Remote Start MERCEDES-BENZ E500 2005 W211 Owner's Manual

32 Getting startedThe “Getting started” section provides an
overview of the vehicle’s most basic func-
tions.
If you are already familiar with the basic
functions described here, the “Controls in
detail” section will provide you with further
information. The corresponding page refer-
ences are located at the end of each seg-
ment.Unlocking
Unlocking with the SmartKeySmartKey with remote control 1‹Lock button
2ŠUnlock button for trunk lid
3ŒUnlock button
4ÂPanic button (
page 84)

Press unlock button Πon the
SmartKey.
All turn signal lamps flash once. The ve-
hicle unlocks. The locking knobs in the
doors move up. The anti-theft alarm
system is disarmed.Warning!
G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.iThe SBC brake system is activated
(page 90).

98 Controls in detailIn the “Controls in detail” section you will
find detailed information on how to oper-
ate the equipment installed on your vehi-
cle. If you are already familiar with the
basic functions of your vehicle, this section
will be of particular interest to you.
To quickly familiarize yourself with the ba-
sic functions of the vehicle, refer to the
“Getting started” section of this manual.
The corresponding page numbers are giv-
en at the beginning of each segment.Locking and unlocking
For more information on locking and un-
locking, see “Getting started” (
page 32)
and (
page 56).
SmartKey
Your vehicle comes supplied with two
SmartKeys, each with remote control and
a removable mechanical key. The locking
tabs for the mechanical key portion of the
two SmartKeys are a different color to help
distinguish each key unit.
The SmartKey provides an extended oper-
ating range. To prevent theft, however, it is
advisable to only unlock the vehicle when
you are in close proximity to it.
The SmartKey centrally locks and unlocks

the doors


the trunk


the fuel filler flap
SmartKey with remote control1‹ Lock button
2Š Unlock button for the trunk lid
3Mechanical key locking tab
4ΠUnlock button
5Battery check lamp
6Â Panic button (
page 84)

112 Controls in detailLocking and unlockingClosing the trunk
Closing the trunk from the inside auto-
matically*
In vehicles with trunk lid opening/closing
system* you can close the trunk from the
inside using the remote trunk lid switch.
Press remote trunk lid switch
(page 111) until the indicator lamp in
the switch goes out and the trunk lid is
closed.
To interrupt the closing procedure:

Release the remote trunk lid switch.If the trunk lid comes into contact with an
object while closing (e.g. luggage that has
been piled too high), the closing procedure
is stopped and the trunk reopens slightly.iYou can also close the trunk by hand.
Warning!
G
Maintain sight of trunk area while operating
the door mounted switch. Monitor the clos-
ing procedure carefully to make sure that no
one is in danger of being injured.
To interrupt the closing procedure, release
the door mounted remote trunk lid switch.
Even with the SmartKey or SmartKey with
KEYLESS-GO* removed from the starter
switch or the SmartKey with KEYLESS-GO*
removed from the vehicle, the remote trunk
lid switch can be operated. Therefore, do
not leave children unattended in the vehicle,
or with access to an unlocked vehicle. Unsu-
pervised use of vehicle equipment may
cause an accident and/or serious personal
injury.
Warning!
G
Only drive with the trunk closed as, among
other dangers such as visibility blockage,
exhaust fumes may enter the vehicle
interior.

114 Controls in detailLocking and unlocking
Closing the trunk from the outside
(vehicles without KEYLESS-GO*)
In vehicles with trunk lid opening/closing
system* you can close the trunk separate-
ly from the outside using the trunk lid clos-
ing switch.
1Trunk lid closing switch
Press trunk lid closing switch1 brief-
ly.
The trunk lid closes.If the trunk lid comes into contact with an
object while closing (e.g. luggage that has
been piled too high), the closing procedure
is stopped and the trunk lid reopens slight-
ly.
iDo not place the SmartKey in the open
trunk. You may lock yourself out.
Vehicles with KEYLESS-GO*:
To prevent a possible inadvertent lock-
out, the trunk lid will open automatical-
ly if a SmartKey with KEYLESS-GO is
recognized inside the vehicle or in the
trunk.iIf the vehicle was previously centrally
locked, the trunk lid will lock automati-
cally after closing it (
page 112). The
turn signals will flash three times to
confirm locking.
iYou can also close the trunk by hand.
Warning!
G
Monitor the closing procedure carefully to
make sure no one is in danger of being in-
jured. To prevent possible personal injury,
always keep hands and fingers away from
the trunk opening when closing the trunk.
Be especially careful when small children
are around. To stop the closing procedure,
do one of the following:

press the trunk lid closing switch1


press the Š button on the SmartKey


press the remote trunk lid switch (on the
driver’s door)
Even with the SmartKey removed from the
starter switch, the remote trunk lid switch
can be operated. Therefore, do not leave
children unattended in the vehicle, or

283 Controls in detail
Useful features
Step 9:
Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the follow-
ing step.
Step 10:

Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (1, 2
or3).
Step 11:

Press, hold for two seconds and re-
lease same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.Step 12:

Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (1, 2
or3).
Step 13:

To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner. If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:

Continue to press and hold the inte-
grated signal transmitter button (1,
2 or3) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp4 will flash slowly and
then rapidly after several seconds.

Proceed with programming step 5 and
step 6 to complete.

284 Controls in detailUseful featuresOperation of integrated remote control
Switch on the ignition (
page 33).

Select and press the appropriate inte-
grated signal transmitter button (1,
2 or3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the integrated remote control
memory

Switch on the ignition (
page 33).

Simultaneously hold down the signal
transmitter buttons1 and 3, for ap-
proximately 20 seconds, until the indi-
cator lamp4 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:

Press and hold the desired signal trans-
mitter button (1, 2 or3). Do not re-
lease the button.

The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
iIf you sell your vehicle, erase the codes
of all three channels.

299 Operation
At the gas station
At the gas station
Refueling
The fuel filler flap is located on the
right-hand side of the vehicle towards the
rear. Locking / unlocking the vehicle with
the remote control automatically
locks / unlocks the fuel filler flap.

Turn the engine off

by turning the SmartKey to
position0.


by pressing the KEYLESS-GO*
start/stop button. Open the driv-
er’s door (with the driver’s door
open, starter switch is now in
position0, same as SmartKey re-
moved from starter switch).

Remove the SmartKey from the starter
switch.

Open the fuel filler flap by pushing at
the point indicated by the arrow.
The fuel filler flap springs open.

Turn the fuel cap to the left and hold on
to it until possible pressure is released.

Take off the cap and set it in the recess
on the fuel filler flap.
To prevent fuel vapors from escaping
into open air, fully insert filler nozzle
unit.

Only fill your tank until the filler nozzle
unit cuts out – do not top up or over-
fill.
Warning!
G
Gasoline and diesel fuel are highly flamma-
ble and poisonous. They burn violently and
can cause serious injury. Whenever you are
around gasoline or diesel fuel, avoid inhaling
fumes and skin contact, extinguish all smok-
ing materials. Never allow sparks, flame or
smoking materials near gasoline or diesel
fuel!
!Diesel engine:
When filling the diesel fuel tank using
fuel containers, place a filling filter, a
suede cloth or a clean flannel cloth into
the filler neck to filter the diesel fuel.
Otherwise, you could clog the fuel
lines.


