wiper blades MERCEDES-BENZ SL600 2008 R230 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2008, Model line: SL600, Model: MERCEDES-BENZ SL600 2008 R230Pages: 489
Page 7 of 489
Contents
Maximum tire load ....................... 319
Maximum tire inflation pressure .. 319
Uniform Tire Quality Grading
Standards (U.S. vehicles) ............. 320
Tire ply material ........................... 322
Tire and loading terminology ........ 322
Rotating tires ............................... 325
Winter driving .................................... 327
Winter tires .................................. 327
Block heater (Canada only) .......... 328
Snow chains................................. 329
Maintenance ...................................... 330
Maintenance service indicator
message....................................... 330
Calling up the maintenance
service indicator display............... 332
Resetting the maintenance
service indicator........................... 332
Vehicle care ....................................... 333
Cleaning and care of the vehicle .. 333
Practical hints.................................. 341
What to do if … ................................... 342
Lamps in the instrument cluster ... 342
Air bag off indicator lamp.............. 357
Vehicle status messages in the
multifunction display..................... 359
Where will I find ...? ............................ 400
First aid kit .................................... 400
Vehicle tool kit, jack, and
spare wheel .................................. 400
Locking/unlocking in an emergency .. 403
Unlocking the vehicle.................... 403
Locking the vehicle ....................... 405
Lowering the load assist
manually ....................................... 406
Replacing SmartKey batteries ............ 407
Replacing bulbs .................................. 409
Bulbs ............................................. 409
Replacing bulbs for front lamps .... 411
Replacing bulbs for rear lamps ..... 414
Replacing wiper blades....................... 415
Placing wiper arms in vertical
position ......................................... 415
Removing wiper blades ................. 416
Installing wiper blades .................. 416Flat tire............................................... 417
Preparing the vehicle .................... 417
Mounting the spare wheel ............ 417
MOExtended system* ................... 425
Batteries............................................. 427
Disconnecting the batteries.......... 429
Removing the batteries................. 430
Charging and reinstalling
batteries ....................................... 430
Reconnecting the batteries........... 431
Jump starting...................................... 432
Towing the vehicle.............................. 434
Installing towing eye bolt .............. 436
Fuses.................................................. 437
Fuse boxes in engine
compartment ................................ 438
Fuse box in passenger
compartment ................................ 439
Fuse in trunk................................. 439
Emergency engine shut-down ....... 439
Page 23 of 489
23 At a glance
Exterior view
ItemPage
1Trunk
Opening the trunk114
Closing the trunk116
Spare wheel400
Vehicle tool kit400
2Rear lamps410
3Rear window defroster187
4Fuel filler flap279
Refueling279
Gasoline461
5Doors
Locking and unlocking104
Opening and closing113
Locking/unlocking in an
emergency403
ItemPage
6Exterior rear view mirrors
Adjusting49
Auto-dimming rear view
mirrors185
7Towing434
Installing towing eye bolt436
8Tires and wheels291
Checking tire inflation
pressure302
General information291
Flat tire417
Vehicle tool kit400
9Hood
Opening282
Engine oil283
Coolant288,
463
ItemPage
aHeadlamp cleaning
system185,
289
bFront lamps410
cWindshield wipers58
Wiper blades, replacing415
Wiper blades, cleaning337
dWindshield
Wiping with windshield
washer fluid60
Cleaning337
eRetractable hardtop
Opening/closing204
Wind screen209
Luggage cover210
Sunshade for panorama
roof*213
Page 58 of 489
58 Getting started
Driving
The combination switch resets automati-
cally after major steering wheel move-
ments.Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1Switching on windshield wipers
2Single wipe
Wiping with windshield washer fluid
Switch on the ignition (page 40).
iTo signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release.
The corresponding turn signals will flash three
times.
!Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions,
always operate the windshield wipers with
windshield washer fluid (
page 60).
!If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off imme-
diately.
For safety reasons, stop the vehicle in a safe
location and
remove the SmartKey from the starter
switch
or
turn off the engine by pressing the
KEYLESS-GO* start/stop button and
open the driver’s door (with the driver’s
door open, the starter switch is in
position 0, same as with the SmartKey
removed from the starter switch)
before attempting to remove any blockage.
