fold seats MERCEDES-BENZ E350 2006 W211 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: E350, Model: MERCEDES-BENZ E350 2006 W211Pages: 521
Page 87 of 521
86 Safety and SecurityOccupant safetySelf-test Occupant Classification Sys-
tem
After turning the SmartKey in the starter
switch to position1 or2 or pressing the
KEYLESS-GO* start/stop button once or
twice, the 75 indicator lamp1
located in the center console illuminates. If
an adult occupant is properly sitting on the
front passenger seat and the system sens-
es the occupant as being an adult, the
75 indicator lamp will illuminate
and go out after approximately 6 seconds.
If the seat is not occupied and the system
senses the front passenger seat as being
empty, the 75 indicator lamp will
illuminate and not go out. For more information, see the “Practical
hints” section (
page 393).Installation of infant and child restraint
systems
This vehicle is equipped with tether an-
chorages for a top tether strap at each of
the rear seating positions.
Not foldable rear seat backrest
1Cover
Remove cover1 from anchorage ring.
Guide tether strap between head re-
straint and top of the seat back.
Warning!
G
If the indicator lamp should not illuminate,
the system is not functioning. You must see
an authorized Mercedes-Benz Center before
seating any child on the front passenger
seat.Warning!
G
Never place anything between seat cushion
and child seat (e.g. pillow), since it reduces
the effectiveness of the Occupant Classifi-
cation System. The bottom of the child seat
must make full contact with the passenger
seat cushion. An incorrectly mounted child
seat could cause injuries to the child in case
of an accident, instead of increasing protec-
tion for the child.
Follow the manufacturer’s instructions for
installation of child seats.
Page 132 of 521
131 Controls in detailSeats
Seats
For more information on seat adjustment,
see the “Getting started” section
(page 41).
Front seat active head restraints
You cannot remove the active head re-
straint on the driver’s and passenger’s
seats.For removal of the active head restraints
we recommend that you contact an autho-
rized Mercedes-Benz Center.
For information on head restraint adjust-
ment, see “Seats” (
page 42).
For information on active head restraints,
see “Active head restraints” (
page 77).
Rear seat head restraints
Folding head restraints back with
switch in the center console
The rear seat head restraints can be folded
backward for increased visibility.
1Head restraint release switch
Switch on the ignition (
page 36).
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the center of
the head restraint supports the back of the
head at eye level. This will reduce the poten-
tial for injury to the head and neck in the
event of an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
iAdjust the head restraint in such a way
that it is as close to the head as possi-
ble.
iThe rear seat head restraints cannot be
adjusted.
Page 133 of 521
132 Controls in detailSeats
Press the symbol-side on switch1to
release the head restraints.
The head restraints will fold backward.Placing head restraints upright
Pull the head restraint forward until it
locks into position.Removing and installing rear seat head
restraints
Warning!
G
For safety reasons, always drive with the
rear head restraints in the upright position
when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
!Make sure the head restraints engage
when placing them upright. Otherwise
their protective function cannot be as-
sured.
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the head re-
straint supports the back of the head at eye
level. This will reduce the potential for injury
to the head and neck in the event of an ac-
cident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
Do not interchange head restraints from
front and rear seat.
Page 134 of 521
133 Controls in detailSeats
1Release catch
Removing rear seat head restraints
Fold the backrest forward
(page 271).
Fold back head restraint (
page 131).
Press head restraint release catch1
and pull the head restraints out of the
guides.
Fold the backrest back to its original
position.Installing rear seat head restraints
Lumbar support
The curvature of the driver’s seat can be
adjusted to help enhance lower back sup-
port and seating comfort.
1Adjustment lever
Move adjustment lever1 in direction
of the arrows until you have reached a
comfortable seating position.
iWhen installing the head restraints,
make sure that:
you place the correct head restraint
on the middle seat. It is marked
with the letter “M” on the outside of
the metal bars.
the head restraints engage fully.
Page 273 of 521
272 Controls in detailLoading
Pull release handle1.
The seat cushion automatically springs
upward slightly.
1Seat cushion
2Seat backrest
Grip the back of seat cushion1 and
fold forward.
Push the rear seat head restraints all
the way in.
Pull the handle in the trunk.
The seat backrest is released and the
head restraints fold back.
Fold the seat backrest forward.Returning seat backrest to original po-
sition
1Seat cushion
2Seat backrest
Swing seat backrest2 to the rear until
it engages.
Swing seat cushion1 to the rear and
press the center front of the cushion
until it audibly engages.
iIf tall persons have occupied the driv-
er’s and front passenger seats, it may
be necessary to move these seats for-
ward slightly in order to fold the rear
seat backrests forward.
iI f t h e r e a r c e n t e r s e a t i s t o b e o cc u p i e d
while driving, it may be necessary to
fold the seat belt buckle up again.
!Make sure the head restraints fit all the
way into the seat cushion pockets. This
will prevent the backrests from being
damaged during loading.
Page 509 of 521
508 IndexHead restraints 131
Folding back 132
Front seat, Adjusting 42
Rear seat, Removing and installing
Removing and installing 132
Headlamp cleaning system* 197
Headlamp shut-off delay see Delayed
shut-off, Exterior lamps
Headlamps
Automatic headlamp mode 142
Bi-Xenon*
Cleaning lenses 367
Cleaning system* 197
Halogen 436
High beam see High beam flasher
High beam see High beam headlamps
Low beam see Low beam headlamps
Manual headlamp mode 142
Messages in display 412, 413, 414,
415
Replacing bulbs 436
Switch 54
Headliner and shelf below rear window,
Cleaning and care of 371
Heated seats* 135
Heated steering wheel* 283Height adjustment
Vehicle level control 260
High beam flasher 145
High beam headlamps
Indicator lamp 25
Messages in display 414
Replacing bulbs 434
Switching on
High mounted brake lamp 434
Hood 319
Message in display 410
Horn 23
Hydroplaning 307
I
Identification labels 468
Identification Number, Vehicle (VIN) 468
Ignition 36, 50, 51
Switching on 51
Immobilizer 101
Indicator lamps see Lamps, indicator and
warning
Infant and child restraint systems see Chil-
dren in the vehicle
Inflation pressure see Tires, Inflation pres-
sure
Inside door handle 119Instrument cluster 24, 150, 495
Cleaning 370
Illumination brightness 150
Lamps 374
Messages in display see Multifunction
display messages
Multifunction display 153
Instrument lighting see Instrument cluster,
Illumination brightness
Instrument panel see Instrument cluster
Instruments and controls see Cockpit
Interior lighting
Delayed shut-off 173
Interior rear view mirror 45
Auto-dimming mirrors 197
Interior storage spaces see Storage com-
partments
J
Jack 422
Jump starting 454