tires Mercury Mariner 2010 Scheduled Maintenance Guide

Crown Victoria Police Interceptor & Taxi, and Executive Series Town
Car equipped with Engine Idle Hour Meter
Inspect frequently, service as
requiredReplace cabin air filter (if equipped)
Every 5,000 milesInspect brake system
Rotate tires, inspect tires for wear and measure tread
depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Lubricate control arm and steering ball joints (if
equipped with zerk fittings)
Every 5,000 miles or 6 monthsInspect and lubricate U-joints
Every 5,000 miles, 6 months or
as indicated by time/mileage
calculationChange engine oil and replace oil filter (see
description below)
Every 15,000 milesReplace fuel filter
Every 30,000 milesChange automatic transmission fluid
Every 60,000 milesReplace spark plugs
ENGINE IDLE HOUR METER (IF EQUIPPED):
Your vehicle may be equipped with an idle meter to indicate how much time the vehicle is idling in P (Park)
or N (Neutral). The meter is incorporated with the vehicle odometer. Depressing the odometer-reset button
once will display the trip odometer (miles followed by a “T” for trip odometer). Depressing the odometer-reset
button a second time will display the idle meter (hours followed by an “H” for hours). The idle meter
only accumulates time when the vehicle is in P (Park) or N (Neutral). Displayed time is cumulative for the
vehicle.It cannot be reset to zero.
Police/Fleet vehicles often experience long periods of idling,
during which engine oil will continue to break down but mileage is not accumulated on the odometer.
To assist fleet managers in maintaining proper oil change intervals, the idle meter will help determine when
an oil change is required. For every hour that the vehicle idles, it has accumulated the equivalent of
approximately 33 miles of driving. Using the combination of the vehicle odometer and idle meter allows
the fleet manager to better determine when the oil needs to be changed
Engine idle hour meter calculation:
Idle hours x 33 = miles equivalency
Miles driven + miles equivalency = oil change interval
Example:When the odometer has accumulated 3,000 miles and the idle meter shows 61 hours, a
5,000 mile oil change interval will have been reached: 3,000 road miles + (61 idle hours x 33 miles/idle
hour) = 5,013 miles.
SPECIALOPERATINGCONDITIONS
Scheduled Maintenance43
2010 Scheduled Maintenance Guide(smg)
Scheduled Maintenance Guide, 1st Printing
USA(fus)
Special Operating
Conditions &
Exceptions

Operating in dusty conditions such as unpaved or dusty roads
Inspect frequently, service as
requiredReplace engine air filter
Replace cabin air filter (if equipped)
Every 5,000 milesRotate tires, inspect tires for wear and measure tread
depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Every 5,000 miles or 6 monthsChange engine oil and replace oil filter
Inspect and lubricate U-joints
Every 15,000 milesReplace fuel filter (Crown Victoria, Grand Marquis,
Town Car, Mustang, Ranger, F-Super Duty, Expedition
EL and Navigator EL)
Every 30,000 milesChange automatic transmission/transaxle fluid (not
required on 6R60/6R80/TorqShift transmissions)
Replace wheel bearing grease and grease seals on
4x2 front wheel bearings (if non-sealed bearings)
Every 50,000 milesChange manual transmission fluid
Change rear axle lubricant (E-450 and F-450/550
only)
Every 60,000 milesChange transfer case fluid
SPECIALOPERATINGCONDITIONS
44Scheduled Maintenance
2010 Scheduled Maintenance Guide(smg)
Scheduled Maintenance Guide, 1st Printing
USA(fus)

Off-road operation
Inspect frequently, service as
requiredReplace cabin air filter (if equipped)
Inspect and lubricate steering linkage ball joints and
U-joints (if equipped with zerk fittings)
Every 5,000 miles or 6 monthsChange engine oil and replace oil filter
Rotate tires, inspect tires for wear and measure tread
depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Every 30,000 milesChange automatic transmission/transaxle fluid (not
required on 6R60/6R80/TorqShift transmissions)
Replace wheel bearing grease and grease seals on
4x2 front wheel bearings (if non-sealed bearings)
Every 50,000 milesChange manual transmission fluid
Change rear axle lubricant (E-450 and F-450/550
only)
Every 60,000 milesChange transfer case fluid
Use of E85 50% of the time or greater (flex fuel vehicles only)
Every 5,000 milesRotate tires, inspect tires for wear and measure tread
depth
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Every 3,000 milesFill fuel tank with a full tank of regular unleaded fuel
Every 5,000 miles or 6 monthsChange engine oil and replace oil filter
SPECIALOPERATINGCONDITIONS
Scheduled Maintenance45
2010 Scheduled Maintenance Guide(smg)
Scheduled Maintenance Guide, 1st Printing
USA(fus)
Special Operating
Conditions &
Exceptions