ignition MERCEDES-BENZ G55AMG 2008 W463 Owner's Manual

39
Getting started
Unlocking
Press unlock button
Πon the
SmartKey.

All turn signal lamps flash once.

The locking knobs in the doors
move up.

The anti-theft alarm system is
disarmed.

The locator lighting comes on if the
feature is enabled in the control
system (
page 152).
Enter the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 100).
Starter switch positions
SmartKey
Starter switch
0 For removing SmartKey
The steering is locked when the
SmartKey is removed from the starter
switch.
1 Power supply for some electrical
consumers, such as seat adjustment
2 Ignition (power supply for all electrical
consumers) and driving position
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster
remains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
page 324).
3 Starting position
Warning!G
When leaving the vehicl e, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.
W463.boo Seite 39 Montag, 19. November 2007 8:41 08

40 Getting started
Unlocking
For information on starting the engine, see
(
page 54).
iWhen you switch on the ignition, the indica-
tor and warning lamps (except high beam head-
lamp indicator lamp and turn signal indicator
lamps unless activated) in the instrument cluster
come on. The indicator and warning lamps
(except high beam headlamp indicator lamp and
turn signal indicator lamps if activated) will go
out when the engine is running. This indicates
that the respective systems are operational.
iThe SmartKey can only be removed from the
starter switch with the gear selector lever in park
position P.
iIf the SmartKey is left in starter switch
position 0 for an extended period of time, it can
no longer be turned in the switch. In this case,
the steering is locked. To unlock, remove
SmartKey from the starter switch and reinsert.
!If the SmartKey cannot be turned in the
starter switch, the battery may not be
sufficiently charged.

Check the battery and charge it if necessary
(
page 396).

Get a jump start (page 397).
To prevent accelerated vehicle battery discharge
or a completely discharged vehicle battery,
always remove the SmartKey from the starter
switch when the engine is not in operation.
W463.boo Seite 40 Montag, 19. November 2007 8:41 08

42 Getting started
Adjusting
Seat adjustment
The seat adjustment switches are located
on the respective front door.1 Head restraint height
2 Seat backrest tilt
3 Seat fore and aft adjustment
4 Seat cushion tilt
5 Seat height
Switch on the ignition (page 39).
or
Open the respective front door.
Warning!G
According to accident statistics, children
are safer when properly restrained in the
rear seating positions than in the front seat-
ing position. Thus, we strongly recommend
that children be placed in the rear seats
whenever possible. Regardless of seating
position, children 12 years old and under
must be seated and properly secured in an
appropriately sized infant restraint, toddler
restraint, or booster seat recommended for
the size and weight of the child. For addi-
tional information, see “Children in the vehi-
cle” (
page 77).
A child’s risk of serious or fatal injuries is
significantly increased if the child restraints
are not properly secured in the vehicle
and/or the child is no t properly secured in
the child restraint.
!When moving the seat, make sure

there are no items in the footwell or behind
the seat

the cup holder next to the armrest is
removed (
page 219)

the cup holder in the front passenger
footwell is folded closed (
page 220)
Otherwise you could damage the seat and/or
cup holders.
iThe memory function (page 114) lets you
store the setting for the seat position together
with the settings for the steering wheel and the
exterior rear view mirrors.
W463.boo Seite 42 Montag, 19. November 2007 8:41 08

44 Getting started
Adjusting
Steering wheelSteering wheel adjustment
Make sure that

you can reach the steering wheel with
your arms slightly bent at the elbows,

you can move your legs freely

all displays (incl. malfunction and indi-
cator lamps) on the instrument cluster
are clearly visibleThe steering wheel adjustment stalk is
located on the lower left of the steering
column.
1 Adjusting steering wheel, in or out
2 Adjusting steering wheel, up or down
Switch on the ignition (page 39).
or
Open the driver’s door.
Warning!G
Do not adjust the steering wheel while
driving. Adjusting the steering wheel while
driving could cause the dr iver to lose control
of the vehicle.
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle.
Even with the SmartKey removed from the
starter switch, the steering wheel adjust-
ment feature can be operated when the
driver’s door is open. Therefore, do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.
iThe memory function (page 114) lets you
store the setting for the steering wheel together
with the settings for the seat position and the
exterior rear view mirrors.
W463.boo Seite 44 Montag, 19. November 2007 8:41 08

45
Getting started
Adjusting
Adjusting steering wheel in or out
Move stalk forward or backward in
direction of arrow
1.
Adjusting steering wheel up or down
Move stalk up or down in direction of
arrow 2.
For information on “Heated steering
wheel”, see (
page 225).
Easy-entry/exit feature
This feature allows for easier entry into and
exit from the vehicle. When entering and
exiting the vehicle, the steering wheel is in
its uppermost position.
The easy-entry/exit feature can be
activated or deactivated in the
Convenience submenu of the control
system (
page 156). With the easy-entry/exit
feature activated,
the steering wheel will return to its last set
position when you:

close the driver’s door with the ignition
switched on
or

insert the SmartKey into the starter
switch with the driver’s door closed
With the easy-entry/exit feature activated,
the steering wheel tilts upwards when you:

remove the SmartKey from the starter
switch
or

open the driver’s door with the
SmartKey in starter switch position 0
or 1
Warning!G
You must make sure no one can become
trapped or injured by the moving steering
wheel when the easy-entry/exit feature is
activated.
To stop steering wheel movement, do one of
the following:

Move the steering wheel adjustment
stalk (
page 44).

