jump cable Mercury Sable 1996 Owner's Manuals
[x] Cancel search | Manufacturer: MERCURY, Model Year: 1996, Model line: Sable, Model: Mercury Sable 1996Pages: 391, PDF Size: 3.26 MB
Page 245 of 391
![Mercury Sable 1996 Owners Manuals 218 %
*
[RE00700(ALL)03/95]
RWARNING
Be careful when lifting a battery that
is in a plastic case. If you put too
much pressure on the ends, you
could spill acid from the vent caps,
causing serious dam Mercury Sable 1996 Owners Manuals 218 %
*
[RE00700(ALL)03/95]
RWARNING
Be careful when lifting a battery that
is in a plastic case. If you put too
much pressure on the ends, you
could spill acid from the vent caps,
causing serious dam](/img/33/11168/w960_11168-244.png)
218 %
*
[RE00700(ALL)03/95]
RWARNING
Be careful when lifting a battery that
is in a plastic case. If you put too
much pressure on the ends, you
could spill acid from the vent caps,
causing serious damage to the vehicle
and injury to yourself. Lift the
battery with a carrier or with your
hands on the opposite corners.
%*
[RE00800(ALL)01/95]
Do not let children touch the battery.
Batteries contain sulfuric acid which
burns skin, eyes, and clothing. If the
acid touches someone's skin, eyes, or
clothing, immediately flush the area
with water for at least 15 minutes. If
someone swallows the acid, have him
or her drink lots of milk or water
first, then Milk of Magnesia, a
beaten egg, or vegetable oil. Call a
doctor immediately.
*
[RE00900(ALL)03/95]
To avoid damaging your vehicle or your battery,
and to avoid injury to yourself, follow these
directions for preparing your vehicle to
jump-start and connecting the jumper cables in
the order they are given. If in doubt, call for
road service.
*
[RE01000(ALL)03/95]
Preparing Your Vehicle
*
[RE01100(ALL)03/95]
1. Your vehicle has a 12-volt starting system, so
you need to use a 12-volt jumper system.
You will damage your starting motor,
ignition system, and other electrical parts if
you connect them to a 24-volt power supply
(either two 12-volt batteries in series or a
24-volt generator set).
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995
Page 246 of 391
![Mercury Sable 1996 Owners Manuals 219
*
[RE01200(ALL)03/95]
2. Do not disconnect the battery of the disabled
vehicle. You could damage the vehicles
electrical system.
*
[RE01300(ALL)04/95]
3. Park the booster vehicle close to the hoo Mercury Sable 1996 Owners Manuals 219
*
[RE01200(ALL)03/95]
2. Do not disconnect the battery of the disabled
vehicle. You could damage the vehicles
electrical system.
*
[RE01300(ALL)04/95]
3. Park the booster vehicle close to the hoo](/img/33/11168/w960_11168-245.png)
219
*
[RE01200(ALL)03/95]
2. Do not disconnect the battery of the disabled
vehicle. You could damage the vehicle's
electrical system.
*
[RE01300(ALL)04/95]
3. Park the booster vehicle close to the hood of
the disabled vehicle.Make sure the vehicles
do not touch each other.Set the parking
brake on both vehicles and stay clear of the
engine cooling fan and other moving parts.
*
[RE01400(ALL)03/95]
4. Check all battery terminals and remove any
excessive corrosion before you attach the
jumper cables.
[RE01500(ALL)04/95]
5. Turn on the heater fan in both vehicles. If
you have electronic climate control, press the
VF-DEF button. Turn off all other switches
and lights.
%*
[RE01700(ALL)08/95]
Connecting the jumper cables
*
[RE02500(ALL)03/95]
1. Connect one end of the first jumper cable to
the positive (+) terminal of the discharged
battery. (You can connect either jumper cable
to the positive (+) terminal, as long as you
use the same cable for both positive
terminals.) Most jumper cables have a red
cable and a black cable. The red cable is
generally used for the positive terminals and
the black for the negative ones.
*
[RE02600(ALL)04/95]
2. Connect the other end of the first cable to
the positive (+) terminal of the booster
battery.
*
[RE02700(ALL)03/95]
3. Connect one end of the second cable to the
negative (s) terminal of the booster battery
Ð NOT to the discharged battery.
