reset Mercury Mountaineer 2007 Quick Reference Guide

Location of Spare Tire and Tools
The spare tire is located under the vehicle,
just forward of the rear bumper. The spare
tire winch drive nut is located at the rear
center of the cargo area, under a lid. The
jack, jack handle and lug nut wrench are
located behind the rear seat under the
carpeted lid in the cargo floor. The tools are
contained in a bag attached to the jack.
Fuses
If the vehicle’s electrical components are not
operating, a fuse may have blown. The fuse
panel is located below the instrument panel
on the driver’s side; remove the cover to
view the fuses. For more information
regarding changing fuses, refer to the
Roadside Emergencies chapter of your
Owner’s Guide.
Fuel Information
Use regular unleaded gasoline with an
(R+M)/2 octane rating of 87. Ford Motor
Company does not recommend using regular
unleaded gasoline with an octane rating
of 86 or lower in high altitude areas. The
advertised fuel capacity of the fuel tank is
equal to the rated refill capacity of the fuel
tank as listed in the Maintenance and
Specifications chapter of the Owner’s Guide.
Tire Pressure
Your vehicle’s tire pressure is properly set by
your authorized dealer according to the
recommended specifications found on the
vehicle’s tire label, located on the driver’s
door jamb. Check your tire pressure during
routine maintenance and seasonal changes.
If the Tire Pressure Monitoring System light
stays illuminated after starting, immediately
check the vehicle’s tire pressures.
Warning: Improperly inflated tires
can affect vehicle handling and
tire performance.
Rear Window Buffeting
When one or both of the rear windows are
open, the vehicle may demonstrate a wind
throb or buffeting noise; this noise is
commonamong a wide range of vehicles
and can be eliminated by simply lowering
a front window approximately two to
three inches.
Fuel Pump Shut-Off Switch
The fuel pump shut-off switch is a device
intended to stop the electric fuel pump
when your vehicle has been involved in a
substantial jolt. The switch is located in the
passenger’s footwell, by the kick panel. After
a collision, if the engine cranks but does not
start, the fuel pump shut-off switch may
have been activated. For more information
regarding the fuel pump shut-
off switch,
refer to the Roadside Emergencieschapter of
your Owner’s Guide.
Changing the Tires
The spare tire is not equipped with a Tire
Pressure Monitoring System (TPMS) sensor.
The TPMS warning light will illuminate when
the spare tire is in use. Replace the spare tire
with a road tire as soon as possible. If you
get a flat tire while driving, do not apply the
brake heavily; instead, gradually decrease
your speed, hold the steering wheel firmly
and slowly move to a safe place on the side
of the road.
Roadside Assistance
During your Mountaineer’s 3-year/36,000
mile limited warranty period, the assurance
and support of a 24-hour emergency
roadside assistance program is included.
Roadside assistance includes such services as
fuel delivery, tire changes, jump starts and
help when you are locked out of your
vehicle. Complete your roadside assistance
identification card and keep it handy (such
as in your wallet) for quick reference. This
identification card is located in your Mercury
Owner’s Information portfolio. To receive
roadside assistance in the United States, call
(800) 241-3673.
MERCURY MOUNTAINEERQUICK REFERENCE GUIDE 20
07
Ford Motor Company
Customer Relationship Center
P.O. Box 6248
Dearborn, MI 48121
1-800-392-3673 (FORD)
(TDD for the hearing impaired: 1-800-232-5952)
This Quick Reference Guide is not intended to
replace your Owner’s Guide which contains
more detailed information concerning the
features of your vehicle, as well as important
safety warnings designed to help reduce the risk
of injury to you and your occupants. Please read
your entire Owner’s Guide carefully as you begin
learning about your new vehicle and refer to
the appropriate sections when questions arise.
All information contained in this Quick ReferenceGuide was accurate at the time of duplication.
We reserve the right to change features,
operation and/or functionality of any vehicle
specification at any time. Your Mercury
dealer is the best source for the most
current information.
For detailed operating and safety information,
please refer to your Owner’s Guide.
August 2006
First Printing
Quick Reference Guide Mercury Mountaineer
Litho in U.S.A.
*7L9J19G217AA*
7L9J-19G217-AA
CENTERCONSOLE
Dual Automatic Temperature Control (DATC) System(if equipped)
If your Mountaineer came equipped with another climate system, refer to your Owner’s Guide
for detailed information.
1 Temperature controls
To control the temperature on the driver’s side in single zone mode, select any temperature
between 60°F and 90°F by pressing the driver temperature control. The climate system’s
display indicates the selected temperature. The passenger can also select any temperature
between 60°F and 90°F by pressing the passenger temperature control.
