fold seats MERCEDES-BENZ ML350 2008 W164 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2008, Model line: ML350, Model: MERCEDES-BENZ ML350 2008 W164Pages: 561
Page 45 of 561
44 Getting started
Adjusting
Seat adjustment
The seat adjustment switch is located on
the entry side of each front seat base.
1 Head restraint height (vehicles with
memory function)*
2Seat cushion tilt
3Seat height
4Backrest tilt
5Seat fore and aft adjustment
Warning!G
According to accident statistics, children
are safer when properly restrained in the
rear seating positions than in the front seat-
ing position. Thus, we strongly recommend
that children be placed in the rear seats
whenever possible. Regardless of seating
position, children 12 years old and under
must be seated and properly secured in an
appropriately sized infant restraint, toddler
restraint, or booster seat recommended for
the size and weight of the child. For addi-
tional information, see “Children in the vehi-
cle” (
page 89).
A child’s risk of serious or fatal injuries is
significantly increased if the child restraints
are not properly secured in the vehicle
and/or the child is not properly secured in
the child restraint.
!When moving the seats, make sure there are
no items in the footwell or behind the seats;
otherwise you could damage the seats.
!When the rear seats are folded forward, e.g.
for cargo compartment expansion (
page 269),
the front seats may not be moved to the rear-
most position. Otherwise you could damage the
front and rear seats.
!When adjusting the seat backrest tilt and
head restraint height, make sure the sun visor is
folded up (
page 201). If the head restraint is in
the uppermost position, it could hit and damage
the sun visor.
iVehicles without memory function*:
The seats can be adjusted within 5 minutes after
either front door has been opened. The counter
resets each time
you open or close a front door
you insert the SmartKey into the starter
switch
you remove the SmartKey from the starter
switch
you switch the ignition on or off
Page 270 of 561
269 Controls in detail
Loading
Hooks
Four hooks are located on the rear com-
partment trim panels, two on each side.
1Hook
Use the hooks to secure light weight items
only. The maximum permissible weight per
hook is 9lb(4kg).Expanding cargo compartment
You can separately fold the left and right
rear seat backrests to expand the cargo
compartment.
Folding the rear seat backrest forward
Warning!G
When expanding the cargo compartment,
always fully fold the corresponding seats
and, if so equipped, always use the
cargo net* (
page 272) when transporting
cargo.
Unless you are transporting cargo, the back-
rests must remain properly locked in the up-
right position.
In an accident, during hard braking or sud-
den maneuvers, loose items will be thrown
around inside the vehicle, and can cause
injury to vehicle occupants unless the items
are securely fastened in the vehicle.
Always use the cargo tie down rings
(
page 268).
Warning!G
Never drive the vehicle with the tailgate
open. Deadly carbon monoxide (CO) gases
may enter vehicle interior resulting in un-
consciousness and death.
!Always release the seat cushion and fold it
up before folding the seat backrest forward. The
covering on the seat backrest may otherwise be
damaged.
When the seat backrest are folded forward, the
front seats may not be moved to the rearmost
position. Otherwise you could damage the front
and second-row seats.
Page 272 of 561
271 Controls in detail
Loading
Returning the rear seat backrest to
original position
1Seat backrest
2Seat cushion
Fold seat backrest1 rearward until it
engages.
The red indicator5 (
page 270)
should no longer be visible.
Fold seat cushion2 rearward until it
locks into position.
Check for secure locking by pushing
and pulling on the seat backrest.
Cargo compartment cover blind
The cargo compartment cover blind can be
installed behind the rear seats.1Handle
2Mount
Rolling out blind
Pull blind on handle1 across the car-
go compartment.
Guide blind into mounts2 and re-
lease.
Rolling up blind
Disengage blind and guide retraction
by its handle1.
Warning!G
If a red indicator is visible with the backrest
up, then the backrest is not properly locked
into position.
Always lock backrest in its upright position
when the rear seats are occupied, or the ex-
tended cargo compartment is not in use.
Check for secure locking by pushing and
pulling on the backrest.
!With the cargo compartment cover blind in-
stalled, do not pile luggage higher than the lower
edges of the rear side windows.
Page 273 of 561
272 Controls in detail
Loading
Installing blind
Place left side of blind2 in left mount.
Position right side of blind2 over right
mount.
Press release button1 and guide
cover2 into mount.
Make sure the cargo compartment
cover blind is securely fastened.Removing blind
1Release button
2Blind
Roll the blind up (page 271).
Push release button1.
Pull blind2 to the left against the
spring pressure until the spring in the
cover audibly engages.
Remove the blind.
Cargo net*
iBefore installing cargo compartment cover
blind behind the front seats, fold the rear seats
forward.
iBefore removing cargo compartment cover
blind behind the rear seats, fold the left or right
rear seat forward. Afterwards, return the left or
right rear seat into its original position.
Warning!G
Make sure the cargo net is properly engaged
at top and bottom position and the tighten-
ing belts are securely fastened.
Never use a damaged cargo net.
To help avoid personal injury from smaller
objects being thrown around in the occu-
pant compartment during a collision or sud-
den maneuver, always use cargo net when
transporting cargo.
The cargo net cannot prevent the movement
of large, heavier objects into the passenger
compartment in an accident. Such items
must be properly secured using the cargo
tie-down rings (
page 268) in the cargo
compartment floor.
Passenger use of seats behind installed
cargo net is restricted because of the
footwell being taken up by the net.
Page 274 of 561
273 Controls in detail
Loading
Use of the cargo net is a particularly impor-
tant safety factor when the vehicle is load-
ed higher than the top of the seat
backrests with smaller objects. For your
safety, always use the cargo net when
transporting cargo.
