high beam Mercury Mystique 2000 Owner's Manuals

Page 24
Rear window
defroster control*
6
Instrumentation
Page 57
Turn signal/high beam
Page 8
Instrument clusterPage 56
Hazard flasher
control
Page 58
Windshield
wiper/washer
control
Page 166
Hood release
Page 22, 23
Headlamp control/
Foglamp control*Page 56
Horn
Page 55
Tilt steering
wheel leverPage 54
Ignition switch
Page 59
Speed control* Page 24
Traction control*
Page 25
Power mirrors*
TRACTION
CONTROLCHECK
ENGINEO/D
OFF
Res
Set
Acc
CoastOff
On
EF

000123
000010 20 3040506070
80
90
10 0
110
120
13 0MPH
20 406055
80120 10 0
14 0
160
18 0
20012
03
x 1000
4
5
6
7
8
MIRRORS
BRAKE
CH
12MInen 24.6.99 15:02 Uhr Seite 6

Instrumentation
9 High beams
Illuminates when the headlamp
high beams are on. Charging system
Briefly illuminates when the
ignition is turned on and the engine
is off. The light also illuminates
when the battery is not charging
properly and the vehicle may
require electrical system service.
O/D
OFFTRACTION
CONTROLAir bag secondary warning
Flashes periodically when there is a
malfunction with the air bag
system.
For more information, refer to the
Seating and safety restraints
chapter. Safety belt
Illuminates when the ignition is
switched on as a reminder to fasten
the safety belts. For more
information, refer to Safety belt
indicator light and warning
chime in the Seating and safety
restraints chapter.Alternative design
Alternative design
Alternative design
12MInen 24.6.99 15:03 Uhr Seite 9

Controls and features
23
Daytime running light (DRL)
(Canadian vehicles only)
The DRL system turns on the
highbeam headlamps, with a
reduced light output, when:
• the vehicle is running and the
ignition is in the on position and
• the headlamp system is in the off
position. Foglamp control
(if equipped)
Pull out the control while the
headlamps are on to turn the
foglamps on.
Push the control in to deactivate
the foglamps.
The daytime running light
(DRL) system will not
illuminate the tail lamps and
parking lamps. Turn on your
headlamps at dusk. Failure to do
so may result in a collision.
13MCfen 24.6.99 15:05 Uhr Seite 23

Controls and features
57
OFF LO PNL/FLR
PANEL
A/CFLOOR
DEF FLR
DEF
MAX
A/C HI/
POWER AUDIO AM/FM
SCAN
SEEK 31245ANSSIDE 1-2EJECTVOLUME
000123
000010 20 3040506070
80
90
10 0
110
120
13 0MPH20 406055
80120 10 0
14 0
160
18 0
200EF12
03
x 1000
4
5
6
7
8
CHECK
ENGINE TRACTION
CONTROLO/D
OFF
MIRRORS
CLOCK
TRACTION
TROL
CH
Multi-function switch
The turn signal functions are
available only with the ignition
switch on.
Right turn signal
Move the lever up.
Left turn signal
Move the lever down.
Flash-to-pass
Pull the lever toward you and
release quickly for “flash-to-pass”
operation.
High beam heaadlamps
Push the lever toward the
instrument panel.
13MCfen 24.6.99 15:06 Uhr Seite 57

Roadside emergencies
145 Ampere
ratingCircuits protected
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
39
40
41
42
43
44
45
46
47
48
49
50
51
52—
7.5
20
—
—
3
20
—
15
—
20
—
20
7.5
7.5
7.5
7.5
7.5
—
20*
20*
40*
—
—
60*
—
—
—
60*
—
60*
60*Not used
Alternator
Foglamps
Not used
Not used
EEC ignition module (memory)
Horn and hazard flasher warning system
Not used
Fuel pump
Not used
Ignition, Electronic Engine Control
Not used
HEGO sensor
ABS module
Low beam headlamp (passenger’s side)
Low beam headlamp (driver’s side)
High beam headlamp (passenger’s side)
High beam headlamp (driver’s side)
Not used
Ignition, light switch, central junction box
EEC relay
Central junction box (fuse 37 to blower relay)
Not used
Not used
Ignition
Not used
Not used
Not used
Engine cooling
not used
ABS
Central junction box (central timer module, rear
window defrost relay, fuses 24, 25, 27, 28, 34) Fuse
Power distribution box (engine compartment)
* Have these fuses replaced by your dealer or qualified technician.
23MREen 24.6.99 15:28 Uhr Seite 145

Roadside emergencies
146Passenger compartment fuse
panel
To check or change a fuse or a
relay, open the fuse box by pulling
down the lock release lever (1).
1
Power distribution box (engine compartment)
RelayCircuits switched
R 1
R 2
R 3
R 4
R 5
R 6
R 7
R 8
R 9
R 10
R 11
D1
D2
Fuel pump
EEC module
Air conditioning
Low beam
High beam
Horn
Starter solenoid
Engine cooling fan (high speed)
Engine cooling fan
Not used
Daytime running lights
Reverse voltage protection
Not used
23MREen 24.6.99 15:28 Uhr Seite 146

