charging MERCEDES-BENZ ML350 2007 W163 Comand Manual

ContentsReplacing bulbs ................................. 482
Bulbs ............................................ 482
Replacing bulbs for front lamps.... 485
Replacing bulbs for rear lamps ..... 490
Adjusting headlamp aim ............... 492
Replacing wiper blades ...................... 494
Front wiper blades ....................... 494
Rear wiper blade .......................... 495
Flat tire .............................................. 497
Preparing the vehicle.................... 497
Mounting the spare wheel ............ 498
Bleeding the fuel system
(diesel engine only) ............................ 506
Battery ............................................... 507
Disconnecting, removing,
reinstalling and
reconnecting the battery .............. 509
Charging the battery .................... 514
Jump starting ..................................... 515
Towing the vehicle ............................. 518
Installing towing eye bolt.............. 520
Stranded vehicle .......................... 521Fuses ................................................. 522
Fuse box in
engine compartment .................... 523
Fuse box in cargo compartment... 523
Fuse box in passenger
compartment ............................... 524
Emergency engine shut-down ...... 525
Technical data................................. 527
Parts service ...................................... 528
Warranty coverage............................. 529
Loss of Service and Warranty
Information Booklet ..................... 529
Identification labels ........................... 530
Layout of poly-V-belt drive ................. 532
ML 350 ........................................ 532
ML 320 CDI .................................. 532
ML 500 ........................................ 532
ML 63 AMG .................................. 533
Engine................................................ 534
Rims and tires.................................... 536
Same size tires ............................. 537
Spare wheel ................................. 538Electrical system ............................... 540
Main Dimensions ............................... 541
Weights ............................................. 542
Fuels, coolants, lubricants ................. 543
Capacities .................................... 543
Engine oils ................................... 546
Engine oil additives ...................... 546
Air conditioning refrigerant .......... 546
Brake fluid.................................... 546
Premium unleaded gasoline
(gasoline engine).......................... 547
Gasoline additives
(gasoline engine).......................... 547
Fuel requirements ........................ 548
Coolants ...................................... 549
Windshield washer and
headlamp cleaning* system......... 551
Index................................................. 553

414 Practical hintsWhat to do if …Lamps in instrument clusterGeneral information:
If any of the following lamps in the instru-
ment cluster fails to come on during thebulb self-check when switching on the
ignition, have the respective bulb checked
and replaced if necessary.Problem
Possible cause/consequence
Suggested solution
-
The yellow ABS indicator lamp
comes on while the engine is
running.
ABS has detected a malfunction and has
switched off. The BAS, ESP
®, EBP and 4-ETS
are also switched off (see messages in multi-
function display).
The brake system is still functioning normally
but without the ABS available.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission may
also be malfunctioning.

Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.

Read and observe messages in the
multifunction display (
page 428).

Have the system checked at an
authorized Mercedes-Benz Light
Truck Center as soon as possible.
Failure to follow these instructions
increases the risk of an accident.
The charging voltage has fallen below
10 volts. The ABS has switched off.
The battery might not be charged sufficiently.
When the voltage is above this value
again, the ABS is operational again and
the ABS indicator lamp should go out.
If the ABS indicator lamp should go out:
Have the generator (alternator) and
the battery checked.

437 Practical hints
What to do if …
Display message
Possible cause/consequence
Possible solution
ESP
unavailable
See Operator’s Manual
The ESP
® was deactivated because
of insufficient power supply. The
charging voltage has fallen below
10 volts.
The brake system is still functioning
normally but without the ABS
available.
When the voltage is above this value again, the
ABS is operational again and the message in the
multifunction display should disappear.
If the message in the multifunction display does
not disappear:
Have the generator (alternator) and the
battery checked.
If the yellow ESP
® warning
lampv flashes while driving and
this message appears, the electron-
ic traction system has switched off
to prevent overheating of the drive
wheel brakes.
As soon as the brakes have cooled off, the
electronic traction system switches on again.
The message in the multifunction display disap-
pears and the ESP
® warning lampv goes
out.
The self-diagnosis has not been
completed yet.
The display will clear after driving a short
distance at a vehicle speed of above
12 mph (20 km/h).