The cargo net can be installed in two
locations:
1Holder in B-pillar
2Holder in C-pillarWithout the cargo compartment ex-
panded (
page 269), use holders
above C-pillars2 and the cargo
tie-down rings in the cargo compart-
ment (
page 268).
With the cargo compartment expanded
(
page 269), use holders above
B-pillars1 and the cargo tie-down
rings behind the front seats
(
page 268).
Open the hook and loop fasteners on
the cargo net package.
Roll out the cargo net.
Unfold the cargo net.
The cargo net bars must audibly
engage.Installing the cargo net
Cargo net bar hung up behind the C-pillar
1Holder
2Cargo net bar
Hang cargo net bar2 on holder1 as
indicated by the arrow.
Push cargo net bar2 forward into
holder1 in direction of arrow.
Page 275 of 561
274 Controls in detail
Loading
Pulling the cargo net tight
Belt hook attached behind the front seats
1Belt hook
2Cargo tie-down ring
3Tightening belt
Hook belt hook1 into cargo tie-down
ring2 in direction of arrow.
Pull tightening belt3 by the loose end
in direction of arrow until the cargo net
is pulled tight.
After driving a short distance, make
sure the cargo net is still tight and, if
necessary, pull it tight again.Loosening the cargo net
Belt hook attached behind the front seats
1Buckle
2Belt hook
3Cargo tie-down ring
Loosen the tightening belt by pulling
buckle1 upward in direction of arrow.
Remove belt hook2 from cargo
tie-down ring3.Removing and storing the cargo net
Take cargo net bar2 out of holder1,
see “Installing the cargo net”
(
page 273).
Press the red button on the upper and
lower cargo net bar.
Fold the cargo net.
Roll up the cargo net.
Close the hook and loop fasteners on
the cargo net package.
Page 278 of 561
277 Controls in detail
Loading
Place load between the cargo net and
the side wall of the cargo compart-
ment.
Press locking button3 on belt
reel1. With the other hand, slowly
pull net over load until it is taut.
Telescoping rod
1Telescoping rod
2Mounting elementInsert one mounting element2 into
each cargo rail.
Turn mounting element2 in cargo rail
toN.
Insert telescoping rod1 into mount-
ing element2.
Turn mounting element2 in cargo rail
until it engages in the‹ position.
You should be able to feel the mounting
element engage in the cargo rail.Removing rear seat cushions
If your vehicle is equipped with the cargo
management system* you can remove the
rear seat cushions.
Removing the rear seat cushions will pro-
vide you with a larger cargo compartment.
Fold the seat cushions forward
(
page 269).
Example illustration passenger-side
1Release lever
2Plug for seat heating*
iThe telescoping rod can be used to tighten
the load against the rear seats so as to secure it
from slipping.
Page 287 of 561
286 Controls in detail
Useful features
Rear center console ashtray (front of
rear seats)
1Ashtray
2Ashtray coverOpening rear ashtray
Briefly press ashtray cover2.
The ashtray1 opens automatically.
Removing rear ashtray insert
Grip the insert on the sides and pull it
out upwards.
Reinstalling rear ashtray insert
Install ashtray insert.
Close the ashtray.
Cigarette lighter
Switch on the ignition (page 40).
Push in cigarette lighter.
The cigarette lighter will pop out auto-
matically when hot.
Cigarette lighter
Depending on vehicle configuration your
vehicle is equipped with a cigarette lighter
and an ashtray (
page 285) located in the
front center console and an ashtray locat-
ed in front of the rear seats (
page 286).
!Close the ashtray when not in use and be-
fore folding the rear seats
Warning!G
Never touch the heating element or sides of
the cigarette lighter; they are extremely hot.
Hold the knob only.
Make sure that any children traveling with
you do not injure themselves or start a fire
with the hot cigarette lighter.
When leaving the vehicle always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised
access to a vehicle could result in an
accident and/or serious personal injury.
Page 549 of 561
548 Index
Seat heating* see Seats
Seat ventilation* see Seats
Seating capacity 353
Seats 43, 127
Adjusting 43
Cushion depth, Multicontour
seat* 129
Folding the backrest forward 269
Heating* 130
Lumbar support 129
Memory function* 133
Multicontour seat* 129
Returning seat backrest to original
position 271
Ventilation* 131
Securing cargo 268
Cargo tie-down rings 268
Hooks 269
Selector lever see Gear selector lever
Self-test
Lamps in the instrument cluster 400
OCS 84
Tele Aid 295
Vehicle battery 489
Service and warranty information 10Service intervals see Maintenance, Service
indicator
Service life
Tires 349
Service see Maintenance
Service system see Maintenance System
Service, Parts 508
Settings
Adaptive Damping System
(ADS)* 255
Air suspension* 254
Clock 169
Comfort functions* 176
Control system menus 150, 152
Control system submenus 151, 153,
166
Date 153, 166, 169
Daytime running lamp mode 170
Factory, SmartKey 112
Factory, SmartKey with
KEYLESS-GO* 116
Individual, Vehicle 163
Instrument cluster 167
Language, multifunction display 167,
168
Lighting 170Memory function* 133
Resetting all, Control system 164
Selective, SmartKey 112
Selective, SmartKey with
KEYLESS-GO* 117
Time 169
Vehicle configuration 177
Vehicle level control* 255
Shift program (ML 63 AMG only) 194
Shifting
Automatic transmission 54
Shifting, Automatic transmission 183
Side impact air bags 78
Side marker lamps
Cleaning lenses 393
Messages in the multifunction
display 441
Replacing bulbs 464, 469, 472
Side windows see Power windows
Sidewall 381
SmartKey see Key, SmartKey
SmartKey see Key, SmartKey with
KEYLESS-GO*
Snow chains 385
Snow tires see Winter tires