tailgate MERCEDES-BENZ G500 2008 W463 Owner's Guide

213
Controls in detail
Loading
Hanging up partition net
1 Partition net
2 Holder
Hang partition net 1 on holder 2 and
push forward in direction of the arrow. Pulling partition net tight
3 Lift tensioner
4 Tightening belt
5 Belt hook
6 Cargo tie-down ring
Lift tensioner 3 on tightening belt 4
must point in direction of the tailgate.
Use lift tensioner 3 to set the length
of tightening belt 4 to cargo tie-down
ring 6.
Hook belt hook 5 into cargo tie-down
ring 6.
Pull tightening belt 4 by the loose end
until the partition net is pulled tight.
After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Loosening partition net
Loosen tightening belt 4 by pulling lift
tensioner 3 upward.
Remove belt hook 5 from cargo
tie-down ring 6.
Removing and storing partition net
Take partition net 1 out of holder 2.
Roll up partition net and secure it.
Store partition net behind the rear seat
bench.
W463.boo Seite 213 Montag, 19 . November 2007 8:41 08

214 Controls in detail
Loading
Cargo compartment cover blind
The cargo compartment cover blind can be
installed behind the rear seat bench.1 Rear seat bench cover blind
2 Tailgate cover blind Rolling out blind
Grip the blind strap and pull blind
1
forward across the cargo compart-
ment.
Engage blind into the mounts on the
rear seat backrest and release.
Grip the blind strap and pull blind 2
rearward across the cargo compart-
ment.
Engage blind into the mounts to the left
and right of the tailgate.
Rolling up blind
Disengage blind 1 from the mounts
on the rear seat backrest and guide
retraction by its blind strap.
Disengage blind 2 from the mounts to
the left and right of the tailgate and
guide retraction by its blind strap. Removing and installing blind
1 Latch
2 Blind
Removing blind
Roll the blind up (page 214).
Open latch 1 on the right and left side
of blind 2 in direction of the arrow.
Pull blind 2 out upwards.
Installing blind
Place blind into recesses.
Press the right and left side of blind
down until blind locks into place.
W463.boo Seite 214 Montag, 19 . November 2007 8:41 08

235
Controls in detail
Useful features
Call priority
If other service calls such as a Roadside
Assistance call or Information call are
active, an Emergency call is still possible.
In this case, the Emergency call will take
priority and override all other active calls.
Remote door unlock
In case you have locked your vehicle unin-
tentionally (e.g. SmartKey inside vehicle),
and the reserve SmartKey is not handy:
Contact the Mercedes-Benz Response
Center at 1-800-756-9018 (in the USA)
or 1-888-923-8367 (in Canada).
You will be asked to provide your pass-
word which you provided when you
completed the subs
criber agreement.
Then return to your vehicle at the time
arranged with the Response Center
and press the tailgate lock for a
minimum of 20 seconds until the
SOS button is flashing.
The message
Connecting call
appears in the multifunction display.
As an alternative, you may unlock the vehi-
cle via Internet using the ID and password
sent to you shortly after the completion of
your acquaintance call.
!If the indicator lamps do not start flashing
after pressing one of the buttons or remain
illuminated (in red) at any time, the Tele Aid
system has detected a malfunction or the
service is not currently active, and may not
initiate a call. Visit your authorized
Mercedes-Benz Light Truck Center and have the
system checked or contact the Response Center
at 1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada) as soon as
possible.
iThe indicator lamp in the respective button
flashes until the call is concluded. Emergency
calls can only be terminated by a Response
Center or Customer Assistance Center repre-
sentative, whereas Roadside Assistance and
Information calls can also be terminated using
the t button on the multifunction steering
wheel or the END button on the COMAND
system headunit.
!If the indicator lamp continues to flash or
the system does not reset, contact the Response
Center at 1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada), or Mercedes-Benz
Customer Assistance at 1-800-FOR-MERCedes
(1-800-367-6372) in the USA or Customer
Service at 1-800-387-0100 in Canada.
W463.boo Seite 235 Montag, 19 . November 2007 8:41 08

