rims MERCEDES-BENZ E-CLASS ESTATE 2022 Owners Manual

&
W
WARNI NG
ARNI NG‑ Risk of /re and injury from the
hot cigar ette lighter
Yo u can burn yourself if youto uch the hot
heating element or the soc ket of the cigar ette
lighter.
In addition, 0ammable materials may ignite if:
R you drop the hot cigar ette lighter
R ach ild holds the hot cigar ette lighter to
objects, forex ample #
Always hold the cigar ette lighter bythe
knob. #
Always make sure that the cigar ette
lighter is out of reach of children. #
Never lea vechildren unattended in the
ve hicle. &
W WARNING
ARNING Risk of burns from theta ilpipe
and tailpipe trims
The exhaust tailpipe and tailpipe trims can
become very hot. If you come into contact
with these parts of theve hicle, you could burn
yo urself. #
Always be particular lycareful around the
ta ilpipe and theta ilpipe trims and super-
vise children especially closely in this
area. #
Allow vehicle parts tocool down before
to uching them. The driving
characteristics of your vehicle are
dependent on the distribution of the load within
th eve hicle. You should bear thefo llowing in mind
when loading theve hicle:
R neverex ceed the permissible gross mass or
th e permissible axle loads forth eve hicle
(including occupants).
Information can be found on theve hicle identi-
/cation plate (/ page 413).
R the load must not pr otru de abo vethe upper
edge of the seat backrests.
R when transporting objects in the load com-
partment, alw ays ins tallth e combined luggage
co ver and net (load compartment co ver and
partitioning net).
R always place the load behind unoccupied
seats if possible. R
secure the load using the tie-down eyes and
distribute the load evenl y.
No tes on driving with a roof load
R Evenly dist ribute thero of load, and place
heavy objects at the bottom. Also comply with
th e no tes on loading theve hicle.
R Drive attentivel y,and avoid suddenly pulling
awa y,braking and steering as well as rapid
cornering.
R When transporting roof loads and when the
ve hicle is fully loaded or fully occupied, select
drive prog rams ; andA. These are
designed tofocus on stability (/ page 198).
% For more information on st owage compart-
ments and st owage areas, please referto the
Digital Owner's Manual. 128 128
Seats and st
owing

Cleaning
Cleaning
R For cleaning, use plenty of water and a mild
cleaning agent without additives or abrasive
substances (e.g. a car shampoo appr ovedfor
Mercedes-Benz).
R Remo vedirt as soon as possible. Avoid rub-
bing too hard in order tonot ir reparably dam-
age the decorative foil.
R Ifth ere is dirt on the /nish or if the decorative
fo il is dull: Use thePa int Cleaner recommen-
ded and appr ovedfo r Mercedes-Benz.
R Insect remains: Soak with insect remo ver and
ri nse o. the treated areas aTer wards.
R Bird droppings: Soak with water and rinse o.
aTer wards.
R Topreve ntwa ter stains, dry a foil-wrapped
ve hicle with a soT, absorbent clo thaTer every
car wash.
Av
Av oiding damag
oiding damag e t
e to t
o t he decor
he decor ativ
ativ e f
e foil
oil
R The service life and colouring of decorative
foils are impaired by:
- Sunlight
- Temp erature (e.g. hot air blo wer) -
Weather conditions
- Stone chippings and dirt
- Chemical cleaning agents
- Oily products
R Do not use polish on matt decorative foil. Po l-
ishing will ha vethe e.ect of shining thefo il-
wrapped sur face.
R Do not treat matt or st ructured decorative
fo ils with wax.Pe rm anent stains may occur.
Scratches, cor rosive deposits, areas a.ected by
cor rosion and damage caused byincor rect care
cannot alw ays be comple tely rep aired. In this
case, contact a quali/ed specialist workshop.
Yo u can obtain more information on care and
cleaning agents from the manufacturer.
In the case of foil-wrapped sur faces, optical di.er-
ences may occur between the sur faces that we re
not pr otected bya decorative foil aTer removing a
decorative foil.
% Have workor repairs todecorative foils car-
ri ed out at a quali/ed specialist workshop
(e.g. in a Mercedes-Benz Se rvice Centre). N No
ot
tes on car
es on car e of car par
e of car par ts
ts &
W
WARNING
ARNING Risk of entrapment if the wind-
screen wipers are switched on while the
windscreen is being cleaned
If th e windscreen wipers are set in motion
while you are cleaning the windscreen or
wiper blades, you can be trapped bythe wiper
arm. #
Always switch o. the windscreen wipers
and theve hicle before cleaning the wind-
screen or wiper blades. &
W
WARNING
ARNING Risk of burns from theta ilpipe
and tailpipe trims
The exhaust tailpipe and tailpipe trims can
become very hot. If you come into contact
with these parts of theve hicle, you could burn
yo urself. #
Always be particular lycareful around the
ta ilpipe and theta ilpipe trims and super-
vise children especially closely in this
area. 366
366
Maintenance and care

