high beam MERCEDES-BENZ G55AMG 2003 W463 Owner's Manual

Contents
Introduction.......................................... 9
Product information ................................ 9
Operator’s Manual ............................... 10
Service and warranty information .. 10
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 11
Maintenance .................................. 12
Roadside Assistance ...................... 12
Change of address or ownership.... 13
Operating your vehicle outside the
USA or Canada............................... 13
Where to find it .................................... 15
Symbols ............................................... 16
Operating safety .................................. 17
Proper use of the vehicle ............... 17
Problems with your vehicle .................. 18
Reporting safety defects...................... 19
Reporting safety defects ................ 19
At a glance.......................................... 21
Cockpit ................................................. 22
Instrument cluster ................................ 24
Multifunction steering wheel ................ 26
Center console ..................................... 27
Upper part ...................................... 27
Lower part ...................................... 28
Overhead control panel ........................ 29
Door control panel................................ 30Getting started................................... 31
Unlocking ............................................. 32
Unlocking with the SmartKey.......... 32
Adjusting .............................................. 34
Seats............................................... 34
Steering wheel ................................ 37
Mirrors ............................................ 38Driving .................................................. 40
Fastening the seat belt ................... 40
Starting the engine ......................... 43
Switching on headlamps ................. 46
Turn signals and high beam ............ 46
Windshield wipers ........................... 47
Rear window wiper/washer ............ 48
Problems while driving .................... 49
Parking and locking .............................. 50
Parking brake ................................. 50
Switching off headlamps................. 51
Turning off engine ........................... 51
Safety and Security........................... 53
Occupant safety ................................... 54
Airbags ........................................... 55
Seat belts ....................................... 60
Children in the vehicle .................... 63
Blocking rear door window
operation ........................................ 69
Panic alarm .......................................... 70

23 At a glance
Cockpit
Item
Page
1
Combination switch

Turn signals
46


Windshield wipers
47


High beam
46
2
Headlamp cleaning system
148
3
Cruise control lever
162
4
Instrument cluster
24
5
Lever for voice control sys-
tem, see separate operat-
ing instructions
Item
Page
6
Starter switch
33
7
Glove box
176
8
Multifunction steering
wheel
26,
112,
194
9
Horn
10
Steering wheel adjustment
stalk
37,
194
11
Exterior lamp switch
46,
100
12
Exterior rear view mirror
adjustment
38

25 At a glance
Instrument cluster
Item
Page
1
Reset knob for:

Resetting trip odometer
109


Resetting individual or all
settings
119,
120,
131,
231


Instrument cluster illumi-
nation
108
2
L
Left turn signal indica-
tor
24
3
?
Engine malfunction in-
dicator lamp
243
v
Electronic Stability
Program (ESP)
75,
238,
239
A
High beam headlamp
indicator
46,
103
Item
Page
4
K
Right turn signal indi-
cator
24
5
Fuel gauge with:Fuel reserve warning lamp
24
1
SRS malfunction
58,
242
<
Fasten seat belts
60,
243
6
Multifunction display with:
111
Trip odometer
24
Main odometer
24
Transfer case program mode
141
Selector lever position
135
Outside temperature indica-
tor
110
Digital clock
111
Item
Page
7
Speedometer
8
Tachometer with:;
Brake warning lamp
(except Canada)
44,
241
3
Brake warning lamp
(Canada only)
44,
241
-
ABS malfunction indi-
cator lamp
71,
240

46 Getting startedDrivingSwitching on headlampsExterior lamp switch1Off
2Low beam headlamps on
Turn the switch to
B
.
More information can be found in the
“Controls in detail” section (page 100).
Turn signals and high beam
The combination switch is on the left of the
steering column.Combination switch1Turn signals, right
2Turn signals, left
Press combination switch up1 or
down2.
The switch is automatically canceled
when the steering wheel is turned a
sufficient degree.High beam

Push the combination switch forward.
The high beam symbol
A
in the
instrument cluster lights up.
More information can be found in the
“Controls in detail” section (
page 103).
iTo signal minor directional changes,
move combination switch to point of
resistance only and release. The turn
signal blinks three times.

100 Controls in detailLighting
LightingFor notes on how to switch on the head-
lamps and use the turn signals, see the
“Getting started” section (
page 46).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel
M
Off
U
Automatic headlamp mode
C
Parking lamps (also side marker
lamps, tail lamps, license plate
lamps, instrument panel lamps)
Canada only: When engine is run-
ning, the low beam is additionally
switched on.
B
Parking lamps plus low beam or
high beam headlamps (combination
switch pushed forward).
ˆ
Standing lamps, right (turn left one
stop)
‚
Standing lamps, left (turn left two
stops)
iIf you remove the key and open the
driver’s door while the parking lamps or
low beam headlamps are switched on,
then

a warning sounds


$
appears in the multifunction
display


the message
SWITCH OFF LIGHTS

appears in the multifunction display
iWith the daytime running lamp mode
activated and the engine running, the
low beam headlamps cannot be
switched off manually.

