ad blue MERCEDES-BENZ S CLASS 2007 Owner's Manual

418 Controls in detailDriving systems
Use the COMAND controller
(page 82) to select “parallel parking”
function2.
You will see the guide lines for parallel
parking on the COMAND display.

Back up carefully parallel to parked car
until the respective vertical blue guide
line1 is at the end of the parked vehi-
cle next to you.

Stop the vehicle.1Vertical blue guide line
3Extended blue guide line
4Blue guide lines for vehicle contour

With the vehicle at a standstill, turn
steering wheel in parking direction until
blue guide lines3 and 4 appear and
the rectangle formed by guide lines 4
shows the desired parking position. If
another vehicle is located next to you,
the extended blue guide line4 must
just touch the corresponding vertical
blue guide line1.
Warning!
G
If the respective vertical guide line1 is not
yet located at the end of the parked vehicle
and you are already turning into the parking
space, you could collide with the parked ve-
hicle. Stop the parking procedure immedi-
ately. Pull out of the parking space and start
the parking procedure over again.
i
If an obstacle is inside of or protrudes into
the area marked by blue guide lines4 for the
vehicle, the parking space is too small for the ve-
hicle.
i
If you turn the steering wheel too far, the
message “Steering wheel turned too far. Please
adjust steering wheel” appears on the COMAND
display. Turn the steering wheel back until the
message disappears and the extended blue
guide line4 intersects with vertical blue guide
line1.
If you back up using the wrong wheel angle, the
following appears in the COMAND display:
“Steering wheel turned too far. Park Assist dis-
abled.”. Pull out of the parking space and start
the parking procedure over again.


419 Controls in detail
Driving systems
5Bent blue guide line
Back up with the set wheel angle.
The guide lines in the COMAND display
disappear. After a short distance, the
bent blue guide line5 appears.

Back up until bent guide line5 inter-
sects the edge of the parking space,
e.g. the curb.

Stop the vehicle.
6Yellow and red guide lines for cornering
7Blue guide line for straight driving

With the vehicle at a standstill, turn
steering wheel as far as it will go in the
opposite direction.
The guide lines for straight driving7
and cornering6 appear in the
COMAND display.

Back up using the set wheel angle until
blue guide line7 for straight driving is
parallel to the edge of the parking
space, e.g. the curb.

Now straighten out steering wheel and
back up until you still have just enough
room behind the vehicle.
While doing so, observe
Parktronic* (
page 405) or Park As-
sist* (
page 409) warning indicators.
i
If you turn the steering wheel while backing
up, the following appears in the COMAND dis-
play: “The steering wheel position has been
changed. Park Assist disabled.”. Pull out of the
parking space and start the parking procedure
over again.

459 Controls in detail
Useful features
Telephone*
Radio transmitters, such as a portable tele-
phone or a citizens band unit, should only
be used inside the vehicle if they are con-
nected to an antenna that is installed on
the outside of the vehicle.
The external antenna must be approved by
Mercedes-Benz. Please contact an autho-
rized Mercedes-Benz Center for informa-
tion on the installation of an approved
external antenna. Refer to the radio trans-
mitter operation instructions regarding use
of an external antenna.When the mobile phone is inserted in the
cradle, you can operate the telephone us-
ing the following devices:


mobile phone keypad


COMAND telephone keypad
(page 115)


buttonss andt on the steering
wheel (
page 249)


Voice Control* (
page 262)


Bluetooth headset (
page 217)
See also separate operating manual for in-
structions on how to use the mobile phone.
Warning!
G
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e. with-
out being connected to an external antenna)
from inside the vehicle while the engine is
running. Doing so could lead to a malfunc-
tion of the vehicle’s electronic system, pos-
sibly resulting in an accident and/or serious
personal injury.
Warning!
G
Please do not forget that your primary re-
sponsibility is to drive the vehicle. A driver’s
attention to the road must always be
his/her primary focus when driving. For
your safety and the safety of others, we rec-
ommend that you pull over to a safe location
and stop before placing or taking a tele-
phone call.
If you choose to use the telephone
1 while
driving, please use the hands-free device
and only use the telephone when road,
weather and traffic conditions permit. Some
jurisdictions prohibit the driver from using a
mobile telephone while driving a vehicle.
Only operate the COMAND (Cockpit Man-
agement and Data System)
1 if road, weather
and traffic conditions permit.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.
1Observe all legal requirements.
i
Various mobile phone cradles can be in-
stalled in the cockpit. These mobile phone cra-
dles can be obtained from an authorized
Mercedes-Benz Center.
The functions and services available to you while
using the mobile phone depend on your service
provider and the type of mobile phone you are
using.

460 Controls in detailUseful featuresThe cradle is located in the center armrest.
Open telephone compartment
(page 448).
Inserting mobile phone in mobile phone
cradle
Once the mobile phone has been inserted
in the mobile phone cradle, calls can only
be made via the hands-free system* or
Bluetooth headset*.

If applicable, remove the cover for the
external antenna connection from the
back of the mobile phone and store it in
a safe place. Be sure to comply with the
mobile phone’s operating instructions,
as well.
Example illustration1Insert the mobile phone
2Connector contact
3Mobile phone cradle
Slide the lower end of the mobile phone
into connector contact 2 on
cradle3.

