stop start MERCEDES-BENZ GL450 2008 X164 Workshop Manual

527 Practical hints
Bleeding the fuel system (diesel engine only)
Bleeding the fuel system (diesel engine only)
Driving the vehicle until the fuel tank is
empty is not recommended. Otherwise, air
may be sucked into the fuel system. If this
happens, the? malfunction indicator
lamp (USA only) or the± malfunction
indicator lamp (Canada only) comes on
and the engine may not start immediately
after refueling the vehicle.
After refueling:
Make sure the automatic transmission
is set toP.
The gear position indicator in the multi-
function display should be on
P.
Do not depress the accelerator.
Turn the SmartKey in the starter switch
to position 2 for at least 10 seconds
(
page 41).
Return the SmartKey in the starter
switch to position 0 (
page 41).
Turn the SmartKey in the starter switch
to position3 (
page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine does not start:
Wait for approximately 2 minutes.
Turn the SmartKey in the starter switch
to position3 (
page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine still does not start, do not
make any further attempts to start the
engine. Contact an authorized
Mercedes-Benz Light Truck Center or call
Roadside Assistance (
page 335).iVehicles with KEYLESS-GO*: If necessary,
remove the KEYLESS-GO start/stop button from
the starter switch (
page 43).iWhen the ?malfunction indicator lamp
(USA only) or the ±malfunction indicator
lamp (Canada only) has been illuminated for the
above condition, it will remain illuminated until
the engine was cycled on and off four times in a
row.
164.boo Seite 527 Freitag, 30. März 2007 12:54 12

530 Practical hints
Battery
Disconnecting, removing, reinstalling
and reconnecting the battery
Step 1 (Disconnecting)
Set the automatic transmission to
positionP (
page 191).
Firmly depress the parking brake
(
page 67).
Turn off the engine (page 68).
Leave the ignition switched on
(
page 42).
!Never loosen or detach battery terminal
clamps while the engine is running or the
SmartKey is in the starter switch. Otherwise the
alternator and other electronic components
could be severely damaged.
Have the battery checked regularly by an
authorized Mercedes-Benz Light Truck Center.
Contact your authorized Mercedes-Benz Light
Truck Center for further information.
Warning!G
Do not place metal objects on the battery as
this could result in a short circuit.
Use leak-proof battery only to avoid the risk
of acid burns in the event of an accident.
Warning!G
Disconnecting, removing, reinstalling and
reconnecting the battery is a complicated
and technically demanding procedure that
also requires safety precautions to avoid the
risk of injury. We strongly recommend that it
be performed by a qualified technician or an
authorized Mercedes-Benz Light Truck
Center only. Please read the instructions
fully before beginning operation and only
undertake it if you feel fully capable of
performing all of the tasks involved as de-
scribed in these instructions. Observe all
safety instructions and precautions when
handling automotive batteries
(
page 528). Performing the tasks involved
incorrectly can cause damage to the vehicle
and impair the operating safety of the
vehicle, and/or cause severe injury to you
or others.
iWith a disconnected battery you will no
longer be able to turn the SmartKey in the starter
switch and pressing the KEYLESS-GO*
start/stop button will have no effect.
iIf your battery is discharged, the vehicle
must be jump started (
page 536) using the
jump start contacts in the engine compartment,
or an accessory battery charge unit* approved
by Mercedes-Benz must be connected using the
jump start contacts in the engine compartment
(see separate instructions for the accessory bat-
tery charge unit*) before any of the following
steps can be performed. If the battery cannot be
jumped or charged, please contact an
authorized Mercedes-Benz Light Truck Center.
164.boo Seite 530 Freitag, 30. März 2007 12:54 12

532 Practical hints
Battery
2Perforated floor carpet, unfolded
Fold the floor carpet piece2 in
direction of the arrow.
Move the front passenger seat to the
most forward and upward position
again (
page 46).
Switch off the ignition (page 42).
Remove SmartKey from starter switch.
Vehicles with KEYLESS-GO*:
Make sure the vehicle’s on-board
electronics have status0 (Turn off
the engine or all electrical systems
using the KEYLESS-GO start/stop
button. Open the driver’s door. With
the driver’s door open, the vehicle’s
on-board electronics have status0,
same as with the SmartKey
removed from the starter switch).
Enter the rear passenger compartment
again.Step 4 (Disconnecting)
3Air channel
4Clip with pin insert
Pull pin out of clip4 in direction of
arrow.
Pull clip with pin4 outwards.
Remove air channel3 by pulling it out
in direction of arrow.
iIf the vehicle battery is discharged and you
had the vehicle jump started, turn off the engine.
164.boo Seite 532 Freitag, 30. März 2007 12:54 12

539 Practical hints
Towing the vehicle
If you want the gear position to remain in
neutral positionN, observe the following
instructions.Vehicles with SmartKey:
With the vehicle at a standstill and the
ignition switched on shift the automatic
transmission to neutral positionN.
If engaged, release the parking brake
(
page 59).
Switch off the ignition and leave the
SmartKey in the starter switch.
Vehicles with KEYLESS-GO*:
With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
With the ignition switched on shift the
automatic transmission to park
positionP.
Release the brake pedal.
Warning!G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.
!When towing the vehicle with all wheels on
the ground, the automatic transmission must be
in neutral positionN.
If you turn off the engine

using the SmartKey and

remove the SmartKey from the starter
switch
or

open a front door

or when using the KEYLESS-GO* start/stop
button and open a front door
the automatic transmission will shift to park
positionP automatically.
Warning!G
When leaving the SmartKey or SmartKey
with KEYLESS-GO* in the starter switch, do
not leave children unattended in the vehicle.
It is possible for children to switch on the
ignition which could result in unsupervised
use of vehicle equipment.
A child’s unsupervised access to a vehicle
could result in an accident and/or serious
personal injury.

