brake pads MERCEDES-BENZ SL500 2003 R230 Owner's Manual

74 Safety and SecurityDriving safety systems
The SBC brake servo assistance switches
off automatically when you

remove the key from the starter switch
(after approximately two minutes)


lock the vehicle (after approximately
20 seconds)
Note on driving with SBC


Following extended periods of only mi-
nor loads to your brake system, you
should occasionally apply the brakes
when traveling at high speeds. This im-
proves the grip of the brake pads.


After driving on wet or snow-covered
roads, you should apply your brakes
firmly before parking your vehicle. This
produces heat which serves to dry the
brake disks and help prevent corro-
sion.


On long and steep grades, shift to a
lower gear (gear range1, 2, or 3) to
prevent the brakes from overheating
and to reduce brake wear.


After hard braking, it is advisable to
drive on for some time so that the air
stream will cool down the brakes fast-
er.


Only Mercedes-Benz approved compo-
nents (e.g. brake pads) should be in-
stalled on your vehicle. Brake pads not
approved by Mercedes-Benz may im-
pair the safety of your vehicle.
Warning!
G
Have brake pad replacement and other work
on the SBC brake system carried out by
qualified technicians only. Contact your
Mercedes-Benz Center for further informa-
tion. The SBC brake system must be deacti-
vated prior to working on the system. High
pressure is intermittently built up in the sys-
tem as part of its automatic self-test. In ad-
dition, the system is automatically activated
when the vehicle is unlocked by remote con-
trol, when the driver or passenger door is
opened, when the key in the starter switch
is turned to position1, when the brake ped-
al is depressed or when the parking brake is
released. Failure to deactivate the system
prior to maintenance will cause brake pis-
tons to extend and brake fluid to leak, which
may result in injuries (contusions and acid
burns). Extended brake pistons may also
cause injury.
Warning!
G
Be very careful not to endanger other road
users when you apply the brakes.

216 OperationDriving instructionsPower assistance
Brakes
Warning!
G
The brake system requires electrical energy
for operation.
A malfunction in the vehicle’s power supply
or electrical system In such a case, the red
brake warning lamp (
page 253) and warn-
ing messages (
page 265) in the instru-
ment cluster light up while driving. To brake,
the driver must then apply significantly
greater brake pedal pressure and depress
the pedal much further to obtain the expect-
ed braking effect. If necessary, apply full
pressure to the brake pedal. Brakes are only
applied to the front wheels. Stopping dis-
tance is increased! If there is a malfunction
in the SBC brake system, we recommend
that the vehicle be transported with all
wheels off the ground using flatbed or ap-
propriate wheel lift/dolly equipment.
A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
up to 30 miles (50 km) and at a speed not to
exceed 30 mph (50 km/h). For more infor-
mation, refer to "Towing the vehicle"
(page 325).
With the engine not running, there is no
power assistance for the steering system. In
this case, it is important to keep in mind that
a considerably higher degree of effort is nec-
essary to steer the vehicle.
Warning!
G
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking ef-
fect. Maintain a safe distance from vehicles
in front.
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an acci-
dent.

217 Operation
Driving instructions
To help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
If your brake system is normally only sub-
jected to moderate loads, you should occa-
sionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads.
If the parking brake is released and the
brake warning lamp in the instrument clus-
ter stays on, there is a malfunction in the
SBC brake system (
page 72) or the
brake fluid level in the reservoir is too low.Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected at an au-
thorized Mercedes-Benz Center immedi-
ately.
All checks and service work on the brake
system should be carried out by an autho-
rized Mercedes-Benz Center.
Only install brake pads and brake fluid rec-
ommended by Mercedes-Benz.After hard braking, it is advisable to drive
on for some time, rather than immediately
parking, so the air stream will cool down
the brakes faster.
!Be very careful not to endanger other
road users when you apply the brakes.
Refer to the description of the Brake
Assist System (BAS) (
page 69).
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.
Be certain to read and observe the warning
notices on brake pad replacement
(page 74).
!When driving down long and steep
grades, relieve the load on the brakes
by shifting into a lower gear to use the
engine’s braking power. This helps pre-
vent overheating of the brakes and re-
duces brake pad wear.

265 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
2
Brake lining wear!
Visit workshop!
The brake pads have reached their
wear limit.