Push the top of the mobile phone in di-
rection of arrow 1, until the lug on the
mobile phone release button engages.
The mobile phone is connected to the
network via the external antenna. The mobile phone is linked to the
hands-free device and the multifunc-
tion steering wheel.
The battery is charged depending on its
charge status and the position of the
SmartKey in the starter switch. The
charge procedure will be indicated in
the mobile phone’s display.
You can place or receive phone calls. You
can control other functions of the mobile
phone via the control system (
page 249)
or COMAND (
page 115).
!
Do not try to remove the mobile phone along
with the cradle. You could otherwise damage the
mobile phone cradle.
i
When you take the SmartKey or SmartKey
with KEYLESS-GO* out of the starter switch, the
mobile phone remains switched on for approx.
10 minutes. If you place or receive a call during
this time, the mobile phone switches off 10 min-
utes after the call has been completed.

670 Technical termsBAS Plus*
(B
rake A
ssist S
ystem Plus)
A system based on radar sensors for
providing brake support in situations
where there is a risk of collision.
BAS Plus is activated in hazardous situ-
ations by stepping quickly on the brake
pedal. During the process, the brake
force is adapted depending on the
proximity to the vehicle in front.
Bead
(
page 526)
Bit
(Binary digit)
The smallest unit of digital information.
Bit rate (MP3)
Measurement of transmission speed.
Indicates the number of ->bits trans-
mitted per time unit.Bi-xenon headlamps
Headlamps which use an electric arc as
the light source and produce a more in-
tense light than filament headlamps.
Bi-xenon headlamps produce low beam
and high beam.
B-pillar
Center connecting pillar between roof
and vehicle body (->A-pillar, ->C-pillar).
Bluetooth
Standard for short-range wireless tech-
nologies, suitable for transmitting
voice and data. It is possible to connect
Bluetooth devices wirelessly.
Bluetooth technology uses the freely
available ISM (Industrial Scientific
Medical) wireless network that works
at 2.45 GHz. Ranges of up to ten
meters are possible with Bluetooth.CAC
(C
ustomer A
ssistance C
enter)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping.
CD
(C
ompact D
isc)
Digital storage medium in disc form.
CD-R
(C
ompact D
isc R
ecordable)
->CD which can be written to once and
read many times.
CD-RW
(C
ompact D
isc R
ew
ritable)
->CD which be read and written to
many times.

681 Index
Batteries, vehicle 634
Charging 637
Discharged, Jump starting 639
Disconnecting 636
For electrical consumers 634
For starter 634
Message in display 586
Reconnecting 638
Removing 637
Bead 526
Beverage holder see Cup holder
Bi-Xenon headlamps see Headlamps
Bluetooth
Settings (COMAND) 217
Brake assist system (BAS Plus) 71
Brake assist system (BAS) 71
Brake fluid 490, 662, 663
Brake lamp bulbs 622
Brake lamp, high mounted 622
Brake pads
Message in display 575
Brake warning lamp 29
Brakes 480
Warning lamp 545Break-in period 478
Bulbs, replacing 621
Additional turn signals 622
Brake lamps 622
Fog lamps 622
Front lamps 622
High beam 622
High mounted brake lamp 622
License plate lamps 622
Low beam 622
Parking and standing lamps 622
Rear fog lamp 622
Turn signal lamps 622
C
CAC (Customer Assistance Center) 670
California retail buyers and lessees, impor-
tant notice for 15
Can holder see Cup holder
CAN system 670
Canceling
Cruise control 382
Capacities and recommended
fuel/lubricants 661Cargo area see Trunk
Cargo tie-down hooks 453
Carpets, Cleaning and care of 542
Catalytic converter 487
CD
Ejecting (COMAND) 109
Loading (COMAND) 107
Menu overview (COMAND) 110
Playback options (COMAND) 114
Selecting a medium (COMAND) 112
Selecting a track (COMAND) 113
CD (COMAND) 104
Central locking
Automatic 313
Locking/unlocking from inside 314
Central locking/unlocking switches 314
Certification label 652
Change of address or ownership 16
Changing
Vehicle level (ABC*) 404
Vehicle level (Airmatic) 402

697 Index
Symbols used in this operator’s
manual 18
System settings (COMAND)
Bluetooth settings 217
Display 213
Favorite button 216
Menu overview 213
Reset 219
Setting the system language 216
Time settings 213
Voice Control* settings
(COMAND) 215
T
Tachometer 379
Overspeed range 379
Tail lamps
Cleaning lenses 537
Messages in display 600
Tar stains 535
Tele Aid 462, 677
Automatic Maintenance Call 469
Call priority 467
Emergency calls 463
Hands-free microphone 37
Information 466Information button 465
Initiating an emergency call
manually 464
Messages in display 607
Remote door lock 469
Remote door unlock 468
Roadside Assistance 465
Roadside Assistance button 465
SOS button 464
Stolen Vehicle Recovery
services 469
System self-check 462
Telematics 677
Telephone cradle
Changing 461
Telephone* 459
“911” emergency call
(COMAND) 117
Accepting/ending a call
(COMAND) 124
Answering/ending a call (Instrument
cluster control system) 252
Call lists (COMAND) 122
Changing mobile phone cradle 461
Dialing (Instrument cluster control
system) 250Entering the telephone number
(COMAND) 125
Hands-free microphone 37
Inserting in cradle 460
Installing a different mobile phone
cradle 461
Operation 249
Operation (COMAND) 115
Phone book (COMAND) 129
Phone book (Instrument cluster control
system) 250
PIN (COMAND) 119
PIN2 (COMAND) 119
PUK / PUK2 (COMAND) 119
Redialing (COMAND) 125
Redialing (Instrument cluster control
system) 251
Removing from cradle 461
Single call connection
(COMAND) 127
Speed dialing (COMAND) 126
Submenu overview (COMAND) 120
Switching on/off (COMAND) 116
Transferring a call (COMAND) 128
Unlock code (COMAND) 119
Voice Control* 262