light MERCEDES-BENZ SLK55AMG 2005 R171 Manual PDF

382 Practical hintsReplacing bulbsNotes on bulb replacement

Only use 12-volt bulbs of the same type
and with the specified watt rating.


Switch lights off before changing a bulb
to prevent short circuits.


Always use a clean lint-free cloth when
handling bulbs.


Your hands should be dry and free of oil
and grease.


If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:


Additional turn signal lamps in the
exterior rear view mirrors


Bi-Xenon* lamps


Front fog lamps


High mounted brake lamp


Brake lamps


Front and rear side marker lamps


Parking/standing lamps in the tail
lamp assemblies
Replacing bulbs for front lamps
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to
positionM (
page 106).

Open the hood (
page 287) (except
for side marker lamps).
iHave the headlamp adjustment
checked regularly.

383 Practical hints
Replacing bulbs
1Housing cover for low beam (halogen
headlamps only)
Housing cover for Bi-Xenon* head-
lamps. Do not remove.
2Bulb socket for turn signal lamp
3Bulb socket for high beam/high beam
flasher lamp
4Bulb socket for parking and standing
light lamp
5Bulb socket for low beam bulb (Halo-
gen headlamps only)Low beam bulb (Halogen headlamps
only)

Turn housing cover1 counterclock-
wise and remove.

Turn bulb socket5 with the bulb
counterclockwise and remove.

Pull the bulb out of bulb socket5.

Press the new bulb into bulb socket5.

Place bulb socket5 back into the
lamp and turn it clockwise.

Reinstall housing cover1.
Warning!
G
Do not remove the cover1 for the Bi-Xe-
non* headlamp. Because of high voltage in
Bi-Xenon lamps, it is dangerous to replace
the bulb or repair the lamp and its compo-
nents. We recommend that you have such
work done by a qualified technician.

391 Practical hints
Flat tire
Removing the wheel
4Alignment bolt
Unscrew the upper-most wheel bolt
and remove.

Replace this wheel bolt with alignment
bolt4 supplied in the vehicle tool kit.

Remove the remaining bolts.

Remove the wheel.Mounting the spare wheel
1Wheel bolt for light alloy rims
2Wheel bolt for spare wheel with
collapsible tire (located in trunk with
spare wheel)

Clean contact surfaces of wheel and
wheel hub.
!Do not place wheel bolts in sand or dirt.
This could result in damage to the bolt
and wheel hub threads.
!Wheel bolts2 must be used when
mounting the spare wheel with
collapsible tire. The use of any wheel
bolts other than wheel bolts2 for the
spare wheel with collapsible tire will
physically damage the vehicle’s
brakes. !To avoid paint damage, place wheel flat
against hub and hold it there while in-
stalling first wheel bolt.

392 Practical hintsFlat tire

Guide the spare wheel onto the align-
ment bolt and push it on.

Insert the wheel bolts and tighten them
slightly.

Unscrew the alignment bolt, install last
wheel bolt and tighten slightly.
Warning!
G
Always replace wheel bolts that are dam-
aged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be re-
paired immediately. Do not continue to drive
under these circumstances! Contact an au-
thorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident. Be
sure to use the correct wheel bolts.
Warning!
G
Use only genuine equipment
Mercedes-Benz wheel bolts. Other wheel
bolts may come loose.
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle
could fall off the jack.

393 Practical hints
Flat tire
Inflating the collapsible tire
1Flap
2Air pump switch
3Electrical plug
4Air hose with pressure gauge and vent
screw
5Union nut

Take the electric air pump out of the
trunk (
page 369).

Open flap1 on air pump.

Pull out electrical plug3 and air hose
with pressure gauge4.

Close vent screw on air hose4.

Remove the valve cap from the tire
valve.

Screw air hose4 with union nut5
onto the collapsible tire valve.

Make sure electric air pump switch2
is set to0.

Insert electrical plug3 into vehicle
cigarette lighter socket.