446 Practical hintsWhat to do if …Symbol messagesDisplay symbol
Display messages
Possible cause/consequence
Possible solution
#
The battery is no longer charging.
Possible causes:

alternator malfunctioning


broken poly-V-belt
Do not forget that the brake system
requires electrical energy and may be
operating with restricted capability.
Considerably greater brake pedal
force is required and the stopping dis-
tance is increased.

Stop the vehicle in a safe location or as
soon as it is safe to do so.

Apply the parking brake (
page 65).

Check the poly-V-belt.
If it is broken:

Do not continue to drive. Otherwise the
engine will overheat due to an inoperative
water pump which may result in damage
to the engine. Notify an authorized
Mercedes-Benz Light Truck Center.
If it is intact:

Drive immediately to the nearest
authorized Mercedes-Benz Light Truck
Center. Adjust driving to be consistent
with reduced braking responsiveness.

514 Practical hintsBattery
Connect the positive lead to the posi-
tive terminal and fasten it’s cover
(page 512).

Connect the negative lead to the nega-
tive terminal (
page 512).
Charging the battery
If the battery is discharged, the battery can
be charged using the jump-start contacts
located in the engine compartment
(page 516).

Charge the battery in accordance with
the instructions of the battery charger
manufacturer.
Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!
Never invert the terminal connections!
i
The following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnection):


Set the clock (
page 169).
Vehicles with COMAND system with naviga-
tion module*: Time and date are set auto-
matically.


Synchronize the door windows
(page 238).


Synchronize the power tilt/sliding sunroof*
(page 244).


Synchronize the power folding exterior rear
view mirrors* (
page 202).
Warning!
G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Light Truck
Center for information and availability.
Charge battery in accordance with the
separate instructions for the accessory
battery charger.


554 IndexAutomatic climate control (3-zone)* 220
Air conditioning, Cooling 230, 231
Air distribution, Front 226
Air distribution, Rear 234
Air recirculation mode 228
Air vents, Front 226
Air volume 227
Control panel, Front 222
Control panel, Rear 232
Deactivating system 224
Defogging 227
Defrosting 227
Maximum cooling, MAX COOL 228
Rear passenger compartment 232
Rear window defroster 205
Residual engine heat (REST) 232
Using driver-side settings for
all temperature zones 231
Automatic headlamp mode 137
Automatic lighting control, Interior
lighting 143
Automatic locking when driving 126
Automatic shift program
(ML 63 AMG only) 196Automatic transmission 54
Accelerator position 191
Automatic shift program
(ML 63 AMG only) 196
Emergency operation
(Limp-Home Mode) 198
Gear ranges 193
Gear selector lever 54, 185
Gear shifting malfunctions 198
Hill start assist system 192
Kickdown 191
Kickdown, manual shift program
(ML 63 AMG only) 198
Manual shift progam
(ML 63 AMG only) 196
Program mode selector switch
(ML 63 AMG only) 195
Shift program (ML 63 AMG only) 195
Shifting procedure 188
Starting the engine 54
Steering wheel gearshift control 194
Towing a trailer 192
Transmission fluid level 362
Transmission positions 189
Automatic Transmission Fluid see ATFB
Backrest
Seat 44
Seat, Lumbar support 130
Seat, Multicontour* 130
Backup lamps
Messages in the
multifunction display 458
Replacing bulbs 490
Bar 395
BAS 97
Lamps in instrument cluster 414
Messages in the
multifunction display 430
Basic carrier bars* 281
Batteries, SmartKey
Check lamp 108, 112
Checking battery condition 111
Messages in the
multifunction display 446
Replacing 480
Battery, Vehicle 507
Charging 514
Disconnecting and connecting 509
Jump starting 515
Removing and installing 509