Press one of the stored position buttons
or the memory button (
page 115).
Do not leave children unattended in the
vehicle, or with access to an unlocked
vehicle. Children could open the driver’s
door and unintentionally activate the
easy-entry/exit feature, which could result
in an accident and/or serious personal
injury.
iThe last set steering wheel position is stored
when

the ignition is switched off (page 39)

the position is stored into memory
(
page 115)
W463.boo Seite 45 Montag, 19. November 2007 8:41 08

47
Getting started
Adjusting
The buttons are located above the exterior
lamp switch.
1 Adjustment button
2 Driver’s side exterior rear view mirror
button
3 Passenger-side exterior rear view
mirror buttonSwitch on the ignition (page 39).
Press button 2 for the driver’s side
exterior rear view mirror or button 3
for the passenger-side exterior rear
view mirror.
Push adjustment button 1 up, down,
left, or right according to the desired
setting. For more information, see “Storing exterior
rear view mirror parking position (Canada
only)” (
page 116).!If an exterior rear view mirror housing is
forcibly pushed forward (hit from the rear) or
rearward (hit from the front), reposition it by
applying firm pressure until it snaps into place.
The exterior rear view mirror housing is now
properly positioned and you can adjust the
mirror in the usual manner.
iAt low ambient temperatures, the exterior
rear view mirrors will be heated automatically.
iThe memory function (page 114) lets you
store the setting for the exterior rear view mir-
rors together with the settings for the steering
wheel and the seat position.
W463.boo Seite 47 Montag, 19. November 2007 8:41 08

58 Getting started
Driving
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1Single wipe
Wiping with windshield washer fluid
2 Switching on windshield wipers
Switch on the ignition (page 39). Switching on windshield wipers
Turn the combination switch to the
desired position depending on the
intensity of the rain.
0
Windshield wipers off
I Intermittent wiping
II Normal wiper speed
III Fast wiper speed
!Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions,
always operate the windshield wipers with
windshield washer fluid (
page 59).
!If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off
immediately.

For safety reasons, stop the vehicle in a safe
location, turn off the engine and remove the
SmartKey from the starter switch before
attempting to remove any blockage.

Remove blockage.

Turn the windshield wipers on again.
If the windshield wipers fail to function at all with
the combination switch in position I,

set the combination switch to the next
higher wiper speed

have the windshield wipers checked at the
nearest authorized Mercedes-Benz Light
Truck Center.
W463.boo Seite 58 Montag, 19. November 2007 8:41 08

60 Getting started
Driving
Rear window wiper/washer
The rear window wiper/washer switch is
located on the upper part of the center
console.1 Intermittent wipe
2 Indicator lamp
3 Rear window washer system
Switch on the ignition (page 39).
Activating intermittent wipe
Press switch 1.
Indicator lamp 2 comes on.
Intermittent wipe is activated.
Deactivating intermittent wipe
Press switch 1 once more.
Indicator lamp 2 goes out.
Intermittent wipe is deactivated. Wiping with windshi
eld washer fluid
Press and hold switch 3.
The wiper operates with washer fluid.
The rear window is wiped for a further
5 seconds after switch 3 is released.
For information on filling up the washer
reservoir, see “Windshield/rear window
washer system and headlamp cleaning
system” (
page 275).
iThe rear window wiper engages
automatically when the gear selector lever is in
reverse gear R with the windshield wipers
switched on.
W463.boo Seite 60 Montag, 19. November 2007 8:41 08

61
Getting started
Driving
Problems while driving
The engine runs erratically and misfires

An ignition cable may be damaged.

The engine electronics may not be
operating properly.

Unburned gasoline may have entered
the catalytic converter and damaged it.
Give very little gas.
Have the problem repaired at an
authorized Mercedes
-Benz Light Truck
Center as soon as possible. The coolant temperature is above
248°F (120°C)
The coolant is too hot and is no longer
cooling the engine.
Stop the vehicle in a safe location as
soon as possible and turn off the
engine. Allow engine and coolant to
cool off.
Check the coolant level and add
coolant if necessary (
page 274).
In case of accident
If the vehicle is leaking fuel:
Do not start the engine under any
circumstances.
Notify local fire and/or police
authorities.
If the extent of the damage cannot be
determined:
Contact an authoriz ed Mercedes-Benz
Light Truck Center or call Roadside
Assistance.
If no damage can be determined on the

major assemblies

fuel system

engine mount:
Start the engine in the usual manner.
iExcessive coolant temperatures trigger a
warning message in the multifunction display
(
page 346).
W463.boo Seite 61 Montag, 19. November 2007 8:41 08

63
Getting started
Parking and locking
1
Parking brake lever
Pull parking brake lever 1 up as many
notches as possible.
When the ignition is switched on or the
engine is running, the brake warning
lamp ; (USA only) or 3 (Canada
only) in the instrument cluster comes
on.
Warning!G
Getting out of your vehicle with the gear
selector lever not fully engaged in park
position P is dangerous. Also, when parked
on an incline, park position P alone may not
prevent your vehicle from moving, possibly
hitting people or objects.
Always set the parking brake in addition to
shifting to park position P (
page 164).
W h e n p a r k e d o n a n i n c l ine, turn front wheels
towards the road curb.
Warning!G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Children
could release the parking brake and/or
move the gear selector lever from park
position P, either of which could result in an
accident and/or seri ous personal injury.
W463.boo Seite 63 Montag, 19. November 2007 8:41 08