wiper blades MERCEDES-BENZ SLC 2017 Owners Manual

X
Turn housing cover C counter-clockwise and
pull it out. X
At the bulb holder, push the bulb upwards,
disconnect it and pull it out of bulb holder D .X
Insert the new bulb into bulb holder D at the
top, push it down and secure it in place. X
Attach housing cover C and turn it clockwise
until it engages.
Side marker lamp s( halogen head-
lamps) Due to their location, have the bulbs in the side
marker lamp changed at aq ualified specialist
workshop.
Windshield wipers
Switching the windshield wipers
on/off
! Do not operate the windshield wipers when
the windshield is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windshield can scratc ht he glass
if wiping takes place when the windshield is
dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, alway su se
washer fluid when operating the windshield
wipers.
! If the windshield wipers leave smears on the
windshield after the vehicle has been washed
in an automatic car wash, wax or other resi-
dues may be the reason for this. Clean the
windshield using washer fluid after washing
the vehicle in an automatic car wash.
! Intermittent wiping with rain sensor: due to
optical influences and the windshield becom-
ing dirty in dry weather conditions, the wind-
shield wipers may be activated inadvertently.
This could then damage the windshield wiper
blades or scratc ht he windshield.
For this reason, you should alway ss witch off
the windshield wipers in dry weather. Combination switch
G
? Windshield wiper offH
b Intermittent wipe, low (rain sensor set
to low sensitivity) I
c Intermittent wipe, high (rain sensor
set to high sensitivity) J

and it falls onto th ew indshield, th ew indshield
may be damage dbyt he force of th ei mpact.
Mercedes-Ben zr ecommend st ha ty ou have
th ew iper blades changed at aq ualified spe-
cialis tw orkshop.
! Always position th ew indshield wiper arms
vertically before folding them away from the
windshield. By doin gs o, you will avoid dam-
age to th eh ood.
Replacing th ew iper bladesRemoving th ew iper bladesX
Turn th eS ma rtKey to position 1 or 2 in the
ignition loc k( Y
page 115).X
Set th ew indshield wiper to position

! Make sure that: R
the side windows and the roof are com-
pletely closed R
the climate control blower is switched off R
the windshiel dw iper switch is at position 0
The vehicle could otherwise be damaged.
You can wash the vehicle in an automatic car
wash from the very start.
If the vehicle is very dirty, pre-wash it before
cleaning it in an automatic car wash.
After using an automatic car wash, wipe off wax
from the windshiel da nd the wiper blades. This
will prevent smears and reduce wiping noises
caused by residue on the windshield.
Washing by hand In some countries, washing by hand is only
allowed at speciall ye quipped washing bays.
Observe the legal requirements in each country. X
Do not use hot water and do not wash the
vehicle in direct sunlight. X
Use as oft sponge to clean.X
Use am ild cleaning agent, such as ac ar
shampoo approved by Mercedes-Benz. X
Thoroughly hose down the vehicle with ag en-
tle jet of water. X
Do not point the water jet directly towards the
air inlet. X
Use plenty of water and rinse out the sponge
frequently. X
Rinse the vehicle with clean water and dry
thoroughly with ac hamois.X
Do not let the cleaning agent dry on the paint-
work.
Carefully remove all deposits of road salt as
soon as possible when driving in winter.
Powe rw ashers
G WARNING
The water jet from ac ircular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components. Compo-
nent sd amage dint his way may fail unexpect-
edly .T here is ar isk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged tires or chassis component sr eplaced imme-
diately.
! Alway sm aintain ad istance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information abou tt he
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following: R
Tires R
Door gaps, roof gaps, joints, etc. R
Soft top (Designo retractable hardtop) R
Electrical components R
Battery R
Connectors R
Lights R
Seals R
Trim R
Ventilation slots
Damaged seals or electrical component sc an
lead to leaks or failures.
! Do not use high-pressure cleaners if the
tank recess is open while you clean it. This
can cause damage to the seals or other com-
ponents.
Cleaning the paintwork
! Do not affix: R
stickers R
films R
magnetic plates or simila ri tems
to painted surfaces. You could otherwise
damage the paintwork.
Scratches, corrosive deposits, areas affected by
corrosion and damage caused by inadequate
care cannot always be completely repaired. In
such cases, visit aq ualified specialist workshop. X
Remove dirt immediately ,w here possible,
while avoiding rubbing too hard. X
Soak insect remains with insect remover and
rinse off the treated areas afterwards. X
Soak bird droppings with water and rinse off
the treated areas afterwards. X
Remove coolant, brake fluid, tree resin, oils,
fuels and greases by rubbing gently with a Care 237
Maintenance and care Z

