is back on a road
known to the system, route guidance con
-
tinues in the usual way.
Off-road and off-mapWarning
G
The COMAND navigation system may direct
you to off-road routes that your vehicle may
not be capable of traversing through without
damaging your tires, wheels or vehicle. It is
the driver’s sole responsibility to determine
the suitability of the route. Off-road routes
may be of varying conditions and their ap
-
propriateness for use may be affected by
various factors such as time of day, time of
year and immediate weather conditions that
cannot be judged or taken into consider
-
ation by the COMAND system.

184 IndexTransmitting number sequences (tele-phone). . . . . . . . . . . . . . . . . . . . . . . . . 96Travelling abroad. . . . . . . . . . . . . . . 105Treble . . . . . . . . . . . . . . . . . . . . . . . . . 31for navigation announcements . . . . 110Trip interruption. . . . . . . . . . . . . . . . 106 UUniversal Time Coordinatedsee UTCUnlock code . . . . . . . . . . . . . . . . . . . 175entering . . . . . . . . . . . . . . . . . . . . . . . 88UTC . . . . . . . . . . . . . . . . . . . . . . 165,
175
VVehicle transport. . . . . . . . . . . . . . . 106VOICE ANNOUNCEMENTS MUTED. 129Volumeautomatic volume control . . . . . . . . . 30setting . . . . . . . . . . . . . . . . . . . . . . . . 30for navigation announcements . . 110
WWarning. . 37,
45,
51,
54,
61,
63,
82,
89,
104,
134
WB . . . . . . . . . . . . . . . . . 36,
38,
42,
175
WRONG PIN NUMBER . . . . . . . . . . . . 87