102 Controls in detailLightingDaytime running lamp mode
Turn exterior lamp switch to
position
M
or
U
.
When the engine is running, the low beam
headlamps are automatically switched on.
In low ambient light conditions the parking
lamps will also switch on.
Canada only
When you shift from a driving position to
positionN orP, the low beam switches off
(three minutes delay).
For nighttime driving, you should turn the
exterior lamp switch to position
B
to
permit activation of the high beam head-
lamps.
USA only
The high beam headlamps can also be ac-
tivated when driving with the daytime run-
ning lamp mode activated and exterior
lamp switch in position
M
.To activate the daytime running lamp
mode, see “Setting daytime running lamp
mode” (
page 124).
Locator lighting and night security illu-
mination
Locator lighting and night security illumi-
nation are described in the control system
section under “Setting locator lighting”
(
page 125) and “Setting night security il-
lumination” (
page 125).
Exterior rear view mirror lamps
If the vehicle is centrally unlocked in the
darkness, the lamps in the exterior rear
view mirrors light up.If a door is opened, the lamp on this side
goes out. If no doors are opened, the
lamps go out:


when the ignition is switched on


after a maximum of 40 seconds
Switching on front fog lamps

Check that the low beam headlamps
are switched on.

Pull out exterior lamp switch to first
stop.
The green indicator lamp
‡
in the
lamp switch lights up.
iSee notes on the exterior lamp switch
(page 100).
iFog lamps will operate with the parking
lamps and/or the low beam headlamps
on. Fog lamps should only be used in
conjunction with low beam headlamps.
Consult your State or Province Motor
Vehicle Regulations regarding allow-
able lamp operation.

103 Controls in detail
Lighting
Switching on rear fog lamp
Check that the low beam headlamps
are switched on.

Pull out exterior lamp switch to second
stop.
The yellow indicator lamp
†
in the
lamp switch lights up.
Combination switch
The combination switch is located on the
left side of the steering column.
1High beam
2High beam flasher
Switching on high beams
Turn exterior lamp switch to
position
B
or to
U

(
page 100).

Push the combination switch in
direction1.
The high beam symbol
A
in the
instrument cluster lights up.High beam flasher

Pull the combination switch briefly in
direction2.
Hazard warning flasher
The hazard warning flasher can be activat-
ed with the ignition switched on or off. It is
activated automatically when an airbag is
deployed.
The switch is located on the center con-
sole.
1Hazard warning flasher switch

260 Practical hintsWhat to do if …Display
Possible cause
Suggested solution
Category
.
BRAKE LAMP
VISIT WORKSHOP!
Brake lamp illumination is delayed or
lamp is permanently on.

Visit an authorized
Mercedes-Benz Light Truck
Center as soon as possible.
2
BRAKE LAMP, L
CHECK LAMP!

The left brake lamp is malfunction-
ing.

Visit an authorized
Mercedes-Benz Center as
soon as possible.
2
BRAKE LAMP, R
CHECK LAMP!

The right brake lamp is malfunction-
ing.

Visit an authorized
Mercedes-Benz Center as
soon as possible.
2
DISPLAY DEFECTIVE
VISIT WORKSHOP!
The display for the lamps or the sys-
tem is malfunctioning.

Visit an authorized
Mercedes-Benz Light Truck
Center as soon as possible.
2
FRONT FOGLAMP, L
CHECK LAMP!

The left front fog lamp is malfunc-
tioning.

Replace the bulb as soon as
possible.
2
FRONT FOGLAMP, R
CHECK LAMP!

The right front fog lamp is malfunc-
tioning.

Replace the bulb as soon as
possible.
2
HIGH BEAM, L
CHECK LAMP!

The left high beam lamp is malfunc-
tioning.

Replace the bulb as soon as
possible.
2
HIGH BEAM, R
CHECK LAMP!

The right high beam lamp is malfunc-
tioning.

Replace the bulb as soon as
possible.
2

279 Practical hints
Replacing bulbs
Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See your autho-
rized Mercedes-Benz Light Truck Center
for headlamp adjustment.
Bulbs Front lamps
iBackup bulbs will be brought into use
when the following lamps malfunction:

Parking lamps


Turn signal lamps


Tail lamps
Lamp
Type
1
Additional turn sig-
nal lamp
LED
2
S i d e t u r n s i g na l l a m p
WY 5 W
3
Turn signal lamp
1156 NA
4
High and low beam
H4 60 (55 W)
Parking and stand-
ing lamps
T 4 W
5
Side marker lamp
T 4 W
6
Fog lamp
H3 (55 W)

282 Practical hintsReplacing bulbs1Protection cover
2Electrical connector (parking and
standing lamps)
3Electrical connector (high and low
beam)4Retainer spring
5Bulb for high and low beam
6Bulb socket for parking and standing
lamps
High and low beam bulb

Remove protection cover1.

Pull off electrical connector3.

Unclip retainer spring4.

Remove bulb5.

Insert new bulb so that the base lo-
cates in the recess on the holder.

Clip in retainer spring4.

Plug electrical connector3 onto
bulb5.

Press on protection cover1.
Parking and standing lamp bulb

Pull off electrical connector2 from
bulb6.

Push bulb6 into socket, turn counter-
clockwise and remove.

Insert new bulb6 in socket, push in
and turn clockwise until it clicks in.

Plug electrical connector2 onto
bulb6.