open hood MERCEDES-BENZ S600 2004 W220 User Guide

328 Practical hintsWhat to do if …?Display symbol
Display message
Possible cause
Possible solution
_
ENTRY POSITION
DO NOT DRIVE!
Seat, exterior mirrors and steering wheel
have not yet moved to their preset driving
positions.

Wait until the seat, exterior mirrors and
steering wheel have moved to their driv-
ing positions.
The message will disappear.
Y

HOOD OPEN!
You are driving with the hood open.

Close the hood (
page 273).
I
REMOVE KEY!
You have forgotten to remove the
SmartKey.

Remove the SmartKey from the ignition.
REPLACE KEY!
DRIVE TO WORKSHOP!
The batteries in the SmartKey are dead.

Change the batteries (
page 349).
AUTOM. LIGHT ON
REMOVE KEY!

Remove the SmartKey from the starter
switch.
F
KEY
CHECK BATTERY
!
The battery in the KEYLESS-GO* key is
discharged.

Change the battery (
page 349).
KEY
NOT RECOGNIZED!
SmartKey with KEYLESS-GO* is not rec-
ognized while the engine is running be-
cause

the SmartKey is not in the vehicle


there is strong radio-frequency inter-
ference

Stop the vehicle as soon as it is safe to do
so.

Search for the SmartKey.
Otherwise the vehicle cannot be centrally
locked nor can the engine be started again
after it has been stopped.

355 Practical hints
Replacing bulbs
Replacing bulbs for front lamps
1Headlamp cover for fog lamp
2Headlamp cover for high beam halogen
headlamp bulb, parking and standing
lamp
3Headlamp cover for Bi-Xenon* (low and
high beam) or halogen (low beam)
headlamp bulb4Bulb socket for fog lamp
5Bulb socket for parking and standing
lamp
6Electrical connector for high beam
halogen headlamp bulb
7Electrical connector for low beam
headlamp bulb
8Bulb socket for turn signal lampReplacing low beam bulbs
Bi-Xenon* headlamp
Halogen headlamp

Switch off the lights.

Open the hood (
page 272).

Press the tab on cover3 and remove
cover.

Pull connector7 off of the lamp.

Release the retaining springs and take
out the bulb.Warning!
G
Do not remove the cover for the Bi-Xenon
headlamp. Because of high voltage in Xenon
lamps, it is dangerous to replace the bulb or
repair the lamp and its components. We rec-
ommend that you have such work done by a
qualified technician.


356 Practical hintsReplacing bulbs
Insert the new bulb in the socket so
that the base is in the recess on the
lower left.

Attach the retaining springs.

Insert connector7 into the bulb.

Press cover3 onto the housing until
the tab engages.Replacing halogen high beam bulbs

Switch off the lights.

Open the hood (
page 272).

Press the tab on cover2 and remove
cover.

Pull connector 6 off of the bulb.

Apply pressure on the bulb contacts
from above until the bulb releases from
the retaining springs.

Remove bulb.

Insert the new bulb in the socket with
the marking facing upward.

Press the bulb upward on the contacts
until it engages in the retaining springs.

Insert connector6 onto the bulb.

Press cover2 onto the housing until
the tab engages.Front turn signal lamp bulb

Switch off the lights.

Open the hood (
page 272).

Twist bulb socket8 counterclockwise
and pull out.

Gently push bulb into socket, turn
counterclockwise and remove.

Insert new bulb in socket, push in and
twist clockwise.

Reinstall bulb socket in lamp and twist
clockwise until it engages.


357 Practical hints
Replacing bulbs
Parking and standing lamp bulb
Switch off the lights.

Open the hood (
page 272).

Press the tab on cover2 and remove
cover.

Pull out the bulb socket5 with the
bulb.

Pull the bulb out of the bulb socket.

Insert a new bulb in the socket.

Reinstall the bulb socket.

Press cover2 onto the housing until
the tab engages.Side marker lamp bulb

Switch off the lights.

Carefully slide lamp towards rear.

Remove front end first.