Remove blockage.
Turn the windshield wipers on again.
Page 59 of 489
59 Getting started
Driving
Switching on windshield wipers
Turn the combination switch in
direction of arrow 1 to the desired
position, depending on the intensity of
the rain.
0Windshield wipers off
IIntermittent wiping
IINormal wiper speed
IIIFast wiper speedIntermittent wiping
Only switch on intermittent wiping under
wet weather conditions or in the presence
of precipitation.
Turn the combination switch in
direction of arrow 1 to positionI.
After the initial wipe, pauses between
wipes are automatically controlled by the
rain sensor.Single wipe
Press the combination switch briefly in
direction of arrow2 (
page 58) to
the resistance point.
The windshield wipers wipe one time
without washer fluid.
If the windshield wipers fail to function at all with
the combination switch in positionI,
set the combination switch to the next
higher wiper speed
have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center
!Do not leave windshield wipers on an inter-
mittent setting when the vehicle is taken to an
automatic car wash or during windshield clean-
ing. Windshield wipers will operate in the pres-
ence of water sprayed on the windshield, and
windshield wipers may be damaged as a result.
!If you have set intermittent wiping, dirt on
the surface of the rain sensor or optical effects
may cause the windshield wipers to wipe in an
undesired fashion. This could then damage the
windshield wiper blades or scratch the wind-
shield. You should therefore switch off the wind-
shield wipers when weather conditions are dry.
iIntermittent wiping is interrupted when the
vehicle is at a standstill and a door is opened.
This protects persons getting into or out of the
vehicle from being sprayed.
Intermittent wiping will be continued when
all doors are closed
and
the gear selector lever is in positionDorR
or
the wiper setting is changed using the
combination switch
Page 60 of 489
60 Getting started
Driving
Wiping with windshield washer fluid
Press the combination switch in
direction of arrow2 (
page 58) past
the resistance point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system”
(
page 289).
Problems while driving
The engine runs erratically and misfires
An ignition cable may be damaged.
The engine electronics may not be
operating properly.
Unburned gasoline may have entered
the catalytic converter and damaged it.
Give very little gas.
Have the problem repaired by an
authorized Mercedes-Benz Center
as soon as possible.The coolant temperature gauge is
above 248°F (120°C)
The coolant is too hot and is no longer
cooling the engine.
Stop the vehicle as soon as possible in
a safe location and turn off the engine.
Allow engine and coolant to cool off.
Check the coolant level and add cool-
ant if necessary (
page 288).
iTo prevent smears on the windshield or
noisy/chattering wiper blades, wipe with wind-
shield washer fluid every now and then even
when it is raining.
Page 338 of 489
337 Operation
Vehicle care
Restart the engine after cleaning
sensor cover1.
Cleaning the Parktronic system*
sensors
1Parktronic system* sensors in front
bumper
Use a mild car wash detergent, such as
Mercedes-Benz approved Car
Shampoo, with plenty of water and a
soft, non-scratching cloth to clean
sensors1 in the bumpers.Cleaning the windows and the wiper
blades
Make sure the hood is fully closed.
Switch on the ignition (page 40).
Turn combination switch to wiper
settingII (
page 58).
With wiper arms in vertical position,
switch off the ignition (
page 40).
!To prevent scratches or damage, never
apply strong force and only use a soft,
non-scratching cloth when cleaning Distronic
system sensor cover1. Do not attempt to wipe
dirty sensor with a dry cloth or sponge.
!Do not apply strong pressure to the sensor
covers. Applying strong pressure may damage
the sensor covers.
Follow the instructions provided by the power
washer manufacturer on maintaining a distance
between the vehicle and the nozzle of the power
washer.
!To prevent scratches, never apply strong
force and only use a soft, non-scratching cloth
when cleaning the sensors. Do not attempt to
wipe dirty sensors with a dry cloth or sponge.
!The windshield wipers must be in a vertical
position before folding them away from the wind-
shield. They could otherwise damage the hood.
Never open the hood when the wiper arms are
folded forward.
