service interval MERCEDES-BENZ E320 2004 W211 User Guide

403 Technical data
Fuels, coolants, lubricants etc.
Engine oils
Engine oils are specifically tested for their
suitability in our engines. Therefore, use
only engine oils recommended by
Mercedes-Benz. Information on recom-
mended brands is available in the Factory
Approved Service Products Pamphlet, or at
your authorized Mercedes-Benz Center.Please follow FSS recommendations for
scheduled oil changes. Failure to do so
could result in engine damage not covered
by the Mercedes-Benz Limited Warranty.
Engine oil additives
Do not blend oil additives with engine oil.
They may damage the engine.
Damage or malfunctions resulting from
blending oil additives are not covered by
the Mercedes-Benz Limited Warranty.Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG
lubricating oil is used in the air condition-
ing system.Never use R-12 (CFC) or mineral-based lu-
bricating oil. Otherwise damage to the
system will occur.
Brake fluid
During vehicle operation, the boiling point
of the brake fluid is continuously reduced
through the absorption of moisture from
the atmosphere. Under extremely strenu-
ous operating conditions, this moisture
content can lead to the formation of bub-
bles in the system, thus reducing the sys-
tem’s efficiency.
Therefore, the brake fluid must be re-
placed every two years, preferably in the
spring.
Only brake fluid approved by
Mercedes-Benz is recommended. Your au-
thorized Mercedes-Benz Center will pro-
vide you with additional information.
!Always check the oil filler cap
(page 285) for important information
pertaining to the engine oil needing to
meet a specific Mercedes-Benz specifi-
cation (e.g. MB 229.5). If such informa-
tion is printed on the oil filler cap, only
use an engine oil from the list of ap-
proved engine oils in the Factory Ap-
proved Service Products pamphlet that
meets the specification indicated on
the oil filler cap.
Using engine oils of other specification
may cause the FSS to incorrectly deter-
mine the next service interval and will
result in engine damage not covered by
the Mercedes-Benz Limited Warranty.

405 Technical data
Fuels, coolants, lubricants etc.
Damage or malfunctions resulting from
poor fuel quality or from blending specific
fuel additives are not covered by the
Mercedes-Benz Limited Warranty.Coolants
The engine coolant is a mixture of water
and anticorrosion / antifreeze, which pro-
vides:

Corrosion protection


Freeze protection


Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and corro-
sion protection.If the antifreeze mixture is effective to
-22°F (-30°C), the boiling point of the cool-
ant in the pressurized cooling system is
reached at approximately 266°F (130°C).
The coolant solution must be used
year-round to provide the necessary corro-
sion protection and increase boil-over pro-
tection. Refer to Service Booklet for
replacement interval
Coolant system design and coolant used
stipulate the replacement interval. The re-
placement interval published in the Ser-
vice Booklet is only applicable if MB 325.0
anticorrosion/antifreeze solution or other
Mercedes-Benz approved products of
equal specification (see Factory Approved
Service Products pamphlet) are used to re-
new the coolant concentration or bring it
back up to the proper level. To provide important corrosion protection,
the solution must be at least 45%
anticorrosion / antifreeze [equivalent to
freeze protection to approximately - 22°F
(-30°C)]. If you use a solution that is more
than 55% anticorrosion / antifreeze [freeze
protection to approximately - 49°F
(-45°C)], the engine temperature will in-
crease due to the lower heat transfer capa-
bility of the solution. Therefore, do not use
more than this amount of
anticorrosion / antifreeze.

434 IndexSeat cushion depth
Adjusting 111
Seat heater*
Switching off 113
Switching on 113
Seat ventilation*
Switching off 114
Switching on 114
Seats 108
Adjusting 34
Easy entry/exit feature* 108
Heater* 113
Multicontour seat* 111
Split rear bench seat* 236
Ventilation 114
Securing cargo
Cargo tie-down rings 241
Selecting display 142, 143
Selector lever
Lock 43
Message in the display 323
Position (automatic
transmission) 158Self-test
BabySmartTM airbag deactivation
system 68
Tele Aid* 251
Service
Batteries 375
Calling up the service indicator 298
Major service (Service H) 297
Minor service (Service A) 297
Overdue 298
Types 297
When due 297
Service and warranty information 10
Service indicator 297
Calling up 298
Clearing 298
Service life (tires) 290
Service System see FSS 297
Setting
Convenience functions 140, 150
Cruise control 212
Daytime running lamp mode 146
Distronic* time interval 221Exterior rear view mirror parking
position 118
Higher speed in cruise control 213
Higher speed in Distronic* 219
Hours (clock) 144
Individual vehicle settings 138
Instrument lighting 126, 127
Interior lighting delayed
switch-off 149
Lamps and lighting (control
system) 146
Language, multifunction display 142
Locator lighting 147
Lower speed in cruise control 213
Lower speed in Distronic* 220
Miles/kilometers in
speedometer 141
Minutes (clock) 144, 145
Parking position for exterior rear view
mirrors 152
Slower speed in cruise control 213
Slower speed in Distronic* 220
Smartkey dependent memory 152