236 Controls in detail
Useful features
The Response Center will then unlock your
vehicle with the remote door unlocking
feature.Stolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered
incident report.
Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is
located, the Response Center will
contact the local law enforcement and
you. The vehicle’s location will only be
provided to law enforcement.
Garage door opener
The integrated remote control is capable of
operating up to three separately controlled
devices. It provides a convenient way to
replace up to three hand-held remote
controls used to operate devices such as
garage door openers, gate openers, or
other devices compatible with HomeLink
®
or some other systems.
Before the integrated remote control can
be used, it must be programmed to the
garage door opener, ga te operator or other
device you wish to operate. See the follow-
ing instructions for programming informa-
tion.
iThe remote door unlock feature is
available if the relevant cellular phone network
is available.
The SOS button will flash and the message
Connecting call will appear in the multi-
function display to indicate receipt of the door
unlock command.
Once the vehicle is unlocked, a Response Center
specialist may attempt to establish voice contact
with the vehicle occupants.
If the tailgate lock was pressed for more than
20 seconds before door unlock authorization
was received by the Response Center, you must
wait 15 minutes before pressing the tailgate lock
again.
iWhen the anti-theft al arm stays on for more
than 30 seconds, a call is initiated automatically
to the Response Center. For more information,
see “Anti-theft systems” (
page 95).
W463.boo Seite 236 Montag, 19 . November 2007 8:41 08

254 Operation
Driving instructions
Checklist before off-road driving
Engine oil level

Check the engine oil level with the
control system (
page 270). The
message
Engine oil level OK must
appear in the multifunction display.
Only then can the vehicle obtain a
trouble-free oil supply, even on steep
gradients.
!Observe the following during off-road
driving:

Keep doors, tailgate, windows, and
tilt/sliding sunroof closed.

Switch cruise control off.

Adjust vehicle speed to condition of terrain.
The more uneven, rutty, and steeper the
terrain, the lower the speed should be. Drive
through water slowly at an even speed,
avoiding a bow wave.

Be especially careful when driving in
unknown territory. It may be necessary to
get out of the vehicle and scout the path you
intend to take.

Watch out for obstacles, such as rocks,
holes, tree stumps, and ruts.

Avoid excessive engine speeds – drive at
moderate engine speeds (max. 3 000 rpm).

Before driving through water, determine its
depth.

Do not stop vehicle while immersed in water,
and do not shut off the engine.

In sandy soil, drive at a steady speed as
allowed by conditions. This helps overcome
the vehicle rolling resistance and reduces
the likelihood of the vehicle sinking into the
ground.

Do not initiate jumps with the vehicle. It
interrupts the forward momentum of the
vehicle.

Always drive on slopes with the engine
running and the vehicle in gear.

Inspect the vehicle for possible damage after
each off-road trip.
Warning!G
Do not reduce the tire inflation pressure
before driving through sand. However, if you
do so, remember to correct the tire inflation
pressure (
page 288) before continuing
your trip. Driving with reduced tire inflation
pressure increases the risk of losing control
of the vehicle and rolling over.
!If a engine oil level warning message
(
page 349) appears in the multifunction
display while driving, stop the vehicle in a safe
location or as soon at is safe to do so. Check the
engine oil level (
page 270).
The engine oil level warning messages should
not be ignored. Extended driving with the
message displayed could result in serious engine
damage that is not covered by the
Mercedes-Benz Limited Warranty.
W463.boo Seite 254 Montag, 19 . November 2007 8:41 08

362 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
LTele Aid
inoperativeOne or more main functions of the
Tele Aid system are malfunctioning.Have the Tele Aid system checked at an
authorized Mercedes-Benz Light Truck
Center.
tFunction
unavailableThis message appears if buttont
or s on the multifunction steering
wheel is pressed and the vehicle is not
equipped with a telephone*.
ÊThis message will appear whenever the
tailgate is open.Close the tailgate.
W463.boo Seite 362 Montag, 19 . November 2007 8:41 08