R
vehicle vib ration
R smo kewhich smells like rubber
R continuous ESP ®
inter vention
R crac ksinthe tyre side walls #
ATer driving in emer gency mode, ha ve
th erims checkedby a quali/ed specialist
wo rkshop with rega rd totheir fur ther
use. #
The defective tyre must be replaced in
ev ery case. Wi
th MOEx tended tyres (run-0at tyres), you can
continue todrive your vehicle even if there is a
to ta l loss of pressure in one or more tyres. Ho w-
ev er, the tyre a.ected must not show any clear ly
visible damage.
Yo u can recognise MOExtended tyres bythe
MOEx tended ma rking which appears on the side
wa ll of the tyre.
V
V ehicles wit ehicles wit h tyr
h tyre pr
e pressur
essur e loss w
e loss w ar
ar ning syst
ning syst em:
em:
MOExtended tyres may only be used in conjunc-
tion with an activated tyre pressure loss warning
system. V
V
ehicles wit
ehicles wit h tyr
h tyre pr
e pressur
essur e monit
e monit or
oring sy
ing sy st
stem:
em:
MOExtended tyres may only be used in conjunc-
tion with an activated tyre pressure monitoring
system.
If a pressure loss warning message appears inthe
driver's displa y,proceed as follo ws:
R Check the tyre for damage.
R If driving on, obser vethefo llowing no tes.
Dr
Dr iving dist iving dist ance possible in emerg
ance possible in emerg ency mode
ency mode
aTer
aTer t
the pr
he pr essur
essur e loss w
e loss w ar
arning:
ning: Load condition
Load condition
Dr
Driving dist
iving dist ance possi-
ance possi-
ble in emerg
ble in emerg ency mode
ency mode
Pa rtially laden 80 km
Fu lly laden 30 km The driving distance possible in emer
gency mode
may vary depending on the driving style. Obser ve
th e maximum permissible speed of 80 km/h.
If a tyre has gone 0at and cannot be replaced with
an MOExtended tyre, you can use a standard tyre
as a temp orary measure. TIREFIT kit st
TIREFIT kit st
or
orag
ag e location
e location The TIREFIT kit is located under
the load compart-
ment 0oor. 1
Tyre sealant bottle
2 Tyre in0ation compressor
Depending on theve hicle version, the TIREFIT kit
may also be located in other places under the
load compartment 0oor.
% You can /nd information on the po wer cate-
gory (LK) and/or electrical data on the back
of the tyre in0ation compressor:
R LK2 – 12 V/15 A,180 W,0.8 kg 374
374
Breakdown assistance