Maintenance and care
206
1
1
2
The bulbs for the low beam, high
beam, turn signals and side lamps
are housed in the lamp assembly.
To replace a bulb, the complete
lamp assembly has to be removed
as follows:
1. Switch off the lamps.
2. Open the hood.
3. Remove the lower screw (2)
from the headlamp housing.
4. Remove the two upper screws
(1) from the headlamp housing.
5. Gently pull the headlamp
housing outward.
6. Replace the headlamp bulbs. BULB REPLACEMENT
Handle a halogen headlamp
bulb carefully and keep out
of children’s reach.Grasp the bulb
only by its plastic base and do not
touch the glass. The oil from your
hand could cause the bulb to
break the next time the
headlamps are operated.
Removing the headlamps
assembly
31MMCen 24.6.99 15:31 Uhr Seite 206

Maintenance and care
207 Reinstalling the headlamp
assembly
The gasket lining must be seated
properly around the lamp assembly
when reinstalling.
All bulb connectors must be
correctly connected.
Install in the reverse order.
Headlamp – low beam
Pull off the connector, release the
wire clip and replace the bulb.
Pay attention to the tab guides
when replacing.
Headlamp alignment
Check the headlamp alignment
after each replacement of a bulb.
Refer to Aiming the headlamps. Headlamps – high beam
Replacement instructions are the
same as for the low beam
headlamp.
31MMCen 24.6.99 15:31 Uhr Seite 207

Maintenance and care
213 Aiming the headlamps
Your vehicle is equipped with a
Vehicle Headlamp Aim Device
(VHAD) on each headlamp body.
Each headlamp may be properly
aimed in the horizontal direction
(left/right) and the vertical
direction (up/down).
A non-zero bubble reading (vertical
indicator) does not necessarily
indicate out-of-aim headlamps. If
your vehicle is not positioned on a
level surface, the slope will be
included in the vertical indication.
Therefore, vertical and horizontal
headlamp adjustment should be
performed only when beam
direction appears to be incorrect. AIMING THE HEADLAMPS
The alignment of your headlamps
should be checked if:
• Oncoming motorists frequently
signal you to deactivate your high
beams, and your high beams are
not activated.
• The headlamps do not seem to
provide enough light for clear night
vision.
• The headlamp beams are pointed
substantially away from a slightly
down and to the right position.
31MMCen 24.6.99 15:31 Uhr Seite 213

Index
244FPage
Fuel
calculating fuel economy . . . .201
capacity . . . . . . . . . . . . . . . . . .224
choosing the right fuel . . . . . .198
consumption . . . . . . . . . . . . . .140
fuel gauge . . . . . . . . . . . . . . . . .21
low fuel warning light . . . . . . . .15
octane rating . . . . . . . . . . . . . .199
quality . . . . . . . . . . . . . . . . . . .199
running out of fuel . . . . . . . . .202
safety information relating
to automotive fuels . . . . . . . . .196
Fuel pump shut-off switch . . . .141
Fuse panels
engine compartment . . . . . . . .144
instrument panel . . . . . . . . . . .146
Fuses
charts . . . . . . . . . . . . . . . .145, 148
checking and replacing . . . . . .143
G
Gas mileage (see Fuel)
Gauges
engine coolant temperature . . .20
fuel . . . . . . . . . . . . . . . . . . . . . . .21
odometer . . . . . . . . . . . . . . . . . .20
speedometer . . . . . . . . . . . . . . .20
trip odometer . . . . . . . . . . . . . .20
GAWR
(Gross Axle Weight Rating) . . .131
Gearshift . . . . . . . . . . . . . .123, 128
GVWR
(Gross Vehicle Weight Rating) .131
H
Hazard flashers . . . . . . . . . .56, 141
Head restraints . . . . . . . . . . . . . .74
Headlamps
aiming . . . . . . . . . . . . . . . . . . .213
bulb specifications . . . . . . . . .212
daytime running light . . . . . . . .23
flashing . . . . . . . . . . . . . . . . . . .57HPage
high beam . . . . . . . . . . . . . . . . .57
replacing bulbs . . . . . . . . . . . .206
turning on and off . . . . . . . . . . .22
warning chime . . . . . . . . . . . . . .19
High beams
indicator light . . . . . . . . . . . . . . .9
operation . . . . . . . . . . . . . . . . . .57
High-mount brakelamp . . . . . . .210
Hood
latch location . . . . . . . . . . . . . .166
release lever . . . . . . . . . . . . . .166
Horn . . . . . . . . . . . . . . . . . . . . . . .56
I
Identification Number, Vehicle
(VIN) . . . . . . . . . . . . . . . . . . . . .228
Idle, relearning . . . . . . . . . . . . .185
Idle, speed . . . . . . . . . . . . . . . . .185
Ignition
chime . . . . . . . . . . . . . . . . . . . . .19
positions on the ignition . . . . . .54
Instrument cluster . . . . . . . . . . . . .8
Instrument panel
cleaning . . . . . . . . . . . . . . . . . .221
lighting up the panel . . . . . . . . .25
Integrated child seat (see Built-in
child seat)
Intermittent wipers . . . . . . . . . . .58
Introduction . . . . . . . . . . . . . . . . . .2
J
Jack
positioning . . . . . . . . . . . . . . . .152
storage . . . . . . . . . . . . . . . . . . .151
Jump starting your vehicle
attaching cables . . . . . . . . . . . .155
disconnecting cables . . . . . . . .158
K
Keys
key in ignition warning chime .19
positions of the ignition . . . . . .54
4MInden 24.6.99 15:41 Uhr Seite 244