automatic transmission MERCEDES-BENZ ML350 2006 W163 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: ML350, Model: MERCEDES-BENZ ML350 2006 W163Pages: 539, PDF Size: 3.77 MB
Page 6 of 539
Contents
Control system .................................. 150
Multifunction display .................... 150
Multifunction steering wheel ........ 151
Menus .......................................... 153
Standard display menu ................ 156
AUDIO menu ................................ 157
NAV* menu .................................. 158
Off-road menu .............................. 159
Vehicle status message
memory menu .............................. 159
Settings menu .............................. 161
Vehicle configuration ................... 175
Trip computer menu..................... 177
TEL menu* ................................... 178
Automatic transmission ..................... 182
Gear selector lever ....................... 182
Shifting procedure ....................... 184
Transmission positions................. 185
Gear ranges ................................. 187
Steering wheel gearshift control .. 188
Shifting into optimal gear range ... 190
Canceling gear range limit ........... 190
Driving tips ................................... 190
Towing a trailer ............................ 191
Emergency operation
(Limp Home Mode) ...................... 192Transfer case ...................................... 193
Good visibility ..................................... 194
Headlamp cleaning system* ......... 194
Rear view mirrors.......................... 194
Power folding exterior
rear view mirrors*......................... 197
Sun visors ..................................... 198
Rear window defroster .................. 200
Climate control ................................... 202
Deactivating the
climate control system ................. 206
Rear air conditioning ..................... 206
Setting the temperature................ 207
Adjusting air distribution............... 207
Adjusting air volume ..................... 208
Defrosting ..................................... 208
Air recirculation mode .................. 209
Air conditioning............................. 211
Residual heat and ventilation ........ 212
Rear air conditioning ..................... 2133-zone automatic climate control* ..... 216
Deactivating the
climate control system ................. 220
Rear air conditioning..................... 221
Setting the temperature ............... 221
Adjusting air distribution .............. 222
Adjusting air volume ..................... 222
Maximum cooling MAX COOL ....... 223
Defrosting ..................................... 223
Air recirculation mode .................. 223
Air conditioning ............................ 225
Residual heat and ventilation ........ 226
Rear air conditioning..................... 227
Power windows .................................. 230
Opening and closing
the windows ................................. 230
Synchronizing power windows ...... 232
Summer opening feature .............. 233
Convenience closing feature......... 234
Power tilt/sliding sunroof* ................ 235
Opening and closing the power
tilt/sliding sunroof........................ 235
Synchronizing the
power tilt/sliding sunroof ............. 237
Page 24 of 539
23 At a glance
Cockpit
Item
Page
1
Cruise control lever
238
2
Instrument cluster
24
3
Multifunction steering
wheel
26
4
Horn
5
Steering wheel gearshift
buttons
189
6
Gear selector lever for
automatic transmission
49
7
Front Parktronic* warning
indicators
256
8
Overhead control panel
29
9
Glove box lid release,
glove box lock
270
Item
Page
a
Glove box
270
b
Power outlet
278
c
Center console
27
d
Starter switch
34
e
Steering wheel adjustment,
manual
41
f
Hood lock release
326
g
Parking brake release
52
h
Parking brake pedal
52
j
Door control panel
30
Item
Page
k
Headlamp washer switch*
194
l
Exterior lamp switch
54
138
m
Steering wheel adjustment,
electrical*
42
n
Combination switch
Turn signals
Windshield wipers
High beam
142
54
55
54
Page 35 of 539
34 Getting startedUnlockingStarter switch positions SmartKey
Starter switch0For removing SmartKey
1Power supply for some electrical con-
sumers, such as seat adjustment
2Ignition (power supply for all electrical
consumers) and driving position
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster re-mains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
page 382).
3Starting position
Warning!
G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. Unsupervised use of vehi-
cle equipment may cause an accident
and/or serious personal injury.
iWhen you switch on the ignition, the in-
dicator and warning lamps (except high
beam headlamp indicator lamp and
turn signal indicator lamps unless acti-
vated) in the instrument cluster come
on. The indicator and warning lamps
(except high beam headlamp indicator
lamp and turn signal indicator lamps if
activated) will go out when the engine
is running. This indicates that the
respective systems are operational.iWhen the SmartKey is removed from
the starter switch and the automatic
transmission is in a position other
thanP, the transmission automatically
shifts toP.