At
a dis tance of app roximately 1 m tothe tyre
in0ation compressor and appr oximately 1.6 m
abo vethegr ound, thefo llowing sound pres-
sure le vels appl y:
R Emission sound pressure le vel L
PA 83 dB
(A)
R Sound po wer le vel L
WA 91 dB (A)
The tyre in0ation compressor is maintenance-
free. If there is a malfunction, please contact
a qu ali/ed specialist workshop. Using t Using t
he TIREFIT kit
he TIREFIT kit R
R
eq
eq uir
uir ements:
ements:
R Tyre sealant bottle and tyre in0ation compres-
sor (/ page 374)
R TIREFIT stic ker
R Gloves
Yo u can use TIREFIT tyre sealant toseal per fora-
tion damage of up to4 mm, particular lythose in
th e tyre contact sur face. You can use TIREFIT in
outside temp eratures down to-20 °C. &
W
WARNING
ARNING Risk of accident when using
tyre sealant
The tyre sealant may be unable toseal the
tyre proper ly, especially in thefo llowing cases:
R there are lar gecuts or punctures in the
tyre (la rger than damage pr eviously men-
tioned)
R the wheel rims ha vebeen damaged
R aTer journe yswith very low tyre pressure
or with 0at tyres #
Do not continue driving. #
Consult a quali/ed specialist workshop. &
W
WARNING
ARNING Risk of injury and poisoning
from tyre sealant
Ty re sealant is hazardous tohealth and causes
ir rita tion. Do not allow it tocome into contact
with your skin, eyes or clo thing, and do not
swallow it. Do not inhale any vapours. Keep
th e tyre sealant away from children. Obser
vethefo llowing if you come into contact
with the tyre sealant: #
Rinse o. the tyre sealant from your skin
using water immediatel y. #
If tyre sealant gets into your eyes, thor-
oughly rinse them using clean water
immediatel y. #
If tyre sealant has been swallo wed,thor-
oughly rinse out your mouth immediately
and drink plenty of water. Do not induce
vo miting and seek medical attention
immediatel y. #
Change out of clo thing which has come
into contact with tyre sealant immedi-
atel y. #
If an alle rgic reaction occurs, seek medi-
cal attention immediatel y. *
N NO
OTE
TE Overheating due tothe tyre in0ation
compressor running too long #
Do not runth e tyre in0ation compressor
fo r longer than ten minutes without inter-
ru ption. Breakdown assistance
375 375

#
Position the hub cap and turn the centre co ver
clockwise until the hub cap engages ph ysically
and audibl y.
Aluminium hub cap
Aluminium hub cap #
T
To r
o r emov
emov e:
e:position soc ket2 from the tyre-
ch ange tool kit on hub cap 1.#
Position wheel spanner 3on soc ket2. #
Using wheel spanner 3, turn hub cap1
anti-clockwise and remo veit. #
T
To
o /t:
/t: follow the inst ructions abo veinreve rse
order.
% Speci/ed
Speci/ed tight
tightening t
ening t orq
orque:ue: 25 Nm. R
R
aising t
aising t he v
he vehicle when c
ehicle when c hanging a wheel
hanging a wheel R R
eq
eq uir uir ements:
ements:
R There are no persons in theve hicle.
R The vehicle has been prepared for a wheel
ch ange (/ page 403).
R The wheel trims and hub caps ha vebeen
re mo ved (/ page 403).
Impor tant no tes on using the jack:
R Use only a vehicle-speci/c jack that has been
appr ovedby Mercedes-Benz toraise theve hi-
cle.
R The jack is only designed forra ising and hold-
ing theve hicle for a short time while a wheel
is being changed and not for maintenance
wo rkunder theve hicle.
R The jack must be placed on a /rm, 0at and
non-slip sur face. If necessar y,use a lar ge, 0at,
load-bearing, non-slip underla y.
R The foot ofthe jack must be positioned verti-
cally under the jack support point. Ru
les of conduct when theve hicle is raised:
R Never place your hands or feet under theve hi-
cle.
R Never lie under theve hicle. 404
404
Wheels and tyres