485 Index
Emergency operations
Opening/closing sliding/pop-up roof*
or panorama sliding/pop-up
roof* 414
Releasing trunk lid from inside 117
Remote door unlock 278
Unlocking the trunk lid 411
Unlocking the vehicle 410
Emergency tensioning device see
ETD 70, 472
Emission control 297
Ending
A call (telephone) 172
Engine 450
Compartment 303
Message in the display 359, 360,
383
Starting 46
Starting with KEYLESS-GO* 47
Starting with the SmartKey 46, 47
Turning off with the key 56
Engine compartment
Hood 303
Engine malfunction indicator lamp 359,
360, 383
Engine number 472Engine oil
Adding 306
Checking level 304
Consumption 304
Display messages 387
Messages in display 305
Viscosity 472
ESP 87, 472
Four wheel electronic traction system
with ESP 93
Switching off 89
Switching on 90
Synchronizing 372
Warning lamp 357
ETD 472
Safety guidelines 64
Exterior lamp switch 133
Exterior rear view mirrors
Adjusting 41
Parking position for 168F
Fahrenheit
Setting temperature units 157
Fastening the seat belts 43
Fine adjustment
Cruise control 234
First aid kit 407
Flat tire 425
Collapsible tire 429
Mounting the spare wheel 425, 428
Spare wheel 425
Flexible Service System (Canada
vehicles) 343
Flexible Service System (FSS) 473
Fog lamp, rear 137
Fog lamps, front
Messages in display 392
Switching on 136
Following distance in Distronic* 242
Four wheel electronic traction system
(4MATIC) with ESP 93
4MATIC 93

486 IndexFront airbags 65
Front fog lamp
Replacing bulb 418
Front lamps 418
Messages in display 394
Replacing bulbs 420
Switching on 133
Front seat head restraints
Power seat 123
Removing and installing 123
Front seats
Heater* 127
FSS (Canada vehicles) 343
FSS (Flexible Service System) 473
Fuel 300
Fuel tank reserve warning lamp 362
Premium unleaded gasoline 300
Fuel consumption statistics
After start 170
Since last reset 170Fuel filler flap 299
Locking 299
Unlocking 299
Fuel requirements 466
Fuel reserve tank
Message in display 389
Fuel tank
Filler flap 299
Fuels, coolants, lubricants etc. 461
Functions (control system) 149
Resetting 155
Fuse chart 443
Fuses 443
Fuse chart 443
Fuse extractor 443
Spare fuses 443G
Garage door opener 29, 279
Erasing the integrated remote
control 284
Integrated remote control 281
Rolling code programming 282
Gasoline see Fuel 300
GAWR 337
Gear range 473
Automatic transmission 177
Limiting 177
Shifting into optimal 176
Gear range limit
Canceling 176
Gear selector lever
Position 178
Global
Locking 100
Locking with KEYLESS-GO* 105
Unlocking 99
Unlocking with KEYLESS-GO* 105
Global Positioning System (GPS) 473
Glove box 262
Closing 262
Opening 262

488 IndexInstrument cluster 24, 142, 353, 473
Coolant temperature gauge 143
Illumination 142
Multifunction display 145
Outside temperature indicator 144
Selecting language 158
Integrated remote control
Canadian programming 283
Erasing memory 284
Gate operator 283
Hand-held transmitter 281
Operation 284
Rolling code programming 282
Interior lighting 139
Activating automatic control 139
Delayed switch-off 165
Interior rear view mirror
Adjusting 41J
Jack 407
Jump starting 436
K
Key, Mechanical 410
Key, SmartKey
Changing the batteries 415, 416
Key, SmartKey with KEYLESS-GO*
Changing the batteries 415, 416
KEYLESS-GO* 473
Activating ignition with 36
Closing
Trunk 115, 116
Factory setting 105
Global locking 105
Global unlocking 105
Important notes 104
Remote controls 102
Starting the engine 47
Turning off engine 57
Unlocking and opening, trunk lid 108
Unlocking with 33
Kickdown 180, 473
Kilometers/miles in speedometer 157
Kilopascal 338
Km/h or mph in speedometer 157L
Lamp bulbs, exterior 417
Lamps, exterior
Front 418
Light sensor 394
Messages in display 394
Replacing bulbs for rear 418, 422
Lamps, indicator and warning
ABS 356
Airbag Off 66
Battery (SmartKey) 100, 106
Brakes 358
CHECK ENGINE 359, 360
Coolant 361
DTR* 237
Engine diagnostics 359, 360
ESP 357
Fuel reserve 359, 360
Maintenance service indicator 343
SBC 90
Seat belts 359, 360, 362
SRS 61
Language
Multifunction display 158
Setting 158
LATCH child seat anchors 81