climate control MERCEDES-BENZ G500 2007 W463 User Guide

188 Controls in detail
Climate control
Deactivating
Press button0 orP
(
page 183) once more.
The indicator lamp on the button goes
out. Defrosting is switched off.
Windshield fogged on the outside
Switch the windshield wipers on
(
page 58).
If the automatic mode of the climate
control is switched off:
Turn air distribution control4
toaorY (
page 183).
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside (e.g. before driving
through a tunnel). This setting cuts off the
intake of outside air and recirculates the
air in the passenger compartment.Activating
Press button, (page 183).
The indicator lamp on the button
comes on.
iThe cooling remains switched on.
iKeep this setting selected only until the
windshield is clear again.Warning!G
Fogged windows impair visibility, endanger-
ing you and others. If the windows begin to
fog on the inside, switching off the air
recirculation mode immediately should clear
interior window fogging. If interior window
fogging persists, make sure the air
conditioning (
page 189) is activated, or
press button0 orP.
iThe air recirculation mode is activated
automatically at high outside temperatures.
The indicator lamp on button, is not lit when
the air recirculation mode is switched on auto-
matically.
A quantity of outside air is added after approxi-
mately 30 minutes.
If you have turned off the air conditioning
(
page 189) or the outside temperature is
below 41°F (5°C), the air recirculation mode will
not switch on automatically.

189 Controls in detail
Climate control
Deactivating
Press button, (page 183) once
more.
The indicator lamp on the button goes
out.
Air conditioning
The cooling function, only operational
when the engine is running, cools the
vehicle interior down to the selected
temperature. The cooling function also
dehumidifies the air in the vehicle interior,
thus preventing the windows from fogging
up.Deactivating
It is possible to deactivate the air condi-
tioning (cooling) function of the climate
control system. The air in the vehicle will
then no longer be cooled or dehumidified.
Press button9 (page 183).
The indicator lamp on the button goes
out.
The cooling function switches off after
a short delay.iThe air recirculation mode is deactivated
automatically:

after 5 minutes if the outside temperature is
below approximately 41°F (5°C)

after 5 minutes if the air conditioning is
turned off

after 30 minutes if the outside temperature
is above approximately 41°F (5°C)
iCondensation may drip out from underneath
the vehicle. This is normal and not an indication
of a malfunction.
Warning!G
If you turn off the cooling function, the inte-
rior air is not dried. The windows can fog up
more quickly. Window fogging may impair
visibility and endanger you and others.

190 Controls in detail
Climate control
Activating
Moist air can fog up the windows. You can
dehumidify the air with the air condition-
ing.
Press button9 (page 183) once
more.
The indicator lamp on the button
comes on.
The air conditioning uses the refrigerant
R134a. This refrigerant is free of CFCs
which are harmful to the ozone layer.
Residual heat and ventilation
With the engine switched off, it is possible
to continue to heat or ventilate the interior
for up to 30 minutes. This feature makes
use of the residual heat produced by the
engine.Activating
Turn the SmartKey in the starter switch
to position0 or1 (
page 39).
or
Remove the SmartKey from the starter
switch.
Press button9 (page 183).
The indicator lamp on the button
comes on.
Deactivating
Press button9 (page 183) once
more.
The indicator lamp on the button goes
out.!If the air conditioning cannot be turned on
again, this indicates that the air conditioning is
losing refrigerant. The compressor has turned
itself off.
Have the air conditioning checked at the nearest
authorized Mercedes-Benz Light Truck Center.
iHow long the system will provide heating
depends on

the coolant temperature

the battery voltage
Regardless of the temperature and air volume
set on the climate control panel, an interior
temperature is aimed at by 72°F (22°C) and the
blower runs on low speed to protect the vehicle
battery.
iThe residual heat is automatically turned off:

when the ignition is switched on

after about 30 minutes

if the coolant temperature is too low

if the battery voltage drops

191 Controls in detail
Climate control
Rear passenger compartment
adjustable air vents
The air conditioning for the rear passenger
compartment is controlled via the climate
control panel (
page 183).
The air vents for the rear passenger
compartment are located in the rear
center console.
1Thumbwheel for air volume control for
center air vents
2Left center air vent, adjustable
3Right center air vent, adjustableAdjusting air distribution
Push the slide for the left center
vent2 or right center air vent3 to
the left, right, up, or down.
The air flow is directed in the
corresponding direction.
Adjusting air volume
Turn thumbwheel1 up.
The air volume is increased.
Turn thumbwheel1 down.
The air volume is decreased.iThe temperature at the center air vents2
and3 for the rear passenger compartment is
the same as at the dashboard center air vents.
iFor draft-free ventilation, move the sliders
for the center air vents2 and3 upward.

258 Operation
Driving instructions

Comply with the warnings
(
page 253) and rules for off-road
driving (
page 253).

Switch off the exterior lamps as well as
the climate control.

Select gear range2 or1 on the auto-
matic transmission (
page 167).

Enter and leave the water only at a
shallow spot, driving at walking speed.

Drive through the water slowly and at a
constant speed.

Do not stop vehicle while immersed in
water, and do not shut off the engine.
There is a very high level of driving
resistance in water. The surface is
slippery and may not be firm, making
pulling away in water difficult and
dangerous.

Make sure that only small bow waves
are formed when driving the vehicle
through water.

Clean mud off the tire tread after
driving through water.

To dry the brakes, apply pressure to the
brake pedal several times after leaving
the water.Crossing obstacles
!Never accelerate before driving into the
water. The bow wave could force water into the
engine and auxiliary equipment, thus damaging
them.
!Do not open any of the vehicle’s doors while
driving through water. Water could otherwise en-
ter the vehicle interior and damage the vehicle’s
electronics, as well as the interior equipment.
!Obstacles can damage the vehicle
underbody or suspension components. If possi-
ble, use the assistance of a second person out-
side the vehicle to scout the path you intend to
take and check for adequate ground clearance
when you cross obstacles with your vehicle. The
person assisting you outside the vehicle should
always be a safe distance away from the vehicle
and positioned so that he or she cannot get hurt
in case of any unexpected vehicle movement.
After off-road driving or crossing obstacles,
inspect vehicle for any damage, especially
vehicle underbody and suspension components.
Failure to do so can adversely affect the vehi-
cle’s future performance, including increased
chance of an accident.

302 Operation
Tires and wheels
Uniform Tire Quality Grading Standards
(U.S. vehicles)
Tire manufacturers are required to grade
tires based on three performance
factors: treadwear, traction and
temperature resistance.
1Treadwear
2Traction
3Temperature resistanceQuality grades can be found, where
applicable, on the tire sidewall between
tread shoulder and maximum section
width. For example:
All passenger car tires must conform to
federal safety requirements in addition to
these grades.Treadwear
The treadwear grade is a comparative rat-
ing based on the wear rate of the tire when
tested under controlled conditions on a
specified government test course. For
example, a tire graded 150 would wear one
and one-half (1
1/2) times as well on the
government course as a tire graded 100.
The relative performance of tires depends
upon the actual conditions of their use,
however, and may depart significantly
from the norm due to variations in driving
habits, service practices and differences in
road characteristics and climate.
iFor illustration purposes only. Actual data
on tires are specific to each vehicle and may vary
from data shown in above illustration.
TreadwearTractionTemperature
200AAA

