air condition Mercury Sable 1996 s User Guide

282
*
[SV19850(ALL)03/95]
q
Check for leaks at the draincock.
*
[SV19900(ALL)03/95]
q
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use.
[SV19950(ALL)04/95]
About Your Battery
*
[SV20001(ALL)02/95]
Your vehicle may have a Motorcraft
maintenance-free battery. When the original
equipment battery is replaced under warranty, it
may be replaced by a Motorcraft
Low-Maintenance Battery.
[SV20850(ALL)04/95]
Because your vehicle's engine is electronically
controlled by a computer, some control
conditions are maintained by power from the
battery. If you ever disconnect the battery or
install a new battery, you must allow the
computer to ªrelearnº its idle conditions before
your vehicle will drive properly. To begin this
process, put the gearshift in P (Park), set the
parking brake, turn off all the accessories, and
start the vehicle. Bring the engine to normal
operating temperature. Allow the engine to idle
for one minute in N (Neutral) and one minute in
Drive or Overdrive. Perform the previous
procedure with the air conditioning on and off
(conditions permitting). The relearning process
will complete automatically as you drive the
vehicle.
*
[SV21000(ALL)03/95]
If you do not let the engine relearn its idle, the
idle quality of your vehicle may be adversely
affected until the idle is relearned. Your vehicle
will eventually relearn its idle while you drive
it, but it takes much longer than if you use the
previous procedure.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

290
*
[SV24900(ALL)08/95]
RWARNING
Over- or under-inflated tires can
affect vehicle handling and can fail
suddenly, possibly resulting in loss
of vehicle control.
[SV24925(ALL)04/95]
Consistent high-speed driving
[SV24950(ALL)02/95]
RWARNING
Ford Motor Company recommends
obeying the posted speed limits.
Driving too fast under certain
conditions is dangerous and could
cause loss of vehicle control or
breakdown of certain vehicle
components resulting in personal
injury.
[SV24975(ALL)02/95]
In the event of continuous operation at high
speed, the cold air pressure in all tires must be
increased by 4 p.s.i. (28 kpa) when compared to
the inflation pressure shown on the tire decal
posted in the glove compartment. Under no
circumstances should you exceed maximum tire
inflation pressure which is molded on the tire
outer side wall.
[SV25025(ALL)02/95]
Your vehicle has been equipped with proper
speed rated tires to meet its speed capabilities.
For further details, consult your Tire Warranty
Booklet provided with the vehicle in the glove
compartment.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

327 %
*
[SV42405(ALL)03/95]
Readiness for Inspection/Maintenance
Testing
*
[SV42410(ALL)03/95]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies a
ªneed for additional mixed city and highway
driving to complete the checkº of the OBD II
system. As soon as all of the OBD II system
checks are successfully completed, the OBD II
system is set to the ready condition. The amount
of driving required to reach the ready condition
varies with individual driving patterns. To
complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle
defined below. If the vehicle owner cannot or
does not want to do the additional driving
required by law, a service center can perform
this drive cycle as it would any other type of
repair work.
*
[SV42420(ALL)03/95]
OBD II Drive Cycle
*
[SV42430(ALL)04/95]
The following steps must be run in the order
shown. If any steps are interrupted, repeat the
preceding step. Any safe driving mode is
acceptable between steps.
*
[SV42440(ALL)03/95]
Always drive vehicle in safe manner according
to traffic conditions and obey all traffic laws.
[SV42445(ALL)04/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[SV42450(ALL)04/95]
1. Start the engine. Drive or idle (in neutral)
the vehicle for 4 minutes.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

Index 347
Index
A
ABS warning light
(see Anti-lock brake system)....... 83
Accessory position on the ignition..... 61
Additives, engine oil.......... 273
Air bag supplemental restraint system
description............... 23
disposal................ 32
driver air bag............. 23
indicator light............. 79
operation............... 28
proper seating............. 24
tone generator............. 31
wearing safety belts........... 23
Air cleaner filter
location............... 261
replacing............... 296
Air conditioning
electronic automatic temperature control
system............... 95
manual heating and air conditioning
system............... 93
Alarm, activating remote personal.... 135
Antifreeze (see Engine coolant)...... 276
Anti-lock brake system (ABS)
description.............. 204
warning light.............. 83
Anti-theft lug nuts and key....... 230
Anti-theft system
triggering.............. 137
warning light.............. 90
Audio system
(see Electronic sound system)..... 169
Autolamp system (see Headlamps).... 108
File:fcixs.ex
Update:Tue Aug 8 10:58:02 1995

354 Index
GVWR (Gross Vehicle Weight Rating)
definition............... 209
location............... 209
H
Hazard flashers............. 118
Headlamps
aiming................ 317
autolamp system........... 108
bulb specification........... 323
checking alignment.......... 314
daytime running lights........ 107
flashing............... 116
high beam.............. 115
replacing bulbs............ 315
turning on and off.......... 106
warning chime............. 79
Head restraints............. 145
Heated mirrors............. 104
Heating
electronic automatic temperature control
system................ 95
manual heating and air conditioning
system................ 93
High beams
indicator light............. 78
operation............... 107
High-mount brakelamp, replacing
the bulb............... 320
Hitch.................. 214
Hood
latch location............. 258
lubrication specifications........ 331
release lever............. 258
Horn.................. 119
Hoses, checking............. 277
File:fcixs.ex
Update:Tue Aug 8 10:58:02 1995