164.boo Seite 539 Freitag, 30. März 2007 12:54 12

540 Practical hints
Towing the vehicle
Remove the KEYLESS-GO* start/stop
button from the starter switch
(
page 43).
Insert the SmartKey with
KEYLESS-GO* into the starter switch.
Switch on the ignition.
Depress the brake pedal.
Shift the automatic transmission to
neutral positionN.
Release the brake pedal.
If engaged, release the parking brake
(
page 59).
Switch off the ignition and leave the
SmartKey with KEYLESS-GO* in the
starter switch.
Installing towing eye bolt
Depending on whether you are towing a
vehicle or you are being towed, the towing
eye bolt can be screwed into threaded
holes which are located behind covers on
the right-hand side of each bumper.
1Cover!Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach a tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension parts.
iTo signal turns while being towed with
hazard warning flasher in use, set the starter
switch to position2 and activate combination
switch for left or right turn signal in usual manner
– only the selected turn signal will operate.
Upon canceling the turn signal, the hazard warn-
ing flasher will operate again.

164.boo Seite 540 Freitag, 30. März 2007 12:54 12

543 Practical hints
Fuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Light Truck
Center.
A fuse chart explains the fuse allocation
and fuse amperages. It is located in the
cargo compartment with the vehicle tool
kit (
page 490).
The electrical fuses are located in different
fuse boxes:

Fuse box in engine compartment
(
page 544)

Fuse box in cargo compartment
(
page 544)

Fuse box in passenger compartment
(
page 545)Before replacing fuses:
Apply parking brake (page 67).
Make sure the automatic transmission
is set toP (
page 191).
The gear position indicator in the multi-
function display should be on
P.
Turn off all electrical consumers.
Turn off the engine (page 41).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door (this puts
the starter switch in position0,
same as with the SmartKey re-
moved from the starter switch). The
driver’s door then can be closed
again.
Warning!G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an au-
thorized Mercedes-Benz Light Truck Center.
iA blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart. Any
Mercedes-Benz Light Truck Center will be glad to
advise you on this subject.
164.boo Seite 543 Freitag, 30. März 2007 12:54 12

581 Index
Instruments and controls see Cockpit
Interior lighting 149
Delayed shut-off 177
Interior rear view mirror 51
Antiglare positions 208
Auto-dimming mirrors* 208
Interior storage spaces see
Storage compartments
Intermittent wiping
Windshield wipers 63
J
Jack 492, 493
Lifting the vehicle 520
Jump starting 536
K
Key, Mechanical 496
Key, SmartKey 112
Batteries 120, 502
Battery check lamp 112
Checking battery condition 120
Closing the power windows
(Convenience closing feature) 250
Closing the tilt/sliding sunroof*
(Convenience closing feature) 250Closing, Power tailgate* 126
Factory setting 114
Locking/unlocking 40, 70, 112
Locking/unlocking, Global
setting 114
Loss of 120
Messages in the multifunction
display 476
Opening the power windows
(Summer opening feature) 249
Opening the tilt/sliding sunroof*
(Summer opening feature) 249
Remote control 112
Replacing batteries 502
Selective setting 114
Starter switch positions 42
Starting the engine 56
Turning off the engine 69
Key, SmartKey with KEYLESS-GO*
Batteries 120, 502
Battery check lamp 115
Checking battery condition 120
Closing the power windows
(Convenience closing feature) 250Closing the tilt/sliding sunroof*
(Convenience closing feature) 250
Closing/locking, Power
tailgate* 127
Factory setting 118
Important notes 117
Locking/unlocking 41, 70, 115
Locking/unlocking, Global
setting 118
Loss of 120
Messages in the multifunction
display 475, 476
Opening the power windows
(Summer opening feature) 249
Opening the tilt/sliding sunroof*
(Summer opening feature) 249
Remote control 115
Replacing batteries 502
Selective setting 119
Start/stop button 43
Starter switch positions 42, 43
Starting the engine 57
Turning off the engine 69
164.boo Seite 581 Freitag, 30. März 2007 12:54 12

586 Index
Plastic and rubber parts, cleaning 432
Poly-V-belt drive
Layout (GL 320 CDI) 552
Layout (GL 450, GL 550) 552
Positions (Memory function*) see Seats
Pounds per square inch see PSI
Power assistance 348
Power outlets 324
Power seat see Seats, Power
Power tilt/sliding sunroof* 251
Convenience closing feature 250
Opening/closing 251
Stopping 250
Summer opening feature 249
Synchronizing 253
Power washer 426Power windows 246
Cleaning 431
Convenience closing feature 250
Door windows 247
Hinged quarter windows* 248
Opening/closing 246
Rear door windows, Blocking
operation 98
Summer opening feature 249
Synchronizing, Door windows 249
Practical hints 490
Premium unleaded gasoline 565
Problems
While driving 65
With starting see Starting difficulties
With the vehicle 18
Product information 9
Production options weight 417
PSI 417
Push-starting see Tow-startingQ
Quarter windows* see Power windows
R
Radio
AUDIO menu, Control system 164
Selecting station 164
Selecting station (satellite*) 164
Radio transmitters 370
Range (distance to empty) 185
Range of the sensors
Parktronic* 289
Reading lamp, front 149
Reading lamp, second-row 151
Rear automatic climate control 241, 244
Rear center console ashtray see Ashtrays
(Depending on vehicle configuration)
Rear climate control* 226
Rear door windows
Blocking operation 98
Rear fog lamp see Fog lamps
164.boo Seite 586 Freitag, 30. März 2007 12:54 12