brake pads MERCEDES-BENZ SLR 2006 R199 Owner's Manual

86 Safety and SecurityDriving safety systemsThe electrohydraulic brake servo assis-
tance switches off automatically

approximately 2 minutes after you
turned the SmartKey in the starter
switch to position0 or removed the
SmartKey


approximately 20 seconds after you
locked the vehicle from outside Note on driving with the electrohydrau-
lic brake system


Following extended periods of only mi-
nor loads to your brake system, you
should occasionally apply the brakes
when traveling at high speeds. This im-
proves the grip of the brake pads and
prevents possible brake noise.


After driving on wet or snow-covered
roads, you should apply your brakes
firmly before parking your vehicle. This
produces heat which serves to dry the
brake disks.


On long and steep grades, shift to a
lower gear (gear range1, 2, or 3) to
prevent the brakes from overheating
and to reduce brake wear.


After hard braking, it is advisable to
drive on for some time so that the air
stream will cool down the brakes fast-
er.


Only Mercedes-Benz approved compo-
nents (e.g. brake pads) should be in-
stalled on your vehicle. Brake pads not
approved by Mercedes-Benz may im-
pair the safety of your vehicle.
Warning!
G
Make sure not to endanger any other road
users when carrying out these braking
maneuvers.

232 OperationDriving instructionsPower assistance
Brakes
Warning!
G
The brake system requires electrical energy
for operation.
A malfunction in the vehicle’s power supply
or electrical system may impair brake sys-
tem operation and switch it into its emer-
gency operation mode. In such a case, the
red brake warning lamp (
page 300) and
warning messages (
page 307) in the in-
strument cluster come on while driving. To
brake, the driver must then apply signifi-
cantly greater brake pedal pressure and de-
press the pedal much further to obtain the
expected braking effect. If necessary, apply
full pressure to the brake pedal. Brakes are
only applied to the front wheels. Stopping
distance is increased! If there is a malfunc-
tion in the electrohydraulic brake system,
we recommend that the vehicle be trans-
ported with all wheels off the ground using
flatbed or appropriate wheel lift/dolly equip-
ment.
A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
up to 30 miles (50 km) and at a speed not to
exceed 30 mph (50 km/h). For more infor-
mation, see “Towing the vehicle”
(page 360).
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the ve-
hicle.
Warning!
G
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking ef-
fect. Maintain a safe distance from vehicles
in front.
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an acci-
dent.

233 Operation
Driving instructions
After driving on wet or snow-covered
roads, you should apply your brakes firmly
before parking your vehicle. This produces
heat which serves to dry the brake disks.
If the parking brake is released and the red
brake warning lamp in the instrument clus-
ter stays on, there is a malfunction in the
electrohydraulic brake system
(
page 300) or the brake fluid level in the
reservoir is too low.
Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected immedi-
ately.All checks and service work on the brake
system should be carried out by qualified
technicians only. Contact an authorized
Mercedes-Benz Center.
Only install brake pads and brake fluid rec-
ommended by Mercedes-Benz.
iThe brake system is designed to decel-
er ate you r S LR f rom hi gh sp ee ds a t the
best possible rate. Depending on the
applied brake force, speed, and ambi-
ent conditions, the brake system may
produce a squeak-type noise when you
apply the brakes at a moderate rate,
e . g . a t c i t y t r a f f i c . I f y o u e x p e r i e n c e t h i s
noise, you should occasionally test the
effectiveness of the brakes by applying
above-normal braking pressure at high
speeds. Please perform this braking
procedure three times. This will also
enhance the grip of the brake pads. If
the noise continuous, contact an au-
thorized Mercedes-Benz Center.
Warning!
G
Make sure not to endanger any other road
users when carrying out these braking
maneuvers.!Refer to the description of the Brake
Assist System (BAS) (
page 81).
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.
Be certain to read and observe the warning
notices on brake pad replacement
(page 85).

318 Practical hintsWhat to do if ...Left display
Right display
Possible cause/
consequence
Possible solution
2
Brake wear
Visit
workshop
The brake pads have reached
their wear limit.