Have the brake pads replaced as soon as
possible.
T
Brake defective!
Stop vehicle!
The SBC brake system is in emer-
gency operation mode. Consider-
ably greater brake pedal force is
required and the stopping distance
is increased.
The maximum speed is limited to
55 mph (90 km/h).

Do not drive any further.

Stop the vehicle and notify an authorized
Mercedes-Benz Center.

Significantly greater force must be applied
to the brake pedal.

Call for roadside assistance.
Reduced
brake effect
Start engine!
The battery has insufficient voltage
and cannot supply sufficient power
to the SBC brake system.

Start the engine.
As soon as the engine is running, the mes-
sage disappears.
!Brake pad thickness must be visually
checked by a qualified technician at the
intervals specified in the Service book-
let.

358 IndexAnti-theft alarm system 75
Arming 76
Canceling the alarm 76
Disarming 76
Anti-theft systems
Anti-theft alarm system 75
Tow-away alarm 77
Aquaplaning see Hydroplanning 219
Armrest
Storage space 193
Ashtray 23, 196
ATF (automatic transmission fluid) 230
Automatic climate control 23, 147
Center air vents 23
Deactivating 154
Residual heat utilization 154
Side air vents 23
Temperature sensor 25
Automatic transmission 137
Emergency operation (Limp Home
Mode) 144
Gear ranges 139
Gear shifting malfunctions 144
Kickdown 142
Manual shift program mode
(SL 55 AMG Kompressor) 142Manual shifting 138
One-touch gearshifting 138
Program mode selector switch 24,
141
Selector lever 24
Selector lever position 137
Transmission fluid 230
Winter program mode 141
Auxiliary cup holder 191
Inserting 191
Removing 192
B
BabySmart
TM airbag deactivation
system 64, 351
BabySmartTM compatible child
seats 351
Backrest supports
Lumbar region 94
Shoulder region 94
Backrest tilt 33
Backup lamp bulbs 296
Backup lamps 299
BAS 68, 69, 351
Messages in display 260Batteries, electronic key
Changing 293
Check lamp 81
Checking 82
Batteries, KEYLESS-GO* card
Changing 294
Check lamp 87
Checking 87
Batteries, vehicle 232
Charging 321
Disconnecting 320
For electrical consumers 232, 289,
319
For starter 232, 319
Messages in display 263, 264
Reconnecting 321
Removing 321
Service 319
Bi-Xenon headlamps 351
Block heater 240
Brake fluid 226, 342, 343
Brake lamp bulb, high mounted 296
Brake lamp bulbs, left and right 296
Brake pads
Message in display 265

366 IndexManual operations
Interior lighting control 107
Locking the vehicle 292
Lowering Easy-Pack 292
Unlocking interior storage
compartments 291
Unlocking the driver’s door 290
Unlocking the trunk 291
Massage function 94
Maximum cooling MAXCOOL 151
Memory function 353
Storing exterior rear view mirror
parking position 100
Storing key dependent settings 130
Menus 111, 353
AUDIO 115
Distronic* 117
Malfunction memory 118
NAVI 117
Standard display 115
TEL* 133
Trip computer 131
Microphone
Hands-free microphone 25
Miles/kilometers in speedometer 123
Minimum distance 187Mirrors 35
Adjusting inside rear view mirror 35
Automatic antiglare for inside
mirror 145
Exterior rear view mirror parking
position 131
Exterior rear view mirrors 35
Storing exterior mirror parking
position 100
Misfiring 45
MON 225, 353
Mph or km/h in speedometer 123
Multicontour backrest* 93
Multifunction display 110, 354
Left display field 21
Right display field 21
Selecting language 123
Standard display 110
Multifunction display messages
ABC 258
ABS 259
BAS 260
Battery 263, 264
Brake pads 265
Coolant 273
Coolant level 272, 274Display 287
Distronic* 262
Doors 286
Easy-entry/exit feature 271
Engine oil level 280
ESP 261
Fuel reserve tank 286
Hood 279
Key 286
KEYLESS-GO* card 269
Lamps 274
Luggage cover 272
Parking brake 271
Retractable hardtop 287
Roll bar 286
SBC brake system 265, 266, 268
Seat belts 272
Tele Aid 263
Telephone* 270
Tires 281
Trunk lid 272
Washer fluid 287
Multifunction steering wheel 22, 111,
354
Buttons 111