fog light MERCEDES-BENZ SLR CLASS 2007 Owners Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2007, Model line: SLR CLASS, Model: MERCEDES-BENZ SLR CLASS 2007Pages: 425, PDF Size: 6.57 MB
Page 107 of 425
106 Controls in detail
Lighting
For information on how to switch on the
headlamps and use the turn signals, see
“Switching on headlamps” (
page 51).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.
MOff
Daytime running lamp mode
(
page 108)
UAutomatic headlamp mode
Daytime running lamp mode
(
page 108)
CParking lamps (also tail lamps,
license plate lamps, side marker
lamps, instrument panel lamps)BLow beam headlamps or high beam
headlamps when the combination
switch is pushed forward. The tail
lamps, license plate lamps, side
marker lamps, parking lamps and
instrument panel lamps also come
on.
ˆStanding lamps, right
(turn left one stop)
‚Standing lamps, left
(turn left two stops)
CIndicator lamp for parking lamps
‡Indicator lamp for front fog lamps
†Indicator lamp for rear fog lamp
iIf you drive in countries where vehicles drive
on the other side of the road than the country
where the vehicle is registered, you must have
the headlamps modified for symmetrical low
beams. Relevant information can be obtained at
your authorized Mercedes-Benz Center.
iIf you hear a warning signal you have forgot-
ten to switch off the headlamps before opening
the driver’s door.
In addition the message$
Turn off lamps
appears in the multifunction display.
Switch off the headlamps.
Page 108 of 425
107 Controls in detail
Lighting
Manual headlamp mode
The low beam headlamps and the parking
lamps can be switched on and off with the
exterior lamp switch.
Automatic headlamp mode
The following lamps switch on and off
automatically depending on the brightness
of the ambient light:
Low beam headlamps
Tail and parking lamps
License plate lamps
Side marker lamps
Turn the exterior lamp switch to
positionU.
With the SmartKey in starter switch
position1, only the parking lamps and
side marker lamps will switch on and
off automatically.
When the engine is running, the low
beam headlamps, the tail and parking
lamps, the license plate lamps, and the
side marker lamps will switch on and
off automatically.
Warning!G
If the exterior lamp switch is set toU,
the headlamps may switch off unexpect-
edly when the system senses bright
ambient light, for example light from
oncoming traffic.
the headlamps will not be automatically
switched on under foggy conditions.
To minimize risk to you and to others,
activate headlamps by turning exterior lamp
switch toB when driving or when traffic
and/or ambient lighting conditions require
you to do so.
In low ambient lighting conditions, only
switch from positionU toB with the
vehicle at a standstill in a safe location.
Switching fromU toB will briefly
switch off the headlamps. Doing so while
driving in low ambient lighting conditions
may result in an accident.
The automatic headlamp feature is only an
aid to the driver. The driver is responsible for
the operation of the vehicle’s lights at all
times.
iUSA only:
With the automatic headlamp mode activated
you can switch on the high beam headlamps in
low ambient lighting conditions.
Page 110 of 425
109 Controls in detail
Lighting
USA only:
By default, the daytime running lamp mode
is deactivated. Activate the daytime
running lamp mode using the control
system, see “Setting daytime running lamp
mode (USA only)” (
page 135).
When the engine is running, and you turn
the exterior lamp switch to positionC
orB, the manual headlamp mode has
priority over the daytime running lamp
mode.
The corresponding exterior lamps switch
on (
page 106).
Locator lighting and night security
illumination
The locator lighting and the night security
illumination are described in the “Control
system” section, see “Setting locator light-
ing” (
page 135) and “Setting night secu-
rity illumination” (
page 136).Fog lampsFront fog lamps
Switch on the low beam headlamps
(
page 106).
Pull out the exterior lamp switch to first
stop.
The front fog lamps switch on.
The green indicator lamp‡ in the
exterior lamp switch comes on.
Push in the exterior lamp switch.
The front fog lamps switch off.
The green indicator lamp‡ in the
exterior lamp switch goes out.
Warning!G
In low ambient lighting or foggy conditions,
only switch from positionU toB with
the vehicle at a standstill in a safe location.