Page 37 of 539
36 Getting startedUnlocking1KEYLESS-GO start/stop button
2Starter switchKEYLESS-GO start/stop button1USA only
2Canada onlyThe SmartKey with KEYLESS-GO must be
located in the vehicle.
Make sure the automatic transmission
is set toP.
Do not depress the brake pedal.
Position 0
Before you press the KEYLESS-GO
start/stop button, the vehicle’s on-board
electronics have status0 (as with
SmartKey removed).
Position 1
Press the KEYLESS-GO start/stop
button once.
This supplies power for some electrical
consumers, such as seat adjustment.Ignition (or Position 2)
Press the KEYLESS-GO start/stop
button twice.
All lamps in the instrument cluster
come on. If a lamp in the instrument
cluster fails to come on when the igni-
tion is switched on, have it checked
and replaced if necessary. If a lamp in
the instrument cluster remains on after
starting the engine or comes on while
driving, refer to “Lamps in instrument
cluster” (
page 382).
iIf you now press the KEYLESS-GO
start/stop button
once more, the ignition (position2)
is switched on
twice more, the power supply is
again switched off
Page 50 of 539
49 Getting started
Driving
Starting the engine Automatic transmission
Gearshift pattern for automatic
transmissionPPark position
RReverse gear
NNeutral
DDrive position
For more information on how to operate
the gear selector lever, see “Automatic
transmission” (
page 182).
Warning!
G
Do not pass belts over sharp edges. They
could tear.
Do not allow the belt to get caught in the
door or in the seat adjustment mechanism.
This could damage the belt.
Never attempt to make modifications to
seat belts. This could impair the effective-
ness of the belts.
Do not bleach or dye seat belts as this may
severely weaken them. In a crash, they may
not be able to provide adequate protection.
Damaged seat belts or belts that were highly
stressed in an accident must be replaced.
Contact an authorized Mercedes-Benz Light
Truck Center.
Warning!
G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide, and inhaling it can cause uncon-
sciousness and lead to death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated. If you think that exhaust gas
fumes are entering the vehicle while driving,
have the cause determined and corrected
immediately. If you must drive under these
conditions, drive only with at least one win-
dow fully open.
Page 51 of 539
50 Getting startedDrivingStarting with the SmartKey
Make sure the automatic transmission
is set toP.
The transmission gear positionP
appears in the multifunction display.
Do not depress accelerator.
Turn the SmartKey in the starter switch
to position3 (
page 34) and hold until
the engine starts.
For information on turning off the engine
with the SmartKey, see “Turning off en-
gine” (
page 62).Starting with KEYLESS-GO*
You can start your vehicle without the
SmartKey in the starter switch using the
KEYLESS-GO start/stop button in the
starter switch.
The SmartKey with KEYLESS-GO must be
located in the vehicle.
KEYLESS-GO start/stop button1USA only
2Canada only
Make sure the KEYLESS-GO start/stop
button1 is inserted in the starter
switch (
page 35).
Make sure the automatic transmission
is set toP.
Depress the brake pedal during the
starting procedure. Do not depress ac-
celerator.
iYou can also use the “touch-start”
function. Turn the SmartKey to
position3 and release it again immedi-
ately. The engine then starts automati-
cally.
Warning!
G
As long as the SmartKey with KEYLESS-GO
is in your vehicle, the vehicle can be started.
Therefore, never leave children unattended
in the vehicle, as they could otherwise acci-
dentally start the engine.
When leaving the vehicle, always take the
SmartKey with KEYLESS-GO with you and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle.
Page 53 of 539
52 Getting startedDrivingParking brake
1Parking brake pedal
2Release handle
Release the parking brake pedal1 by
pulling on release handle2.
The warning lamp; (USA only) or
!(Canada only) in the instrument
cluster goes out.
