battery location MERCEDES-BENZ SL500 2006 R230 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: SL500, Model: MERCEDES-BENZ SL500 2006 R230Pages: 480
Page 360 of 480
359 Practical hints
What to do if …
Symbol messagesLeft display
Right display
Possible cause/consequence
Possible solution
#
Battery/Alternator
Stop vehicle
The battery is malfunctioning.
The electro-hydraulic brake system
requires electrical energy and
therefore has only limited opera-
tion. Considerably greater brake
pedal force is required and the stop-
ping distance is increased.
Stop the vehicle in a safe location. Adjust driv-
ing to be consistent with reduced braking re-
sponsiveness.
Notify an authorized Mercedes-Benz Center.
Visit
workshop!
The battery is no longer charging.
Possible causes:
alternator malfunctioning
broken poly-V-belt
Do not forget that the brake system
requires electrical energy and may
be operating with restricted capa-
bility. Considerably greater brake
pedal force is required and the stop-
ping distance is increased.
Stop the vehicle immediately in a safe loca-
tion and check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise, the
engine will overheat due to an inoperative
water pump which may result in damage
to the engine. Notify an authorized
Mercedes-Benz Center.
If it is in order:
Drive immediately to the nearest autho-
rized Mercedes-Benz Center. Adjust driv-
ing to be consistent with reduced braking
responsiveness.
Page 362 of 480
361 Practical hints
What to do if …
Left display
Right display
Possible cause/consequence
Possible solution
T
Reduced
braking power!
Depress brake
pedal fully!
The electro-hydraulic brake system
is in emergency operation mode.
Considerably greater brake pedal
force is required and the stopping
distance is increased.
The maximum speed is limited to
55 mph (90 km/h).
Do not drive any further.
Stop the vehicle in a safe location or as soon
as it is safe to do so and notify an authorized
Mercedes-Benz Center.
Prevent the vehicle from rolling away by
blocking the wheels with wheel chocks or oth-
er sizable objects.
Call for Roadside Assistance.
USA only:;Canada only:3
Reduced
brake effect
Start engine
The battery has insufficient voltage
and cannot supply sufficient power
to the electro-hydraulic brake sys-
tem.
Start the engine.
The message disappears when sufficient
voltage is available.
Warning!
G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide, and inhaling it can cause uncon-
sciousness and lead to death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated.
Page 419 of 480
418 Practical hintsBatteriesReconnecting the batteries
Turn off all electrical consumers.
Install starter battery in the designated
location in the engine compartment.
Install consumer battery in the desig-
nated location in the trunk.
Attach supports and brackets.
Tighten support and bracket screws.
Connect positive lead 3 of the con-
sumer battery and positive lead 1 of
the starter battery and fasten covers.
Connect negative lead 2 of the starter
battery.
Connect negative lead 4 of the con-
sumer battery.
Reinstall the trunk floor.
Rehook trunk luggage cover into hold-
ers.
!Always connect the batteries in the
order described below. Otherwise the
vehicle’s electronics can be damaged.!Never invert the terminal connections!
iThe following procedures must be car-
ried out following any interruption of
battery power (e.g. due to reconnec-
tion):
Resynchronize the ESP
®
(
page 354).
Resynchronize side windows
(page 194).