Switching fromU toB will briefly
switch off the headlamps. Doing so while
driving in low ambient lighting conditions
may result in an accident.
iFog lamps will operate with the parking
lamps and/or the low beam headlamps on. Fog
lamps should only be used in conjunction with
low beam headlamps. Consult your State or
Province Motor Vehicle Regulations regarding al-
lowable lamp operation.
iFog lamps cannot be switched on with the
exterior lamp switch in positionU. For
switching on the fog lamps, turn the exterior
lamp switch to positionB first.
Page 111 of 425
110 Controls in detail
Lighting
Rear fog lamp (driver’s side only)
Switch on the low beam headlamps
(
page 106).
Pull out the exterior lamp switch to
second stop.
The front fog lamps and rear fog lamp
switch on.
The yellow indicator lamp† in the
exterior lamp switch comes on.
Push in the exterior lamp switch to first
stop.
The rear fog lamp switches off.
The yellow indicator lamp† in the
exterior lamp switch goes out.
The front fog lamps remain lit.
Combination switch
The combination switch is located on the
left of the steering column.
1High beam
2High beam flasherHigh beam
USA only: Turn the exterior lamp switch
to positionB orU
(
page 106).
Canada only: Turn the exterior lamp
switch to positionB (
page 106).
Push the combination switch in
direction of arrow1 to switch on the
high beam.
The high beam headlamp indicator
lampA in the instrument cluster
comes on (
page 29).
Pull the combination switch in direction
of arrow2 to its original position to
switch off the high beam.
The high beam headlamp indicator
lampA in the instrument cluster
goes out.
High beam flasher
Pull the combination switch briefly in
direction of arrow2.
Page 136 of 425
135 Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
Move the selection marker with button
æ or ç to the
Lighting sub-
menu.
Press button j or k repeatedly
until you see this message in the left
multifunction display:
Light circuit
Headlamp mode
.
The selection marker is on the current
setting.
Press buttonæ orç to select
manual operation (
Manual) or daytime
running lamp mode (
Constant)
activated.With daytime running lamp mode activated
and the exterior lamp switch in
positionM orU, the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
For more information on the daytime
running lamp mode, see “Daytime running
lamp mode” (
page 108).Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
positionU, the following lamps will
switch on during darkness when the
vehicle is unlocked with the SmartKey:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
Front fog lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey the lamps
will switch off automatically after approxi-
mately 40 seconds.
iThis function is not available in countries
where the daytime running lamp mode is manda-
tory and therefore in a constant mode.
iIf you turn the exterior lamp switch to anoth-
er position, the corresponding lamp(s) will
switch on.
For safety reasons, resetting the
Lighting sub-
menu to factory settings (
page 129) will not
reset the daytime running lamp mode.
The following message appears in the right multi-
function display:
Cannot be fully reset to
factory settings when driving
.
Page 137 of 425
136 Controls in detail
Control system
Move the selection marker with button
æ or ç to the
Lighting
submenu.
Press button j or k repeatedly
until you see this message in the left
multifunction display:
Locator lighting.
The selection marker is on the current
setting.
Press button æ or ç to switch
the locator lighting function
On.
Turn the exterior lamp switch to
positionU when exiting the vehicle
(
page 106).
The locator lighting feature is
activated.Setting night security illumination
(Headlamps delayed switch-off)
Use this function to set whether you would
like the exterior lamps to remain on for
15 seconds during darkness after exiting
the vehicle and closing the doors.
With the delayed shut-off feature activated
and the exterior lamp switch in
positionU before the engine is turned
off, the following lamps will switch on
when the engine is turned off:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
Front fog lamps
If after turning off the engine you do not
open a door or do not close an opened
door, the lamps will automatically switch
off after 60 seconds.
Move the selection marker with button
æ or ç to the
Lighting sub-
menu.
Press button j or k repeatedly
until you see this message in the left
multifunction display:
Headlamps delayed switch-off.
The selection marker is on the current
setting.
Press button æ or ç to switch
the headlamps delayed shut-off feature
On or Off.
Turn the exterior lamp switch to
positionU before turning off the
engine (
page 106).
The headlamps delayed switch-off
feature is activated.