Turn the SmartKey in the starter switch
to position1.
Warning!
G
Inflate collapsible tire only after the wheel is
properly mounted.
Inflate the collapsible tire using the electric
pump (
page 369) before
lowering the ve-
hicle.
Warning!
G
Observe instructions on air pump label.!Do not lower the vehicle before inflat-
ing the collapsible tire. Otherwise the
rim may be damaged.


400 Practical hintsJump starting
Make sure the two vehicles do not
touch.

Switch off all electrical consumers.

Apply parking brake.

Shift gear selector lever* to positionP
(manual transmission to Neutral).

Open the hood (
page 287).

Remove the cover from positive under
hood terminal2 in front of discharged
battery.1Positive terminal of charged battery
2Positive under hood terminal in front of
discharged battery
3Negative under hood terminal in front
of discharged battery
4Negative terminal of charged battery

Connect positive terminal1 of the
charged battery with positive under
hood terminal2 in front of the dis-
charged battery with one jumper cable.
Clamp the cable to positive terminal1
of the charged battery first.

Start the engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminal4 of the
charged battery with negative under
hood terminal3 in front of the dis-
charged battery with the second jump-
er cable. Clamp the cable to negative
terminal4 of the charged battery
first.

Start the engine of the disabled vehi-
cle.
You can now switch on the electrical con-
sumers. Do not switch on the lights under
any circumstances.

Remove the jumper cables first from
negative terminals3 and4 and then
from positive terminals2 and1.
You can now switch on the lights.

Have the battery checked at the near-
est authorized Mercedes-Benz Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 294).
!Never invert the terminal connections.
iVehicles with automatic transmission*:
Do not tow-start vehicle.

414 Technical dataRims and tiresSame size tires
17" tires
SLK 350
SLK 350 (Sport Package*)
SLK 55 AMG
Rims (light alloy)
71/2J x 17 H2
71/2J x 17 H2
Wheel offset
1.42 in (36 mm)
1.46 in (37 mm)
Summer tires (radial-ply tires)
-
-
Winter tires (radial-ply tires)
225/45 R17 91H M+S
or
225/45 R17 91H M+S MOExtended
1
1Must be used in conjunction with Run-Flat Indicator* only.
205/50 R17 89H M+S
2
or
225/45 R17 91H M+S
2
or
225/45 R17 91H M+S MOExtended
1,2
2For use with snow chains contact an authorized Mercedes-Benz Center.

415 Technical data
Rims and tires
18" tires
SLK 55 AMG
Rims (light alloy)
71/2J x 18 H2
Wheel offset
1.46 in (37 mm)
Summer tires (radial-ply tires)
-
Winter tires (radial-ply tires)
225/40 R18 92H XL (Extra Load) M+S
1
1For use with snow chains contact an authorized Mercedes-Benz Center.

416 Technical dataRims and tiresMixed size tires
SLK 350
SLK 350 (Sport Package*)
Front axle:Rims (light alloy)
71/2J x 17 H2
71/2J x 17 H2
Wheel offset
1.42 in (36 mm)
1.46 in (37 mm)
Summer tires (radial-ply tires)
225/45 R17 91W
or
225/45 R17 91W MOExtended
1
225/45 R17 91W
or
225/45 R17 91W MOExtended
1
Rear axle:Rims (light alloy)
81/2J x17 H2
81/2J x17 H2
Wheel offset
1.18 in (30 mm)
1.18 in (30 mm)
Summer tires (radial-ply tires)
245/40 R17 91W
2
or
245/40 R17 91W MOExtended
1,2
245/40 R17 91W
2
or
245/40 R17 91W MOExtended
1,2
1Must be used in conjunction with Run Flat Indicator* only.2Must not be used with snow chains.

417 Technical data
Rims and tires
SLK 55 AMG
Front axle:Rims (light alloy)
71/2Jx18 H2
Wheel offset
1.46 in (37 mm)
Summer tires (radial-ply tires)
225/40 ZR18 92Y XL (Extra Load)
Rear axle:Rims (light alloy)
81/2 J x18 H2
Wheel offset
1.18 in (30 mm)
Summer tires (radial-ply tires)
245/35 ZR18 92Y XL (Extra Load)
1
1Must not be used with snow chains.