Twist bulb socket counterclockwise
and pull out.

Pull bulb out of the bulb socket.

Insert new bulb in socket.

Reinstall bulb socket, push in and twist
clockwise.

To reinstall lamp, set rear end in
bumper and let front end snap into
place.

360 Practical hintsReplacing wiper bladesInstalling wiper blades
Slide the wiper blade onto wiper arm
until it locks in place

Rotate the wiper blade into position
parallel to wiper arm.

Fold the wiper arm backward to rest on
the windshield. Make sure you hold
onto the wiper when folding the wiper
arm back.
!Never open the hood when the wiper
arm is folded forward.
Hold on to the wiper when folding the
wiper arm back. If released, the force
of the impact from the tensioning
spring could crack the windshield.
Do not allow the wiper arms to contact
the windshield glass without a wiper
blade inserted.
Make certain that the wiper blades are
properly installed. Improperly installed
wiper blades may cause windshield
damage.
For your convenience, we recommend
that you have this work carried out by
an authorized Mercedes-Benz Center.

417 Index
Global Positioning System (GPS) 403
Glove box 231
Closing 231
Locking 231
Opening 231
Unlocking 231
Gloves (vehicle tool kit) 345
Good visibility 174
GPS 243, 403
H
Hand-held transmitter
Programming integrated remote
control 252
Hands-free microphone 27
Hard plastic trim items
Cleaning 301
Hazard warning flasher 128
Switching off 129
Switching on 129
Head restraint folding 119
Head restraints 109
Headlamp cleaning system* 281Headlamps
Automatic control 125
Bi-Xenon 401
Cleaning 298
Cleaning system* 177, 281
Refilling washer fluid 281
Switching off 53
Switching on 47
Headliner
Cleaning 301
Heated steering wheel* 240
Height adjustment
Head restraints 36
Steering wheel 37
Height adjustments
Vehicle level 219, 221
High beam
Replacing bulbs 353
High beam flasher 48, 128
High beam headlamps
Messages in display 330
Switching on 128
High mounted brake lamp 354Hood 272
Closing 273
Message in display 328
Opening 272
Hydroplaning 263
I
Identification labels 380
Ignition 31, 33
Switching on 43, 44
Immobilizer 83
Activating 83
Deactivating 83
Indicator lamps see Lamps, indicator and
warning
Individual seats* 118
Infant and child restraint systems 69
Installing 72
LATCH child seat anchors 73
Information
About service and warranty 10
Button for Tele Aid* 247
Infrared reflecting windshield 256

421 Index
Entry position 328
Hood 328
Lamps 331
Parking brake 321
Selector lever 317
SmartKey 328
SmartKey with KEYLESS-GO* 328
TeleAid 334
Telephone* 334
Tires 336, 339
Trunk 334
Washer fluid 334
Multifunction steering wheel 24, 135,
404
Buttons 135
N
Navigation system
Operating 147
See separate COMAND* operating
instructions
Night security illumination 126
Nubuck leather upholstery
Cleaning 302O
Occupant safety 58
Airbags 59
Children and airbags 60
Children in the vehicle 69
Fastening the seat belt 40
Infant and child restraint systems 69
LATCH child seat anchors 73
Seat belts 40, 62
Oil
Adding 277
Consumption 273
Dipstick 273
Filler neck 277
Viscosity 403
Oil level
Checking 271
Oil level via control system
Checking 274
One-touch gearshifting 165
Canceling gear range limit 165
Downshifting 165
Upshifting 165Opening
Ashtray 238
Cup holder 237
Doors from the inside 96
Fuel filler flap 269
Fuel filler flap manually 351
Glove box 231
Hood 272
Side windows 196
Sliding/pop-up roof 199, 352
Sliding/pop-up roof in an
emergency 352
Sliding/pop-up roof with
SmartKey 201
Storage compartment in the center
console 232
Storage compartments in the
armrest 233
Storage compartments in the center
console 233, 234
Trunk 97
Trunk lid from the inside 97
Windows 195
Windows with SmartKey 197