engine coolant MERCEDES-BENZ GL SUV 2012 User Guide

H
Environmenta
lnote
When toppin guptheoil, tak ecaren ot to spill
any .Ifo il enters th esoil or waterways, it is
harmful to th eenvironment.
! Only use engine oil sand oil filters that
have bee napproved for vehicles with a
servic esystem. You can obtain alist of the
engine oils and oil filters tested and
approved in accordance with the
Mercedes-Ben zSpecification sfor Service
Product satany Mercedes-Ben zService
Centre.
Damage to th eengine or exhaust sys temis
caused by the following:
R using engine oil sand oil filters that have
not bee nspecifically approved for the
servic esystem
R changing the engine oil and oil filter after
missing the change interval required by
the servic esystem
R using engine oil additives
! Do not add too muc hoil. Toppin gupwith
to om uche ngine oil can resul tindamage
to the engine or to the catalytic converter.
Hav eexcess engine oil siphoned off. Example: engine oil filler cap
X
Turn cap :anti-clockwis eand remove it.
X Top up the engine oil.
If the oil level is at or below the MIN mark
on the oil dipstick ,add 1. 0litreo fengine
oil. X
Replace cap :on the filler nec kand turn
clockwise.
Make sure that the cap locks securely into
place.
X Check the oil level agai nwith the oil dip-
stic k(Ypage 36 2).
For furthe rinformation on engine oil ,see
(Y page 42 8). Other service products
Checking th ecoolant level G
WARNING
The coolin gsystem is pressurised. Therefore,
only unscrew the cap onc ethe engine has
coole ddown. The coolan ttemperatur edis-
play must be less than 70 †. Otherwise, you
could be scalded if hot coolant escapes. X
Park the vehicle on alevel surface.
Only chec kthe coolant level if the vehicle
is on alevel surface and the engine has
cooled down.
X Turn the key to position 2in the ignition
lock (Y page 159).
On vehicles with KEYLESS-GO, press the
Start/Stop button twic e(Ypage 159).
X Check the coolant temperatur egauge in
the multifunction displ ay.
Th ec oolant temperatur emust be below
70 †.
X Turn the key to position 0(Y page 159 )in
the ignition lock. Eng
inecompartment
363Maintenance and care Z

data applicable to your vehicle on the vehi-
cle' sidentification plate. VIN
X
Open the fron tright-han ddoor.
X Open cover :in the dire ction of the arrow
and remove it.
The VI Ncan be seen.
The VIN can also be foun donthe vehi cle
identification plate (Y page 422).Engine number
The engin enumber is stamped ont othe
crankcase .You can obtain further informa-
tion fr om any qualified specialist workshop. Service products and capacities
Important safety notes
G
WARNING
Whe nhandling ,storing and disposing of any
servic eproducts, please observe the relevant
regulations, as you could othe rwise endanger
yourself and others.
Keep servic eproducts awa yfromc hildren.
To protec tyour health, do no tallow service
products to com eintoc ontac twith your eyes
or open wounds. See adoctor immediately if
any servic eproduct is swallowed. H
Environmental note
Dispose of service products in an environ-
mentally-responsible manner.
Service products includ ethe following:
R fuels (e.g. petrol, diesel)
R exhaust gas after treatmen tadditives, e.g.
AdBlue ®
R lubrican ts(e.g. engin eoil, transmission oil)
R coolant
R brake fluid
R windscreen washer fluid
R clima te control systemrefrigerant
Components and servic eproducts mus tbe
matched. Mercedes-Benz reco mmends that
you use produc tstested and approved by
Mercedes-Benz. They are listed in this
Mercedes-Benz Owne r'sM anual in the appro-
priat esection.
You can identif yservice product sapproved
by Mercedes-Ben zbythe fol lowinginscrip-
tion sonthe container:
R MB Freigab e(e.g. MB Freigab e229.51)
R MB Approva l(e.g. MB Approval 229.51)
Other designation sorrecommendation sind i-
cat eal evel of qualit yora specification in
ac cord ance wit hanMBS heet Nu mber (e.g.
MB 229.5). They hav enot necessarily been
approved by Mercedes-Benz.
Further informatio ncan be obtained from any
Mercedes -Ben zS ervice Cent reor on the
In te rnet at ht tp://bevo.mercedes -benz.co m. Fuel
Important safety notes G
WARNING
Fuel is highly flammable. If you handle fuel
incorrectly, there is arisk of fir eand explo-
sio n.
You must avoi dfire, naked flames, creating
sparks and smoking. Switc hoff the engine Servic
eproducts and capacities
423Technical data
Z