Driving
Depress the brake pedal.
The gear selector lever can now be
used.
Shift automatic transmission toD orR
(page 182).
Release the brake pedal.
Carefully depress the accelerator
pedal.
Once the vehicle is in motion, the auto-
matic central locking system engages
and the locking knobs drop down.
Warning!
G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. Children could release the
parking brake, which could result in an acci-
dent and/or serious injury.
iWait for the gear selection process to
complete before setting the vehicle in
motion.
iShifting from gear positionP to
positionR, N, orD is only possible with
the brake pedal depressed. Without the
brake pedal depressed, the gear selec-
tor lever can be moved, but the parking
pawl remains engaged, not allowing
shifting to occur.iThe automatic door lock feature can be
deactivated (
page 172).
iYou can open a locked door from the
inside. Open door only when conditions
are safe to do so.
Page 54 of 539
53 Getting started
Driving
After a cold start, the automatic transmis-
sion shifts at a higher engine revolution.
This allows the catalytic converter to reach
its operating temperature earlier.For more information, see “Driving instruc-
tions” (
page 299).
For information on off-road driving, see
“Off-road driving” (
page 306).
!If you hear a warning signal and the
message
Release parking brake
appears in the multifunction display
when driving off, you have forgotten to
release the parking brake.
Release the parking brake.Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.
Warning!
G
It is dangerous to shift the automatic trans-
mission out ofP orN if the engine speed is
higher than idle speed. If your foot is not
firmly on the brake pedal, the vehicle could
accelerate quickly forward or in reverse. You
could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and when
your right foot is firmly on the brake pedal.!Shift automatic transmission to
positionPorR only when the vehicle is
stopped in order to avoid damaging the
transmission.!Do not run cold engine at high engine
speeds. Running a cold engine at high
engine speeds may shorten the service
life of the engine.
!Simultaneously depressing the acceler-
ator pedal and applying the brake re-
duces engine performance and causes
premature brake and drivetrain wear.
Page 59 of 539
58 Getting startedDriving6Symbol in multifunction display indicat-
ing that rear window wiper is activated
Switch on the ignition (
page 34).
Activating intermittent wiping
Turn switch1 to position3.
Deactivating intermittent wiping
Turn switch1 to position4.Wiping with windshield washer fluid
Turn switch1 to position2 or5.
The rear window wiper operates with
washer fluid.
Hold switch1 in position2 or5
until the rear window is clean.
For information on filling up the washer
reservoir, see “Windshield/rear window
washer system and headlamp cleaning
system*” (
page 333).
Problems while driving
The engine runs erratically and misfires
An ignition cable may be damaged.
The engine electronics may not be
operating properly.
Unburned gasoline may have entered
the catalytic converter and damaged it.
Give very little gas.
Have the problem repaired by an au-
thorized Mercedes-Benz Light Truck
Center as soon as possible.
iThe rear window wiper engages auto-
matically if the automatic transmission
is shifted to positionR with the wind-
shield wipers switched on.
Page 61 of 539
60 Getting startedParking and lockingYou have now completed your first drive.
You have properly stopped and parked
your vehicle. End your drive as follows.Warning!
G
With the engine not running, there is no
power assistance for the brake and the
steering system. In this case, it is important
to keep in mind that a considerably higher
degree of effort is necessary to brake and
steer the vehicle.
Warning!
G
Do not park this vehicle in areas where com-
bustible materials such as grass, hay or
leaves can come into contact with the hot
exhaust system, as these materials could be
ignited and cause a vehicle fire.
To reduce the risk of personal injury as a re-
sult of vehicle movement, before turning off
the engine and leaving the vehicle always:
Keep right foot on brake pedal.
Firmly depress parking brake pedal.
Shift the automatic transmission to
positionP.
Slowly release brake pedal.
When parked on an incline, turn front
wheel towards the road curb.
Turn the SmartKey to starter switch
position0 and remove, or press
start/stop button (vehicles with
KEYLESS-GO*).
Take the SmartKey or the SmartKey with
KEYLESS-GO* and lock vehicle when
leaving.