Have the brake pads replaced immediately.
!Brake pad thickness must be visually
checked by a qualified technician at the
intervals specified in the Maintenance
Booklet.Warning!
G
Have brake pad replacement and other work
on the electrohydraulic brake system car-
ried out by qualified technicians only. Con-
tact your Mercedes-Benz Center for further
information. The electrohydraulic brake sys-
tem must be deactivated prior to working on
the system. High pressure is intermittently
built up in the system as part of its automat-
ic self-test. In addition, the system is auto-
matically activated when the vehicle is
unlocked by remote control, when the driver
or passenger door is opened, when the
SmartKey in the starter switch is turned to
position1, when the brake pedal is de-
pressed or when the parking brake is re-
leased.
Failure to deactivate the system prior to
maintenance will cause brake pistons to ex-
tend and brake fluid to leak, which may re-
sult in injuries (contusions and acid burns),
see “Electrohydraulic brake system”
(page 84).

393 Index
Body surface 292
Brake
Electrohydraulic brake system 84
Brake Assist System see BAS
Brake fluid 377, 379
Checking 242
Messages in the multifunction
display 300, 317
Brake lamps 349
High mounted 349
Messages in the multifunction
display 330
Brake pads
Messages in the multifunction
display 318
Brakes 232
Warning lamp 29, 300
Break-in the vehicle 230
Bulbs
Messages in the multifunction
display 330
Replacing 348C
CAC 385
California retail buyers and lessees, impor-
tant notice for 15
Call priority, Tele Aid 214
CAN system 386
Capacities and recommended
fuel/lubricants 377
Cargo area see Trunk
Cassette player 152
Catalytic converter 239
CD changer 156
Location 157
CD player 124
Cellular phone
Delayed switch-off time 206
Inserting the cradle 205
Making calls in hands-free mode 207
Making calls in private mode 206
Re-inserting 207
Removing the cradle 205
Center console
Lower part 32
Upper part 31
Center storage compartment 201Central locking
Automatic 103, 137
Central locking switch 31
Locking/unlocking from inside 103
Central locking switch 103
Children in the vehicle 72
Airbags 64
Indicator lamp, front passenger front
airbag 75
Infant and child restraint systems 62,
75, 77
Cigarette lighter 202
Clock 29, 131
Setting time 131
Cockpit 26, 386
Cold tire inflation pressure 281
Combination switch 27, 53, 109
Compact guide 343
Control and operation of radio
transmitters 238
Control system 117, 386
Multifunction display 117
Multifunction steering wheel 118
Resetting to factory default 127

400 IndexMultifunction display messages
ABS 309
ACL malfunction 312
Airbrake 315
Battery, Vehicle 315
Brake pads 318
Coolant 323
Cruise control 310
Differential 326
Display 327
Doors 327
Electrohydraulic brake system 319
Engine 328
Engine oil 328
ESP
®
310
Fuel system 329
Hood 329
Lamps 330
Parking brake 322
Reserve fuel 329
Seat belt 334
Service brake 322
SmartKey 329
Telephone 329
Tires 335
Trunk lid 341Washer fluid 341
Multifunction steering wheel 30, 118,
387
Button operation 118
Gearshift control, Automatic
transmission 174
N
Net, parcel 201
New vehicle break-in 230
Night security illumination 108, 134
Normal occupant weight 282
Number, Vehicle Identification
(VIN) 368, 389
O
Occupant distribution 282
Occupant safety
Airbags 63
BabySmart
TM airbag deactivation
system 75
Children and airbags 64
Children in the vehicle 72
Fastening the seat belts 46
Infant and child restraint systems 73
Seat belts 69
Octane number 388Odometer
Main 117
Trip 115
Oil level see Engine oil, Checking level
Oil see Engine oil
One-touch gearshifting, Automatic
transmission 168
Operating safety
Audio system 143
Vehicle 20
Operator’s manual 342
Outside temperature see Displays
Overdue maintenance service 290
Overhead control panel 33
Overspeed range, Engine 115, 388
P
Panic alarm 78
Parcel net in trunk 201
Parking 57, 234
Parking brake 32
Engaging 57
Message in the multifunction
display 322
Releasing 50