Page 339 of 489
338 Operation
Vehicle care
Fold the wiper arms forward until they
snap into place.
Clean the wiper blade inserts with a
clean cloth and detergent solution.
Use a soft, clean cloth and a mild win-
dow cleaning solution on all outside
and inside glass surfaces.
An automotive glass cleaner is recom-
mended.Rear window cleaning
Clean the rear window with the hardtop
fully raised and closed.
Use a soft, clean cloth and a mild win-
dow cleaning solution on all outside
and inside glass surfaces.
An automotive glass cleaner is recom-
mended.
Light alloy wheels
If possible, clean wheels once a week.
Use Mercedes-Benz approved Wheel
Care, a soft bristle brush and a strong
spray of water for cleaning the light al-
loy wheels.
Warning!G
For safety reasons, switch off wipers and re-
move SmartKey from starter switch (vehi-
cles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status0.) before cleaning the windshield
and/or the wiper blades. Otherwise, the
wiper motor could suddenly turn on and
cause injury.
!Do not pull on the wiper blade inserts. They
could tear.
!Fold the windshield wiper arms back onto
the windshield before turning the SmartKey in
the starter switch or pressing the KEYLESS-GO
start/stop button (vehicles with KEYLESS-GO*).
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
!To clean the window interior, do not use a
dry cloth, abrasives, solvents or cleaners con-
taining solvents. Do not touch the inside of the
front, rear or side windows with hard objects
such as an ice scraper or ring. Doing so may
damage the windows.
Warning!G
Do not clean the rear window with the hard-
top in a position other than the fully raised
and closed position. Otherwise, the hardtop
may move unexpectedly which may result in
personal injury to you or others.
!Only use acid-free cleaning materials. Acid
may cause corrosion or damage the clear coat.
Page 342 of 489
341 Practical hints
What to do if …
Where will I find ...?
Locking/unlocking in an
emergency
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Batteries
Jump starting
Towing the vehicle
Fuses
Page 416 of 489
415 Practical hints
Replacing wiper blades
Replacing wiper blades
Placing wiper arms in vertical position
Wiper blades in vertical position
Vehicles with SmartKey
Turn SmartKey to starter switch
position1 (
page 40).
Turn combination switch to wiper
settingII (
page 58).
With wiper arms in the vertical position,
turn SmartKey in starter switch to
position0.
Remove SmartKey from starter switch.
Warning!G
For safety reasons, switch off wipers and re-
move SmartKey from starter switch
(vehicles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status0) before replacing a wiper blade.
Otherwise the wiper motor could suddenly
turn on and cause injury.
Warning!G
Wiper blades are components that are sub-
ject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not be
able to observe surrounding traffic condi-
tions and could cause an accident.
!To avoid damage to the hood:
The wiper arms should only be folded
forward when in the vertical position.
Never open the hood when a wiper arm is
folded forward.
!Hold on to the wiper when folding the wiper
arm back. If released, the force of the impact
from the tensioning spring could crack the wind-
shield.
Do not allow the wiper arms to contact the wind-
shield glass without a wiper blade inserted.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Center.
Page 417 of 489
416 Practical hints
Replacing wiper blades
Vehicles with KEYLESS-GO*
Turn off the engine (page 64).
With the driver’s door closed, the
starter switch is now in position1.
Turn combination switch to wiper
settingII (
page 58).
With wiper arms in the vertical position,
open the driver’s door.
The starter switch is set to position0,
same as SmartKey removed from
starter switch.
Turn combination switch to wiper
setting0 (
page 58).
Removing wiper blades
Fold the wiper arm forward until it
snaps into place.
Turn wiper blade at a right angle to the
wiper arm.
Slide the wiper blade sideways out of
the retainer.
Installing wiper blades
Slide the wiper blade onto the wiper
arm in opposite direction of arrow.
Rotate the wiper blade into a position
parallel to the wiper arm.
Fold the wiper arm backward to rest on
the windshield. Make sure you hold on
to the wiper when folding the wiper arm
back.
!Do not pull on the wiper blade inserts. They
could tear.
!Make sure the wiper blades are properly
installed. Improperly installed wiper blades may
cause windshield damage.