317 Operation
Vehicle care
Rinse with clean water and thoroughly
dry with a chamois.
Do not allow cleaning agents to dry on
the finish.
Automatic car wash
You can have your car washed in an auto-
matic car wash from the start. Automatic
car washes without brushes are prefera-
ble.
To protect the filter system, switch the
climate control to air recirculation
mode (
page 183).If the vehicle is very dirty, prewash it
before running it through the automatic
car wash.Ornamental moldings
For regular cleaning and care of
ornamental moldings, use a damp cloth.
!Do not use scouring agents on these parts.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the vehicle.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the paint.
!Do not clean your vehicle in an automatic
touchless car wash which use caustic spray.
Otherwise the caustic spray will damage the
paint or ornamental moldings.
!Make sure that the windshield wiper switch
is set to0 (
page 58). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent
damage to the mirrors.
iAfter running the vehicle through an auto-
matic car wash, wipe any wax off of the wind-
shield (
page 319). This will prevent smears
and reduce wiping noise which can be caused by
residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may
vibrate.
!Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which you
are sure are chrome-plated, use a chrome
cleaner. If in doubt whether an ornamental
molding is chrome-plated, contact an authorized
Mercedes-Benz Light Truck Center.

432 Index
Air pressure 304
Air pressure see Tire inflation pressure
Air recirculation mode 188
Activating 188
Deactivating 189
Air vents, Rear
Climate control 191
Air volume
Adjusting 186
Alarm
Audible 87, 96
Canceling 97, 98
Visual 96
Alarm system
Anti-theft 96
Anticorrosion/antifreeze 428
Anti-theft alarm system
Arming 97
Canceling alarm 97
Disarming 97
Anti-theft systems 96
Anti-theft alarm system 96
Tow-away alarm 98
Aquaplaning see HydroplaningArmrest
Storage box in front of 217
Storage compartments below 216
Telephone* tray below 216
Ashtrays 220
In center console 220
In rear passenger compartment 221
Aspect ratio 304
At the gas station 264
ATF (automatic transmission fluid) 273
Audio menu 141
Selecting radio station 141
Audio search function 155
Auto-dimming for rear view mirror 177
Automatic central locking
Activating/deactivating (control
system) 155
Automatic headlamp mode 118
Automatic locking when driving 106
Automatic operation
Interior lighting control 125Automatic transmission 162
Accelerator position 166
Emergency operation (Limp Home
Mode) 169
Fluid level 273
Gear ranges 167
Gear selector lever 162
Gear selector lever position 163, 164
Gear shifting malfunctions 169
Kickdown 166
One-touch gearshifting 168
Shifting procedure 163
Transmission fluid 273
B
BabySmart
TM
Air bag deactivation system 81
Compatible child seats 81
Self-test 82
Backup lamp
Message in display 357
Backup lamps
Bulbs 378
Replacing bulbs 386
Bar 304
BAS 88, 90

434 Index
Cargo tie-down rings 209
Carpets, Cleaning 321
Catalytic converter 262
CD changer 368
CD player
Operating 143
Center console 30
Front passenger front air bag off
indicator lamp 337
Lower part 31
Upper part 30
Central locking
From inside 107
Switch 107
Switching on/off (control
system) 155
Unlocking from inside 107
Central unlocking
Switch 107
Certification label 412
Charging
Vehicle battery 398
Checking
Coolant level 266, 274
Oil level 266, 269Checking tire pressure electronically with
the Advanced Tire Pressure Monitoring
System (Advanced TPMS) 289
Checklist
Off-road driving 254
Child safety 78
Infant and child restraint systems 68,
79
LATCH child seat anchors 83
Child safety switch see Blocking of rear
door window operation
Cigarette lighter 222
Cleaning
Gear selector lever 321
Headlamps 177
Headliner 321
Leather upholstery 322
Light alloy wheels 320
Rear Parking Assist sensors 318,
319
Seat belts 321
Steering wheel 321Upholstery 322
Windows 319
Windshield 59
Wiper blades 319
Wood trims 322
Cleaning tires 279
Climate control 182
Adjusting air distribution 186
Adjusting air volume 186
Air conditioning 189
Air recirculation mode 188
Defogging windshield 188
Defrosting 187
Rear window defroster 181
Residual heat utilization (REST) 190
Setting the temperature 185
Windshield defroster 180
Clock 27
Closing
Glove box 215
Hood 269
Tailgate 106
Tilt/sliding sunroof 196, 374
Windows 192
Closing tilt/sliding sunroof
In an emergency 374