navigation MERCEDES-BENZ SLK-Class 2007 R171 Comand Manual

31 At a glance
Quick reference COMAND

Quick reference COMAND
Switching ON
Turn the key in the steering lock to po-
sition 1 or 2,
or
Press).
COMAND switches on the last active
system and displays the corresponding
menu.
Switching OFF
Turn the key in the steering lock to po-
sition 0 and remove it,
or
Press).Different volume settings are possible for
Navigation* or Telephone*.
A common volume setting is provided for
Radio, Single CD, MP3, CD changer*, AUX
and Satellite radio* operating modes.
When setting the volume, the system auto-
matically stores the setting for the current-
ly active operating mode. The volume of
navigation announcements can be
changed only during an actual announce-
ment.
Setting the volume Turn the rotary control* located on
the COMAND control unit,
or
i
The system can be operated as follows:
from COMAND itself, or
from the multifunction steering
wheel
This operating manual describes oper-
ation from COMAND and from the mul-
tifunction steering wheel.
Unless otherwise specified, the de-
scriptions and the displays illustrated
relate to the COMAND control unit.
Switching COMAND ON/OFF
i
Without the key in position 1 or 2 of the
steering lock, the system automatically
switches OFF again after approx. 30
minutes of inactivity.
i
If a telephone call is in progress (hands-
free) you cannot switch the COMAND
OFF, ) is disabled.
Volume


32 At a glance
Quick reference COMAND
Pressæ or ç on the multifunc-
tion steering wheel
The volume changes up or down, de-
pending on the direction of rotation or
which button was pressed.
The system stores the volume settings
when the device is switched OFF.
After switching the system back on again,
the volume may be lower than at the time
when the system was switched OFF.
This could be the case if
the system was switched OFF for more
than 15 minutes, and
the volume had been set to a value in a
certain range at the time the device
was switched OFF.Automatic volume control
The automatic volume control adjusts the
volume depending on
the vehicle’s speed (only in vehicles
without sound-system*),
or on
the interior ambient noises of the vehi-
cle (only in vehicles with sound-sys-
tem*)
other parameters (e.g. windows open
or closed)
A common balance setting applies to the
following operating modes:
Radio
Single CD
MP3
CD changer*
AUX
Satellite radio*
When adjusting the balance, the system
automatically stores the setting for the
currently active operating mode.
Setting balance
Open the main menu of the appropriate
operating mode (
page 29).
Press the Balance soft key.
The Balance menu appears.
Balance
i
For Navigation* a different balance set-
ting is possible. You find the descrip-
tion under “Adjusting the acoustics for
navigation announcements”
(
page 113).

33 At a glance
Quick reference COMAND
Press# or $:
The cursor moves horizontally, adjust-
ing the balance accordingly.
Storing new settings:
Press' or the Back soft key,
or
wait until the display changes.For the following operating modes, differ-
ent settings for bass and treble can be se-
lected:
Radio (FM waveband)
Radio (AM waveband)
Radio (Weather Band)
Single CD
MP3
CD changer*
AUX
Satellite radio*
Navigation*
Bass and treble settings for navigation an-
nouncements are found under “Adjusting
the acoustics for navigation announce-
ments” (
page 113).When adjusting bass or treble, the system
automatically stores the setting for the
currently active operating mode.
Setting bass and treble
Open the main menu of the appropriate
operating mode (
page 29).
Press the Bass or Treble soft key.
The Bass or Treble menu appears.
Bass and treble


93 Telephone*
Telephone operation
Press1.
The Telephone main menu appears.
Telephone status information is displayed
on the right end of the status bar. The following displays are possible:
READY = telephone is logged into your
mobile communcations home network
and ready for use,
ROAMING = telephone is logged into a mo-
bile communications network outside
your home network,
NO SERV. = no network available,
 = telephone signal strength,
 = call active (page 99).
Other messages could also appear:
If the message
Please insert phone, Phone not installed
or Please insert SIM card
appears, see chapter “Switching the
phone ON / OFF” (
page 89).
If the message
Please Enter PIN: appears, see “Enter-
ing the PIN” (
page 91).
If the message
Enter unlock code: appears, see “Enter-
ing unlock code” (
page 91).
Selectable soft keys and options
 soft key
Opens the phone book (
page 101),
Recvd.# soft key
Opens the accepted and missed calls
list (
page 96),
Dialed # soft key
Opens dialed calls list (
page 97),
SMS soft key
Provides access to the SMS menu
(
page 104),
Entry of a phone number (page 95).
i
The information is also displayed in
Navigation* mode (only in map dis-
plays).


107
Important notes
Navigation main menu
Destination entry
Route guidance
During route guidance
Last destinations and destination memory
POIs (Points of Interest)
Navigation*

108 Navigation*
Important notes
Safety instructions
WarningG
For safety reasons, you should only enter a
destination when the vehicle is stationary.
When the vehicle is in motion, a passenger
should enter the destination. Study manual
and select route before driving.
Do not watch display screen or operate but-
tons while the vehicle is in motion - let navi-
gation announcements guide you. Stop at a
safe location before using buttons or mak-
ing corrections.
Traffic regulations always have priority over
any route recommendations given.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.
WarningG
The route calculated by COMAND is a rec-
ommendation on how to best reach your se-
lected destination.
During route guidance, you will not receive
any information on
Traffic lights
Stop and yield signs
Parking or stopping zones
One-way streets
Narrow bridges
Similar traffic regulation data
You should therefore always strictly observe
traffic regulations while driving. Drive care-
fully and always obey traffic laws and road
signs even if they contradict COMAND in-
structions.
WarningG
The Navigation DVD module contains a
Class 1 laser product. There is a danger of
invisible laser radiation if the cover is
opened or damaged.
Do not remove the cover. The Navigation
DVD module does not contain any parts
which can be serviced by the user. For safe-
ty reasons, have any service work which
may be necessary performed only by quali-
fied personnel.