365
Practical hints
Where will I find...?
Vehicle jack
The vehicle jack is stored in a storage com-
partment under the rear bench seat on the
passenger side.
1 Cover
2 Tab
3 Vehicle jack
Fold the rear bench seat forward
(
page 207).
Open cover 1.
Open tab 2 and remove vehicle
jack 3 from the compartment. Observe the safety guid
elines in the “Flat
tire” section (
page 388) when using the
vehicle jack.
Warning!G
The jack is designed exclusively for jacking
up the vehicle under the axle housing. To
help avoid personal inju ry, use the jack only
to lift the vehicle during a wheel change.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always firmly set parking brake and block
wheels before raising vehicle with jack.
Do not disengage park ing brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface.
Make sure the jack is positioned correctly
under the axle housin g. Always lower the
vehicle onto sufficient capacity jackstands
before working under the vehicle.
If the vehicle is not raised as described, it
could slip off the jack as a result of vibra-
tions (e.g. opening or closing a door or the
tailgate).
W463.boo Seite 365 Montag, 19 . November 2007 8:41 08

366 Practical hints
Where will I find...?
CD changer
The CD changer is located on the driver’s
side of the cargo compartment.
CD changer
For information on CD changer operation,
see separate COMAND system operating
instructions.
Spare wheel
The spare wheel is located under a cover
on the outside of the vehicle’s tailgate.
For information on rim and tire specifica-
tions, see “Rims and tires” (
page 414).
Removing cover
1 Lock
2 Tab
Open lock 1 for cover ring 3 with
screwdriver or coin.
Fold tab 2 downwards. 3
Cover ring
4 Cover plate
Pull cover ring 3 slightly outwards in
direction of arrows and remove.
Pull cover plate 4 towards you.
W463.boo Seite 366 Montag, 19 . November 2007 8:41 08

368 Practical hints
Unlocking/locking in an emergency
Unlocking the vehicle
If you cannot unlock the vehicle with the
SmartKey, open the driver’s door and the
tailgate using the mechanical key.Removing the mechanical key
1 Mechanical key locking tab
2 Mechanical key
Move locking tab 1 in direction of
arrow.
Slide the mechanical key 2 out of the
housing. Unlocking the driver’s door
Insert the mechanical key into the
driver’s door lock cy
linder until it stops.
Turn the mechanical key counterclock-
wise until the locking knob moves up.
The driver’s door is unlocked.
Remove the mechanical key.
Press lock cylinder and pull on door
handle to open the driver’s door.
iUnlocking the driver’s door and the tailgate
with the mechanical key will trigger the anti-theft
alarm system.
To cancel the alarm:

Press button Œ or‹ on the
SmartKey.

Insert the SmartKey in the starter switch.
W463.boo Seite 368 Montag, 19 . November 2007 8:41 08

369
Practical hints
Unlocking/locking in an emergency
Unlocking the tailgateInsert the mechanical key into lock
cylinder
2.
Turn the mechanical key counterclock-
wise to position 1 and release it.
Remove the mechanical key.
Press lock cylinder 2 and pull on door
handle 3 to open the tailgate.
Locking the vehicle
If you cannot lock the vehicle with the
SmartKey, lock the vehicle with the
mechanical key carrying out the following
steps:
Close the front passenger door, the
rear doors and the tailgate.
Open the driver’s door.
Press the central locking switch in the
center console (
page 107).
The locking knobs on the front
passenger door, the rear doors and the
tailgate move down.
If the vehicle battery is disconnected or
drained:
Press down the locking knobs on
the front passenger door, the rear
doors and the tailgate manually.
Exit the vehicle.
1Unlocking in an emergency
2Lock cylinder
3Door handle
Warning!G
The tailgate swings open to one side. Always
make sure there is sufficient clearance for
tailgate.

W463.boo Seite 369 Montag, 19 . November 2007 8:41 08