Page 360 of 425
359 Practical hints
Replacing bulbs
Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp
assemblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See an authorized
Mercedes-Benz Center for headlamp
adjustment.!Do not replace the LEDs or bulbs yourself.
You could otherwise damage the vehicle lighting
system or parts of the vehicle. Only have the
LEDs or bulbs replaced by an authorized
Mercedes-Benz Center.
iIf the headlamps are fogged up on the inside
as a result of high humidity, driving the vehicle a
distance should clear up the fogging.
iSubstitute bulbs will be brought into use
when lamps malfunction. Observe the messages
in the multifunction display (
page 341).
iIf one of the following bulbs blows, another
bulb will adopt its function:
Rear turn signals
Brake lamps
Side lamps
Tail lamps
Page 410 of 425
409 Index
D
Daytime running lamp mode 108
Setting 135
Deep water see Standing water
Defogging, Windshield 194
Defrosting, Front 194
Defrosting, Rear 185
Delayed switch-off
Exterior lamps 136
Interior lighting 137
Department of Transportation see DOT
Differential
Message in the multifunction
display 338
Difficulties
While driving 54
With starting 49
Digital clock see Clock
Digital speedometer 122
Dimensions, Vehicle 387
Direction of rotation, Tires 261
Display elements, Audio system 146Displays
Digital speedometer 122
Maintenance service indicator 292
Multifunction display 117
Outside temperature 116, 122
Symbol messages 327
Text messages 316
Vehicle status messages 128, 314
Distance to empty 140
Distance to empty (range), Trip
computer 140
Door
Control panel 34
Entry lamps 112
Handle, Inside 34
Handle, Outside 38
Locking/unlocking, SmartKey 38, 98
Message in the multifunction
display 352
Opening from inside/outside 38,
101
Remote door unlock, Tele Aid 220
Unlocking in an emergency 356DOT 284
Drinking and driving 235
Driving 45, 50
Abroad 243
Hints, Electro-hydraulic brake
system 88
Hydroplaning 241
In winter 242
Instructions 45, 235
Problems 54
Safety systems 81
Systems 203
Through standing water 243
Tips, Automatic transmission 173
Driving safety systems 81
ABS 81
BAS 83
Electro-hydraulic brake system 86
Electronic traction system 85
ESP
®83
Driving systems
Cruise control 203
Dust cover 228
Page 422 of 425
421 Index
U
Uniform Tire Quality Grading
Standards 286
Units, Setting
Digital speedometer 132
Unleaded gasoline, Premium 247, 392
Useful features 206
V
Vacuum line routing diagram label 378
Vehicle
Batteries 256
Control system, Settings menu 129
Dimensions 387
Locking/unlocking 38, 57, 98, 105
Modifications and alterations, Operat-
ing safety 20
Towing 370
Transporting 372
Unlocking in an emergency 355
Vehicle care 295
Vehicle Identification Number see VIN
Vehicle lighting 249
Vehicle literature portfolio 353Vehicle loading 261
Load limit 262
Roof and trunk lid racks 230
Terminology 284
Vehicle maximum load on the tire 286
Vehicle Recovery services, Stolen
(Tele Aid) 221
Vehicle status message memory
menu 128
Vehicle washing 296
VIN 378, 403
W
Warning lamps see Lamps, Indicator and
warning
Warning sounds
Drivers seat belts 74
Exterior lamps 57
Parking brake 50
Warranty coverage 14, 377
Washer fluid see Windshield washer fluid
Washer reservoir level 257
Washing the vehicle 295
Wear pattern, Tires 287
Wheel bolts
Anti-theft wheel nuts 288
Tightening torque 287Wheels, Sizes 382
Wheels, Tires and 258
Windows see Power windows
Windshield
Cleaning 297
Defogging 194
Windshield washer fluid 257, 397
Message in the multifunction
display 352
Mixing ratio 397
Refilling 257
Wiping with 53
Windshield washer system 397
Windshield wipers 27, 52
Cleaning wiper blades 297
Replacing wiper blades 361
Single wipe 53
Winter driving 290
Instructions 242
Snow chains 291
Tires* 290
Winter tires* 290