109 Navigation*
Important notes
COMAND calculates the route with the
help of data that is stored on the naviga-
tion DVD.
Only use Mercedes-Benz navigation DVDs
designed for the SLK-Class (R171)
COMAND system. No other CDs or DVDs
will work. Using other navigation CDs or
DVDs might lead to malfunctions.
Because of changes in local traffic patterns
(e.g. road works) and/or incomplete data,
errors in calculation may occur.
As a result, the recommended route may
deviate from the ideal route. The data
stored on the DVD only reflects local con-
ditions at the time of DVD production. DVD
maps do not cover all areas nor all routes
within an area.The DVD is loaded into (and ejected from)
the navigation computer.
Th e n a v i g a t i o n c o m p u t e r i s m o u n t e d i n t h e
center of the trunk.
1Ejecting DVDs
2DVD slotLoading Insert the DVD into the DVD slot 2
face up.
Th e n a v i g a t i o n c o m p u t e r p u l l s t h e D V D
in.
Ejecting
Press: 1 and wait until the naviga-
tion computer ejects the DVD.
.
The navigation DVD covers the continental
U.S., Hawaii and Canada.
Contact your Mercedes-Benz Center or the
Customer Assistance Center in the U.S. at
1-800-FOR-MERCedes (1-800-367-6372)
or in Canada at 1-800-387-0100 for other
DVDs that may be available.
Change the navigation DVD
(
page 109).
Tips on the navigation DVDLoading/ejecting the DVD
i
Your Navigation DVD drive has been
designed to play DVDs which corre-
spond to the IEC 60908 standard.
If you insert thicker data carriers, e.g.
ones that have data on both sides (one
side with DVD data, the other side with
audio data), they cannot be ejected
and will damage the drive.
Travelling abroad

110 Navigation*
Important notes
If your vehicle has been transported by a
car, train or ferry, COMAND may require
some time to find its exact position. COMAND may issue navigation announce-
ments not suited to your actual position.
Moving the vehicle a few yards is typically
enough to remedy the situation.
While determining the exact position,
route guidance is subject to the following
restrictions:
COMAND does not output navigation
announcements.
The display OFF ROAD and an arrow indi-
cating the direction of the destination
appear instead of the detailed naviga-
tion displays.
Once the system is correctly repositioned,
route guidance continues with navigation
announcements and detailed navigation
displays. The following instructions have to be fol-
lowed when interrupting a trip during route
guidance, and later continuation:
Continuation of the trip within 2 hours
after interruption:
The system automatically resumes
route guidance.
Continuation of the trip between
2 and 12 hours after interruption:
Continue Route guidance manually
in the Navigation main menu
(
page 112).
Route guidance with GPS
i
GPS (Global Positioning System) sig-
nals received make it possible to deter-
mine the current vehicle position.
Deviations from the actual position
may occur
if the reception of GPS signals is
disturbed, e. g. in parking garages
and tunnels
if road conditions are bad
depending on the vehicle’s location
Determination of location after
vehicle transport
i
The navigation DVD must be loaded in
the navigation computer (
page 109).
Trip interruption during route guid-
ance
i
Trip interruption means parking the ve-
hicle and switching COMAND OFF.
Trip continuation means trip continua-
tion with COMAND switched ON.

111 Navigation*
Important notes
Continuation of the trip more than 12
hours after interruption:
Route guidance must be restarted.
Select the destination from the Last
destinations
memory (page 151),
or
Re-enter the destination
(
page 115).
Some menus provide lists from which you
can select an item.
Example: Menu to select a streetYou can select a list item using% or &.
If, as shown in the example, you can see
the
Page soft keys, then you can use the
soft keys to scroll up or down the list, page
by page.
As soon as you reach the beginning or end
of a list, the appropriate soft key is deacti-
vated.
Selection lists

112 Navigation*
Navigation main menu
Press 4.
The Navigation main menu appears if
no route guidance is active.
aa
Use% or & to select a menu item
and press ';
or
Press one of the soft keys.
The selected menu or the selected soft
key function appears.
Selectable menu items
Continue route guidance:
Continues a cancelled route guidance,
Destination memory:
Destinations can be selected from the
Destination memory (page 153),
Destination entry:
Provides access to the Destination en-
try menu (
page 115),
Last destinations:
You can select from the list of last des-
tinations (
page 151), or of such that
have been saved as current locations
(
page 130).
POIs:
(P
oints of Interest)
Provides access to POIs input
(
page 155). POIs include gas sta-
tions, airports, rest areas, hospitals,
etc.
Calling up the Navigation main menu
i
If route guidance is active, a prompt is
displayed instead, asking if route guid-
ance is to be cancelled (
page 135).
i
This menu item only appears:
if the route guidance had previously
been interrupted (
page 135), and
less than 30 minutes have expired
since the interruption,
or
if the trip was interrupted and is to
be continued 2 - 12 hours after in-
terruption (
page 110).
i
Destination memory (page 152) and
Last destinations
(page 151) can be
selected only if destinations are al-
ready stored in the system.