Do not us ep ower washers with circular jet
nozzles to clean the vehicle. Hav ed amaged
tire sorc hassi sc omponents replaced imme-
diately.
! Do not us ea cidi cw heel cleaning products
to remove brake dust. Thi sc ould damage
whee lb ol ts and brake components.
! Do not park your vehicl ef or al on gp er io do f
time directl ya ft er cleaning, particularly after
cleaning the whee lr im with whee lc leaner.
Whee lc leane rc an lead to the increased cor-
rosio noft he brake discs and pads .T herefore,
drive for af ew minute sa ft er cleaning. By
heating up the brakes ,t he brake discs and
pads dry .T he vehicl ec an the nb ep ar ked for a
long perio doft ime.
Cleanin gt he windows
G WARNING
Yo uc ould become trapped by the windshield
wipers if the ys tart moving whil ec leaning the
windshiel dorw iper blades. There is ar is ko f
injury.
Alway ss wi tch off the windshiel dw iper sa nd
the ignition befor ec leaning the windshiel do r
wipe rb lade s.
! Do not us ed ry cloths, abrasive products,
solvents or cleaning agents containing sol-
vents to clean the insid eoft he windows .D o
not touch the insides of the windows with
hard objects ,e .g .ani ce scrape rorr ing. There
is otherwis ear is kofd amagin gt he windows.
! Clea nt he water drainage channel soft he
windshiel da nd the rea rw in do watr egular
intervals .D eposits such as leaves, petal sa nd
pollen ma yu nder certain circumstances pre-
vent water fro md raining away .T hi sc an lead
to corrosion damage and damage to elec-
troni cc omponents.X
Clea nt he insid ea nd outside of the windows
with ad am pc loth and ac leaning product that
is recommende da nd approved by Mercedes-
Benz. Cleanin gw ip er blades
G WARNING
Yo uc ould become trapped by the windshield
wipers if the ys tart moving whil ec leaning the
windshiel dorw iper blades. There is ar is ko f
injury.
Alway ss wi tch off the windshiel dw iper sa nd
the ignition befor ec leaning the windshiel do r
wipe rb lade s.
! Do not pull the wipe rb lade .O therwise, the
wipe rb lade could be damaged.
! Do not clean wipe rb lade st oo ofte na nd do
not ru bt he mt oo hard. Otherwise, the graph-
ite coating could be damaged. Thi sc ould
cause wipe rn oise.
! Hol dt he wipe ra rm securel yw he nf olding
back. The windshiel dc ould be damage dift he
wipe ra rm smacks against it suddenly. X
Fol dt he windshiel dw iper arms away fro mt he
windshield. X
Carefully clean the wipe rb lade sw it had am p
cloth. X
Fol dt he windshiel dw iper arms back again
befor es wi tching on the ignition.
Cleanin gt he exterior lighting
! Onl yu se cleaning agents or cleaning cloths
which ar es ui tabl ef or plastic light lenses.
Unsuitabl ec leaning agents or cleaning cloths
could scratch or damage the plastic light len-
ses. X
Clea nt he plastic lense soft he exterio rl ig hts
with aw et spong ea nd am il dc leaning agent,
e.g .M er cedes-Benz car shampo oorc leaning
cloths.
Cleanin gt he mirro rt urn signals
! Onl yu se cleaning agents or cleaning cloths
tha ta re suitabl ef or plastic lenses. Unsuitable
cleaning agents or cleaning cloths could
scratch or damage the plastic lense soft he
mirror tur ns ig nals. X
Clea nt he plastic lense soft he mirror tur ns ig -
nal sint he exterio rm irror housing using aw et
spong ea nd mil dc leaning agent, e.g.Care 239
Maintenance and care Z