*
[RE02800(ALL)04/95]
4. Connect the other end of the second cable to
a good metallic surface on the engine or
frame of the disabled vehicle.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995
Page 247 of 391
![Mercury Sable 1996 Owners Manuals 220
*
[RE02900(ALL)03/95]
RWARNING
Do not connect the end of the second
cable to the negative (s) terminal of
the discharged battery. If you do, a
spark may cause an explosion of the
gases that normal Mercury Sable 1996 Owners Manuals 220
*
[RE02900(ALL)03/95]
RWARNING
Do not connect the end of the second
cable to the negative (s) terminal of
the discharged battery. If you do, a
spark may cause an explosion of the
gases that normal](/img/33/11168/w960_11168-246.png)
220
*
[RE02900(ALL)03/95]
RWARNING
Do not connect the end of the second
cable to the negative (s) terminal of
the discharged battery. If you do, a
spark may cause an explosion of the
gases that normally surround the
battery and could seriously injure
someone.
[RE03100(ALL)04/95]
one third page art:0000388-D
Jumper cable connections
*
[RE03400(ALL)03/95]
Jump-Starting
*
[RE03600(ALL)03/95]
1. Make sure that the jumper cables are not in
the way of moving engine parts, then start
the booster vehicle. Run the engine at a
moderate speed.
*
[RE03700(ALL)03/95]
2. Let the discharged battery charge for a few
minutes and then start the disabled vehicle.
It may take a couple of tries before the
vehicle starts. If the vehicle does not start
after several attempts, there may be a
different problem.
*
[RE03800(ALL)03/95]
3. When both vehicles are running, let them
idle for a few minutes to charge the
discharged battery.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995
Page 248 of 391
![Mercury Sable 1996 Owners Manuals 221 %
*
[RE03900(ALL)03/95]
Removing jumper cables
*
[RE04000(ALL)03/95]
1.Always remove the jumper cables in the
reverse order.Remove the negative (s) end
of the jumper cable from the metallic surfac Mercury Sable 1996 Owners Manuals 221 %
*
[RE03900(ALL)03/95]
Removing jumper cables
*
[RE04000(ALL)03/95]
1.Always remove the jumper cables in the
reverse order.Remove the negative (s) end
of the jumper cable from the metallic surfac](/img/33/11168/w960_11168-247.png)
221 %
*
[RE03900(ALL)03/95]
Removing jumper cables
*
[RE04000(ALL)03/95]
1.Always remove the jumper cables in the
reverse order.Remove the negative (s) end
of the jumper cable from the metallic surface
on the engine or frame of the disabled
vehicle.
*
[RE04100(ALL)03/95]
2. Remove the negative (s) cable from the
booster battery.
*
[RE04200(ALL)03/95]
3. Remove the positive (+) cable from the
booster battery.
*
[RE04300(ALL)03/95]
4. Remove the other end of the positive (+)
cable from the discharged battery.
*
[RE04400(ALL)04/95]
After the vehicle is started, let it idle for a while
to let the engine ªrelearnº its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
You may need to use a battery charger to fully
recharge the battery.
*
[RE04450(ALL)03/95]
If you need to replace your battery, seeBattery
in theServicing Your Vehiclechapter.
%
*
[RE04500(ALL)03/95]
Changing a Tire
*
[RE04600(ALL)01/95]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
[RE04610(ALL)01/95]
NOTE: Tire sealants that are injected through
the valve stem are not to be used to
service punctured tires because they
can produce wheel rust and tire
imbalance.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995
Page 382 of 391

Index 355
I
Idle
relearning.............. 282
speed................. 66
Ignition
positions of the ignition......... 61
removing the key............ 62
Infant seats (see Safety seats)........ 34
Instrument cluster........... 73,86
standard................ 73
Instrument panel
lighting up panel and interior..... 110
location of components......... 92
Interval wipers............. 117
J
Jack, positioning............ 226
Jump-starting your vehicle
attaching cables............ 219
disconnecting cables.......... 221
K
Keyless entry system
locking and unlocking doors...... 130
programming entry code....... 129
Keys
positions of the ignition......... 61
removing from the ignition....... 62
stuck in lock position.......... 62
L
Lamps
bulb replacement specifications chart . . 323
daytime running light system..... 107
dome lamps............. 111
flashing the lamps.......... 116
hazard flashers............ 118
headlamps.............. 106
File:fcixs.ex
Update:Tue Aug 8 10:58:02 1995