Model Replacement
amount GL 50
04MATIC
Blue EFFICIEN CY 8.5 l
GL 63 AMG
With external oil
cooler: 9.5 l GL 350 Blue-
TEC 4MATIC
GL 350 CDI
4MATIC
8.0 l
Additives
!
Do not use any additives with the engine
oil .T his could damage the engine.
Engine oil viscosity Viscosit
ydescribes the flow characteristics
of afluid. If an engine oil has ahigh viscosity
rating, it flows slowly ;the lower the viscosity,
the faster it flows.
Engin eoil selection is based on the respective
outside temperatures and in accordance with
the SAE classification (viscosity). The table
shows you which SAE classifications are to be
used. The low-temperature properties of
engine oils can be significantly impaired dur-
ing operation due to, for example, ageing or
soot and fuel accretion .Itistherefore
strongly recommended to observe regular oil
changes usin ganapproved engine oil with the
appropriate SAE classification. Brake fluid
G
WARNING
Over aperiod of time, the brak efluid absorbs
moisture from the air; This lowers its boiling
point.
If the boiling point of the brake fluid is too low,
vapour pocket smay form in the brake system
when the brakes are applied hard (e.g. when
driving downhill). This impairs braking effi-
ciency.
You shoul dhave the brake fluid renewed at
regular intervals. The brake fluid change inter-
vals can be found in the Service Booklet.
Only use brake fluid approved by Mercedes-
Benz according to MB Approval 331.0.
Information about approved brake fluid can
be obtained at any qualified specialist work-
sho poront he Internet at
http://bevo. mercedes-benz.com.
i Have th ebrake flui drenewed regularly at
aq ualified specialist workshop. Coolant
Important safety notes G
WARNING
Antifreeze is highly flammable. Fire, naked
flames and smoking are prohibited when han-
dling antifreeze.
If antifreeze comes into contact with hot
engine parts, it may ignite and you could burn
yourself. Do not spill any antifreeze on hot
engine parts.
! Only add coolant that has been premixed
with the desired antifreez eprotection. You
cou ld othe rwise damage th eengine.
Further information on cool ants can be
found in the Merced es-Benz Specifications
for Service Prod ucts, MB Specifications for
Service Products 310.1 ,e.g. on the Inter-
net at http://bevo.mercedes-benz.co m.
Or contac taqualified specialist workshop. Servic
eproducts and capacities
429Technical data Z

!
Alway suseasuitabl ecoolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the engin ecooling system is not
sufficiently protected from corrosion and
overheating.
! The engin ecooling system is filled with
coolant, which must be renewed after
15 years or after 250,000 kilometres at the
latest.
The coolant is amixtur eofw ater and anti-
freeze/corrosio ninhibitor. It performs the
following tasks:
R anti-corrosio nprotection
R antifreeze protection
R raising th eboiling point
If antifreeze/ corrosion inhibitor is presen tin
the correct concentration, the boil ingp oint of
the coolant during operation will be approx-
imately 13 0†.
The antifreeze/ corrosion inhibitor concentra-
tion in the engin ecooling system should:
R be at least 50%. This will protect the engine
coolin gsystem against freezing down to
approximatel y-37 †.
R not exceed 55% (antifreeze protection
down to -45 †). Hea twill otherwise not be
dissipated as effectively.
If the vehicle has lost coolant, top it up with
equa lamounts of water and antifreeze/cor-
rosio ninhibitor. Mercedes-Benz recom-
mends an antifreeze/corrosion inhibito rcon-
cen trate in accordance with MB Specifica-
tions for Service Products 310.1.
The coolant is checked at every maintenance
interval at aqualified special istworkshop.
i When the vehicle is first delivered ,itisfil-
led with acoolant mixtur ethat ensures
adequate antifreeze and corrosion protec-
tion. Windscreen washe
rsystem an dhead-
lamp cleaning system
Important safety notes G
WARNING
Windscreen washer concentrat eishighly
flammable. If it comes into contact with hot
engine component sorthe exhaust system it
coul dignite. There is arisk of fire and injury.
Make sure that no windscreen washer con-
centrate is spille dnext to the filler neck.
! Only use washer fluid that is suitable for
plastic lamp lenses, e.g. MB SummerFit or
MB WinterFit. Unsuitable washer fluid
could damage the plastic lenses of the
headlamps.
! Do not use distilled or de-ionised water in
the washer fluid reservoir. Otherwise, the
level sensor may be damaged.
! Only the washer fluids SummerFit and
WinterFit can be mixed. Otherwise, the
spraying nozzles could become blocked.
At temperatures above freezing:
X Fill the washer fluid reservoir with amixture
of water and washer fluid, e.g. MB Sum-
merFit.
Mix 1part MB SummerFit to 100 parts water.
At temperatures below freezing:
X Fill the washe rfluid reservoir with amixture
of water and washer fluid, e.g. MB Winter-
Fit.
Adapt the mixin gratio to the outside temper-
ature.
R Down to Ò10 †: mix 1part MB WinterFit to
2p arts water.
R Down to Ò20 †: mix 1part MB WinterFit to
1p art water.
R Down to Ò29 †: mix 2parts MB WinterFit
to 1p art water.
i Add washe rfluid concentrate, e.g. MB
SummerFit or MB WinterFit, to the washer
fluid all year round. 430
Service products and capacitiesTechnical data