2 Fan Speed
Press to manually increase and decrease fan speed.
3 DUAL(Single / Dual Electric Temperature Control)
The control allows the driver to have full control of the cabin temperature settings (single
zone) or allows the passenger to have control of their individual temperature settings (dual
zone control). Press to turn on dual zone mode; press again to return to single zone.
4 AUTO
Press to select the desired temperature shown in the display window. The system will
automaticallydetermine the fan speed, the direction of the airflow, and outside or recirculated
air to heat or cool the vehicle to the selected temperature.
5 OFF
Outside air is shut out and the fan will not operate. Note:If your vehicle is equipped with
the auxiliary climate control system, the auxiliary fan can still operate with the front system off.
6 Manual Override Controls
Press to manually determine where airflow is directed. To return to fully automatic
control, press AUTO.
7 Windshield Defroster
Outside air is distributed through the windshield defroster vents.
8 Rear Window Defroster
The rear defroster control is located on the instrument panel. Press the rear defroster control
to clear the rear window of thin ice and fog. The ignition must be in the 3 (ON) position to
operate the rear window defroster. The defroster turns off automatically after ten minutes or
when the ignition is turned to the 1 (OFF/LOCK) or 2 (ACC) position. To manually turn off the
defroster before ten minutes have passed, push the control again.Audiophile AM / FM In-Dash Six CD /
MP3 / Satellite Compatible



Sound System (if equipped)
If your Mountaineer came equipped with
another audio system, refer to your Owner’s
Guide for detailed information.
ACD Eject:Press and hold to auto eject all
CDs present in the system. Press and a
memory preset to eject from a specific slot.
BLOAD:Press LOAD and a memory preset
to load to a specific slot. Press and hold to
autoload up to six CDs.
CTune / Disc selector:Press and release to
manually advance up / down the radio
frequency or to select a desired disc. Press
and hold for a fast advance through radio
frequencies or all loaded discs. Also use in
menu mode to select various settings.
DCD:Press to enter CD mode. If a CD is
already loaded into the system, CD play will
begin where it ended last. If no CD is
loaded, NO DISC will appear in the display.
E AM / FM:Press to select AM / FM1 / FM2
frequency band.
FMUTE / Phone:Press to mute the
playing media. Press again to return to
the playing media.
SATELLITE RADIO CONTROLS(if equipped)
GAUX:Press repeatedly to cycle through
SAT1, SAT2, SAT3 (satellite radio mode if
equipped), LINE IN (auxiliary audio mode),
or FES/DVD (if equipped). Once Satellite
Radio mode is activated you may use the
following functions:
Press MENU until CATEGORY MODE
appears in the display. Press / to select
from various categories of music (country,
rock, etc.) and press and hold SEEK or
TEXT/SCAN to search for channels playing
that specific category of music.
Press SEEK to access the previous/next
channels. Press and release TEXT/SCAN to
display the current song title. Press again toscroll through current song title, artist, chan-
nel category and the SIRIUS long channel
name. Press and hold for a brief sampling of
the next channels. Press again to stop.
H MENU: Press repeatedly to cycle through
the following modes: Autoset, Bass, Treble,
Balance, Fade, Occupancy mode, Speed
sensitive volume, Setting the clock, RBDS,
(Radio Broadcast Digital Signal), Track /
Folder Mode & Compression. For more
information on these menu items, refer to
your Owner’s Guide.
ISEEK:Press < to access the previous
strong station or track. Press > to access the
next strong station or track.
J TEXT/SCAN:Press and hold for a brief
sampling of radio stations or CD tracks.
Press again to stop. In CD / MP3 mode,
press TEXT to display track title, artist name
and disc title.
KREW (Rewind):Press to manually reverse
in a CD or MP3 track.
L FF (Fast forward):Press to manually
advance in a CD or MP3 track.
M FOLDER:In folder mode, press to access
the previous or next folder on MP3 discs, if
available.
NSHUFFLE:Press to play the tracks on the
current disc in random order.
OPLAY / PAUSE:This control is operational
in CD and DVD mode (if equipped). When
a CD or DVD is playing in the Family
Entertainment System, press this control to
play or pause the current CD / DVD. The CD
/ DVD status will display in the radio display.
PMemory Presets:To set a station, select
frequency band AM / FM1 / FM2, tune to a
station, press and hold a preset button (1-6)
until sound returns.
Essential InformationClimate Co n t r o lAudio System
45678
12
A
B
E
H
I
KLM
P
NO
F
I
C
D
GJ
1
3